Monoprice 605650 Bedienungsanleitung
SAFETY WARNINGS AND GUIDELINES
Please read this entire manual before using this device, paying extra attention to these
safety warnings and guidelines. Please keep this manual in a safe place for future reference.
These speakers are intended for indoor use only.
Do not expose these speakers to water or moisture of any kind. Do not place drinks
or other containers with moisture on or near these speakers. If moisture does get in
or on these speakers, immediately unplug them from the power outlet and allow
them to fully dry before reapplying power.
Do not touch the power cord or any other connected cables with wet hands.
If operating these speakers in a humid environment, ensure that no condensation
occurs. Condensation could cause damage to the speaker cone and could cause a
short in the amplifier, which in turn could cause fire or severe electric shock.
Do not install these speakers on an unstable surface where they could fall and cause
either personal injury or damage to the speakers and/or other equipment.
Do not place or install these speakers in an area where they can be exposed to
excessive amounts of heat, dust, humidity, oil, smoke, or combustible vapors.
Prior to operation, check the power cord for physical damage. Do not use if physical
damage has occurred.
Before plugging the speakers into a power outlet, ensure that the outlet provides
the same type and level of power required by the speakers.
These speakers use grounded power cords and require a ground connection for safe
operation. Ensure that the power source has a proper ground connection. Do not
modify the plug or use a "cheater" plug to bypass the ground connection.
Unplug these speakers from the power source when not in use.
Disconnect these speakers from their power source when replacing the fuse.
Replace the fuse only with the same type.
Do not bypass the purpose of the fuse by shorting the contacts or by any other
means.
3
Take care to prevent damage to the power cord. Do not allow it to become
crimped, pinched, walked on, or become tangled with other cords. Ensure that the
power cord does not present a tripping hazard.
Never unplug these speakers by pulling on the power cord. Always grasp the
connector head.
Ensure that power is turned off and disconnected before making any electrical
connections.
Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or
detergents. For stubborn deposits, moisten the cloth with warm water.
These speakers have no user serviceable parts. Do not attempt to open, service, or
modify these speakers.
INTRODUCTION
Thank you for purchasing these 6.5-inch Powered Coaxial Studio Multimedia Monitor
Speakers from Monoprice! These speakers are professional quality studio monitors,
designed to produce a flat frequency response for studio recording, mixing, and mastering
duties. Each speaker is bi-amped, with separate power amplifiers for the low-frequency
and high-frequency coaxial drivers. They include balanced XLR, balanced/unbalanced
TRS/TS, and unbalanced RCA inputs.
4
FEATURES
6.5" DuPont™ Kevlar® fiber cone woofer with high-temperature voice coil
1" silk dome coaxial tweeter
50Hz ~ 22kHz frequency response
60-watt low-frequency class D amplifier
30-watt high-frequency class D amplifier
Balanced XLR, balanced/unbalanced TRS/TS, and unbalanced RCA inputs
90dBA output SPL
Greater than 95dB signal-to-noise ratio
CUSTOMER SERVICE
The Monoprice Customer Service department is dedicated to ensuring that your ordering,
purchasing, and delivery experience is second to none. If you have any problem with your
order, please give us an opportunity to make it right. You can contact a Monoprice
Customer Service representative through the Live Chat link on our website
www.monoprice.com during normal business hours (Mon-Fri: 5am-7pm PT, Sat-Sun: 9am-
PACKAGE CONTENTS
Please take an inventory of the package contents to ensure you have all the items listed
below. If anything is missing or damaged, please contact Monoprice Customer Service for a
replacement.
2x 6.5" powered studio monitors
2x AC power cords (IEC 60320 C14 to NEMA 5-15)
1x User's manual
5
PRODUCT OVERVIEW
1. WOOFER AND TWEETER: 6.5" DuPont™ Kevlar®
fiber woofer and coaxial 1" silk dome tweeter.
2. BASS REFLEX PORT: Enhances the bass
response.
3. VOLUME: Volume control knob.
4. TRS INPUT: TRS/TS balanced/unbalanced input.
5. HF ADJUST: Boosts or attenuates the high-
frequency response to match the
characteristics of the room.
6. XLR INPUT: Balanced XLR input.
7. RCA INPUT: Unbalanced RCA input.
8. POWER CONNECTOR: Combination power
connector and fuse holder.
9. POWER SWITCH: Rocker switch to turn power
on or off.
6
SETUP AND OPERATION
1. Power off and unplug all equipment to be connected.
2. Carefully remove the speakers and all materials from the packaging.
WARNING! These monitors have no grill covering the speaker diaphragm, so
extreme care must be taken to avoid touching and damaging the speaker cones
when removing the monitors from the packaging!
3. Ensure that the POWER switch on each enclosure is set to the OFF position.
4. Position each monitor in the desired location. Ensure that the monitor is stable and
fully supported upon whatever surface it is positioned and that there is sufficient
room to reach the controls on the back of the monitor.
5. For each monitor, connect a balanced XLR, balanced TRS, unbalanced TRS,
unbalanced TS, or unbalanced RCA cable (not included), then plug the other end to
the audio source (mixer, headphone output, line output, etc.).
6. For each monitor, plug the AC power cord into the monitor, then plug the other end
into a nearby AC power outlet. Note that the input power cord is grounded and it
should be connected to a grounded power source. Do not use a cheater plug or
otherwise bypass the grounding.
7. Double-check all your connections to ensure that they are fully connected and
secure.
8. Turn the VOLUME knob on each monitor fully counterclockwise. This ensures that
you don't inadvertently damage the speakers, or your hearing, when power and
audio material is applied.
9. Switch the POWER to the ON position.
10. Plug in and power on all connected devices. Start playback of your audio source(s).
11. Turn the VOLUME knob clockwise to increase the volume to a comfortable level.
12. If the high-frequencies sound too bright, try using the HF ADJUST switch to
attenuate them by -1dB or -2dB. If the high-frequencies sound a bit muddied or
subdued, try boosting them by setting the HF ADJUST switch to the +1dB position.
7
SPECIFICATIONS
Model
605650
Speaker Type
2-way near-field studio reference monitor
Woofer
6.5" DuPont™ Kevlar® fiber cone with high-
temperature voice coil
Tweeter
Coaxial 1" silk dome
LF Amplifier
60-watt Class D
HF Amplifier
30-watt Class D
Frequency Response
50Hz ~ 22kHz
Crossover Frequency
3.5kHz
HD Adjustment
-2dB, -1dB, Flat, or +1dB
Sensitivity
90dBA SPL@1 meter with 85mV pink noise input
Signal-to-Noise Ratio
> 95dB (typical, A-weighted)
Input Impedance
10 kilohms unbalanced, 20 kilohms balanced
Inputs
Balanced XLR, balanced/unbalanced TRS/TS,
unbalanced RCA
Input Power
110 ~ 120 VAC, 60Hz
Dimensions (each)
10.4" x 8.3" x 9.8" (265 x 210 x 250 mm)
Weight (each)
10.5 lbs. (2.76 kg)
8
TECHNICAL SUPPORT
Monoprice is pleased to provide free, live, online technical support to assist you with any
questions you may have about installation, setup, troubleshooting, or product
recommendations. If you ever need assistance with your new product, please come online
to talk to one of our friendly and knowledgeable Tech Support Associates. Technical
support is available through the online chat button on our website www.monoprice.com
during regular business hours, 7 days a week. You can also get assistance through email by
sending a message to tech@monoprice.com
REGULATORY COMPLIANCE
Notice for FCC
Modifying the equipment without Monoprice’s authorization may result in the equipment
no longer complying with FCC requirements for Class B digital devices. In that event, your
right to use the equipment may be limited by FCC regulations, and you may be required to
correct any interference to radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
9
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Notice for Industry Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
DuPont™ and Kevlar® are trademarks or registered trademarks of E.I. du Pont de Nemours
and Company.
Inhaltsverzeichnis
Andere Monoprice Sprecher Handbücher
Monoprice
Monoprice 43249 Bedienungsanleitung
Monoprice
Monoprice DT-3 Bedienungsanleitung
Monoprice
Monoprice 10951 Bedienungsanleitung
Monoprice
Monoprice Harmony XL Bedienungsanleitung
Monoprice
Monoprice 13264 Bedienungsanleitung
Monoprice
Monoprice MP True Bedienungsanleitung
Monoprice
Monoprice 10800 Bedienungsanleitung
Monoprice
Monoprice DT-4BT Bedienungsanleitung
Monoprice
Monoprice 13193 Bedienungsanleitung
Monoprice
Monoprice MS-03 Bedienungsanleitung
Monoprice
Monoprice 24760 Bedienungsanleitung
Monoprice
Monoprice 41841 Bedienungsanleitung
Monoprice
Monoprice 14446 Bedienungsanleitung
Monoprice
Monoprice DT-3BT Bedienungsanleitung
Monoprice
Monoprice 14890 Bedienungsanleitung
Monoprice
Monoprice 11948 Bedienungsanleitung
Monoprice
Monoprice 33828 Bedienungsanleitung
Monoprice
Monoprice MM-5 Bedienungsanleitung
Monoprice
Monoprice Harmony Capsule 200 Bedienungsanleitung
Monoprice
Monoprice PID11180 Bedienungsanleitung
Beliebte Sprecher Handbücher anderer Marken
Bowers & Wilkins
Bowers & Wilkins 4 Bedienungsanleitung
Sonance
Sonance SONOS OUTDOOR Series Bedienungsanleitung
Electro-Voice
Electro-Voice EVID FM4.2 Bedienungsanleitung
Pioneer
Pioneer XW-HTD630 Bedienungsanleitung
Onn
Onn BWA16AA002 Bedienungsanleitung
HP
HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung