OWC Data doubler Bedienungsanleitung

DATA DOUBLER

Installation Guide

OWC Data Doubler

Introduction........................................................................ 1

1.1 Minimum Requirements

1.2 Package Contents

1.3 About This Manual

Installation..........................................................................3

2.1 Mounting a 2.5" SATA Drive to the Bracket

2.2 Installation by Laptop type

2.2.1 - Late 2008 13” MacBook (5,1) and Mid-2009 13” MacBook Pro (5,5)

2.2.2 - Late 2009 13” MacBook (6,1) and Mid-2010 13" MacBook (7,1)

2.2.3 - Mid-2010 13” MacBook Pro (7,1)

2.2.4 - Early / Late 2011 13” MacBook Pro (8,1) and Mid-2012 13” MacBook Pro (9,2)

2.2.5 - Late 2008 15” MacBook Pro (5,1), Mid-2009 15" MacBook Pro (5,3 and 5,4)

2.2.6 - Mid-2010 15” MacBook Pro (6,2)

2.2.7 - Early / Late 15” MacBook Pro (8,2) and Mid-2012 15” MacBook Pro (9,1)

2.2.8 - Early / Mid 2009 17” MacBook Pro (5,2)

2.2.9 - Mid-2010 17” MacBook Pro (6,1) and Early / Late 2011 17” MacBook Pro (8,3)

Support Resources..........................................................77

3.1 Troubleshooting

3.2 Contacting Technical Support

OWC Data Doubler Table of Contents

Contents

OWC Data Doubler Introduction

1.1 Minimum Requirements

• MacBook 13” (Late 2008, Late 2009, Mid 2010)

• MacBook Pro 13” (Mid 2009, Mid 2010, Early 2011, Late 2011, Mid 2012)

• MacBook Pro 15” (Late 2008, Mid 2009, Mid 2010, Early 2011, Late 2011,

Mid 2012)

• MacBook Pro 17” (Early 2009, Mid 2009, Early 2010, Early 2011, Late

2011)

• The Data Doubler works with 2.5 inch SATA drives (7mm or 9.5mm drive

height)

1.2 Package Contents

Installation screws (7)

OWC Data Doubler

5-Piece Toolkit

NOTE: Some kits do not come with a 2.5 inch SATA drive as pictured above.

1.3 About this manual

The images and descriptions may vary between this manual and the unit

shipped. Functions and features may change depending on the rmware

version. Please visit the product web page for the most recent product

specications.

Introduction

OWC Data Doubler Introduction

Your laptop is a static-sensitive device. It is susceptible

to invisible damage if not protected during installation.

We recommend proper grounding by using a

grounding strap. Make sure to work in a clean, static-

free area, and avoid wearing clothing that retains

static charges. For more information please visit:

www.owcdigital.com/support/anti-static

OWC Data Doubler Installation

2.1 Mounting a 2.5" SATA Drive to the Bracket

1. Align the drive to the connector on the green circuit board, then apply

gentle pressure in the direction shown below to fully connect the drive.

2. Use the two large, round-head Phillips screws from the kit to ax the drive

to the side of the Data Doubler bracket (screw hole locations shown in red).

The OWC Data Doubler and SATA drive are now ready for installation.

Installation

OWC Data Doubler Installation

2.2 Installation by Laptop type

2.2.1 Late 2008 13” MacBook (5,1) and Mid-2009 13” MacBook Pro (5,5)

IMPORTANT: before beginning, be sure that your laptop is fully shut down

and disconnected from all cables, including the power cable. If you have a

MacBook model 5,1, start with Steps 1-3. If you have a MacBook Pro model

5,5 start with Step 4.

1. Use the release lever (highlighted below in red) to release the battery cover,

then remove it (bottom photo). Recommended: Use the pull-tab on the

battery to remove it from the laptop, then set it aside.

OWC Data Doubler Installation

2. Next, remove the eight Phillips screws that secure the bottom cover to the

chassis (highlighted below).

Note: the three right-most screws along the top edge (shown in yellow)

are longer than the rest; install them in the same screw holes at the end of

the process. The rest can be used interchangeably in the remaining screw

holes.

3. Place your ngers on the bottom cover near the black vent opposite the

battery compartment, then lift the bottom cover. There are two snap clips

holding the cover in place; they will release when you lift the cover. Set the

bottom cover aside. You do not need to remove the SATA drive.

Proceed to Step 6.

OWC Data Doubler Installation

4. Remove the 10 Phillips screws from the bottom cover. Note: the three right-

most screws along the top edge (shown in yellow) are longer than the rest;

install them in the same screw holes at the end of the process. The rest can

be used interchangeably in the remaining screw holes.

5. Once the screws are removed, place your ngers along the bottom cover

near the black vent, then lift the bottom cover. There are two snap clips

attached to the cover that will release when you do this. Set the cover aside.

Recommended: before continuing, use the nylon pry tool to gently lift the

battery connector (highlighted in yellow) from the logic board.

OWC Data Doubler Installation

6. You should see the optical drive (indicated by the red arrow). This drive

needs to be removed before you can install the OWC Data Doubler.

7. Rotate the laptop so the optical drive is oriented in the same manner as the

drive shown below.

OWC Data Doubler Installation

8. Beginning on the right side of the optical drive, remove the two Phillips

screws that are highlighted in the photos below. Note: These screws are

not used when reassembling the laptop; store them in a safe place in case

you need them later.

Andere Handbücher für data doubler

Inhaltsverzeichnis

Andere OWC Gehäuse Handbücher

OWC

OWC Envoy Pro Bedienungsanleitung

OWC

OWC OWC “Value Line” Bedienungsanleitung

OWC

OWC ThunderBay 4 mini Leitfaden

OWC

OWC Mercury Elite-AL Pro Bedienungsanleitung

OWC

OWC Mercury Elite-AL Pro Bedienungsanleitung

OWC

OWC Mercury On-The-Go Pro Bedienungsanleitung

OWC

OWC Mercury Elite-AL Pro Bedienungsanleitung

OWC

OWC U.2 NVMe Interchange System Leitfaden

OWC

OWC Mercury Pro Leitfaden

OWC

OWC Mercury Elite Pro Dual Leitfaden

OWC

OWC ThunderBay 4 Leitfaden

OWC

OWC OWCMANVLS2ASY Bedienungsanleitung

OWC

OWC NASPerform Bedienungsanleitung

OWC

OWC Mercury Elite Pro Dual Leitfaden

OWC

OWC Mercury Elite Pro Dual Leitfaden

OWC

OWC Mercury On-The-Go Pro Series Bedienungsanleitung

OWC

OWC TB2U3DKR2 Bedienungsanleitung

OWC

OWC Mercury Elite Pro Dual mini Leitfaden

OWC

OWC Mercury Elite-AL Pro Bedienungsanleitung

OWC

OWC Mercury Elite Pro Dual Bedienungsanleitung

OWC

OWC Mercury Elite-AL Pro Bedienungsanleitung

OWC

OWC Mercury Elite Pro Dual Leitfaden

OWC

OWC Mercury Elite-AL 800 Pro Bedienungsanleitung

OWC

OWC Envoy Pro Bedienungsanleitung

Beliebte Gehäuse Handbücher anderer Marken

SilentiumPC

SilentiumPC Armis AR5 Handbuch

Pulsar

Pulsar 17/TRP80/DSPR Bedienungsanleitung

Thermaltake

Thermaltake V150 TG Bedienungsanleitung

MSI

MSI MPG SEKIRA 500X Bedienungsanleitung

Antec

Antec Dark fleet DF-10 Bedienungsanleitung

Nexans

Nexans WTC05 Bedienungsanleitung

Peavey

Peavey DS 1502 Bedienungsanleitung

D-Link

D-Link ShareCenter Pro DNS-1550-04 Bedienungsanleitung

Rosewill

Rosewill RX82-U(JBOD) Bedienungsanleitung

QNAP

QNAP SAS JBOD CLI 1.0 Bedienungsanleitung

GAMDIAS

GAMDIAS Talos P1 Bedienungsanleitung

Auvs

Auvs KR615 Bedienungsanleitung

Digitus

Digitus DA-71114 Bedienungsanleitung

CommScope

CommScope FDH 3000 Bedienungsanleitung

FS FHD-FWME4 Bedienungsanleitung

JBL

JBL CS1215T Bedienungsanleitung

Pulsar

Pulsar ARAD-S4 Bedienungsanleitung

Pulsar

Pulsar AWO454 Bedienungsanleitung

OWC data doubler Bedienungsanleitung

Beliebte Gehäuse Handbücher anderer Marken