Philips AVENT scf356 Bedienungsanleitung
SCF356
1
SCF356
ENGLISH 6
DEUTSCH 18
FRANÇAIS 32
ITALIANO 46
NEDERLANDS 59
6
General description (Fig. 1)
1 Baby bottle warmer
2 Progress indicator
3 Settings and on/off knob
4 Defrost setting
5 Milk warming setting 1
6 Milk warming setting 2
7 Milk warming setting 3
8 Baby food warming setting
9 On/off button
Important
To fully benet from the support that Philips offers,
register your appliance at www.philips.com/welcome.
Read this user manual carefully before you use the
baby bottle warmer and save it for future reference.
Danger
- Never immerse the appliance in water or any
other liquid, nor rinse it under the tap.
Warning
- Only use the appliance indoors.
- This appliance can be used by children aged from
8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and if they understand the hazards involved.
Cleaning and user maintenance shall not be made by
children unless they are older than 8 and supervised.
ENGLISH
Keep the appliance and its cord out of reach of
children aged less than 8 years.
- Children shall not play with the appliance.
- Do not immerse the cord, plug or appliance in
water or any other liquid.
- Do not let the mains cord hang over the edge of
a table or worktop. Excess cord can be stored in
the base of the baby bottle warmer to ensure
stability of the appliance.
- Keep the mains cord away from hot surfaces.
- Only connect the appliance to an earthed wall
socket. Always make sure that the plug is inserted
into the wall socket properly.
- Check if the voltage indicated on the bottom of
the appliance corresponds to the local mains
voltage before you connect the appliance.
- If you need to use an extension cord, make sure it
is an earthed extension cord with a rating of at
least 13 amperes.
- Do not use the appliance if the plug, the mains cord
or the appliance itself is damaged. If the mains cord is
damaged, you must have it replaced by Philips,
a service centre authorised by Philips or similarly
qualied persons in order to avoid a hazard.
- Do not place the appliance on or near a hot gas
or electric cooker, or in a heated oven.
- Do not preheat the appliance.
ENGLISH 7
- Always place a fully assembled bottle with cap in
the baby bottle warmer before you add water.
- Make sure you add water before you switch on
the baby bottle warmer.
- Hot water can cause serious burns. Be careful
when the baby bottle warmer contains hot water.
- The accessible surfaces of the appliance may
become hot during use.
- Do not move the appliance when it contains hot
water.
- Always check the baby food temperature before
you feed your child.
Caution
- This appliance is intended to be used in
household and similar applications such as farm
houses, bed and breakfast type environments, staff
kitchen areas in shops, ofces and other working
environments, and by clients in hotels, motels and
other residential type environments.
- Unplug the appliance when it is not in use.
- Store any excess mains cord in the base to ensure
stability of the baby bottle warmer.
- Let the appliance cool down before you clean it.
- Follow the descaling instructions to avoid
irreparable damage.
- Do not try to open or repair the appliance yourself.
You can contact the Philips Consumer Care Centre
in your country (see www.philips.com/support).
ENGLISH8
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic elds.
Using the baby bottle warmer
With this baby bottle warmer, you can safely warm and defrost milk in
Philips Avent feeding bottles and milk or baby food in containers.
The baby bottle warmer helps to preserve the valuable nutrients and
vitamins in breast milk because it never overheats the milk. If milk
becomes too warm, nutrients and vitamins are damaged. To help preserve
the quality of your breast milk, it is important to heat the milk in a safe
and controlled way. The baby bottle warmer is designed to warm gently
and evenly and to avoid hot spots, as the milk circulates during warming.
The built-in sensor tracks and controls the milk temperature, to avoid
overheating at all times.
Note: Philips Avent breast milk bags and Philips Avent 2oz/60ml bottles
cannot be used in this baby bottle warmer.
Explanation of settings
- You can choose between the following settings: (Fig. 2)
Defrost setting: To defrost a bottle or container with frozen milk or frozen
baby food. No warming occurs.
Milk warming settings: Select one of these settings when you want to
warm a bottle of milk to a safe temperature. Setting 2 warms your
milk to approximately body temperature. Setting 1 warms your milk
to a slightly lower temperature and setting 3 warms your milk to a
slightly higher temperature.
Baby food warming setting: Select this setting when you want to warm a
container or jar with baby food.
ENGLISH 9
Using the baby bottle warmer to warm milk
1 Put the mains plug in the wall socket (Fig. 3).
2 Place a bottle centrally in the baby bottle warmer (Fig. 4).
Note:To warm milk in a milk storage container, follow the same steps as
indicated for warming milk in a bottle.
3 Fill the baby bottle warmer with the same amount of drinking
water as the amount of milk you want to warm up (for example, to
warm up 125ml/4oz of milk, you need to use 125ml/4oz of drinking
water). If you want to heat up a large amount of milk (>180ml/6oz),
the maximum water level is approximately 1cm/0.4 inches under
the rim of the baby bottle warmer (which corresponds to adding
160ml/4.5oz of drinking water).An accurate water level ensures
correct warming performance. (Fig. 5)
4 Select the desired setting (Fig. 6).
Note: Experience teaches that babies may have a preference for a specic
milk temperature.This can be due to personal preference or external factors
(e.g. environment temperature).All three settings ensure that the milk is
warmed to a safe temperature which is comfortable for your child and helps
to preserve the nutrients and vitamins in the milk.
5 Press the on/off button to switch on the appliance.The light in the
button lights up to indicate that the baby bottle warmer is on (Fig. 7).
Note:The baby bottle warmer starts warming up right after you press the button.
6 Theprogressindicatorstartstollupgraduallywithwhitelightto
show the progress of the milk warming process (Fig. 8).
Note:The progress indicator shows the progress of the milk warming process.
The progress indicator starts ashing when the appliance is on. When the rst
warming phase has been completed, the bottom segment lights up continuously
and the next segment starts ashing to show that the second warming phase is
in progress.These steps continue until the third warming phase has been
completed.Then the entire progress indicator lights up continuously.
ENGLISH10
Andere Handbücher für AVENT scf356
12
Inhaltsverzeichnis
Sprachen:
Andere Philips Flaschenwärmer Handbücher
Philips
Philips SCF355 Bedienungsanleitung
Philips
Philips SCF250/00 Bedienungsanleitung
Philips
Philips SBCSC250/00 Bedienungsanleitung
Philips
Philips AVENT SCF358 Bedienungsanleitung
Philips
Philips SCF215/86 Bedienungsanleitung
Philips
Philips SCF255/52 Bedienungsanleitung
Philips
Philips AVENT scf356 Bedienungsanleitung
Philips
Philips SCF355 Bedienungsanleitung
Philips
Philips SCF282/22 Bedienungsanleitung
Philips
Philips AVENT scf356 Bedienungsanleitung
Philips
Philips SCF355/03 Bedienungsanleitung
Philips
Philips SCF355 Bedienungsanleitung
Philips
Philips SCF355/05 Bedienungsanleitung
Philips
Philips SCF355 Bedienungsanleitung
Philips
Philips SCF355 Bedienungsanleitung
Philips
Philips SCF355 Bedienungsanleitung
Philips
Philips SCF355 Bedienungsanleitung
Philips
Philips SCF355 Bedienungsanleitung
Philips
Philips SBCSC215/87 Bedienungsanleitung
Philips
Philips AVENT scf356 Bedienungsanleitung
