Philips SCF355 Bedienungsanleitung

使用本产品之前，请仔细阅读本用户手册

保留备用

4213 342 21207

SCF355

User manual

用户手册

出版日期：2018-08-20

䀙߱

ؓ⑟

ᘡ䙕

䀙߱

ؓ⑟

ᘡ䙕

2 3 4 5

67 8 9

10 11 12 13

14 15

SCF355

ENGLISH 6

简体中文 18

General description (Fig. 1)

1 Bottle warmer

2 Light

3 Settings knob

4 O setting

5 Defrost setting

6 Keep warm setting

7 Express warming setting

Important

To fully benet from the support that Philips oers, register

your appliance at www.philips.com/welcome.

Read this user manual carefully before you use the bottle

warmer and save it for future reference.

Danger

-Do not immerse the cord, plug or appliance in water or

other liquid.

Warning

-Only use the appliance indoors.

-Do not let the mains cord hang over the edge of a table or

worktop. Excess cord can be stored in the base of the

bottle warmer.

-Keep the mains cord away from hot surfaces.

-Only connect the appliance to an earthed wall socket.

Always make sure that the plug is inserted into the wall

socket properly.

-Check if the voltage indicated on the bottom of the

appliance corresponds to the local mains voltage before

you connect the appliance.

ENGLISH

-If you need to use an extension cord, make sure it is an

earthed extension cord with a rating of at least

13 amperes.

-Do not use the appliance if the plug, the mains cord or the

appliance itself is damaged. If the mains cord is damaged,

you must have it replaced by Philips, a service centre

authorised by Philips or similarly qualied persons in order

to avoid a hazard.

-Do not place the appliance on or near a hot gas or electric

cooker, or in a heated oven.

-This appliances can be used by persons with reduced

physical, sensory or mental capabilities or lack of

experience and knowledge if they have been given

supervision or instruction concerning use of the appliance

in a safe way and understand the hazards involved.

-Children should be supervised to ensure that they do not

play with the appliance.

-This appliance shall not be used by children. Keep the

appliance and its cord out of reach of children.

-Do not spill water on the mains plug.

-Only use the appliance as described in the user manual to

avoid potential injury due to misuse.

-Do not preheat the appliance.

-Always place a fully assembled bottle with cap in the

bottle warmer before you add water.

-Make sure you add water before you switch on the bottle

warmer.

-Hot water can cause serious burns. Be careful when the

bottle warmer contains hot water.

-The accessible surfaces of the appliance may become hot

during use.

ENGLISH 7

-Do not move the appliance when it contains hot water.

-When the food or milk has reached the required

temperature, remove the bottle or container from the

bottle warmer. If you leave food or milk in the bottle

warmer, the temperature of the food or milk increases.

-Always check the food temperature before you feed your

child.

Caution

-This appliance is intended to be used in household and

similar applications such as farm houses, bed and

breakfast type environments, sta kitchen areas in shops,

oces and other working environments, and by clients in

hotels, motels and other residential type environments.

-Unplug the appliance when it is not in use.

-The surface of the heating element is subject to residual

heat after use.

-Let the appliance cool down before you clean it.

-Follow the descaling instructions to avoid irreparable

damage.

-Do not try to open or repair the appliance yourself. You

can contact the Philips Consumer Care Centre in your

country (see www.philips.com/support).

-The food should not be heated for too long.

You can nd the production date code YYWW in the cord

storage compartment in the base of the bottle warmer.

Electromagnetic elds (EMF)

This Philips appliance complies with all applicable standards

and regulations regarding exposure to electromagnetic elds.

ENGLISH

Using the bottle warmer

With this bottle warmer, you can quickly warm all Philips

Avent feeding bottles and milk/baby food in containers and

other baby food jars.

Note: Philips Avent breast milk bags and Philips Avent

2oz/60ml bottles cannot be used in this bottle warmer.

Explanation of settings

-O setting: The bottle warmer is switched o and the light

is o. On every other setting, the appliance is switched on

and the light is lit (Fig. 2).

-Express warming setting: The milk/baby food will be

warmed quickly.

The bottle needs to be taken out immediately after

warming, otherwise the milk will overheat.

-Keep warm setting: Milk is warmed at a slower speed and

be kept at right temperature.

-Defrost setting: Defrost a bottle/container of milk/baby

food to liquid state. No warming occurs.

Using the bottle warmer with express warming setting

1 Put the mains plug in the wall socket (Fig. 3).

2 Place the bottle or container in the bottle warmer (Fig. 4).

3 Fill the bottle warmer with drinking water up to the level

of the milk/baby food in the bottle/container. In case of

large amounts of milk, the maximum level of water is

approximately 1 cm below the top of the bottle warmer.

An accurate water level ensures correct warming

performance (Fig. 5).

4 Select a position in the express warming area. Consider

the beginning of this area as milk content volume up to

180ml and the end of the area as milk content volume

over and including 180 ml, see the express warming

reference table for you reference (Fig. 6).

ENGLISH

Baby food can also be warmed quickly if you select a

position in this area. Make sure to stir and check the food

regularly during warming. Be careful not to burn your ngers

during stirring.

Note: The speed of warming milk/baby food depends on the

amount of the milk/baby food warmed and on its initial

temperature, i.e. room temperature (20°C) or fridge

temperature (5°C).

5 The orange light goes on when you select a setting. This

indicates that the bottle warmer is on (Fig. 8).

Note: Whilst warming the milk circulates and heats evenly.

6 Check the express warming reference table for the time

required to warm the milk. Remove the bottle/container

from the bottle warmer immediately after the warming is

nished (Fig. 9).

Caution: Please make sure to check the milk/baby

food on a regular basis for temperature during

warming.

Caution: If you leave the bottle/container in the bottle

warmer too long, the milk/baby food may become

overheated.

Note: Due to the high variety of baby food consistencies, it

is strongly recommended to continuously stir and check

while you are warming the baby food for an optimal result.

Note: If you overheat breast milk, valuable nutrients and

vitamins may be lost.

7 Always check the temperature before you feed your

baby:

-Milk: Gently shake the bottle or milk storage container

and check the temperature of the milk by sprinkling a few

drops on the inside of your wrist (Fig. 10).

ENGLISH10

-Baby food: Stir the baby food thoroughly and test it

yourself with a spoon to ensure it is not too hot. If the

baby food is not warm enough, put the container back

into the bottle warmer and warm the baby food until it has

the desired temperature (Fig. 11).

8 Turn the knob back to the ‘o’ position. The orange light

goes o (Fig. 7).

Caution: The water in the bottle warmer might be hot

after nishing warming milk / baby food. Be careful

that hot water can cause serious burns.

If you do not turn the knob back to the ‘o’ position,

the water keeps heating up and will reach a very high

temperature.

Caution: In case of selecting a position in the express

warming area which is not the beginning or the end,

please make sure to check the milk on a regular basis

for temperature during warming.

Express warming reference table

䀙߱

ؓ⑟

ᘡ䙕䀙߱

ؓ⑟

ᘡ䙕䀙߱

ؓ⑟

ᘡ䙕䀙߱

ؓ⑟

ᘡ䙕

Milk volume

Express warming

knob postion

Start temperature

5°C *1

Start temperature

20°C *2

60~<125ml 125~<180ml 180~<260ml 260~<330ml

4.5~5.5min3.5~5min5.5~7min7~7.5min

3min 3min 4min4.5~5min

1 For example the milk stored in the refrigerator.

2 For example the milk stored at room temperature.

ENGLISH 11

Note: The indicated warming times are based on Philips

Avent Classic and Natural PP bottle ranges. Be aware that

warming times of Philips Avent standard bottles and glass

bottles deviate from these indications. The characteristics of

bottles such as material or thickness may also impact the

warming times, therefore it may take less time to warm a

larger volume of milk.

Note: Due to the high variety of baby food consistencies, it

is not possible to indicate warming times for baby food.

Note: The warming indications in the table above are solely

applicable to the Express Warming setting of the product.

Note: The baby food or milk may feel cool to you, but for a

newborn baby its temperature is very pleasant.

Using the bottle warmer with keep warm setting

1 Put the mains plug in the wall socket (Fig. 3).

2 Place the bottle or container in the bottle warmer (Fig. 4).

3 Fill the bottle warmer with drinking water up to the level

of the milk in the bottle/container. In case of large

amounts of milk, the maximum level of water is

approximately 1 cm below the top of the bottle warmer

(Fig. 5).

4 Select the position of keep warm (Fig. 6).

At this setting, you can warm your milk at a slow pace and

keep it warm at the right end temperature. E.g. to warm a

bottle of 4oz milk starting from room temperature, it will take

15-20min. The warming time may be longer or shorter

depends on the milk volumes and starting temperature.

Note: Philips Avent recommends to feed your baby as soon

as possible after the milk is warmed. We advise not to

reheat the milk after it has cooled down again.

Note: Always check the temperature before you feed your

baby (Fig. 10).

5 Turn the knob back to the ‘o’ position when the bottle/

container is removed from the bottle warmer (Fig. 7).

ENGLISH12

Andere Handbücher für SCF355

Dieses Handbuch passt für folgende Modelle

Andere Philips Flaschenwärmer Handbücher

Philips

Philips AVENT SCF358 Bedienungsanleitung

Philips

Philips SBCSC250 Bedienungsanleitung

Philips

Philips SCF355 Bedienungsanleitung

Philips

Philips SCF255/52 Bedienungsanleitung

Philips

Philips AVENT SCF356/00 Bedienungsanleitung

Philips

Philips SBC SC215 Bedienungsanleitung

Philips

Philips SCF 215 Bedienungsanleitung

Philips

Philips AVENT scf356 Bedienungsanleitung

Philips

Philips SCF355 Bedienungsanleitung

Philips

Philips AVENT SCF355/07 Bedienungsanleitung

Philips

Philips SBCSC215/23 Bedienungsanleitung

Philips

Philips SCF355 Bedienungsanleitung

Philips

Philips SCF355 Bedienungsanleitung

Philips

Philips SBCSC205/34U Bedienungsanleitung

Philips

Philips SCF205/34 Bedienungsanleitung

Philips

Philips SCF355 Bedienungsanleitung

Philips

Philips SCF355 Bedienungsanleitung

Philips

Philips SCF355 Bedienungsanleitung

Philips

Philips AVENT scf356 Bedienungsanleitung

Philips

Philips SCF215/86 Bedienungsanleitung

Philips

Philips SCF355 Bedienungsanleitung

Philips

Philips AVENT scf356 Bedienungsanleitung

Philips

Philips SCF287 Bedienungsanleitung

Philips

Philips SCF355 Bedienungsanleitung

Beliebte Flaschenwärmer Handbücher anderer Marken

Topcom

Topcom KD-4302 Bedienungsanleitung

SEVERIN

SEVERIN BK-3177 Bedienungsanleitung

SEVERIN

SEVERIN BK 3176 Bedienungsanleitung

Chicco

Chicco 06867 MU Bedienungsanleitung

Reer

Reer Multimax 2 in 1 -travel Bedienungsanleitung

Lionelo

Lionelo Thermup Go Bedienungsanleitung

TEFAL

TEFAL Disney Baby TD1100K0 Bedienungsanleitung

TrueLife

TrueLife INVIO BW Single Bedienungsanleitung

Gourmia

Gourmia JBW-250 Bedienungsanleitung

König Electronic

König Electronic HC-BW10 Bedienungsanleitung

Gourmia

Gourmia JBW-150 Bedienungsanleitung

NUK

NUK MEDICPRO 10.256.467 Bedienungsanleitung

Petra

Petra DI 6.00 Bedienungsanleitung

Philips AVENT

Philips AVENT Electric Bottle and Baby Food Warmer Bedienungsanleitung

babymoov

babymoov Auto Speed Bib Bedienungsanleitung

Alecto

Alecto BW600 Bedienungsanleitung

Lionelo

Lionelo Thermup Bedienungsanleitung

Vinotemp

Vinotemp VT-Chiller Bedienungsanleitung