Philips FC9202 Bedienungsanleitung

FC9202

ENGLISH 6

FC9202

General description (fig. 1)

1. Filter cylinder

2. Filter cylinder case

3. Dust bucket release button

4. Dust bucket

5. Hose connection opening

6. On/off button

7. Suction power knob

8. Cover

9. Cleaning brush

10. Motor Protection Filter

11. Rear wheel

12. Cord rewind button

13. Hose connector

14. Hose connector release button

15. Small brush

16. Small nozzle

17. Crevice tool

18. Parking ridge

19.Tri-Active nozzle

20. Rocker switch for carpet/hard floor settings

21. Side brush

22. Hose with handgrip

23. Accessory holder

24.Telescopic tube

25. Super Clean Air HEPA Filter

26. Filter grille (open)

27. Mains plug

28. Parking slot

29. Swivel wheel

30.Type plate

Important

Read these instructions for use carefully before using the appliance and save them for future

reference.

◗Check if the voltage indicated on the appliance corresponds to the local mains voltage before

you connect the appliance.

◗Do not use the appliance if the plug, the cord or the appliance itself is damaged.

◗If the mains cord of this appliance is damaged, it must be replaced by Philips, a service centre

authorised by Philips or similarly qualified persons in order to avoid a hazard.

◗Keep the appliance out of the reach of children.

◗Never suck up water or any other liquid. Never suck up flammable substances and do not

suck up ashes until they are cold.

◗Do not point the hose at the eyes or ears nor put it in your mouth when the vacuum

cleaner is switched on and the hose is connected to the vacuum cleaner.

◗Sucking up large objects may cause the air passage in the tube or hose to become

obstructed. If this happens, the blockage indicator will turn red to indicate that there is an

obstruction that needs to be removed.

◗Never use the appliance without the Motor Protection Filter.This could damage the motor

and shorten the life of the appliance.

◗Only use the Philips filter cylinder supplied with the appliance.

ENGLISH6

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled

properly and according to the instructions in this user manual, the appliance is safe to use based on

scientific evidence available today.

Preparing for use

Connecting accessories

Hose

1To connect the hose, push it firmly into the appliance ('click') (fig. 2).

2To disconnect the hose, press the release button and pull the hose out of the appliance (fig. 3).

Telescopic tube

1Connect the tube to the handgrip of the hose by pressing the spring-loaded lock button on

the handgrip and inserting the handgrip into the tube. Fit the spring-loaded lock button into

the opening in the tube ('click') (fig. 4).

2To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the

handgrip out of the tube.

Use the same method to connect and disconnect the nozzles.

3Adjust the tube to the length you find most comfortable during vacuum cleaning (fig. 5).

Tri-Active nozzle

◗The Tri-Active nozzle is a multi-purpose nozzle for carpets and hard floors (fig. 6).

The side brushes catch more dust and dirt at the sides of the nozzle and allow you to clean better

along furniture and other obstacles.

◗The opening at the front of the nozzle allows you to suck up larger particles (fig. 7).

Hard floor setting:

1Push the rocker switch on top of the nozzle with your foot to make the brush strip come

out of the housing.At the same time the wheel will be lifted to prevent scratching and to

increase manoeuvrability (fig. 8).

Carpet setting:

2Push the rocker switch again to make the brush strip disappear into the nozzle housing.

The wheel will be lowered automatically (fig. 9).

Crevice tool, small nozzle and small brush.

1Connect the crevice tool, the small nozzle (specific types only) or the small brush directly to

the handgrip or to the tube (fig. 10).

Accessory holder

◗The accessory holder can simply be snapped onto the handgrip (fig. 11).

The accessories can be stored in the accessory holder by pushing them into the holder.To detach

the accessories, pull them out of the holder.

ENGLISH 7

You can store two accessories at a time in the accessory holder:

◗Crevice tool and small nozzle (specific types only) (fig. 12).

Please note the way in which the small nozzle must be placed in the accessory holder.

◗Crevice tool and small brush (fig. 13).

Using the appliance

1Pull the cord out of the appliance and put the mains plug in the wall socket.

2Switch the appliance on by pressing the on/off button on top of the appliance (fig. 14).

◗During vacuum cleaning you can adjust the suction power by means of the knob on top of

the appliance (fig. 15).

- Use maximum suction power for vacuum cleaning very dirty carpets and hard floors.

- Use minimum suction power for vacuum cleaning curtains, table carpets, etc.

◗If you want to pause for a moment, you can park the tube in a convenient position by

inserting the ridge on the nozzle into the parking slot (fig. 16).

Storage

1Switch the appliance off and remove the mains plug from the wall socket.

2Rewind the mains cord by pressing the cord rewind button (fig. 17).

3Attach the nozzle to the appliance by inserting the ridge on the nozzle into the slot. Store

the appliance in horizontal position, with all wheels touching the floor (fig. 16).

4Always put the Tri-Active nozzle in the carpet setting when you store it and prevent the side

brushes from becoming bent (fig. 9).

Emptying the dust bucket

Always unplug the appliance before emptying the dust bucket.

The dust bucket is not dishwasher-proof.

◗Empty the dust bucket as soon as the dust level has reached the round disc of the filter

cylinder case (fig. 18).

1Switch the appliance off and disconnect the hose from the appliance.

2Unlock the cover by pressing the release button on top of the handle of the dust bucket (1).

Swing the cover open (2) (fig. 19).

3Remove the bucket by lifting it out of the appliance (fig. 20).

4Hold the bucket over a dustbin and lift the filter cylinder case out of the bucket. Empty the

bucket (fig. 21).

5If you wish, you can clean the dust bucket with cold tap water and some washing-up liquid.

6Put the filter cylinder case back into the dust bucket and put the bucket back into the

appliance.

7Close the cover firmly ('click').

Always put the filter cylinder case back into the bucket, otherwise the appliance cannot be

switched on.

ENGLISH8

Cleaning and maintenance of filters

Always unplug the appliance before cleaning or replacing the filters.

The filter cylinder and the filter cylinder case are not dishwasher-proof.

Filter cylinder

Clean the filter cylinder every 2 months.

1Switch the appliance off and disconnect the hose from the appliance.

2Unlock the cover by pressing the release button on top of the handle of the dust bucket (1).

Swing the cover open (2) (fig. 19).

3Remove the bucket by lifting it out of the appliance (fig. 20).

4Lift the filter cylinder case out of the bucket (fig. 21).

5Turn the handle on top of the filter cylinder case anticlockwise (1) and lift the filter cylinder

out of the case (2) (fig. 22).

6Clean the filter cylinder and the case with the brush supplied. Brush from the top of the filter

downwards along the ribs of the filter (fig. 23).

Only use the brush supplied! Other brushes may damage the filter cylinder.

7If there is dirt on the inside of the case, empty the case over a dustbin.

8If you wish, you can clean the filter cylinder case with cold tap water and some washing-up

liquid.

9If you wish to wash the filter cylinder, wash it thoroughly with only water. Do not use any

soap, washing-up liquid or other detergent to clean the filter. Let it dry completely before

reinserting it into the case (fig. 24).

10 Put the filter cylinder back into the case and turn the handle clockwise until the filter

cylinder locks into position.

Make sure the filter cylinder is securely fixed in the case.

11 Put the case with the filter cylinder back into the dust bucket.

Motor Protection Filter

Clean the Permanent Motor Protection Filter every time you clean the filter cylinder case.

1Take the Motor Protection Filter out the appliance and clean the filter by tapping the dust

out of it over a dustbin (fig. 25).

2Press the clean filter firmly back into the filter compartment to ensure that it is properly

placed.

◗If the Motor Protection Filter is very dirty, you can also rinse it with cold tap water.

Do not use any soap, cleaning agent or other detergent to clean the filter!

Super Clean Air HEPA Filter

This appliance is equipped with the Super Clean Air HEPA Filter.This filter is located in the back off

the appliance and is able to remove 99.5% off all particles down to 0.0003 mm in size from the

outlet air.This is not only includes normal house dust, but also harmful microscopic vermin such as

dust mites and their excrements, which are will-known causes of respiratory allergies.

ENGLISH 9

Replace the HEPA Filter every six months.

1Open the filter grille (fig. 26).

2Remove the old filter (fig. 27).

3Insert the new filter into the appliance.

4Close the filter grille and push the bottom corners until they snap home (fig. 28).

Ordering accessories and filters

If you have any difficulties obtaining filters or other accessories for this appliance, please contact the

Philips Customer Care Centre in your country or consult the worldwide guarantee leaflet.

- Philips filter cylinders are available under service number 4322 005 17520.

- Super Clean Air filters are available under type number FC8030.

- Super Clean Air HEPA Filters are available under type number FC8031.

Guarantee & service

If you need information or if you have a problem, please visit the Philips website at www.philips.com

or contact the Philips Customer Care Centre in your country (you will find its phone number in the

worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your

local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal

Care BV.

Troubleshooting

1The suction power is insufficient.

◗Check if the suction power knob is in maximum position.

◗Check if the filter cylinder is filled with dirt. If necessary, clean this filter.

◗Check if the other filters need to be cleaned or replaced.

◗Check if the blockage indicator has changed colour. If so, the nozzle, tube or hose may be

blocked up.To remove the obstruction, disconnect the blocked-up item and connect it (as far

as possible) the other way around. Switch the vacuum cleaner on to force the air through the

blocked-up item in opposite direction (fig. 29).

2The appliance cannot be switched on.

◗Check if the filter cylinder case with the filter cylinder in it has been inserted into the dust

bucket.

ENGLISH10

Andere Handbücher für FC9202

Inhaltsverzeichnis

Andere Philips Staubsauger Handbücher

Philips

Philips FC8740 Bedienungsanleitung

Philips

Philips Vision Bedienungsanleitung

Philips

Philips Marathon FC9239 Bedienungsanleitung

Philips

Philips StudioPower FC9080 SERIES Handbuch

Philips

Philips FC8715 Bedienungsanleitung

Philips

Philips FC9130/01 Bedienungsanleitung

Philips

Philips Vision HR8837/02 Bedienungsanleitung

Philips

Philips FC6149 Bedienungsanleitung

Philips

Philips FC9184/01 Bedienungsanleitung

Philips

Philips FC7070/01 Bedienungsanleitung

Philips

Philips HR8378/07 Bedienungsanleitung

Philips

Philips FC7088 Betriebsanleitung

Philips

Philips FC8479 Handbuch

Philips

Philips FC8138 Bedienungsanleitung

Philips

Philips HR8378/07 Bedienungsanleitung

Philips

Philips SmallStar FC8234/01 Bedienungsanleitung

Philips

Philips HomeRun 3000 Series Bedienungsanleitung

Philips

Philips FC 9102/A Bedienungsanleitung

Philips

Philips FC8230/51 Bedienungsanleitung

Philips

Philips FC6161 Bedienungsanleitung

Philips

Philips FC9205/01 Bedienungsanleitung

Philips

Philips FC9202 Bedienungsanleitung

Philips

Philips Vision HR 8910 Bedienungsanleitung

Philips

Philips PerformerPro FC9190 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung