Prem-I-Air Elite EH1331 Bedienungsanleitung

EH1331

2 kW Convector Heater with Turbo Fan

Radiateur Convecteur 2 kW avec

Ventilateur Turbo

•Adjustable thermostat

•24 hour timer

•Wall mounting

or free-standing

•Silent operation

•Turbo fan

•Safety overload cut-out

•2 year guarantee

•Thermostat réglable

•Programmateur 24 heures

•Installation murale ou

au sol avec pieds fournis

•Fonctionnement silencieux

•Ventilateur Turbo

•Coupure de Sécurité

en cas de Surchauffe

•Garantie 2 ans

Page 1

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the user of the

product for future reference.

BEFORE USE

You must inspect the appliance including its cable and plug for any signs

of damage. If the product is damaged, DO NOT use it, and contact your

supplier immediately. INSTALLATION

For free-standing use: Attach the feet to the underneath of the heater

using the four 12mm (½") screws.

To wall-mount: Referring to the diagram opposite, draw two horizontal

lines on the wall 255 mm (10") apart, the lower line more than 50 mm (2")

from the floor.

•On the upper line, drill holes 550 mm (21½") from the centre line, using

a 6 mm (¼") masonry bit, and insert a wall plug.

•On the lower line, drill holes 521 mm (20½") from the centre line using a

6 mm (¼") masonry bit, and insert a wall-plug.

•Fix the two hook-brackets to the upper holes using the 30 mm (1¼")

screws.

•Fix the two L-shaped brackets to the underside of the heater between

the first and second sets of slots, using the 12 mm (½") screws

•Hang the heater on the hook-brackets using the two 25 mm (1") slots.

•The L-shaped brackets will now line up with the lower holes in the wall.

Attach to the wall using the other two 30 mm (1¼") screws.

Page 2

DRILLING DIMENSIONS FOR WALL MOUNTING

155mm155mm

217mm217mm

330mm

Page 3

PRODUCT SAFETY

•This appliance can be used by children aged from 8 years and

above and persons with reduced physical, sensory or mental

capabilities or lack of experience and knowledge if they have been given

supervision or instruction concerning use of the appliance in a safe way

and understand the hazards involved.

•Children shall not play with the appliance.

•Cleaning and user maintenance shall not be made by children without

supervision.

•Place the EH1331 on a firm flat surface.Ensure that the air inlets (at the

bottom) and the air outlets (at the top) are not obstructed.

•Ensure that curtains are at least 900mm (3') from the top of the heater

•Leave a gap of at least 50mm (2") at the sides of the heater.

•If used free-standing, do not operate unless the plastic feet correctly

attached.

•Do not place on soft surfaces.

•Do not cover. This symbol shown on the casing of the heater

means that the heater should not be covered.

•For indoor use only.

•Do not use in bathrooms, or in wet or damp locations.

•Do not use in the immediate surroundings of a bath, a shower or a

swimming pool.

•Do not place the mains lead beneath a carpet or rug.

•Do not use the heater in locations where paint, petrol or other flammable

liquids are used or stored.

•Do not locate the appliance immediately below a socket outlet

•Do no insert any object into the heater through the grilles. This may

damage the heater or result in overheating or electric shock.

PAT TESTING

When used in a workplace, this product must be safety-tested yearly by a

qualified electrician (PAT Tested) in order to comply with the Electricity at

Work Regulations.

We recommend that it is PAT tested regularly when used in a domestic

environment.

Page 4

GENERAL SAFETY REQUIREMENTS

Domestic wiring must be tested periodically by a qualified electrician at

least once every 10 years or at every change of occupancy.

For office and retail premises, and buildings such as village halls, the

wiring must be inspected at least once every 5 years.

It is recommended that all buildings be fitted with smoke alarms (it is

mandatory for new buildings)

OPERATION

Plug the mains lead into a 13 Amp mains socket.

If connecting via an extension lead, make sure that the lead is rated at 13

Amps, and that it is fully unwound.

Move the 3-position switch on the timer to the "I" position.

Use the two power control switches on the side to select the required

operation:

•Both switches off = OFF

•Left switch ON = Low Heat (750 W)

•Right switch ON = Medium heat (1250 W)

•Both switches ON = High Heat (2000 W)

Do not touch the air output grille when the heater is in operation, because

it will be hot and may cause burns.

Switch on the turbo fan to accelerate heat convection to warm a cold

room more quickly.

Unplug the heater from the mains when not in use.

USING THE THERMOSTAT

The thermostat can be use to regulate the room temperature.

Turn the heater on, and rotate the temperature control fully clockwise.

The heater will then operate at maximum output. When the desired

temperature is reached, rotate the temperature control anticlockwise until

a click is heard. The heater will then switch on and off to keep the room at

the desired temperature.

If the temperature control is rotated fully anticlockwise, it will operate as a

"frost-stat" and switch the heater on if the temperature drops below 4°C,

preventing damage by frost.

Page 5

USING THE TIMER

When the timer switch is in this

position, the heater will be

permanently OFF. Use this position in

the summer when a permanently installed

heater is not required.

When the timer switch is in this

position, the heater will be

controlled by the timer.

When the timer switch is in this

position, the heater will

permanently ON.

The numbers around the timer dial show the time in 24-hour clock.The

timer is controlled by the plastic segments - each segment represents 15

minutes. Move the segment outwards if the heater should be ON for that

time period, or inwards towards the centre of the dial if it should be OFF.

Rotate the dial clockwise until the arrowhead at the right of the dial points

to the current time.

To use the heater in timed mode, it should be permanently connected to

the mains supply. If the power is disconnected, the clock will stop.

OPERATING COSTS

At time of going to press, the average cost of electricity is £0.12 per unit

(kilowatt-hour). The amount you are being charged will be shown on your

electricity bill.

At this cost, the EH1331 will cost £0.24 per hour to run with the

thermostat set to its maximum.

If the thermostat is used to regulate the temperature the operating costs

will be lower, depending on the room temperature.

Page 6

MAINTENANCE

Before cleaning, turn the heater off, and disconnect from the mains

supply. The heater may then be cleaned using a damp cloth with a drop

of washing-up liquid to remove any dust or dirt from the case. Do no use

stronger detergents or solvents as these may damage the plastic.

Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.

If the mains lead is damaged, it must be replaced by the manufacturer or

and authorised service centre.

If the mains plug needs to be replaced, proceed as follows:

•Connect the brown wire to the

terminal labelled "L".

•Connect the blue wire to the terminal

labelled "N".

•Connect the green/yellow wire to the

terminal labelled with the earth symbol

or "E".

•Make sure that the cord-grip is

positioned correctly (over the outer

sheath of the cable) and it fully

tightened.

FAULT-FINDING

The EH1331 has an overheat protection switch, which disconnects the

power if the element gets too hot. The usual reason for this is because

the air-flow has been obstructed, or the grilles have been blocked. If the

heater ceases to operate, leave it for 20 minutes to cool down, then

check that the grilles are not being obstructed.

Switch back on, and check that the unit is operating normally. If not,

contact an authorised service agent for repair.

DISPOSAL AND RECYCLING

You must not dispose of this appliance with domestic household waste.

Most local authorities have specific collection system for appliances and

disposal is free of charge to the end-user.

When replacing an existing appliance with a similar new appliance your

retailer may take the old appliance for disposal.

Page 7

TECHNICAL SPECIFICATION

Dimensions (wall mounting): 600×325×50 mm

Dimensions (floor standing): 600×350×150 mm

Weight: 3.5 kg

Power supply: 230 V AC

Power consumption: 2000 W

Operating current: 8.7 A

SERVICE WARRANTY

Prem-i-Air guarantees the product free from defects in materials

and workmanship for a period of two years.

Should this unit be operated under conditions other than those

recommended, at voltages other than the voltage indicated on the

unit, or any attempts made to service or modify the unit, then the

warranty will be rendered void.

The product you buy may sometimes differ slightly from

illustrations. This warranty is in addition to, and does not affect,

your statutory rights.

If you have any problems with this product, please call our Help

Desk on (0845) 459 4816.

Prem-i-Air Appliances Ltd.,

Lancots Lane,

Sutton,

St. Helens,

Merseyside.

WA9 3EX

website: www.prem-i-air.com

Page 8

Inhaltsverzeichnis

Andere Prem-I-Air Heizung Handbücher

Prem-I-Air

Prem-I-Air EH1668 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1712 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0154 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1840 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1558 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1892 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1436 Bedienungsanleitung

Prem-I-Air

Prem-I-Air PFH550 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0287 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1434 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1526 Bedienungsanleitung

Prem-I-Air

Prem-I-Air PFH0130R Bedienungsanleitung

Prem-I-Air

Prem-I-Air PECCB3200 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0209 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1674 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0153 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1266 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0286 Bedienungsanleitung

Prem-I-Air

Prem-I-Air HQH2000H Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0291 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1794 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1372 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung

iLO

iLO IHP2424 Betriebsanleitung