Prem-I-Air EH1266 Bedienungsanleitung

EH1266

1.5kW Convector Heater

2 Heat settings

Adjustable thermostat

Free-standing or wall mounting

Convenient built-in carrying handle

Safety overload cut-out

2 year guarantee

Page 1

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the

user of the product for future reference.

INSTALLATION

For free-standing use: attach the feet to the underneath of

the heater using the four 12mm (½") screws.

To wall-mount: Firstly, remove the lower brackets from the

back of the heater, turn them upside down and replace them,

so that the tags protrude below the heater.

Referring to the diagram opposite, draw two horizontal lines

on the wall 308mm (12¼") apart, the lower line more than

50mm (2") from the floor.

On the upper line, drill holes 250mm (9¾") from the centre

line, using a 6mm (¼") masonry bit, and insert a wall plug.

Insert a screw into the hole and almost fully tighten.

On the upper line, drill holes 233mm (9¼") from the centre

line, using a 6mm (¼") masonry bit, and insert a wall plug.

Hang the heater on the two top brackets using the keyhole

slots on the back.

The lower brackets should now line up with the lower holes.

Insert a screw into the each of the holes through the

brackets, and fully tighten.

Page 2

DRILLING DIMENSIONS FOR WALL MOUNTING

250mm250mm

233mm233mm

308mm

Page 3

PRODUCT SAFETY

•

This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

•

Children should be supervised to ensure that they do not

play with the appliance

•

Place the EH1266 on a firm flat surface. Ensure that the air

inlets (at the bottom) and the air outlets (at the top) are not

obstructed.

•

Ensure that curtains are at least 900mm (3') from the top of

the heater.

•

Leave a gap of at least 50mm (2") at the sides of the

heater.

•

If used free-standing, do not operate unless the feet are

correctly attached.

•

Do not place on soft surfaces.

•

Do not cover. This symbol shown on the casing of

the heater means that the heater should not be

covered.

•

Do not use outdoors.

•

Do not locate the heater immediately below a socket outlet.

•

Do not use in bathrooms, or in wet or damp locations.

•

Do not place the mains lead beneath a carpet or rug.

•

Do not use the heater in locations where paint, petrol or

other flammable liquids are used or stored.

•

Do no insert any object into the heater through the grilles.

This may damage the heater or result in overheating or

electric shock.

Page 4

OPERATION

Plug the mains lead into a 13 Amp mains socket.

If connecting via an extension lead, make sure that the lead

is rated at 10 Amps or more, and that it is fully unwound.

Switch the unit on at the mains socket.

Use the two switches on the side to select the required

operation:

•

One switch on = Low Heat (750W)

•

Both switches on = High Heat (1500W)

Do not touch the air output grille when the heater is in

operation, because it will be hot and may cause burns.

Unplug the heater from the mains when not in use.

USING THE THERMOSTAT

The thermostat can be use to regulate the room temperature.

Turn both switches on (high heat), and rotate the

temperature control fully clockwise.

The heater will then operate at maximum output. When the

desired temperature is reached, rotate the temperature

control anticlockwise until a click is heard. The heater will

then switch on and off to keep the room at the desired

temperature. The indicator light will show that this is

happening.

Either the "low heat" or the "high heat" setting may be used.

If the temperature control is rotated fully anticlockwise, it will

operate as a "frost-stat" and switch the heater on if the

temperature drops below 4°C, preventing damage by frost.

Page 5

OPERATING COSTS

At time of going to press, the average cost of electricity is

£0.11 per unit (kilowatt-hour). The amount you are being

charged will be shown on your electricity bill.

At this cost, the EH1266 will cost £0.08 per hour to run on the

"low heat " setting, and £0.16 per hour to run on the "high

heat" setting with the thermostat set to its maximum.

If the thermostat is used to regulate the temperature the

operating costs will be lower, depending on the room

temperature.

MAINTENANCE

Before cleaning, turn the heater off, and disconnect from the

mains supply. The heater may then be cleaned using a damp

cloth with a drop of washing-up liquid to remove any dust or

dirt from the case. Do no use stronger detergents or solvents

as these may damage the paint finish.

Using a dry 1" (25mm) paint-brush, remove any dust from the

grilles.

If the mains lead is damaged, it must be replaced by the

manufacturer or and authorised service centre. If the mains

plug needs to be replaced, proceed as follows:

•

Connect the brown wire to the

terminal labelled "L".

•

Connect the blue wire to the

terminal labelled "N".

•

Connect the green/yellow wire

to the terminal labelled with the

earth symbol or "E".

•

Make sure that the cord-grip is

positioned correctly (over the

outer sheath of the cable) and it

fully tightened.

Page 6

FAULT-FINDING

The EH1266 has an overheat protection switch, which

disconnects the power if the element gets too hot. The usual

reason for this is because the air-flow has been obstructed,

or the grilles have been blocked. If the heater ceases to

operate, leave it for 20 minutes to cool down, then check that

the grilles are not being obstructed.

Switch back on, and check that the unit is operating normally.

If not, contact an authorised service agent for repair.

DISPOSAL AND RECYCLING

You must not dispose of this appliance with domestic

household waste.

Most local authorities have specific collection system for

appliances and disposal is free of charge to the end-user.

When replacing an existing appliance with a similar new

appliance your retailer may take the old appliance for

disposal.

TECHNICAL SPECIFICATION

Dimensions (wall mounting): 900×455×80mm

Dimensions (floor standing): 900×525×260mm

Weight: 9·4kg

Power supply: 230V AC

Power consumption: 1500W

Operating current: 6.5A

Page 7

SERVICE WARRANTY

Prem-i-Air guarantees the product free from defects in

materials and workmanship for a period of twelve months.

This Elite product is guaranteed for a further twelve months

subject to the enclosed registration card being completed

and returned to the address printed on it, or the registration

form being completed on-line at www.prem-i-air.com

Should this unit be operated under conditions other than

those recommended, at voltages other than the voltage

indicated on the unit, or any attempts made to service or

modify the unit, then the warranty will be rendered void.

The product you buy may sometimes differ slightly from

illustrations. This warranty is in addition to, and does not

affect, your statutory rights.

If you have any problems with this product, please call our

Help Desk on (0845) 459 4816.

Prem-i-Air Appliances Ltd.,

Lancots Lane,

Sutton Oak,

St. Helens,

Merseyside.

WA9 3EX

website: www.prem-i-air.com

Page 8

Inhaltsverzeichnis

Andere Prem-I-Air Heizung Handbücher

Prem-I-Air

Prem-I-Air EH1668 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1644 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1524 Handbuch

Prem-I-Air

Prem-I-Air EH1426 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1890 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1892 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1530 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1566 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0152 Bedienungsanleitung

Prem-I-Air

Prem-I-Air HT2007 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1526 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1550 Bedienungsanleitung

Prem-I-Air

Prem-I-Air HQH2000H Bedienungsanleitung

Prem-I-Air

Prem-I-Air PECCB3200 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1712 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1369 Benutzerhandbuch

Prem-I-Air

Prem-I-Air EH1840 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1404 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1558 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1442 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1422 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air C307 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung

iLO

iLO IHP2424 Betriebsanleitung