Premier Mounts Nesting Cart Series Bedienungsanleitung

PSD-VPS

Page - 1 - Installation Instructions

9532-005-111-01

PSD-VPS

NOTE: Please refer to the PSD-BW Base and RTM-L Installation Instructions for complete assembly

instructions.

1. Attach the support tubes to the PSD-BW base and tighten

the set screws with the supplied Allen wrench. 2. Attach the RTM-L mount to the support tubes and tighten the set

screws with the supplied Allen wrench.

Landscape Orientation Portrait Orientation

INSTALLATION MANUAL

PSD-BW/PSD-BWL

Nesting Cart Series

NORTH AMERICA EUROPE AUSTRALIA,NEW ZEALAND,

OCEANIA (Distributor)

3130 East Miraloma Avenue

Anaheim, CA 92806 USA

USA and Canada –

Phone: 800-368-9700

Fax: 800-832-4888

Swallow House,

Shilton Industrial Estate,

Shilton, Coventry, England CV79JY

Phone: +44 (0) 2476 614700

Fax: +44 (0) 2476 614710

P.O. Box 295

Mordialloc Victoria 3195

Australia

Phone: 03 9586 6330

www.premiermounts.com.au

Other Locations – Phone: 001.714.632.7100; Fax: 001.714.632.1044

©Premier Mounts 2008

9532-003-011-01

PSD-BW/L

Installation Instructions Page - 2 -

Table of Contents

WARRANTY ....................................................................................................................................................- 2 -

CONTACT PREMIER MOUNTS ....................................................................................................................- 2 -

WARNING STATEMENTS .............................................................................................................................- 3 -

PARTS LIST ......................................................................................................................................................- 4 -

INSTALLATION TOOLS ................................................................................................................................- 4 -

BW BASE CASTOR INSTALLATION (FIGURE 1) ......................................................................................- 5 -

SUPPORT TUBE INSTALLATION (FIGURE 2) ...........................................................................................- 5 -

PSD-SPA INSTALLATION (FIGURE 3) ........................................................................................................- 6 -

PSD-BW/L NESTING CART STORAGE (FIGURE 4) ..................................................................................- 6 -

OPTIONAL MOUNTING CONFIGURATIONS .............................................................................................- 7 -

TECHNICAL SPECIFICATIONS ....................................................................................................................- 8 -

NOTES ...............................................................................................................................................................- 8 -

Warranty

Limited Lifetime Warranty

All Premier Mounts products carry a limited lifetime warranty from ship date against defects in materials and workmanship. Premier

Mounts is not liable for improper installation that results in damage to mounts, adapters, display equipment or

personal injury.

Contact Premier Mounts

In the event of missing and/or damage equipment, or technical questions, the following information can help in the completion of the

installation.

Customer Service – (800) 368-9700

Technical Support – techsupport@mounts.com

PSD-BW/L

Page - 3 - Installation Instructions

Warning Statements

PREMIER MOUNTS DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY

PREMIER MOUNTS PRODUCT FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED

OR DAMAGE CAUSED BY UNAUTHORIZED ATTACHMENTS OR MODIFICATIONS, AND IS NOT

RESPONSIBLE FOR ANY DAMAGES, CLAIMS, DEMANDS, SUITS, ACTIONS OR CAUSES OF ACTION

OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR IN ANY MANNER RELATING TO

ANY SUCH USE, ATTACHMENTS OR MODIFICATIONS.

THE FLOOR STRUCTURE MUST BE CAPABLE OF SUPPORTING AT LEAST 250 LBS. IF NOT, THE

FLOOR STRUCTURE MUST BE REINFORCED. PROPER INSTALLATION PROCEDURE BY A

QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE INSTALLATION INSTRUCTIONS, MUST

BE ADHERED TO. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY, OR EVEN

DEATH.

SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE ASSEMBLY OF THIS

PRODUCT. USE PROPER SAFETY GEAR AND TOOLS FOR THE ASSEMBLY PROCEDURE TO

PREVENT PERSONAL INJURY.

PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE ASSEMBLY INSTRUCTIONS SHOULD BE

READ AND COMPLETELY UNDERSTOOD. THE ASSEMBLY INSTRUCTIONS MUST BE READ TO

PREVENT PERSONAL INJURY AND PROPERTY DAMAGE. KEEP THESE ASSEMBLY INSTRUCTIONS

IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE REFERENCE.

Indicates that the power plug is to be

disconnected from the power outlet.

Contact Premier Mounts with any questions.

Safety precautions must be taken at all times.

Warning and Caution statements.

Do not install on a structure that is prone to vibration, movement or chance of impact. Failure to do so could result in

damage to the plasma display and/or damage to the mounting surface.

Do not install near heater, fireplace, direct sunlight, air conditioning or any other source of direct heat energy. Failure to

do so may result in damage to the display and could increase the risk of fire.

At least two qualified people should perform the assembly procedure. Injury and/or damage can result from dropping or

mishandling the display.

DO NOT ATTACH EQUIPMENT WEIGHING MORE THAN 75LBS. ABOVE THE 60” MARKED LINE ON

THE SUPPORT POLES. DOING SO MAY CAUSE THE NESTING CART TO TIP OVER, RESULTING IN

SEVERE PROPERTY DAMAGE AND/OR PERSONAL INJURY.

PSD-BW/L

Installation Instructions Page - 4 -

Parts List

Congratulations on purchasing the PSD-BW/PSD-BWL Nesting Cart. The PSD-BW/PSD-BWL Nesting Cart is shipped with all

proper installation hardware and components. Please verify that none of these parts are missing and/or damaged before assembly. If

there are parts missing and/or damaged, please stop the assembly and contact Premier Mounts (800) 368-7000.

Some mounting configurations will allow for a “landscape” orientation. In these situations, when moving the PSD-

BW/L Nesting Cart through a doorway, the orientation of the display must be returned to the “portrait” orientation. If

not, maneuvering through the doorway could prove costly by damaging the display.

BW Base (Qty 1)

PSD-SPA (Qty 1)

3” Castors (Qty 4)

(2 locking,

2 non-locking)

M8 x 10mm Set

Screws (Qty 6)

Support Tubes

(Qty 2)

NOTE: Length will

vary depending on

model purchased.

M10 Flat Washers

(Qty 4)

M10 x 12mm Hex

Head Screws

(Qty 4)

21mm Caster Wrench

(Qty 1)

Installation Tools

Socket head wrench Soft Material/ Blanket

M5 Allen Wrench (Supplied) 5/32” Allen Wrench (Supplied)

PSD-BW/L

Page - 5 - Installation Instructions

BW Base Castor Installation (Figure 1)

Unpack the PSD-BW/L Nesting Cart and review any WARNING statements that apply to the installation. Select the desired location

for the PSD-BW/L Nesting Cart.

Figure 1

1. Place the BW/L on a flat surface.

Make sure the locking castors (Qty 2) are attached to the rear legs of the Nesting Cart.

2. Insert each castor into the threaded mounting point located on the underside of the BW/L base (Figure 1). Turn each castor

clockwise to tighten. Make sure all four castors are tightened all the way until flush with the base. Tighten using the 21mm caster

wrench (supplied).

Support Tube Installation (Figure 2)

1. Place the BW/L on a flat surface.

2. Take the support tubes and slide them over the mounting clamps that are located on the Nesting Cart.

To perform the following step, the access holes that are located at the end of the support tubes must line up with the

set screw holes on the mounting clamps. The upper access holes will be used for cable management once the display

has been mounted to the support tubes.

3. Insert the set screws into each hole and tighten using the supplied M5 Allen Wrench (Figure 2).

Figure 2

Locking Castor

Non-Locking Castor

Support Tubes

PSD-BW/L Base

M5 Allen Wrench

M10 x 35mm Set

Screw

Access Holes

Mounting Clamps

PSD-BW/L

Installation Instructions Page - 6 -

PSD-SPA Installation (Figure 3)

Use of the PSD-SPA will depend on the mount that is used. All PSM/CTM Series mounts require using the PSD-SPA.

The Revolution Series, USA and UFA Mounts, however, do not require the use of the PSD-SPA.

1. Slide the PSD-SPA over and down the support tubes.

2. Once the desired height has been determined, tighten the four (4) M8 x 10mm set screws, using the 5/32” Allen wrench (supplied)

to secure the PSD-SPA (Figure 3).

Figure 3

PSD-BW/L Nesting Cart Storage (Figure 4)

The PSD-BW/L is designed to maximize storage space. When storing multiple carts, slide the Nesting Carts together as close as

possible.

Please adhere to any WARNING statements that will apply to the different mounting configurations the PSD-BW/L

Nesting Cart will be used with.

Figure 4

5/32” Allen Wrench

Support Tubes

PSD-SPA

PSD-BW/L

Page 7 Installation Instructions

Optional Mounting Configurations

CTM-Series Revolution Series

USA/UFA Series

PSD-BW/L

Installation Instructions Page 8

Technical Specifications

All measurements are in inches (mm).

Notes

PSD-BW PSD-BWL

INSTALLATION INSTRUCTIONS

Rotary Tilt Mount

Model: RTM-L

NORTH AMERICA

3130 East Miraloma Avenue

Anaheim, CA 92806 USA

USA and Canada –

Phone: 800-368-9700

Fax: 800-832-4888

EUROPE

Swallow House,

Shilton Industrial Estate,

Shilton, Coventry, England CV79JY

Phone: +44 (0) 2476 614700

Fax: +44 (0) 2476 614710

AUSTRALIA, NEW ZEALAND, OCEANIA

(DISTRIBUTOR)

P.O. Box 295

Mordialloc Victoria 3195

Australia

Phone: 039586 6330

www.premiermounts.com.au

Other Locations – Phone: (001)-714-632-7100; Fax: (001)-714-632-1044

©Premier Mounts 2008

9531-009-011-03

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Premier Mounts Rack & Stand Handbücher

Premier Mounts

Premier Mounts Swingout Arm AM3 Bedienungsanleitung

Premier Mounts

Premier Mounts PP-5 Bedienungsanleitung

Premier Mounts

Premier Mounts AST-1321 Bedienungsanleitung

Premier Mounts

Premier Mounts Universal Projector Mount PBL-UMS Bedienungsanleitung

Premier Mounts

Premier Mounts UNI Bedienungsanleitung

Premier Mounts

Premier Mounts AM80 Bedienungsanleitung

Premier Mounts

Premier Mounts Convergent Series Bedienungsanleitung

Premier Mounts

Premier Mounts AM175 Bedienungsanleitung

Premier Mounts

Premier Mounts AM500 Bedienungsanleitung

Premier Mounts

Premier Mounts PSPK Bedienungsanleitung

Premier Mounts

Premier Mounts Universal Flat-Only Mount UFM Bedienungsanleitung

Premier Mounts

Premier Mounts UMB-DBTS Bedienungsanleitung

Premier Mounts

Premier Mounts AST-2446-2 Bedienungsanleitung

Premier Mounts

Premier Mounts AM100 Bedienungsanleitung

Premier Mounts

Premier Mounts MVW463 Bedienungsanleitung

Premier Mounts

Premier Mounts PSM-442T Bedienungsanleitung

Premier Mounts

Premier Mounts FLIP Bedienungsanleitung

Premier Mounts

Premier Mounts SHLF-EQ Bedienungsanleitung

Premier Mounts

Premier Mounts AM3 Bedienungsanleitung

Premier Mounts

Premier Mounts LMVSP Bedienungsanleitung

Premier Mounts

Premier Mounts Convergent UNI-UPS-A CLD Bedienungsanleitung

Premier Mounts

Premier Mounts RFM Bedienungsanleitung

Premier Mounts

Premier Mounts MVWC-2X2 Bedienungsanleitung

Premier Mounts

Premier Mounts PTM-B Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung