Prestan PP-AEDT-101 Kurzanleitung

USE AND CARE INSTRUCTIONS

Models PP-AEDT-101 —> Prestan Professional AED Trainer with

English/Spanish Module, 4 'C' batteries (pre-installed), one set of adult

training pads, one set of extra connector pins, an Instruction Sheet, a demo

CD and a nylon carrying case (pictured at right).

Models PP-AEDT-401 —> Prestan Professional AED Trainer 4-Pack with

English/Spanish Modules, 16 'C' batteries (pre-installed), four sets of adult

training pads, four sets of extra connector pins, an Instruction Sheet, a

demo CD and a nylon carrying case.

START HERE

Use this instruction sheet as your first source for information about the Prestan Professional AED

Trainer and Accessories.

Warning: The Prestan Professional AED Trainer is intended for the expressed purpose and use of

CPR/AED Instructors. It is NOT an Automated External Defibrillator (AED) and will not deliver a

shock. To avoid confusion, it should NEVER be kept in the same area with AEDs.

If you have any problems with the care and use of the Prestan Professional AED Trainer, refer to

the troubleshooting section of this document or the help guides on www.prestanproducts.com.

THANK YOU for buying the Prestan Professional AED Trainer!

If you have any questions about the Prestan Professional AED Trainer, or if you would like to order

additional AED Trainers, manikins or accessories, please contact your Prestan Authorized Distributor.

For information on Prestan’s Authorized Distributors, help guides, resources and more, please visit the

Prestan website at www.prestanproducts.com.

FEATURES OF THE PRESTAN

PROFESSIONAL AED TRAINER

Clear & Calm Voice Prompts

Automatic Pads-On-Manikin Detection

Remote Control NOT Required

Plugging in connector NOT Required

Works on any Manikin

Five Training Scenarios

Chest Compression Rate Metronome

Recording of the clicker in a Prestan

Professional Adult Manikin!

Audio Clicker with Count Reminder at 10, 20

and 30 compressions

Automatic OR Semi-Automatic Shock-Delivery

Flip Up Lid

Sturdy, durable polycarbonate lid & hinge

DOES NOT TURN AED TRAINER ON!

Bright Illuminated Shock Button

Flashes when shock is advised

On/Off Button with Lighted Indicator

Protective & Reusable Pad Case

High Performance Training Pads

Clear Anatomical Placement Graphics

Long-Life Adhesive

Adheres well to all Manikins

Unique Pad Connector

With Locking Connector Pin

Simple Control Panel

Language Button

Selections Indicator Lights Button

Scenario Button

Volume Button

Pause / Play Button

Long Battery Life

Low Battery Voice Prompt Warning

Automatic Shut Off Extends Battery Life

Water & Splash Resistant

____________________________________________________

ADULT TRAINING PADS

Pads cord is pre-connected to the AED Trainer

Pads Sensing System automatically lets the unit know

when the pads have been connected to a manikin

Lasts at least 50-60 applications

Unique pad replacement (see assembly section)

Pads are kept in a unique white plastic Pad Case

LANGUAGE MODULE

Contains two languages (English & Spanish)

Programming is compatible with current AHA Guidelines (2015)

Language &

Program Module

Battery Compartment

Speaker

FEATURE GUIDE

[FRONT OF UNIT]

PROFESSIONAL AED TRAINER

[BACK OF UNIT]

Blue Flip Top

Lid

Shock Button

Training Pad Case

Control Panel

Language Button

Selection Indicator Lights

Scenario Selection Button

Volume Button

Pause Button

On/Off Button

On/Off Indicator Light

ASSEMBLY, SETUP AND USE

1. Remove the contents of the plastic package containing the instruction sheet, module, package of

two extra connector pins and set of adult pads from the shipping container

2. Remove the cardboard tray from the shipping container

3. Remove the PRESTAN PROFESSIONAL AED TRAINER from the box

4. Unzip the PRESTAN PROFESSIONAL AED TRAINER carrying case

5. Remove the PRESTAN PROFESSIONAL AED TRAINER from the carrying case

6. Insert the MODULE into the back of the unit on the lower left hand corner

7. Pad Assembly

Open the plastic package and remove the Prestan Professional Adult Training Pads

Find the ends of the AED Trainer cables that are not connected to the unit

Remove black pad connector pins by pushing on the small end of the pin with a ball point pen

Insert pad into cable connector (be sure the pad graphics are on same side as pad connector

pin head and the hole in the tab of the pad matches the hole in the connector ends)

Insure pad is not upside down

ASSEMBLY, SETUP AND USE

(Continued)

Push black pad connector pins back into hole on the end of the pad cable connectors

Open the white plastic pad carrying case found in the unit

Then, turn pad over and remove the clear plastic liner from the Adult AED Pad by gently

pushing down on the tab end of the pad, causing the liner to separate

THROW THE CLEAR PLASTIC LINER AWAY (re-using the liner does not extend the life of the

adhesive)

Adhere the pads to the INSIDE of the white plastic Pad Case, close the case

8. Coil the Cables, place them in the well and cover them with the Pad Case

CONTROL PANEL

LANGUAGE SELECTION BUTTON

The LANGUAGE BUTTON is located at the top of the line of buttons on the Prestan Professional

AED Unit.

The language button is there to select the language that the unit will use

Simply press the button to toggle between the two languages that come with the unit

(Either English or Spanish)

The LAST language used on the unit will be used for the FIRST scenarios when the unit

starts

You do not have to turn the unit on to change Control Panel selections

INDICATOR LIGHTS

The indicator lights are just below the Language Selection button on the Prestan Professional

AED Trainer, in line with the Control Panel buttons

The Indicator Lights are used with the Scenario Selection button, the Volume Button and

the Pause Button

The indicator lights are either red or yellow

For each function, the indicator lights are defined NEXT

They also Indicate semi-automatic or automatic shock delivery mode

Language Button

Selection Indicator Lights

Scenario Selection Button

Volume Button

Pause Button

CONTROL PANEL

(Continued)

SCENARIO SELECTION BUTTON

The SCENARIO SELECTION button is located under the Indicator Lights.

The scenario selection button is used to select one of the five scenarios available

on the unit:

▌A red indicator means ‘shock’

▌A yellow indicator means ‘no shock’

The indicator is read left to right

▌▌▌The default is for three cycles, all of which are for ‘shock’

SCENARIOS

1. ▌▌▌This scenario is for shock; no shock; no shock

2. ▌▌▌This scenario is for shock; no shock; shock

3. ▌▌▌This scenario is for shock; shock; no shock

4. ▌▌▌This scenario is for no shock; no shock; no shock

5. ▌▌▌This scenario is for shock; shock; shock

VOLUME BUTTON

There are three volume levels on the unit

By pressing the volume button you can increase or decrease the volume of the unit

depending on need

The Indicator Lights will light up to indicate

▌Low Volume

▌▌Medium Volume

▌▌▌High Volume

PAUSE/PLAY BUTTON

When the pause Button is pushed, the unit will pause the scenario

When in pause mode, three (3) yellow lights ▌▌▌ in the Indicator Lights will blink

AUTOMATIC/SEMI-AUTOMATIC

The Prestan AED Trainer can be set to automatically deliver a simulated Shock without

depressing the Shock button.

The AED Trainer is preset from the factory in Semi-Automatic Mode –the shock is

delivered manually by pressing the red Shock Button

To Change this Mode:

•With the AED Trainer off, hold down the On/Off Button until you hear the second

beep, about 10 seconds.

•The first beep is for test mode so wait for the second double beep

•The Shock Button will flash on and off

•Look at the Selection Indicator Lights

•If there are three yellow lights –▌▌▌ –you are in Semi-Automatic Mode

•If there are three red lights –▌▌▌–you are in Automatic Mode

•To change the Mode, Push the Shock Button

•To Exit and Save, Press the On/Off Button

CARE AND CLEANING INSTRUCTIONS

Store the Prestan Professional AED Trainer in its case

and in a cool, dry area.

If the unit is being stored for long periods, remove

batteries to protect against corrosion.

Never pick up or carry the unit by the cables.

The Prestan Professional AED Trainer should be kept

clean. If it becomes soiled, simply wipe with a clean,

damp, soft cloth. If the Trainer is extremely dirty,

common cleaners can be used cautiously with a

minimum amount of abrasion to ensure the life of the

unit. Do not submerge in water.

OPTIONAL ACCESSORIES

Professional AED Trainer Remote

[OPTIONAL –NOT INCLUDED WITH AED TRAINER]

PP-AEDT-100-R Prestan Professional AED Trainer Remote with 2 'AA' batteries (installed) (for use with

the Prestan Professional AED Trainer)

PP-AEDT-400-R Four Prestan Professional AED Trainer Remotes with 8 'AA' batteries (installed) (for

use with the Prestan Professional AED Trainer)

Pediatric Training Pads / Yellow Pad Case

[OPTIONAL –NOT INCLUDED WITH AED TRAINER]

PP-PPAD-1 One set of Pediatric Pads

PP-PPAD-4 Four sets of Pediatric Pads

PP-PCASE-1 One Pediatric Pads Case

PP-PPDC-1 One set of Pediatric Pads with Case

Pediatric Pads illustrate the pad placement position for a small child or infant,

but work the same as the Adult Training Pads with the AED Trainer.

Volume

Language

Scenario

Pads On

Pads Off

Push Harder

Play

Pause

Stop

TROUBLESHOOTING GUIDE

SYMPTOM

POSSIBLE ISSUES OR COMMENTS

SOLUTIONS

Module will not fit into slot

The Module is designed to be inserted

one way only

Rotate the Module 180 degrees

and it will fit

Unit does not turn on

Unit must be manually turned on

Module is missing or not fully inserted

Batteries are not property installed

Batteries are dead or are missing

Push green power button

Insert or re-insert module properly

Re-orient batteries properly

Replace batteries

Difficult to peel off the

pads liner

Peel the liner from the Tab End

Gently bend the Connector to start

separation

Peel with thumb if necessary

Remove and throw away liner

Refer to the Assembly Section

Both pads attached to

manikin but device will not

advance to analysis

Operational solution

Pad is inserted upside down in the cable

connector

Adhesive worn out

Insure pads are pressed on firmly,

specifically so that the sensor in the

center of the adhesive is touching a

surface

Push out black connector pin, flip

pad around and re-secure with

black connector pin

Replace pad (lasts 50-60 uses)

Pad pulls out from pad

connector

Check for black connector pin missing

Install new black connector pin

Pad will not stick to the

manikin

Adhesive is worn out

Replace pads (lasts 50-60 uses)

Lid will not stay closed

Pads case is not placed in proper positon

Wires not properly stored in compartment

under case - wire may be caught under

edge of pads case

Pads case not properly closed

Re-seat pads case

Re-coil the wires

Snap case together on all 4 corners

Andere Handbücher für PP-AEDT-101

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Prestan Fitnessgeräte Handbücher

Prestan

Prestan PP-AEDT-101 Betriebsanleitung

Beliebte Fitnessgeräte Handbücher anderer Marken

NSD

NSD PB-188P Bedienungsanleitung

Performance

Performance HyperVibe Bedienungsanleitung

Scalamobil

Scalamobil S27 Bedienungsanleitung

Precor

Precor Experience Series Bedienungsanleitung

FYTTER

FYTTER RedMIUM BENCH BE-T6R Bedienungsanleitung

Taurus

Taurus TF-RK1312 Bedienungsanleitung

Nustep

Nustep T5 Bedienungsanleitung

Precor

Precor CW-507 Bedienungsanleitung

Movement

Movement BICEPS Idea Bedienungsanleitung

Kegel8

Kegel8 V For Men Bedienungsanleitung

Skandika

Skandika Styrke II Bedienungsanleitung

BLK BOX

BLK BOX 21-0122-0B Bedienungsanleitung

Stamina

Stamina aeropilates premier 299 Bedienungsanleitung

SPORTSTECH

SPORTSTECH PBX300 Bedienungsanleitung

ParaBody

ParaBody Serious Steel 877102 Bedienungsanleitung

Weslo

Weslo Gym 650 Bedienungsanleitung

Rebel

Rebel ACTIVE RBA-1011 Bedienungsanleitung

4iiii

4iiii FLiiiight Bedienungsanleitung