Prorack K676 Bedienungs- und Installationshandbuch

K676

Fitting Kit

EN Fitting Instructions for Basic Carrier

x 4 x 4 x 4 x 8

x 4 x 2 x 2 x 4

x 4 x 4 x 4

Revision No: 1A 1

Fitting Kit K676

MAX kgs (lbs)

W/P WHD

Honda

CR-V EX-L, 5dr SUV 12-+ US 75 kgs (165 lbs) 75 kgs (165 lbs)

CR-V N/Sport N, 5dr SUV 12-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)

CR-V , 5dr SUV 12-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)

CR-V , 5dr SUV 12-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)

CR-V SR/EX, 5dr SUV 12-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)

Fitting Kit EN

K676

First Time Installation

●Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

●This kit fits type A, B, C and D.

●These instructions show type A crossbar

fitted. They also apply to type B, C and D.

●Use keys to remove covers.

Fitting Kit EN

K676

●Use hex screwdriver to reverse adjusting

screw 10 turns.

●Press adjusting screw and pull crossbar

legs out. Refer to the crossbar instructions

for crossbar adjustment.

●Ensure each end of the crossbar is

adjusted equally.

●Set bars to length (refer to the crossbar

instructions for crossbar adjustment).

●Clamps onto flush roof rail.

Fitting Kit EN

K676

●Tighten adjusting screw to 5 Nm (3.7 ft lb).

●Remove plastic clamp block by gripping bar

leg with fingers and push firmly with

thumbs until clamp block drops out behind

leg.

●Remove both pins from each leg. Use

tapered end of spanner located inside left

hand cover to assist.

Fitting Kit EN

K676

●Detach foot from leg. Store loose parts in a

safe place.

●Repeat for all legs.

●Select four feet assemblies and match the

left and right assemblies to the left and

right roof rack legs.

●Assemble foot from kit into leg by pressing

it down.

●Ensure foot interlocks with leg.

●Using short capscrew and washer, secure

assembly onto leg (use Hex Screwdriver

supplied with crossbar to assist)

●Do not over tighten.

●Repeat for all legs.

Fitting Kit EN

K676

●Use two M5 x 12 mm self tapping screws to

secure the assembly onto the leg.

●Do not over tighten.

Fitment

●Apply protective strip as shown.

Trim if required.

●Open or remove fixed-point covers.

●Place crossbar foot over fixed-point mount.

●Ensure back edge of foot sits flush with the

back edge of vehicle roof rail.

Fitting Kit EN

K676

●Slide clamp through opening in leg.

●Using the Hex Key and the capscrews,

secure the clamps to the vehicle.

●Ensure spring washer is between clamp

and the head of the screw.

●Thread the coach bolt through the clamp

and the leg.

Fitting Kit EN

K676

●Tighten the red plastic knob.

●Ensure the red plastic knob is in the

position shown when fully tightened.

●Do not over tighten.

●Repeat for all four positions.

●Use keys to fit and lock covers

●Check crossbar is securely attached to the

vehicle.

CAUTION: Recheck all fasteners immediately after

a load is applied to the crossbars.

Regularly check screws are tight.

Fitting Kit EN

K676

Maintenance

●Clean the car roof and surfaces of the

product that will be in contact with the car

roof.

●Follow the fitting instructions for fitting the

product to your vehicle. Make sure all steps

are carried out in order.

●Set crossbars a minimum distance of

700mm (27 1/2") apart where no other

distance is specified in the fitting

instructions. This is especially important

when carrying long loads.

●Check unit is securely attached whenever

you refit it to the vehicle. If the unit feels

loose, refer to the fitting instructions and

readjust.

●Some glass/panoramic roofs and radio

antennae may not be able to be used when

the product is fitted.

●Do not modify this product.

●Refer to the maximum permitted load

capacity specified in the fitting instructions.

Do not exceed the vehicle manufacturers

roof load rating if it is lower than the

maximum load capacity specified in the

fitting instructions.

●Loads should not overhang the sides of the

product and be evenly distributed with the

lowest possible centre of gravity.

●Long loads should be secured with non-

elastic straps to the front and rear of the

vehicle.

●Objects with pointed ends (e.g. ski poles)

should be carried with the pointed ends to

the rear of the vehicle.

●Remove all loose or removable objects

from the load prior to loading.

●Make sure all loads are securely fastened

with non-elastic straps. Check regularly

during longer journeys.

●A loaded roof rack system can alter the

performance of your vehicle. Be especially

aware of the effects of side winds,

changing of direction, and braking

performance. Avoid rapid acceleration and

deceleration. Drive carefully.

●Note that the total height of the vehicle

increases when upright loads are carried.

●Products should be locked during transport

if they have locks fitted.

Inhaltsverzeichnis

Andere Prorack Autozubehör Handbücher

Prorack

Prorack Whispbar Q20 Bedienungsanleitung

Prorack

Prorack K855 Bedienungsanleitung

Prorack

Prorack K906 Bedienungsanleitung

Prorack

Prorack K890 Bedienungsanleitung

Prorack

Prorack K727 Bedienungsanleitung

Prorack

Prorack K777 Bedienungsanleitung

Prorack

Prorack K992 Bedienungsanleitung

Prorack

Prorack K486 Bedienungsanleitung

Prorack

Prorack K686 Bedienungsanleitung

Prorack

Prorack K375 Bedienungsanleitung

Prorack

Prorack K1004 Bedienungsanleitung

Prorack

Prorack K301 Bedienungsanleitung

Prorack

Prorack K382 Bedienungsanleitung

Prorack

Prorack 567 Bedienungsanleitung

Prorack

Prorack K163 Bedienungsanleitung

Prorack

Prorack PR3108 Bedienungsanleitung

Prorack

Prorack K629 Bedienungsanleitung

Prorack

Prorack Whispbar S43 Bedienungsanleitung

Prorack

Prorack PR3217 Bedienungsanleitung

Prorack

Prorack K426 Bedienungsanleitung

Prorack

Prorack K083 Bedienungsanleitung

Prorack

Prorack K365 Bedienungsanleitung

Prorack

Prorack VOYAGER PR3207 Bedienungsanleitung

Prorack

Prorack K465 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Curt Manufacturing

Curt Manufacturing A25 Bedienungsanleitung