Prorack Whispbar Q20 Bedienungsanleitung
Q20
Whispbar Track System
EN Fitting Instructions for Basic Carrier
x
12
x
12 x 1 x
12
x 1 x 1 x 1 x 2
x 2 x 4 x 4 x 4
x 2
Revision No: 2C 1
Whispbar Track System EN
Q20
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●Front end plug.
2
Whispbar Track System EN
Q20
●Rear end plug.
●Assemble front and rear plugs to tracks.
Note: Rear plug shown in picture.
●NOTE: There is a left hand track and right
hand track. The end plugs should be fitted
accordingly.
3
Whispbar Track System EN
Q20
●Carefully select position on vehicle roof
making sure that your crossbar lengths will
match selected positions for the tracks.
●Apply long lengths of masking tape to
vehicle roof in both positions.
●Repeat for all four positions.
●Make sure there is no interference between
what you intend to carry with aerials,
sunroof or tailgate.
●Tracks can be fitted either parallel or
tapered to match vehicle roof shape.
●Parallel Tracks:
A1 & A2 are equal
B1 & B2 are equal
C1 & C2 are equal
D1 & D2 are equal
●Tapered Tracks:
A1 & A2 are different
B1 & B2 are equal
C1 & С2 are equal
D1 & D2 are equal
●With help from another person, carefully lay
tracks over the masking tape and mark
hole positions with a pencil or pen.
●Take care not to move the tracks until the
holes are marked out.
4
Whispbar Track System EN
Q20
●Use drill bit supplied, to drill holes in
marked positions.
●Remove masking tape and apply non-
acetic silicon sealant around drilled holes.
●Sit tracks on roof and line up tracks with
drilled holes.
●Insert all cap screws through the drilled
holes.
●With assistance, fit washer and nut loosely
onto each of the cap screws from inside the
canopy.
●Use a spanner to tighten the nuts onto the
cap screws to 3Nm (2.2 ft lb) using the
provided 3mm provided hex key.
5
Whispbar Track System EN
Q20
●If the position of the roof racks need to be
adjusted along the tracks, use the 3mm
(1/8") hex key to hold the T-bolt stationary,
and using the 10mm (3/8") spanner
supplied loosen both of the nuts slightly on
all the mounting points to be adjusted.
●Adjust the position of the mounting points
along the tracks as required.
●Use the 3mm (1/8") Hex Key to hold the T-
bolt in a stationary position and ensure the
T-bolt has correct engagement.
●Using the 10mm (3/8") spanner supplied,
tighten the nut to 5Nm (3.7 ft lb).
●Use keys to remove covers.
6
Whispbar Track System EN
Q20
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Remove both pins from each leg. Use
tapered end of spanner located inside left
hand cover to assist.
●Detach foot from leg. Store loose parts in a
safe place.
●Repeat for all legs.
7
Whispbar Track System EN
Q20
●Assemble foot from kit into leg.
●Insert pins through foot into leg.
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
8
Whispbar Track System EN
Q20
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment.
●Ensure each end of the crossbar is
adjusted equally.
●Set bars to length so that the mounting
holes will line up (refer to the crossbar
instructions for crossbar adjustment).
9
Whispbar Track System EN
Q20
●Place crossbars over mounting assembly
on tracks.
●Tighten the red plastic knob.
●Ensure the red plastic knob is in the
position shown when fully tightened.
●Repeat for all four positions.
10
Inhaltsverzeichnis
Andere Prorack Autozubehör Handbücher
Prorack
Prorack K462 Bedienungsanleitung
Prorack
Prorack K786 Bedienungsanleitung
Prorack
Prorack K308 Bedienungsanleitung
Prorack
Prorack K425 Bedienungsanleitung
Prorack
Prorack K676 Bedienungs- und Installationshandbuch
Prorack
Prorack K1003 Bedienungsanleitung
Prorack
Prorack K879 Bedienungsanleitung
Prorack
Prorack K365 Bedienungsanleitung
Prorack
Prorack K746 Bedienungsanleitung
Prorack
Prorack K333 Bedienungsanleitung
Prorack
Prorack K987 Bedienungsanleitung
Prorack
Prorack K800 Bedienungsanleitung
Prorack
Prorack K045 Bedienungsanleitung
Prorack
Prorack K569 Bedienungsanleitung
Prorack
Prorack K130 Bedienungsanleitung
Prorack
Prorack K010 Bedienungsanleitung
Prorack
Prorack PR3075 Bedienungsanleitung
Prorack
Prorack K603 Bedienungsanleitung
Prorack
Prorack K983 Bedienungsanleitung
Prorack
Prorack K710 Bedienungsanleitung
