R.V.R. Elettronica TJ5KPS Bedienungsanleitung

TJ5KPS

UserManual

Volume 1

Manufactured by Italia

TJ5KPS-UserManual

Version 1.0

R.V.R. Elettronica SpA

Via del Fonditore 2/2c - 40138 - Bologna (Italia)

Telephone: +39 051 6010506

Fax: +39 051 6011104

Email: info@rvr.it

Web: www.rvr.it

Allrightsreserved

PrintedandboundinItaly.Nopart ofthismanualmaybereproduced,

memorized or transmitted in any form or by any means, electronic or

mechanic, including photocopying, recording or by any information

storageandretrievalsystem,withoutwrittenpermissionofthecopyright

owner.

File name: CAPITOLI_EN.P65

Version: 1.0

Date: 18/02/2004

Revision History

Date Version Reason Editor

18/02/04

1.0 New Version J. Berti

Notification of intended purpose and limitations of product use

This product is a FM transmitter intended for FM audio broadcasting. It utilises

operating frequencies not harmonised in the intended countries of use.

The user must obtain a license before using the product in intended country of

use. Ensure respective country licensing requirements are complied with.

Limitations of use can apply in respect of operating freuency, transmitter power

and or channel spacing.

Declaration of Conformity

Hereby, R.V.R. Elettronica SpA, declares that this FM transmitter is in

compliance with the essential requirements and other relevant provisions of

Directive 1999 5 EC.

TJ5KPS - Test Jig

iUser Manual Rev.1.0 -18/02/04

Table of Contents

1. Preliminary Instructions 1

2. Warranty 3

3. First Aid 5

3.1 Treatment of electrical shocks 5

3.2 Treatment of electrical Burns 6

4. Introduction 7

5. Description 7

6. Use 9

7. Software 10

8. Procedure of module setting 12

TJ5KPS - Test Jig

ii User ManualRev.1.0 -18/02/04

This page was intentionally left blank

TJ5KPS - Test Jig

1 / 14User Manual Rev. 1.0 - 18/02/04

1. Preliminary Instructions

This manual is written as a general guide for those having previous knowledge

and experience with this kind of equipment, well conscious of the risks connected

with the operation of electrical equipment.

It is not intended to contain a complete statement of all safety rules which should

be observed by personnel in using this or other electronic equipment.

The installation, use and maintenance of this piece of equipment involve risks

both for the personnel performing them and for the device itself, that shall be used

only by trained personnel.

R.V.R.Elettronica SpAdoesn’tassumeresponsibilityforinjuryordamageresulting

from improper procedures or practices by untrained/unqualified personnel in the

handling of this unit.

Please observe all local codes and fire protection standards in the operations of

this unit.

WARNING: alwaysdisconnectpowerbeforeopeningcovers or removing any part

of this unit.

Use appropriate grounding procedures to short out capacitors and high voltage

points before servicing.

WARNING: thisdevicecanirradiateradiofrequencywaves, and if it’snotinstalled

following the instructions contained in the manual and local regulations it could

generate interferences in radio communications.

This is a "CLASS A" equipment. In a residential place this equipment can cause

hash. In this case can be requested to user to take the necessary measures.

R.V.R. Elettronica SpA reserves the right to modifythedesignand/orthetechnical

specifications of the product and this manual without notice.

TJ5KPS - Test Jig

2 / 14 User ManualRev. 1.0 - 18/02/04

This page was intentionally left blank

TJ5KPS - Test Jig

3 / 14User Manual Rev. 1.0 - 18/02/04

2. Warranty

AnyproductofR.V.R. Elettronica is coveredbya24(twenty-four)monthwarranty.

Forcomponentsliketubesforpoweramplifiers,theoriginalmanufacturer’swarranty

applies.

R.V.R. Elettronica SpA extends to the original end-user purchaser all

manufacturers warranties which are transferrable and all claims are to be made

directly to R.V.R. per indicated procedures.

Warranty shall not include:

1 Damage while the equipment is being shipped to R.V.R. for repairs;

2 Any unauthorized repair/modification;

3 Incidental/consequential damages as a result of any defect

4 Nominal non-incidental defects

5 Re-shipment costs or insurance of the unit or replacement units/parts

Anydamagetothegoodsmustbereportedtothecarrierinwriting on the shipment

receipt.

Any discrepancy or damage discovered subsequent to delivery, shall be reported

to R.V.R. Elettronica within 5(five) days from delivery date.

To claim your rights under this warranty, you shold follow this procedure:

1 Contact the dealer or distributor where you purchased the unit. Describe the

problem and, so that a possible easy solution can be detected.

Dealers and Distributors are supplied with all the information about problems

that may occur and usually they can repair the unit quicker than what the

manufacturer could do. Very often installing errors are discovered by dealers.

2 If your dealer cannot help you, contact R.V.R. Elettronica and explain the

problem. If it is decided to return the unit to the factory, R.V.R. Elettronica

will mail you a regular authorization with all the necessary instructions to send

back the goods.

3 When you receive the authorization, you can return the unit. Pack it carefully

for the shipment, preferably using the original packing and seal the package

perfectly. The customer always assumes the risks of loss (i.e., R.V.R. is never

responsible for damage or loss), until the package reaches R.V.R. premises.

For this reason, we suggest you to insure the goods for the whole value.

Shipmentmustbe effectedC.I.F.(PREPAID)to theaddressspecifiedbyR.V.R.’s

service manager on the authorization

DO NOT RETURN UNITS WITHOUTOURAUTHORIZATIONAS THEY WILLBE

REFUSED

TJ5KPS - Test Jig

4 / 14 User ManualRev. 1.0 - 18/02/04

4 Be sure to enclose a written technical report where mention all the problems

found and a copy of your original invoice establishing the starting date of the

warranty.

Replacement and warranty parts may be ordered from the following address. Be

sure to include the equipment model and serial number as well as part description

and part number.

R.V.R. Elettronica SpA

Via del Fonditore, 2/2c

40138 BOLOGNA

ITALY

Tel. +39 051 6010506

TJ5KPS - Test Jig

5 / 14User Manual Rev. 1.0 - 18/02/04

3. First Aid

The personnel employed in the installation, use and maintenance of the device,

shall be familiar with theory and practice of first aid..

3.1 Treatment of electrical shocks

3.1.1 If the victim is not responsive

Follow the A-B-C's of basic life support

• Place victim flat on his backon a hard surface.

• Open airway: lift up neck, push forehead back (Fig. 3-1).

• clear out mouth if necessary and observe for breathing

• if not breathing, begin artificial breathing (Figure 3-2): tilt head, pinch nostrils,

make airtight seal, four quick full breaths. Remember mouth to mouth

resuscitation must be commenced as soon as possible

Figure 3-1 Figure 3-2

• Check carotid pulse (Fig 3-3); if pulse is absent, begin artificial circulation

(Fig. 3-4) depressing sternum (Fig. 3-5)

Figure 3-3 Figure 3-4 Figure 3-5

• In case of only one rescuer, 15 compressions alternated to two breaths.

• If there are two rescuers, the rythm shall be of one brath each 5 compressions.

• Do not interrupt the rythm of compressions when the second person is giving

breath.

• Call for medical assistance as soon as possible.

TJ5KPS - Test Jig

6 / 14 User ManualRev. 1.0 - 18/02/04

3.1.2 If victim is responsive

•Keep them warm

•Keep them as quiet as possible

•Loosen their clothing (a reclining position is recommended)

•Call for medical help as soon as possible

3.2 Treatment of electrical Burns

3.2.1 Extensive burned and broken skin

•Cover area with clean sheet or cloth

•Do not break blisters, remove tissue, remove adhered particles of clothing,or

apply any salve or ointment.

•Treat victim for shock as required.

•Arrange transportation to a hospital as quickly as possible.

•If arms or legs are affected keep them elevated

If medical help will not be available within an hour and the victim is conscious and

not vomiting, give him a weak solution of salt and soda: 1 level teaspoonful of salt

and 1/2 level teaspoonful of baking soda to each quart of water (neither hot or

cold). Allow victim to sip slowly about 4 ounces (half a glass) over a period of 15

minutes. Discontinue fluid if vomiting occurs

DO NOT give alcohol

3.2.2 Less severe burns

• Applycool (not ice cold)compressesusing the cleansed available clotharticle.

•Do not break blisters, remove tissue, remove adhered particles of clothing, or

apply salve or ointment.

•Apply clean dry dressing if necessary.

•Treat victim for shock as required.

•Arrange transportation to a hospital as quickly as possible

•If arms or legs are affected keep them elevated.

Inhaltsverzeichnis

Andere R.V.R. Elettronica Industrieanlagen Handbücher

R.V.R. Elettronica

R.V.R. Elettronica VJ3000 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica TOUCH30S Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica TEX150-LCD/S Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica SDC100 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica TRDS4001 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica TEX100 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica SDC20 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica URP Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica PTX30 UHT/S3 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica RDMODWEB Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica IBJECT12K10A Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica PJ3500M-C Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica PJ10KPS-CA Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica VJ1000HP Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica TELINK-SNMP2 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica TELINK-SNMP1 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica PJ250-NV Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica PTRL NV/3 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica URPT/MIC Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica PTRL-NV/2/S3 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica RXRL-NV/2 Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica PJ300M Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica RXRL-NV Bedienungsanleitung

R.V.R. Elettronica

R.V.R. Elettronica PJ5KPS Bedienungsanleitung

Beliebte Industrieanlagen Handbücher anderer Marken

ABB

ABB Unifix AD Handbuch

Mark 7

Mark 7 Evolution Bedienungsanleitung

Husky

Husky HyPET Bedienungsanleitung

bora

bora PM-1800 Bedienungsanleitung

Grizzly

Grizzly T32428 Bedienungsanleitung

Siemens

Siemens 8MF1 Series Bedienungsanleitung

ABB

ABB HT610965 Bedienungsanleitung

ABB

ABB SafeLink Bedienungsanleitung

Phoenix

Phoenix PHX-150 Bedienungsanleitung

ABB

ABB A165-L32 Bedienungsanleitung

ABB

ABB HT842936 Bedienungsanleitung

Hermetica

Hermetica 10 Series Bedienungsanleitung

HORNER

HORNER OEE Solution Bedienungsanleitung

Hammerhead

Hammerhead HG375 Bedienungsanleitung

SCHUNK

SCHUNK VERO-S NSE-A3 138 Gebrauchsanweisung

ABB

ABB HT566657 Bedienungsanleitung

Webasto

Webasto GSE CAN Bedienungsanleitung

ABB

ABB HT614003 Bedienungsanleitung