Samsung WMN-4270SD Bedienungsanleitung

º~ ºº~ º

Components

Only use the supplied components for the bracket installation.

Product Image

Safety Instructions

Be sure to contact an authorized service center when installing your set.

Contact a qualified technician at your dealer for moving

or replacing the product after the installation. Do not hang on or give sudden impacts to the product.

1. Be sure to keep the product away from children. There can be serious damage on the head when hit by the edge of the product.

2. Be careful when you adjust the angle or rotate the set. The product can be damaged if it is too close to touch the wall.

(Attach some sponges to 4 corners of the product to avoid the product or wall damage.)

3. Do not install the product in a place with high temperature and high humidity. Avoid to install the product on the wall which cannot

bear the weight.

4. Under no circumstances insert your finger into the groove created by separating the stand at the bottom of the LED while installing

the LED onto the wall. There is a danger of electric shock.

5. Make sure to cover the groove with the cover supplied with the LED before completing the LED installation on the wall.

Angle Adjustment and Rotation Type Wall-Mount Bracket Installation Guide

WMN-4270SD

Angle Adjustment Bracket

Bracket

left : 1 right : 1

Screw : 4

Accessories

Anchor : 8 Screw : 8

Screw : 8

plastic hanger : 4

Wire Fixing Tool

: 1

Slim, Normal LED

Screw : 4

plastic hanger : 4

Ultra-Slim Only

Install the angle adjustment bracket on the wall as shown in the

figure.

Wall Bracket Assembly

Securely fix the set to the wall. Pull the bracket forward and unfold it. Insert

the bracket to the assigned area of the angle adjustment bracket and tighten

the supplied 8 screws . (Same for both left and right side)

Tighten the angle adjustment bracket by using anchors and screws

orderly from to .

If it cannot be installed on the assigned area, install at the nearest

place.

Remove the screws on the LED set. Put the plastic hanger and 4 screws together

and firmly tighten on the back panel.

1. Mount the product on the wall bracket. Be sure to check on the left and right side to see if it is properly fixed.

2. Be careful when installing the product or adjusting the angle as fingers can be caught in the holes.

3. Be sure the wall bracket is securely fixed to the wall. Falling down the product may cause physical dama

Make a hole in the wall with the drill of

6x50.

How to Tighten Anchors or Screws

Clean up the hole.

Insert the supplied anchor to the hole.

Match the angle adjustment bracket to

the holes on the wall and tighten the

screws .

Use the drill with the required size when making a hole in the wall.

Be sure to follow the directions for the installation to avoid safety

problems.

1. Check the solidity of the wall before the installation. Strengthen the wall and install the bracket if the wall is not firm enough.

2. The supplied screws and anchors are for installing on concrete walls.

3. For the wall of plaster, marble, or steel, use the appropriate screws.

Slim, Normal LED Ultra-Slim Only

Pull the wall bracket fixing part forward. Two people are required to install the product on the assigned area of the wall bracket.

For managing the power cord and other cables for peripheral equipments, bundle the wires

by using the supplied wire fixing tool. Be sure the wires are not unbundled or came off when

rotating or operating.

Insert the cables and pull the angle adjustment bracket forward. Arrange the wires by using

the hole to avoid the interference with wires when rotating the set.

Check the operation 2 ~ 3 times and fix the wall molding if it works properly.

Wall Bracket Angle Adjustment

The smooth moving mechanism is applied to this product to move the product smoothly for

convenience.

You can adjust the angle to left, and right side between 20º ~ -20º, to

down side to 10º ~ 15º.

The adjustable angle range may be vary depending on the model.

Do not adjust the angle with force. The product can be damaged if it is

too close to touch the wall.

Hold the left and right side of the product when you want to adjust the

left and right angle.

Hold the top center to adjust the down angle.

Install the LED set to the wall

bracket and rotate the 2 safety

pins on the upper part to fix.

Slim, Normal LED Ultra-Slim Only

Product Specifications

Product Standards

Width(mm) 465.0

Height(mm) 460.0

Depth(mm) 24.5

Weight(Kg) 5.5

Bracket VESA Standard 400 X 400

Information in this document is subject to change without notice.

Inhaltsverzeichnis

Andere Samsung Rack & Stand Handbücher

Samsung

Samsung 46UE Bedienungsanleitung

Samsung

Samsung WMN-M E Series Bedienungsanleitung

Samsung

Samsung Q7FN Series Bedienungsanleitung

Samsung

Samsung QE32LS03TBKXRU Bedienungsanleitung

Samsung

Samsung Wall Mount Bedienungsanleitung

Samsung

Samsung WMN-M13E Bedienungsanleitung

Samsung

Samsung WMN-1000BD Bedienungsanleitung

Samsung

Samsung SCX-300CM Bedienungsanleitung

Samsung

Samsung WMN3000B Series Bedienungsanleitung

Samsung

Samsung WMN-M25EB/ZA Bedienungsanleitung

Samsung

Samsung SADT-103WM Bedienungsanleitung

Samsung

Samsung SBP-300NB Bedienungsanleitung

Samsung

Samsung WMN550M Bedienungsanleitung

Samsung

Samsung WMN-M12E Bedienungsanleitung

Samsung

Samsung Harman AMX VARIA-ACS-810A Bedienungsanleitung

Samsung

Samsung WMN-M20E Bedienungsanleitung

Samsung

Samsung STN-W4075E Bedienungsanleitung

Samsung

Samsung WMN-M15EB Bedienungsanleitung

Samsung

Samsung SHD-3000F2 Bedienungsanleitung

Samsung

Samsung WMN550M Bedienungsanleitung

Samsung

Samsung WMN4277TT Bedienungsanleitung

Samsung

Samsung WMN3000C Series Bedienungsanleitung

Samsung

Samsung TWMB-1900 Bedienungsanleitung

Samsung

Samsung Sbr-100dcm Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung