Sanyo SC-F298 Bedienungsanleitung

- 2 -

A FEW PRECAUTIONS

1. Operating without the dust compartment and/or filters in place

will allow dust to enter the motor and could damage the

vacuum cleaner.

2. Keep the vacuum cleaner away from stoves and other heat

sources. Heat can deform and discolor the plastic parts of the

unit.

3. Keep the vacuum cleaner free of insecticides. Do not wipe with

benzine, thinner, petrol or other oils which might cause

discoloration or cracking.

To clean the body and hose, dampen a cloth with a mild

detergent and wipe clean.

4. Blocking the suction inlet or allowing the dust to clog the hose

will decrease the efficiency of the motor.

5. Be sure not to push the clamp button while carrying the

vacuum cleaner.

6. Never try to vacuum the following objects. They may damage

the unit or cause a fire:

* Wet things, mud, soil and fluids

* Burning cigarettes

* Needles and razor blades

* Inflammable materials such as gasoline and thinner

* Construction rubbish

7. The following kinds of treatment shorten hose life:

* Bending hose at an acute angle when storing

* Pulling the hose with excessive force

* Placing heavy objects on, or stepping on the hose

8. Pull out the plug from the power source after use. Grasp the

plug (not the cord) when pulling out the plug. Pulling on the

cord may lead to short circuiting.

9. Long and continuous use causes the exhaust air and the body

of vacuum cleaner to become warm. This, however, dose not

denote malfunction.

10. When vacuuming places that are very dusty, and also when

vacuuming regularly, empty the dust compartment before it

becomes completely filled.

Frequent emptying lengthens the life of the motor and

maintains strong suction power.

Vacuum cleaner: SANYO SC-F298,

Voltage: AC220-240V, Frequency: 50-60Hz; Power:1600W

- 3 -

A FEW PRECAUTIONS

11. If the supply cord of this appliance is damaged, it must only be

replaced by a repair shop designated by the manufacturer, in

order to avoid a hazard.

12. Do not allow it to be used as a toy. Close attention is necessary

when used by or near children or infirm persons.

13. Young children should be supervised to ensure that they do not

play with the appliance.

14. This appliance is not to be used by persons (or children) whose

physical, sensory or mental capacities are impaired, or who

have no experience or knowledge, unless supervised or

instructed in the use of appliance by a person responsible for

their safety.

15. Unplug the appliance from outlet before cleaning or maintaining.

NAME AND FUNCTION OF PARTS

(Assemble as indicated in the center illustration)

- 4 - HandleCord rewind button Switch

Handle

Hose

Angled pipe

Wands

Floor brush

Put the round brush

or crevice tool here

whennot in use.

Connect the angled pipe

Insert securely by turning

Power control

Cord rewind button

To pull the cord back into the unit,

press the cord rewinder button.

Hold the plug when rewinding

the cord so that the plug does

not damage furniture, hands,

the vacuum cleaner or the cord

by hitting them. Holding the plug

will make rewinding smoother.

Caution:

Start or stop

vacuum

cleaner by

pushing on

the switch.

Set the POWER

CONTROL to “+” for

maximum suction.

In the position “-”

the suction power

is decreased.

Cord and plug

Hose stopper

Pull out the cord and

connect the plug.

Insert the hose all the way

up to the hose stopper.

To detach it, press the hose

stopper and pull the hose

out.

Do not extend the cord

from the unit beyond

the red marker line.

Cleaning Utensil Attachments

Cleaning utensil

To clean the filter, please remove

the cleaning utensil from the filter

and use it to do the cleaning. For vacuuming edges and gaps.

The head of the brush can rotate.

For vacuuming fragile or easily

scratched items.

Crevice tool

Round brush

DUST DISPOSAL

- 5 -

• • •

If there is a reduction in suction power, turn off the vacuum cleaner,

disconnect the hose and proceed as follows:

1. To separate the dust compartment

from the vacuum cleaner, push the

clamp button as shown. Clamp button

Dust compartment

Cleaning utensil

2. To remove dust, scrape the filter

from side to side with the cleaning

utensil.

Repeat approximately ten times.

3. To remove the filter.

Caution:

Remove the filter slowly to prevent

the dust from falling out.

4. Removing the dirt.

Caution:

If the dust is packed tightly and difficult to remove,

lightly tap the dust compartment.

Filter Pre-filter

Dust compartment

Then open up the

pre-filter and empty

the dirt out of the filter.

5. To reassemble the unit.

Insert the filter in the

dust compartment.

Then attach the dust

compartment section

to the motor section.

FILTER CARE

- 6 -

When the suction power is low and the dust has been discarded,

the filter still should be cleaned.

If you are concerned about dust on the filter.

1. Clean the filter with the cleaning utensil.

2. Lightly tap the filter to remove the dust.

cleaning utensil

1. Wash the filter with water.

If the dust is not easily removed,

use a brush for removal.

2. Dry the filter thoroughly.

Caution:

Do not dry in direct sunlight or by heating,

as the filter may become damage. Never

put the filter into the vacuum cleaner

unless it is completely dry.

* To assure the best results, we recommend cleaning the filters

once every one (1) year, or depending on usage.

If you have a problem with your vacuum cleaner, consult the handy guide

below. If the vacuum cleaner is malfunctioning, do not operate, please

contact your dealer.

- 7 -

CARE AND MAINTENANCE

Problem

(1) Vacuum cleaner won’ t run.

(2) Suction does not increase

after cleaning out the dirt.

(3) Cord doesn’ t fully rewind.

Possible cause Possible solution

1. Not firmly pulgged in.

2. No voltage in wall outlet.

1. Filter dirty.

2. Clogged floor brush or hose.

1. Cord twisted or uneven.

1. Plug unit in firmly.

2. Check the fuse or breaker.

1. Clean out the filter.

2. Clean out floor brush or hose.

1. Pull out cord and rewind.

HOW TO USE THE HOSE STAND

The vacuum cleaner with the floor brush, wands and hose can be stored

while still connected.

1. Stand the vacuum cleaner up

and insert the wand-holder into

the wand-holder hole.

2. Hold the hose and wind it

around the wands.

Caution:

Do not carry the vacuum cleaner

while it is in the storage position.

(Injury or damage may result if

the hose or coupling pipe becomes

unattached.)

Hold here

Wand-holder

Wand-holder hole

Wind

Inhaltsverzeichnis

Andere Sanyo Staubsauger Handbücher

Sanyo

Sanyo SC-K140T Bedienungsanleitung

Sanyo

Sanyo SC-B1221 Bedienungsanleitung

Sanyo

Sanyo SC-X1000P Bedienungsanleitung

Sanyo

Sanyo SC-A127C - Upright Commerical Vacuum Cleaner Bedienungsanleitung

Sanyo

Sanyo SC-U8 MA Bedienungsanleitung

Sanyo

Sanyo SC 53 series Bedienungsanleitung

Sanyo

Sanyo SC-B1210 Bedienungsanleitung

Sanyo

Sanyo SC 90 Series Bedienungsanleitung

Sanyo

Sanyo SC-B1230 Bedienungsanleitung

Sanyo

Sanyo SC-296T Bedienungsanleitung

Sanyo

Sanyo SC-30L Bedienungsanleitung

Sanyo

Sanyo SC-X1000P Bedienungsanleitung

Sanyo

Sanyo SC-15(M) Bedienungsanleitung

Sanyo

Sanyo SC-400 Bedienungsanleitung

Sanyo

Sanyo SC-A601 Bedienungsanleitung

Sanyo

Sanyo SC-X1801 Bedienungsanleitung

Sanyo

Sanyo SC-X80 Bedienungsanleitung

Sanyo

Sanyo SC-A114 Bedienungsanleitung

Sanyo

Sanyo SC-B550R Bedienungsanleitung

Sanyo

Sanyo SC-270 Bedienungsanleitung

Sanyo

Sanyo SC 50 Bedienungsanleitung

Sanyo

Sanyo Think Gaia SC-L180H Bedienungsanleitung

Sanyo

Sanyo SC-N500 Bedienungsanleitung

Sanyo

Sanyo SC-5006 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung

Nobles

Nobles 608669 Produkthandbuch