6SOR 1500 A1
GB
IE
Assembly
Use the fold-out page of these instructions to assist
you with assembly.
1) Remove the oil radiator and all components from
the box and remove all packaging materials.
2) Place the oil radiator, with the base uppermost,
on a soft surface, for example a carpet.
3) Place the mounting bracket 6 under the
heater element so that the threaded parts
project upwards.
4) Lay a roller rail 7over it, such that the screw
threads protrude through the holes. Check to
ensure that the recesses on the roller rails 7
are facing outwards. The screw ends project-
ing from the appliance must reach into the
recesses.
5) Screw one wing nut 8hand tight onto each of
the threaded ends of the mounting bracket 6.
6) Lay the second roller rail 7over the two
threaded rods that protrude from the control
panel so that they project through the holes in
the roller rail 7. Ensure that the small recesses
on the side of the roller rail 7face inwards.
The screw ends that project from the appliance
must grip into the recesses.
7) Attach the roller rail 7by screwing one wing
nut 8onto each of the threaded rods.
8) Turn the appliance over and place it on the rollers.
Initial operation
1) Unwind all of the power cable from the power
cable retainer 5.
NOTE
► Ensure that the thermostat 2and the heat
level switch 3are standing at MIN resp. 0.
2) Insert the plug into a mains power socket.
3) Set the heat level switch 3to "3" and the
thermostat 2to MAX. The "Power" control
lamp 1illuminates.
NOTE
► You can use the heat level switch 3to regu-
late how quickly the appliance warms up.
If you wish to heat it up particularly quickly,
select heat level "3", if a slow warming up is
preferred, select heat level "1".
Using the thermostat 2you can set it to the
desired temperature.
4) When the desired room temperature has been
reached, slowly turn the thermostat 2back
down until a quiet "click" is heard and the
"Power" control lamp 1goes out. The current
room temperature will now be retained. The
"Power" control lamp 1will light up occasion-
ally then switch back off after a short while.
This merely means that the programmed room
temperature has fallen below this level for a
short period and the appliance has warmed
itself back up.
5) If you want to switch off the appliance, turn the
heat level switch 3to “0” and then the thermo-
stat 2to MIN.
6) Remove the plug from the mains power socket.
IB_115164_SOR1500A1_LB6.indb 6IB_115164_SOR1500A1_LB6.indb 6 14.07.15 10:4614.07.15 10:46
