10 GB
Do not use this product near a
bathtub, shower or swimming
pool.
Installation (see fig. A–C)
Place the product upside down on a soft
underlay to avoid scratch on the surface,
power cord retainer 7upper than
temperature control 3, see fig. A.
Attach the U shape bolt 10 to the product
between first two fins with the threaded ends
pointing upward, see fig. A.
Place the U shape castor assembly 11 over
the U shape bolt 10 with both wheels
pointing upward, see fig. B, ensure both
threaded ends of U shape bolt 10 passing
through both holes on the U shape castor
assembly 11 .
Fasten wing nut 8securely onto each
threaded end of U shape bolt 10 .
Repeat above steps on the rear side of the
product with the I shape castor assembly 9
and the U shape bolt 10 attached between
last two fins, see fig C.
S
et the product back to upright position, whe
els
on the floor. It is now ready to use.
Note: The product is equipped with a tilt
protection switch. It will shut down the product
automatically if it falls over or is lying on its side.
Operation
Unwind the power cord completely from the
power cord retainer 7.
Make sure that both, temperature control 3
and heat level switch 2, are set to MIN and
“0” respectively.
Connect the oil-filled radiator to a grounded
electrical outlet protected by a residual
current circuit breaker, see “Technical data”
chapter.
Reaching the decided
room temperature
Set the temperature control 3to MAX. and
the heat level switch 2to “3”, the power
indicator 1lights up.
When the desired room temperature is reached,
turn the temperature control 3gently counter-
clockwise until the product shuts off, a “click”
sound is heard and the power indicator 1
goes off. Leave the temperature control 3
at the position and the room temperature is
now retained.
The product automatically cycles on and off
to keep the decided room temperature, the
power indicator 1light also cycles on and
off to indicate when the product is heating
up. As long as the heat level switch 2is set
to “1”/”2”/”3”, the product operates even
when the power indicator 1is off.
Use the heat level switch 2to select how
quickly the product shall warm up. To warm
up quickly, set the heat level switch 2to “3”.
Turbo heating
To heat the room more quickly, set the
temperature control 3to MAX. and the
heat level switch 2to “3”, the power
indicator 1lights up.
Press the heating fan switch 4to position
“I” to switch on the heating fan. An indicator
in the heating fan switch 4will light up.
Hot air will be blown through the hot air
outlet 5.
To switch off the hot air outlet 5, press the
heating fan switch 4to “0” position.
Using the temperature control 3to set the
product to the desired temperature.
Switch off the product
Press the heating fan switch 4to position “0”
to switch off the hot air outlet 5.
