SportsPlay 511-107C Bedienungsanleitung

511-107C CURVED BALANCE BEAM

Installation Guide

INSTALLATION INSTRUCTIONS

511-107C

CURVED BALABCE BEAM

Please read the entire manual before beginning installation.

511-107C CURVED BALANCE BEAM

Installation Guide

511-107C CURVED BALANCE BEAM

Installation Guide

Important

Please read completely before beginning installation.

This equipment has been designed for safety as well as challenge and fun. This

equipment has been designed to reduce injuries and therefore must be installed

“Step by Step” per our Instructions.

The U.S. Consumer Product Safety Commission (CPSC) published a report

stating 79% of all playground injuries treated in U.S. Emergency Rooms was the

result of a fall. It is critical that you refer to the Protective Surfacing section of

these instructions, located on the next page prior to installing your playground.

As the owner you are responsible for the safe installation of not only the play

equipment, but also the safety of the site.

When your receive your playground

Identify all parts by comparing them to the part list and component

instruction pages.

Always compare the number of pallets, cartons or other items the BOL

has listed with the number actually received. Note the any discrepancies

on the BOL.

Also note any obvious damage to the packing materials, pallets or

components on the BOL.

Equipment should be inventoried and installed within a few days of

receipt. The packing materials are meant to protect the equipment

during shipping and not for storage. Heat, weather and sunlight can

damage the packing materials, which can impact the components. If

storage is required you must store the equipment in a controlled

environment away from heat, moisture and sunlight. SportsPlay

recommends carefully unpacking the unit and taking an inventory before

storing the equipment. Care should be taken with all powder coated and

thermoplastic-coated parts to prevent damage to the coating.

You have 30 days from receipt of your equipment to file a claim for

missing or damaged parts.

511-107C CURVED BALANCE BEAM

Installation Guide

Safety Surfacing

WARNING! –INSTALLATION OVER A HARD SURFACE SUCH AS

CONCRETE, ASPHALT OR PACKED EARTH MAY RESULT IN

SERIOUS INJURY OR DEATH FROM A FALL

Because accidental falls are likely to occur around play equipment, SportsPlay

Equipment Inc. recommends that a resilient safety surfacing that will meet

standard ASTM F1292 be placed under and around the structure and extend

throughout the entire use zone.

SportsPlay Equipment Inc. does not manufacture safety surfacing. All

manufacturers of safety surfacing require different depths of surfacing for fall

heights. Consult your surfacing supplier about the required safety surfacing

depth for your play equipment.

SportsPlay Equipment Inc. manufactures all playgrounds to accommodate

12” of safety surfacing. If you intend to adjust the height of the surfacing

you will need to adjust the depth of the footing to accommodate the

surfacing height.

Refer to the CPSC Handbook for Public Playground Safety for the recommended

type and depth of the protective surfacing as well as all other playground safety

concerns.

For a copy of the most current issue of the CPSC Handbook for Public

Playground Safety, write to:

U.S. Consumer Product Safety Commission

Office of Information and Public Affairs

Washington DC, 20207

USA

Call - 1-800-638-2772 (US and Canada only)

Call - 301-504-0990

Direct Link - http://www.cpsc.gov

For a copy of either the standard for surfacing (ASTM F1292) or for play

equipment (ASTM 1487) write to:

American Society for Testing and Materials

100 Bar harbor drive

West Conshohocken PA, 19428-2959

USA

Call –618-832-9585

Web Site –www.astm.org

You must consider the type of safety surfacing you will use before beginning

the installation process. There are two general types, organic/loose fill or

synthetic unitary (pour in place). You must know which type of surfacing

you are going to use prior to installing the playground. This unit was

designed for 12” of loose fill surfacing so if the customer wants to use a

synthetic unitary product that has a much smaller height than 12” you must

dig the footing holes deeper to allow for the difference.

If loose fill surface material is to be used (example: wood mulch) you will

need to consider containment borders. There are many products to choose

from including hard plastic and natural products such as wood (Creosoted

railroad ties are NOT recommended for use as borders in a play area). Loose

fill materials are easily displaced so use of some type of containment border

is necessary to keep the surfacing material inside the intended area. Some

customers also prefer to have a weed mat installed to prevent weed growth.

Choose a mat that will prevent growth but will also allow for drainage.

511-107C CURVED BALANCE BEAM

Installation Guide

Tools and Materials

List is for tools and materials needed that are not included with the

playground

Follow manufacturer’s guidelines for proper use of tools and materials.

Shovels (long handled spades)

Post hole digger

Spray paint to mark holes

Levels –Magnetic torpedo and 4’ long levels

Scrap lumber to use for shims in post holes to keep posts level

Blocking materials for the post holes (bricks, concrete blocks, etc.)

Safety surfacing

Cement (2,500 psi minimum)

Straight line or transit level (and tripod) for ensuring hole depths are

at the same level

511-107C CURVED BALANCE BEAM

Installation Guide

BEFORE STARTING INSTALLATION OF YOUR CURVED BALANCE

BEAM, PLEASE READ INSTRUCTIONS THOROUGHLY.

BEFORE BEGINNING

SITE REQUIREMENTS

The Playground system is designed to suit a level site. Should there be any falls

or slopes on the site; care should be taken to accommodate the entry and exit points

and to maintain the correct height. There should not be more than 3” of drop in grade

per every 10’.

The site must be inspected for natural obstacles such as roots or rocks that may

be a trip hazard, poor drainage and sharp objects such as glass.

Every state has different rules and regulations governing digging, some are

stricter than others. In addition, 62 separate One Call Centers serve different

areas of the country; now 811 will connect you directly to your local One Call

Center. Prior to digging, be sure to call 811 or the local One Call Center to

prevent accidentally disrupting local utility service.

MAINTENANCE:

As an owner, it is most important that you are aware of your responsibility to

insure safe use of your new equipment. It is necessary to install equipment

according to the installation instructions provided and inspect the equipment at

regular intervals. During inspection, if anypart is found damaged orexcessivelyworn,

equipment shouldbeclosed immediately. Amaintenance sectionisincludedinthe

appendixofthisinstructionbooklet.

If a part is missing or damaged the playground must be put out of service while

the part is replaced. Lack of maintenance will result in premature wear, reduced

life expectancy,andpossiblefailurethatmayresult ininjury.

All SportsPlay Equipment play events have been engineered to meet all

applicable safety guidelines, but if installed improperly, these problems may

occur:

Entrapment gaps (between 3 1/2” and 9”)

String Entanglements

Protrusions

Make sure that any bolt end that protrudes more than 2 threads past the face of the

nut is trimmed and de-burred smoothly. Always double-check your work.

Installationmust adhere to the manufacturer’s assembly manual and all other applicable

safety guidelines.

PLAY AREA:

The area immediately above and around the play structure must be free of any

obstructions such as:

Trees

Other Play Equipment

Buildings

Overhead Power lines

Make sure the play area has all the required safety surfacingandthe

minimumfall zonesasrequiredby thesafety guidelines. These guidelines can

be found at www.cpsc.gov.

CHILDRENMUST BE SUPERVISED AT ALL TIMES. No playground is

safe without adult supervision!

There may be situations that require you to modify the layout or use your own

judgment. If you have any questions contact you distributor.

Reading this entire manual before beginning the installation will help you to

ensure your equipment is installed and maintained correctly.

511-107C CURVED BALANCE BEAM

Installation Guide

SUPERVISION GUIDE

Although the equipment is designed, installed and maintained in accordance with

all safety guidelines adult supervision is required.

Not all equipment is appropriate for all ages. Direct children to age appropriate

equipment.

Younger children will require more supervision than older children.

While eliminating accidents is not likely, following these guidelines will help

minimize accidents.

Basic playground safety for supervisors:

Make sure all safety surfacing is in place and at the correct height.

Inspect area for hard or sharp objects and remove them.

No dangerous horseplay in the play area. (Jumping from dangerous

heights, displacing of surfacing, etc…)

Inspecting for missing or broken equipment. (Do not allow children to

play on broken equipment or equipment with missing components).

Make sure there are no unsafe modifications (especially ropes tied to

equipment). Remove all unsafe modifications and close the equipment

for play until they are removed.

Keep children in the designated play area.

Do not let children play on wet equipment.

Prevent overcrowding on play equipment.

Loose clothing, hoods, strings or jewelry shall be tight or not worn

while playing to prevent strangulation.

Ensure the temperature of the equipment is not hazardous. Direct

sunlight exposure can increase the temperature of the equipment high

enough to cause injury.

Inspect the playground every day using the General Inspection Checklist

located in the appendix of this manual

The easiest method for performing the daily inspection with the

checklist is to laminate the checklist and use a dry erase marker to mark

the items off before opening the play area

511-107C CURVED BALANCE BEAM

Installation Guide

½ X ½ SET

SCREW

¼ ALLEN WRENCH (BLUE BAG)

511-107C CURVED BALANCE BEAM

Installation Guide

COMPONENT INSTALLATION INSTRUCTIONS

March 2, 2016

511-107C CURVED BALANCE BEAM

INSTALLATION INSTRUCTION

INSTALLATION DETAILS

Recommended crew (Adult): 2

Installation time: 4 hr

User age: 5-12

Use zone: 24’ x 14’

Weight: 50 lbs

SURFACING: Use of safety surfacing in compliance with

ASTM specification F1292 is required.

MAINTENANCE:

As the owner of the playground you are responsible for

maintenance of the equipment and play area. A

maintenance schedule must be developed and the

equipment inspected frequently. A maintenance section

that includes component specific maintenance

requirements is included at the end of this manual.

Be sure to inspect surfacing for foreign objects that could

cause injury and that sufficient surfacing are in place in

accordance with ASTM and CPSC standards.

Inhaltsverzeichnis

Andere SportsPlay Spielgeräte und Spielplatzausstattung Handbücher

SportsPlay

SportsPlay 511-152 Bedienungsanleitung

SportsPlay

SportsPlay 581-638M Bedienungsanleitung

SportsPlay

SportsPlay 581-830-8M Bedienungsanleitung

SportsPlay

SportsPlay 581-638F Bedienungsanleitung

SportsPlay

SportsPlay 581-638H Bedienungsanleitung

SportsPlay

SportsPlay Value Series Bedienungsanleitung

SportsPlay

SportsPlay 902-795 Bedienungsanleitung

SportsPlay

SportsPlay 511-107 Bedienungsanleitung

SportsPlay

SportsPlay 581-242F Bedienungsanleitung

SportsPlay

SportsPlay 511-146P Bedienungsanleitung

SportsPlay

SportsPlay 581-842HD Bedienungsanleitung

SportsPlay

SportsPlay HERCULES CLIMBER VII Bedienungsanleitung

SportsPlay

SportsPlay HERCULES CLIMBER VI Bedienungsanleitung

SportsPlay

SportsPlay 581-442HD Bedienungsanleitung

SportsPlay

SportsPlay Quick Ship 3 Modified Bedienungsanleitung

SportsPlay

SportsPlay LAUREN Bedienungsanleitung

SportsPlay

SportsPlay JR SLIDER Bedienungsanleitung

SportsPlay

SportsPlay Independent Spiral Slide Bedienungsanleitung

SportsPlay

SportsPlay 581-838H Bedienungsanleitung

SportsPlay

SportsPlay Ray 911-110 Bedienungsanleitung

SportsPlay

SportsPlay 511-102 Bedienungsanleitung

SportsPlay

SportsPlay 581-630-8M Bedienungsanleitung

SportsPlay

SportsPlay 581-238F Bedienungsanleitung

SportsPlay

SportsPlay Jeremy 911-116-N Bedienungsanleitung

Beliebte Spielgeräte und Spielplatzausstattung Handbücher anderer Marken

FUNormous

FUNormous Disney Junior MICKEY MOUSE Bedienungsanleitung

b4Adventure

b4Adventure Slackers TREEZONE ADVENTURE THREE HOUSE Bedienungsanleitung

PoolMaster

PoolMaster 72775 Bedienungsanleitung

Palmako

Palmako 4743142009857 Installationshandbuch

BOERPLAY

BOERPLAY PSTE000.019 Bedienungsanleitung

MGA Entertainment

MGA Entertainment Little Tikes Dunk'n Toss Bouncer Benutzerhandbuch

stilum

stilum Erika Bedienungsanleitung

Costway

Costway NP10816 Bedienungsanleitung

Trigano

Trigano VABI Bedienungsanleitung

Outward

Outward OUT116 Bedienungsanleitung

GALOPIN

GALOPIN ARC02 Bedienungsanleitung

stilum

stilum levis Technische Daten

Ledon

Ledon BASIC Bai LB012 Bedienungsanleitung

BOERPLAY

BOERPLAY PSTE115.002 Bedienungsanleitung

Europlay

Europlay S306 Programmierhandbuch

SportsPlay Equipment

SportsPlay Equipment 361-509H Bedienungsanleitung

Ledon

Ledon 302250 Bedienungsanleitung

Costway

Costway NP10441 Bedienungsanleitung