Teledyne Everywhereyoulook T3PM1100 Bedienungsanleitung

T3PM1100

Digital Power Meter

User Manual

This manual contains proprietary information, which is protected by

photocopied, reproduced or translated to another language without

prior written consent of Teledyne LeCroy company.

The information in this manual was correct at the time of printing.

However, Teledyne LeCroy continues to improve products and

reserves the rights to change specification, equipment, and

maintenance procedures at any time without notice.

TABLE OF CONTENTS

Table of Contents

SAFETY INSTRUCTIONS .................................................. 5

GETTING STARTED .......................................................... 9

Characteristics ........................................................... 10

Appearance ................................................................ 13

Set Up ....................................................................... 22

BASIC SETTING ............................................................. 25

Setting up measurement range .................................. 26

Setting up measurement status ................................. 30

Setting up System status ........................................... 62

MEASUREMENT AND OTHER FUNCTIONS .................... 70

Measurement function............................................... 71

Other functions ......................................................... 76

Integration measurement function............................. 79

Graph measurement function .................................... 90

REMOTE CONTROL ......................................................108

Configure Remote Control Interface ......................... 109

Configure EOL Character ......................................... 115

Return to Local Control............................................ 115

COMMAND OVERVIEW ................................................116

Command Syntax ..................................................... 116

Command List ......................................................... 120

APPENDIX ....................................................................198

Specifications .......................................................... 199

Status system .......................................................... 209

Dimensions ............................................................. 213

T3PM1100 User Manual

Power measurement ................................................ 214

Introduction to IEC-62301........................................ 216

EUP Directive Lot6 specifications ............................ 217

Connection Guide .................................................... 218

CERTIFICATIONS..........................................................221

EMC Compliance ..................................................... 221

Safety Compliance ................................................... 223

Environmental Compliance ...................................... 224

RESTRICTION OF HAZARDOUS SUBSTANCES

(RoHS) .................................................................... 224

T3PM1100 User Manual

SAFETY INSTRUCTIONS

This chapter contains important safety

instructions that you must follow during

operation and storage. Read the following before

any operation to ensure your safety and to keep

the instrument in the best possible condition.

Safety Symbols

These safety symbols may appear in this manual or on the

instrument.

WARNING

Warning: Identifies conditions or practices that

could result in injury or loss of life.

CAUTION

Caution: Identifies conditions or practices that

could result in damage to the T3PM1100

or to other properties.

DANGER High Voltage

Attention Refer to the Manual

Protective Conductor Terminal

Earth (ground) Terminal

On (Supply)

Off (Supply)

T3PM1100 User Manual

Safety Guidelines

General Guideline

CAUTION

Make sure that the voltage input level does not

exceed AC600V.

Make sure the current input level does not

exceed 20A.

Do not place any heavy object on the

instrument.

Avoid severe impact or rough handling that can

lead to damaging the instrument.

Do not discharge static electricity to the

instrument.

Use only mating connectors, not bare wires, for

the terminals.

Do not block or obstruct the cooling fan vent

opening.

Do not perform measurement at the source of a

low-voltage installation or at building

installations (Note below).

Do not disassemble the instrument unless you

are qualified as service personnel.

Make sure that the COM terminal to earth is

limited to 600Vpk.

Remove all test leads before disconnecting the

mains power cord from the socket.

If the equipment is used in a manner not

specified by the manufacturer, the protection

provided by the equipment may be impaired.

The device should be placed in a way that the

plug connected to it can be removed easily.

SAFETY INSTRUCTIONS

(Note) EN 61010-1:2010 specifies the measurement categories and

their requirements as follows. The T3PM1100 falls under category II

600V.

Measurement category IV is for measurement performed at the

source of low-voltage installation.

Measurement category III is for measurement performed in the

building installation.

Measurement category II is for measurement performed on the

circuits directly connected to the low voltage installation.

Power Supply

WARNING

AC Input voltage: 100-240 VAC 50/60Hz

The power supply voltage should not fluctuate

more than 10%.

Connect the protective grounding conductor of

the AC power cord to an earth ground, to avoid

electrical shock.

Cleaning the

Instrument

Disconnect the power cord before cleaning.

Use a soft cloth dampened in a solution of mild

detergent and water. Do not spray any liquid.

Do not use chemicals containing harsh material

such as benzene, toluene, xylene, and acetone.

Operation

Environment

Location: Indoor, no direct sunlight, dust free,

almost non-conductive pollution (Note below)

Temperature: 0°C to 40°C

Humidity: < 30°C: < 80%RH(non-condensing);

30°C~40°C:<70%RH(non-condensing);

>40°C: <50%RH (non-condensing)

Altitude: <2000m

Overvoltage category: OVC II

T3PM1100 User Manual

(Note) EN 61010-1:2010 specifies the pollution degrees and their

requirements as follows. The T3PM1100 falls under degree 2.

Pollution refers to “addition of foreign matter, solid, liquid, or

gaseous (ionized gases), that may produce a reduction of

dielectric strength or surface resistivity”.

Pollution degree 1: No pollution or only dry, non-conductive

pollution occurs. The pollution has no influence.

Pollution degree 2: Normally only non-conductive pollution

occurs. Occasionally, however, a temporary conductivity caused

by condensation must be expected.

Pollution degree 3: Conductive pollution occurs, or dry, non-

conductive pollution occurs which becomes conductive due to

condensation which is expected. In such conditions, equipment

is normally protected against exposure to direct sunlight,

precipitation, and full wind pressure, but neither temperature

nor humidity is controlled.

Storage

environment

Location: Indoor

Temperature: -40°C to 70°C

Humidity: <90%RH(non-condensing)

Disposal

Do not dispose this instrument as unsorted

municipal waste. Please use a separate collection

facility or contact the supplier from which this

instrument was purchased. Please make sure

discarded electrical waste is properly recycled to

reduce environmental impact.

GETTING STARTED

This chapter describes the T3PM1100, including

accessories, package contents, its main features

and front / rear panel introduction.

Characteristics ........................................................... 10

Accessories ...............................................................................12

Package Contents .....................................................................12

Appearance ................................................................ 13

Front Panel................................................................................13

Main Display Overview.............................................................16

Rear Panel .................................................................................19

Set Up ....................................................................... 22

Tilting the Stand .......................................................................22

Power Up...................................................................................23

Connect the wires to the T3PM1100 ........................................24

T3PM1100 User Manual

Characteristics

The T3PM1100 is a high-precision, programmable power meter for

measuring low power devices such as switching power supplies,

transformers, power supplies, and adapters. It is equipped with a

color TFT-LCD screen and also multiple graph displays which are

very convenient for reading the measurement results. The

T3PM1100 has become a reliable power measurement instruments

because of its simple operation, excellent performance, user-

friendly graph displays and automatic measurement interface.

Operation

Press the buttons on the front panel to easily

turn on the T3PM1100 measurement function.

All settings and measurements results are

displayed on the 5-inches TFT-LCD screen panel

for easy use of each function.

Standard display mode: 2 main measurement

results and 8 secondary measurement results are

displayed in this screen.

Simple display mode: 4 major measurement

results are displayed in this screen.

Performance

6 selectable voltage ranges available from 15V to

600V with 0.1% of reading + 0.05% of range.

12 selectable current ranges available from 5mA

to 20A with 0.1% of reading + 0.05% of range.

It can even measure the voltage of abnormal

wave of CF 3. The half-range CF is up to 6 or 6A.

It can even measure the current of abnormal

wave of CF 3. The half-range CF is up to 6 or 6A.

Total harmonic distortion measurement.

50-orders harmonic test and analysis function.

Graph display for measurement results

including harmonic orders distribution.

Plug-in USB disk data store function including

Andere Handbücher für Everywhereyoulook T3PM1100

Inhaltsverzeichnis

Andere Teledyne Messgerät Handbücher

Teledyne

Teledyne 212R Bedienungsanleitung

Teledyne

Teledyne T3CP30-50 Bedienungsanleitung

Teledyne

Teledyne T200U Montage- und Bedienungsanleitung

Teledyne

Teledyne 200A Bedienungsanleitung

Teledyne

Teledyne 465M Bedienungsanleitung

Teledyne

Teledyne First Responder CG Bedienungsanleitung

Teledyne

Teledyne 730 Bubbler Bedienungsanleitung

Teledyne

Teledyne Sierra M6-2 Bedienungsanleitung

Teledyne

Teledyne T3PM1006 Bedienungsanleitung

Teledyne

Teledyne Mixchek Bedienungsanleitung

Teledyne

Teledyne T3SP Series Bedienungsanleitung

Teledyne

Teledyne T200 Bedienungsanleitung

Teledyne

Teledyne HASTINGS 4/6 Bedienungsanleitung

Teledyne

Teledyne PS200-LMP Bedienungsanleitung

Teledyne

Teledyne Frontline Sodera Bedienungsanleitung

Teledyne

Teledyne T3LVD Bedienungsanleitung

Teledyne

Teledyne PMAT 2000 Bedienungsanleitung

Teledyne

Teledyne PS200 Series Handbuch

Teledyne

Teledyne TED 191 Bedienungsanleitung

Teledyne

Teledyne 8800T Bedienungsanleitung

Teledyne

Teledyne HVG-2020B Bedienungsanleitung

Teledyne

Teledyne T3SP Series Bedienungsanleitung

Teledyne

Teledyne 440 Benutzerhandbuch

Teledyne

Teledyne AX300 Bedienungsanleitung

Beliebte Messgerät Handbücher anderer Marken

Suaoki

Suaoki D40 Bedienungsanleitung

Elster

Elster BK-G1.6 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Deltabar FMD71 Handbuch

Duratool

Duratool D03128 Bedienungsanleitung

Vega

Vega VEGAPULS 65 Bedienungsanleitung

Tonghui

Tonghui TH2618B Bedienungsanleitung

Tenmars

Tenmars TM-801 Bedienungsanleitung

MSR

MSR 145 Bedienungsanleitung

TPS

TPS WP-82 Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 003C30 Bedienungsanleitung

Tenma

Tenma 72-10465 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Proline Promag 50 Technische Daten

Siemens

Siemens SITRANS F Coriolis FCT030 Stücklistenhandbuch

KLINGER

KLINGER CMF V Series Bedienungsanleitung

Keysight

Keysight M8290A Bedienungsanleitung

Acterna

Acterna MS1400 Bedienungsanleitung

R&S

R&S ZPH Bedienungsanleitung

Datacolor

Datacolor ColorReader DC10-2 Bedienungsanleitung