2
INSTALLATION & SAFEGUARDS
All the safety and operating instructions should be read before the unit is operated.
Environment Condition for Installation
- To prevent electric shock or other hazard, do not expose units to rain, oisture, or dust.
- This unit should be located in an area with low hu idity and a ini u of dust..
- Place this unit in a well-ventilated place and do not place heat-generating objects on this unit.
- This unit should not be located in an area where it is likely to be subjected to echanical shocks.
Before ou Start
- Ensure the power switch is in the OFF position prior to starting.
- Do not atte pt to service this unit yourself as opening or re oving covers ay expose you to
dangerous voltage or other hazards.
- Installation should be perfor ed by qualified service personnel only.
- This unit should be operated only fro the type of power source indicated on the anufacturer’s
label and with the power supply included with the unit.
Notice
NoticeNotice
Notice
- Before initial configuration or operation you must first set the TIME/DATE, followed by
setting the unit to the FACTORY DEFAULT settings, lastly clearing the HDD. Please follow
these steps in order.
- Before installing a second HDD, ensure that the drive conforms to the specifications
listed on the specifications page at the end of this manual. When installing a second HDD,
set the drive to SLAVE. After installation, first reset the TIME/DATE, followed by resetting
the unit to the FACTORY DEFAULT settings, lastly clearing the new HDD.
- Pull the unit out of record mode prior to cutting power to the unit. Do this by entering the
setup menu, followed by switching the unit off. Powering off the unit while writing to the
disks can cause critical malfunctions. (ex: Recording Error, Playback Error, System Error)
- When you set the record type, you have to set the Record Configuration and also
Schedule Setup. This unit records as per the Record type & Schedule setup.
- The [REC] button on the front panel is for emergency record using highest image quality.
The lightning flash with arrowhead sy bol within an equilateral triangle is intended to alert the
user of this equip ent that there are dangerous voltages within the enclosure which ay be of
sufficient agnitude to constitute a risk of electric shock.
The excla ation point within an equilateral triangle is intended to alert the user to presence of
i portant operating and aintenance(Servicing) instructions in the literature acco panying the
appliance.
