FIGURE 7
P9 P7
9For Customer Service Call 1-888-996-2729
© 2016 Escalade Sports
All RIghts Reserved.
STEP 6
PARTS REQUIRED:
8 pcs - H3 M6 x 25 mm Allen Head Bolt 1 pc - P7 Backboard
8 pcs - H4 Flat Washer 2 pcs - P11 Mechanical Scoring Arm
8 pcs - H5 Wing Nut 2 pcs - P12 Rim
8 pcs - H8 Lock Washer 1 pc - T1 Allen Wrench
Slide P12 Rims onto Rim Support Plates that already attached to the
front of the P7 Backboard. Use T1-Allen Wrench or Phillips
Screwdriver and Plyers (not provided) to
tighten P12 Rims.
Attach P11 Mechanical Scoring Arms to
P7 Backboard using H3 Bolts, H4 Washers,
H8 Lock Washers and H5 Wing Nuts as
shown in FIGURE 6.
Use T1-Allen Wrench or Phillips Screwdriver
and Plyers (not provided) to tighten H3 Bolts.
P11
P7
H5
FIGURE 6
H4
PARTS REQUIRED:
1 pc - P9 Electronic Scorer
1 pc - P10 Electronic Scorer Face Plate
2 pcs - P13 Rim Net
STEP 7
Attach P9 Electronic Scorer and P10 Electronic
Scorer Face Plate to P7 Backboard as shown
in FIGURE 7.
NOTE: Place P10 Electronic Scorer Face Plate
into P7 Backboard first, then carefully “press”
P9 Electronic Scorer onto the four tabs on P10.
You should hear the four tabs “snap”
into place.
Loop the P13 Rim Net through the ram horns
on the P12 Rims as shown in FIGURE 7.
P13
P10
NOTE:
P11 Mechanical Scoring Arm
sensor plug must pass through
P7 Backboard before attaching
the scoring arm.
H3
P12
NOTE:
Slide P12 Rims onto Rim
Brackets C1 pre-installed
on P7 Backboard.
Next, tighten C1 Brackets
to secure the P12 Rims
well using T1 Allen Wrench
(provided) or Phillips
Screwdriver and Plyers
(not provided).
C1
H8
