Viavi T-BERD/MTS 5800 Bedienungsanleitung

VIAVI//Public

T-BERD/MTS 5800 Portable Network Tester

T-BERD/MTS-5800 Portable Network Tester

QUICK CARD

Serial Datacom Bit Error Rate Testing (BERT)

This quick card describes how to configure the T-BERD 5800 as Data Terminal Equipment

(DTE) and run a Bit Error Rate Test on a Serial Datacom interface with typical configuration

settings. Please refer to the T-BERD 5800 Testing Manual for an explanation of all settings.

•T-BERD/MTS 5800 with Transport software release

V31.2.1 or greater

•Datacom Expansion Module (VIAVI Part# C5DEM)

•USB Type B to USB TypeA cable

•One of the following Datacom cables to connect the

Datacom Expansion Module to the line under test:

oRS-232/V.24, EIA-530 Cable

(VIAVI Part# CB-21148994-002)

oRS-449/V.36 Cable (VIAVI Part# CB-21144332-002)

oV.35 Cable (VIAVI Part# CB-21148995-002) Figure 1: Equipment Requirements

LAUNCH TEST

1. Press the Power button to turn on the

T-BERD.

2. Tap the Datacom icon at the top of

the launch screen.

Figure 2: Launch Screen

CONNECT TO LINE UNDER TEST

•Connect the USB Type B to USB Type A cable to the Datacom Module and the USB port on the

side of the T-BERD 5800.

•Connect the desired Datacom cable to the Datacom Expansion Module.

•Use the connector labeled “To DCE” to connect to the line under test.

VIAVI//Public

T-BERD/MTS 5800 Portable Network Tester

T-BERD/MTS-5800 Portable Network Tester

QUICK CARD

1. Press the Setup soft key on the top

right side of the screen.

2. Tap .

3. Press to continue.

4. Select the indicated folders and configure

your test as follows. Leave all other values

at default, unless specified in the work order.

•The following Information is needed to configure

the test:

•Interface (RS-232/V.24, EIA-530, RS-

449/V.36, or V.35)

•Signal Mode (Balanced or Unbalanced)

•Timing Mode (Synchronous or Asynchronous)

•Rx Timing Source (Internal or Interface)

•Tx Timing Source (Internal or Interface)

•Out of Band Flow Control (On or Off)

•Test Patterns(s)

•BER Pass/Fail Threshold

Figure 3: Work Order

CONFIGURE TEST

Figure 5: Setup, Timing

Figure 6: Setup, Pattern

Folder

Option

Value(s)

Interface

-232/V.24, EIA-530,

-449/V.36, etc.

Timing

Mode

Synchronous or

Asynchronous

Rx Timing

Source

Interface (RT)

Tx Timing

Source

Select Interface (ST) for

Synchronous timing,

select Internal (Synth) for

Asynchronous timing.

Synthesizer

Frequency

Enter frequency in kHz;

i.e., 9.6 kHz for 9600 bps.

Pattern

Enter the 1st Pattern in your

test plan (QRSS, 2^6

-1, etc.)

Note: 2^11

-1 = 2047,

2^9

-1 = 511, 2^6-1 = 63

5. Press the Results soft key to view the

Test Results screen.

Figure 4: Setup, Interface

VIAVI//Public

T-BERD/MTS 5800 Portable Network Tester

T-BERD/MTS-5800 Portable Network Tester

QUICK CARD

Product specifications and descriptions in this

document are subject to change without notice.

Patented as described at viavisolutions.com/patents

To reach the VIAVI office nearest you,

visit viavisolutions.com/contact

+1 844 GO VIAVI

(+1 844 468-4284)

RUN TEST

1. Tap the Signal Lead tab at the bottom of the

screen and tap the RTS and DTR buttons.

2. Press the Restart soft key .

3. Using the drop-down menus, select

“Summary/Status” for the left results display

and select “HS Datacom/BERT” for the right

results display.

4. Allow the test to run for desired duration and

verify the following:

•Pattern Sync LED is green.

•Error Rate result does not exceed

your required Bit Error Rate (BER)

threshold. (0.00E+00 if pass/fail

threshold unknown)

5. In the T-BERD’s Quick Config menu,

change “Pattern” to the next value in the

test plan.

6. Press the Restart soft key to reset

results.

7. Allow the test to run for desired duration and

verify the following:

•Pattern Sync LED is green.

•Error Rate result does not exceed

your required BER threshold.

(0.00E+00 if pass/fail threshold

unknown)

8. Repeat steps 5 through 7 for all Patterns in

the test plan.

Figure 7: Test Results Screen, Signal Leads

Figure 8: Test Results Screen, HS Datacom/BERT

Figure 9: Test Plan

Andere Viavi Prüfgeräte Handbücher

Viavi

Viavi T-BERD MTS 5800 Stücklistenhandbuch

Viavi

Viavi T-BERD 5800 Bedienungsanleitung

Viavi

Viavi ONX 580 Bedienungsanleitung

Viavi

Viavi OSA-4100 Bedienungsanleitung

Viavi

Viavi OneAdvisor 1000 Bedienungsanleitung

Viavi

Viavi OneAdvisor 800 400G Module Bedienungsanleitung

Viavi

Viavi 7200 Series Bedienungsanleitung

Viavi

Viavi OneExpert ONX CATV Bedienungsanleitung

Viavi

Viavi OneAdvisor 1000 Bedienungsanleitung

Viavi

Viavi IFR 6015 Bedienungsanleitung

Viavi

Viavi T-BERD MTS 5800 Stücklistenhandbuch

Viavi

Viavi T-BERD 5800 Stücklistenhandbuch

Viavi

Viavi NSC-200 Bedienungsanleitung

Viavi

Viavi OneExpert CATV Bedienungsanleitung

Viavi

Viavi T-BERD/MTS 5800 Installationsanleitung

Viavi

Viavi T-BERD/MTS-4000 v2 Stücklistenhandbuch

Viavi

Viavi 8000 V2 Platform Bedienungsanleitung

Viavi

Viavi Parent Guide Bedienungsanleitung

Viavi

Viavi SmartClass OLP-85 Series Bedienungsanleitung

Viavi

Viavi IFR 6000 Stücklistenhandbuch

Viavi

Viavi OneAdvisor 1000 Bedienungsanleitung

Viavi

Viavi ATC-5000NG Bedienungsanleitung

Viavi

Viavi OTU-8000 Stücklistenhandbuch

Viavi

Viavi OCC-4056 Stücklistenhandbuch

Beliebte Prüfgeräte Handbücher anderer Marken

SMART

SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung

Agilent Technologies

Agilent Technologies BERT Serial Bedienungsanleitung

Agilent Technologies

Agilent Technologies N3280A Bedienungsanleitung

Vernier

Vernier Go Direct Voltage Bedienungsanleitung

Lifeloc

Lifeloc R.A.D.A.R. Bedienungsanleitung

Fluke

Fluke T5-600 Bedienungs- und Montageanleitung

Mercury

Mercury TSL01 Bedienungsanleitung

MAHA

MAHA MBT Series Bedienungsanleitung

Fuji Electric

Fuji Electric P-61 Bedienungsanleitung

ETC

ETC SealerAtor Bedienungsanleitung

Skyfine

Skyfine ETHYWAY V2 Bedienungsanleitung

Appion

Appion G5 Twin Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 8159-0112A Bedienungsanleitung

BW Technologies

BW Technologies MicroDock II Bedienungsanleitung

Sun Nuclear

Sun Nuclear 1027 Bedienungsanleitung

Biomark

Biomark HPR LITE READER Bedienungsanleitung

Hioki

Hioki 3169-20 Bedienungsanleitung

Ashcroft

Ashcroft ATE-100 Bedienungsanleitung