VS Sassoon VSM7472A Bedienungsanleitung

TOOL TIPS

THECRAFTEDCUT

for the multi-purpose grooming tool

for clipping, shaping & detailing.

VSM7472A

HEY YOU!

TAKE A BOW FINE SIR.

THINGS ARE LOOKING UP

& YOU’VE JUST MADE A

QUALITY PURCHASE

WITH THIS NEW GROOMING TOOL.

WE KNOW YOU’VE GOT THIS, BUT BEFORE YOU JUMP INTO

USING YOUR NEW SIDE KICK, HERE’S A FEW TIPS & TRICKS

TO KNOW BEFORE LETTING YOUR CREATIVITY RUN LOOSE.

HIT UP VSFORMEN.COM.AU FOR MORE GROOMING & INSPIRATION.

THE CRAFTED CUT / TOOL TIPS

IMPORTANT SAFETY

INSTRUCTIONS

When using electrical appliances, especially when children are present, basic

safety instructions should always be followed, including the following:

Polythene bags over product or package may be dangerous. To avoid danger of

suffocation, keep this wrapper away from babies and children. This bag is not

a toy.

DANGER: When the unit is used in a bathroom, unplug it after use

since the proximity of water presents a hazard even when the

appliance is switched off

WARNING: Do not use or leave the adaptor in a position where it can become wet

or there is a danger of it falling into a basin or other vessels containing water.

Keep the appliance dry, unless it otherwise specified. Do not use this appliance

in or near bathtubs, showers, basins or other vessels containing water.

- Do not immerse appliance in water or other liquids.

- Do not reach for an appliance that has fallen into water. Unplug immediately.

- Take care to avoid contact between the moving blades of the unit and the

skin, paying particular attention to the face, neck and hands.

- This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

- Children should be supervised to ensure that they do not play with the

appliance.

THE CRAFTED CUT / TOOL TIPS

IMPORTANT: Always unplug the appliance when not in use or before cleaning.

Do not leave unattended when plugged in or switched on. Do not place on any

heat sensitive surface.

- Do not use any attachments other than those supplied by Conair Australia

Pty Ltd.

- Use this appliance only for its intended use as described within this

instruction booklet.

- Always unplug the appliance when fully charged.

- This appliance is not intended for commercial use.

- Never drop or insert any object into an opening.

- Do not use the appliance with damaged or broken attachment combs or with

any teeth missing from the blades, as injury may occur.

- Do not place on any surface while it is operating.

- Keep the cord away from heated surfaces

- Never twist or pull on the power cord.

- Do not use an extension cord with this appliance.

- After use do not wrap the cord around the appliance as in time this may cause

the cord to fracture. Coil cord loosely by the side of the appliance in storage.

- Do not use outdoors or operate where aerosol (spray) products are being

used or where oxygen is being administered.

- Do not use the appliance if it is damaged. In the event of damage, discontinue

use immediately and contact your dealer for instructions on returning it for

examination or exchange. If the supply cord is damaged, it must be replaced

by the manufacturer, its service agent or similarly qualified person in order

to avoid a hazard.

- Always ensure that the voltage to be used corresponds to the voltage marked

on the unit.

1. Diamond sharpened blades

2. 45mm pro clipping blade

attachment set

3. 30mm detail trimming

blade attachment set

4. DC direct drive motor

5. Charging light

6. 8 cutting comb guides

- grades #1 – 8 (3mm to

25mm) for cutting, shaping

& fading

7. Left + right ear taper

cutting comb guides for

the finishing touches

around the ears

8. 5 position taper control

9. Barber comb

10. Scissors

11. 3 hair sectioning clips

12. Blade guard

13. Durable storage case

14. Cleaning brush

15. Oil

THE CRAFTED CUT

BRAVO. YOU’VE MADE A QUALITY PURCHASE.

The Crafted Cut is the multi-purpose grooming tool for

clipping, shaping & detailing.

7 3

14 15

THE CRAFTED CUT / TOOL TIPS

PREPPING YOUR

NEW TOOL

CHARGING

The Crafted Cut clipper is so easy to use. But before you start using your new

tool, you must take the time to charge it overnight for 16 hours before its first

use. Your new tool comes with a small amount of charge, but the initial charge

will ensure your new tool will have optimum power performance to give you

smooth fast cutting, every time.

- Before using for the first time, fully charge your new tool continuously for

16 hours.

- Maximum battery capacity will only be reached after 3 charging &

discharging cycles.

- Ensure your new tool is switched off.

- Insert the small plug on the charging adaptor into the socket on the bottom

of your new tool.

- Plug the charging adaptor into a suitable mains power socket and switch on.

- The red charging LED indicator light on your new tool will remain on when

correctly connected to the mains power.

- A full charge will supply 60 minutes cordless runtime.

- To maintain optimum capacity of the rechargeable battery, it is highly

recommended to fully discharge & then recharge your tool for 16 hours every

6 months.

THE CRAFTED CUT / TOOL TIPS

OILING THE BLADES

To get the sharpest, most precise cut, it is highly recommended to oil the blades

before each use.

Using the oil supplied with your new tool, unscrew the cap & cut off the very end

of the plastic tube with a pair of scissors to release the oil.

Switch your tool on, gently squeeze the oil tube & apply 2 drops of oil onto the

blades. Leave the tool on for a further few seconds to allow the oil to thoroughly

spread across each of the blades. Switch off the tool & remove any excess oil by

gently dabbing with a cloth.

THE CRAFTED CUT / TOOL TIPS

HOW TO USE

THE CRAFTED CUT

BEFORE USING

• Always inspect the clipper blades for noticeable signs of damage.

• Ensure the clipper blades are well oiled before using.

• Always inspect the clipper blades before use to ensure they are free from

hair, debris etc.

• Ensure the clipper is sufficiently charged before use.

• For best performance use on clean, dry hair that has been combed until

tangle-free.

5 POSITION TAPER CONTROL

The 5 position taper control for is designed for blending layers & a precise close

trim, everytime.

• To increase the cutting length, push the lever down.

• To reduce the cutting length, push the lever up.

THE CRAFTED CUT / TOOL TIPS

EASY CLIPPING, YOUR WAY

The Crafted Cut features 8 cutting comb guide from grades #1 – 8 comb guides

(3mm to 25mm) for cutting, shaping & fading and left + right ear taper cutting

comb guides for the finishing touches around the ears.

The comb guides are marked with the following grade number:

Cutting Length Grade

3mm #1

6mm #2

9.5mm #3

13mm #4

16mm #5

19mm #6

22mm #7

25mm #8

Ear taper Left

Ear taper Right

• To attach a comb guide, ensure the appliance is switched off. Position the

comb guide over the front of the clipper blade and slide over the head. Push

and click the rear of the comb guide into position.

• To remove the comb guide, ensure the appliance is switched off. Push the tab

on the rear of the comb guide away from the head and lift off.

• To attach the ear comb guides, choose either the left or right guide depending

on which ear you are cutting above. Angle the clipper and gently stroke

around the ear towards the back of the neck.

Inhaltsverzeichnis

Andere VS Sassoon Elektrorasierer Handbücher

VS Sassoon

VS Sassoon ELITE CLIP VSM6000A Montageanleitung

VS Sassoon

VS Sassoon PRO METAL Series Bedienungsanleitung

VS Sassoon

VS Sassoon VSM725A Bedienungsanleitung

VS Sassoon

VS Sassoon VSM350A Bedienungsanleitung

VS Sassoon

VS Sassoon VS7050A Bedienungsanleitung

VS Sassoon

VS Sassoon VSM7898A Bedienungsanleitung

VS Sassoon

VS Sassoon The Crafted Trim VSM7847A Montageanleitung

VS Sassoon

VS Sassoon The Beard Designer Bedienungsanleitung

VS Sassoon

VS Sassoon VSM890A Bedienungsanleitung

VS Sassoon

VS Sassoon The Rugged Commander Lithium All-In-One Bedienungsanleitung

VS Sassoon

VS Sassoon THE GROOM CAPTAIN Montageanleitung

VS Sassoon

VS Sassoon THE ESSENTIAL CUT Montageanleitung

VS Sassoon

VS Sassoon i-Twin Trim VSM155A Bedienungsanleitung

VS Sassoon

VS Sassoon Metro Groom Bedienungsanleitung

VS Sassoon

VS Sassoon THE BEARD TRIM VSM7840A Montageanleitung

VS Sassoon

VS Sassoon VSM189RA Montageanleitung

VS Sassoon

VS Sassoon Xpert Beard VSM7865A Montageanleitung

VS Sassoon

VS Sassoon Xpert Groom Bedienungsanleitung

VS Sassoon

VS Sassoon THETRIMBUDDY VSM702A Montageanleitung

VS Sassoon

VS Sassoon Twin Trim VSM1A Montageanleitung

VS Sassoon

VS Sassoon Trim & Groom VSM856A Montageanleitung

VS Sassoon

VS Sassoon THE BEARD BUDDY VSM703A Montageanleitung

VS Sassoon

VS Sassoon Xpert Precision VSM50MA Bedienungsanleitung

VS Sassoon

VS Sassoon Metro Cordless HairCut VS704A Bedienungsanleitung

Beliebte Elektrorasierer Handbücher anderer Marken

Philips

Philips MicroAction 4402LC Bedienungsanleitung

Philips

Philips HQ7740 Bedienungsanleitung

Philips

Philips Norelco BG2022 Bodygroom Bedienungsanleitung

Norelco

Norelco Quadra 7610X Bedienungsanleitung

Philips

Philips 7616X Bedienungsanleitung

Philips

Philips HQ802 Bedienungsanleitung

Philips

Philips HQ7363/17 Bedienungsanleitung

Braun

Braun WaterFlex WF2s Bedienungsanleitung

Philips

Philips NORELCO S7371 Bedienungsanleitung

Daga

Daga MT-400 Handbuch

Remington

Remington BHT100 Bedienungsanleitung

Philips

Philips Bodygroom BG2000 Bedienungsanleitung

Kompernass

Kompernass KH 5537 Bedienungsanleitung

Remington

Remington BHT6100 Bedienungsanleitung

Philips

Philips qc5365 Bedienungsanleitung

MIA

MIA Aqua Body Bedienungsanleitung

Philips

Philips NORELCO AT880 Bedienungsanleitung

Matheo

Matheo MLR 15 Bedienungsanleitung