VS Sassoon I-Twin Trim VSM155A Bedienungsanleitung

Model VSM155A

i-Twin Trim

Dual BlaDe BaTTery Trimmer

INSTRUCTIONS FOR USE

1. Always purchase the correct size and grade of battery most suitable

for the intended use.

2. Replace all batteries of a set at the same time.

3. Clean the battery contacts and also those of the device prior to

battery installation.

4. Ensure the batteries are installed correctly with regard to polarity

(+ and -).

5. Remove batteries from equipment which is not to be used for an

extended period of time.

6. Remove used batteries promptly.

7. Store unused batteries in their original packaging, away from metal

objects that could short-circuit them. Never short-circuit batteries.

8. Never dispose of batteries in fire, except under conditions of

controlled incineration. Failure to observe this precaution may result

in an explosion. Never attempt to recharge primary batteries as this

may cause leakage, fire, or explosion.

9. Do not mix old and new batteries.

10. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel

cadmium or nickel metal hydride) batteries.

SavE ThESE INSTRUCTIONS FOR hOUSEhOLD USE ONLY

BEaRD & MUSTaChE TRIMMER

Dual trimming blade

5-position

comb attachment

The dual blade cutting system is designed to neatly, quickly and evenly trim

your beard, goatee, mustache, neckline and even close-cut stubble. While

both blades are used for trimming, the upper blade can easily be removed,

leaving the bottom blade for detailing fine lines and edging.

Multi-use trimmer

Jawline combs

Stubble comb

Upper trimming

blade

Single trimming

blade

OpERaTINg INSTRUCTIONS:

1. Remove the battery compartment cover by pushing in and down

toward the bottom of the trimmer. To assist in removing the batteries,

pull ribbon upwards.

2. Align the AAA batteries with the positive and negative positions

indicated inside the battery compartment. Being careful not to bend

the clips, insert the negative end of each battery first so it will slip

easily into position.

3. Return the battery cover to its original position by pushing it in and up

until you hear a small click as it locks into place.

4. To use your trimmer, push ON/OFF switch up wards to ON position.

5. After you finish using your trimmer, push down on the ON/OFF

switch to turn the trimmer off.

6. This trimmer comes with a detachable trimmer head. To remove,

make sure the trimmer is in the OFF position, turn the head

counterclockwise until “I” mark aligns with “arrow” mark on the back

of the body and then pull up. To attach trimmer head, align the “I”

mark with the “arrow” mark and then turn clockwise until the “I” and

“circle” marks align.

*Requires 3 AAA batteries (not included). We recommend using alkaline

batteries in your trimmer because they last longer.

TakINg CaRE OF YOUR TRIMMER

OILINg ThE BLaDES

About once a month you should oil the trimmer blades. It is best to do

this over a piece of newspaper. Turn the trimmer on and hold it so that

the blades are pointed downward. Spread one drop of oil across the

blades, wait a few seconds for the oil to disperse then turn the trimmer

off and wipe away the excess oil with a soft cloth.

Be careful not to use too much oil and don’t oil your trimmer more

than necessary, as this could damage the motor. (Never attempt to oil

the motor bearing, as it is permanently lubricated.) Keep oil away from

children.

BLaDE CaRE

Because the trimmer blades are precision-made for a very special use,

they should always be handled with care. Each time you finish using

the trimmer, take a cleaning brush and brush away any loose hair that

has collected in the blades. Be especially careful when changing or

adjusting blades. When you have your trimmer serviced, be sure that

both blades are sharpened or replaced at the same time. To promote

the long life of the appliance, use your trimmer only for the purpose

intended by the manufacturer – to trim your beard and mustache.

DUaL BLaDE TEChNOLOgY

The new dual blade technology features a detachable upper blade for

regular trimming and a lower blade that provides a close, even cut with

the first pass and can also be used as a detailing blade.

gROwINg a BEaRD aND MUSTaChE

There are three key factors that will determine which beard or mustache

style is best for you:

1. The shape and dimensions of your face.

2. The natural growth of your beard/ mustache.

3. The thickness of your beard/mustache. If you are unsure about the

type of beard or mustache that would most suit your face, speak with

a professional hair stylist and ask for an opinion on what style would

be best. Once your beard or mustache has been styled, it is essential

that you maintain its appearance. To do this, use your trimmer to

trim your beard/mustache weekly. For the best trimming results, your

beard should be slightly damp (NOT WET) when using your trimmer.

This will prevent the trimmer from removing more hair than desired.

TYpES OF BEaRDS/MUSTaChES gETTINg STaRTED:

The dual blade cutting system is designed to neatly, quickly and evenly

trim your beard, goatee, mustache, neckline and even close-cut stubble.

While both blades are used for trimming, the upper blade can easily be

removed, leaving the bottom blade for detailing fine lines and edging.

S1, J1, J2

5-POSITION

COMB

COMB gUIDES

The table below explains the trim length for each comb. You should

start out with a longer trim-length comb and work your way down to the

desired trim length.

Close stubble look

1mm trim

2mm trim

4mm, 6.5mm, 9mm,

11.5mm & 14mm trims

5-POSITION COMB

hOw TO USE ThE SINgLE DETaILINg TRIMMINg BLaDE UppER

BLaDE REMOvaL aND aTTaChMENT

The trimmer’s upper blade can be removed to use the single detailing

blade as shown in Fig. 1 and Fig. 2.

Fig.3 Fig.4

Step 3 Line up rear

tab with opening in lower

blade.

Step 4 Insert the rear tab,

slide forward until the 2 front

tabs drop in and the blade

snaps in place.

To reattach upper blade, see Fig. 3 and Fig. 4.

OUTLININg YOUR BEaRD

1. It is always best to begin with a clean, slightly damp

beard.

2. After you have combed through your beard in the

direction it grows naturally, you will want to outline

the desired shape, beginning under your jawline.

3. Begin defining your beard’s shape under your chin and work upward

on each side of your face toward your ears. Then define the upper

outline of your beard across your cheeks, past your sideburns, and

toward your hairline.

TRIMMINg YOUR BEaRD

1. The trimmer includes a five-position comb for use with the hair trimming

blade (4–14mm). Each position increases the length by 2.5mm.

2. To use the 5-position comb, slide the unit over the trimmer blade and

snap it down into position. At first, until you become familiar with the

adjustments, use the longest trim setting. (You can always go back

and make your beard a little shorter.)

3. Begin trimming your beard using smooth, even strokes. Start with

your sideburns and work downward toward your chin. (Never attempt

to trim against the natural growth of your beard because the hair will

be cut too short.)

4. If you decide you want a closer trim, you can now

adjust the 5-position comb attachment to a

shorter setting (such as 4mm or 6.5mm) and go

over your beard again until you achieve the

desired length.

BLENDINg ThE JawLINE

1. The two jawline attachments will help you to achieve a neat, finished

trim under your chin. To use one of the attachments, press it down

over the trimmer blades until it clicks into position (jawline J1 provides

1mm and jawline J2 provides 2mm).

2. Hold the trimmer in an upright position and begin trimming under

your jawline, using short, even strokes.

3. After your beard is blended, turn off the trimmer and remove the

attachment by gently pulling up on tab.

TO TRIM YOUR MUSTaChE

1. For best results, start with a clean, slightly damp

mustache.

2. Comb through your mustache in the direction it

grows.

3. Place the 5-position comb over the facial hair blade

and snap it into position. It is a good idea to start

with the longest trim setting adjustment. (You can

always go back and cut your mustache more closely

with a shorter setting.)

aLwaYS TRIM YOUR MUSTaChE FROM ThE TOp DOwN

4. After your mustache has been trimmed to the desired

length, remove the 5-position comb and, using the

blades only, define the outline of the bottom of your

mustache.

5. Use the single detailing blade for fine detail trimming

and edging.

hOw TO gET ThE STUBBLE LOOk

This trimmer includes 1 stubble comb. Comb #1 is close to the skin. The

stubble comb fits on the blade just like the jawline combs (note blending

the jawline section for specifics on how combs/jawline combs go on).

ON/OFF SwITCh

To operate, simply slide switch toward blade; to stop push slide away

from blade.

CaRE OF YOUR TRIMMER

REpLaCEMENT (REMOvaL) OF BLaDE SET

Before storing your trimmer, use a cleaning brush to whisk

away any loose hair from the unit and the blades. You should

remove the blade set after a few uses to clean between the

blades. To remove entire blade set from your trimmer, make

sure the trimmer is in the OFF position. Remove the blade set

by placing thumb against the smaller cutter and pushing

forward, releasing the cutter assembly from the trimmer

housing. Replace with new cutting system and reverse the removal proce-

dure, only this time place your thumb on the large cutter and snap into

place.

Inhaltsverzeichnis

Andere VS Sassoon Elektrorasierer Handbücher

VS Sassoon

VS Sassoon THE GROOM CAPTAIN Montageanleitung

VS Sassoon

VS Sassoon Xpert Groom Bedienungsanleitung

VS Sassoon

VS Sassoon VS7050A Bedienungsanleitung

VS Sassoon

VS Sassoon SUPER BEARD XTP VSM7876A Montageanleitung

VS Sassoon

VS Sassoon VSM2330A Montageanleitung

VS Sassoon

VS Sassoon VSM7472A Bedienungsanleitung

VS Sassoon

VS Sassoon LITHIUM-PRO GROOM BUDDY VSM7420A Montageanleitung

VS Sassoon

VS Sassoon THE BEARD TRIM VSM7840A Montageanleitung

VS Sassoon

VS Sassoon VSM7318A Montageanleitung

VS Sassoon

VS Sassoon The Beard Designer Bedienungsanleitung

VS Sassoon

VS Sassoon THETRIMBUDDY VSM702A Montageanleitung

VS Sassoon

VS Sassoon Metro Groom Bedienungsanleitung

VS Sassoon

VS Sassoon THE BEARD BUDDY VSM703A Montageanleitung

VS Sassoon

VS Sassoon The Rugged Commander Lithium All-In-One Bedienungsanleitung

VS Sassoon

VS Sassoon Xpert Beard VSM7865A Montageanleitung

VS Sassoon

VS Sassoon The All-Rounder VSM837A Montageanleitung

VS Sassoon

VS Sassoon PRO METAL Series Bedienungsanleitung

VS Sassoon

VS Sassoon VSM890A Bedienungsanleitung

VS Sassoon

VS Sassoon VSM189RA Montageanleitung

VS Sassoon

VS Sassoon Metro Cordless HairCut VS704A Bedienungsanleitung

VS Sassoon

VS Sassoon VS7895A Bedienungsanleitung

VS Sassoon

VS Sassoon ELITE CLIP VSM6000A Montageanleitung

VS Sassoon

VS Sassoon VS7053A Bedienungsanleitung

VS Sassoon

VS Sassoon Trim & Groom VSM856A Montageanleitung

Beliebte Elektrorasierer Handbücher anderer Marken

Philips

Philips MicroAction 4402LC Bedienungsanleitung

Philips

Philips HQ7740 Bedienungsanleitung

Philips

Philips Norelco BG2022 Bodygroom Bedienungsanleitung

Norelco

Norelco Quadra 7610X Bedienungsanleitung

Philips

Philips 7616X Bedienungsanleitung

Philips

Philips HQ802 Bedienungsanleitung

Philips

Philips HQ7363/17 Bedienungsanleitung

Braun

Braun WaterFlex WF2s Bedienungsanleitung

Philips

Philips NORELCO S7371 Bedienungsanleitung

Daga

Daga MT-400 Handbuch

Remington

Remington BHT100 Bedienungsanleitung

Philips

Philips Bodygroom BG2000 Bedienungsanleitung

Kompernass

Kompernass KH 5537 Bedienungsanleitung

Remington

Remington BHT6100 Bedienungsanleitung

Philips

Philips qc5365 Bedienungsanleitung

MIA

MIA Aqua Body Bedienungsanleitung

Philips

Philips NORELCO AT880 Bedienungsanleitung

Matheo

Matheo MLR 15 Bedienungsanleitung

VS Sassoon i-Twin Trim VSM155A Bedienungsanleitung

Beliebte Elektrorasierer Handbücher anderer Marken