Windsor ADMIRAL ADM8IA - 10080010 Bedienungsanleitung

Read these instructions before operating the machine

Lire ce manuel avant d’utiliser la machine

Bitte lesen Sie diese Anleitungen, bevor Sie die Maschine in Gebrauch nehmen

MODEL: COUNTRY

ADM8IA - 10080010 AUSTRALIA

ADM8IB - 10080020 BRITIAN

ADM8IE - 10080030 EUROPE

ADM8IS - 10080040 SWITZERLAND

Operating Instructions (GB/USA)

Manuel d’utilisation (FRE)

Bedienungsanleitung (GER)

86038270 10/12/07

PRV NO. 98655

CARPET EXTRACTOR

IPX4

TABLE OF CONTENTS

ADMIRAL 86038270 05/22/07

Data Log/Table of Contents..............1

Safety Instructions............................2

Controls ............................................3-5

Operations........................................6-11

Troubleshooting................................12

Blank Page .......................................13

Wiring Diagram.................................14

Maintenance..................................... 15-17

Technical Specifications................... 18

Parts Lists......................................... 19-34

Spare Parts/Notes............................ 35

EC Declaration of Conformity........... 36

INSPECTION

Carefully unpack and inspect your machine for shipping damage. Each unit is operated and thoroughly inspected

before shipping, and any damage is the responsibility of the carrier, who should be notified immediately.

MODEL

DATE OF PURCHASE

SERIAL NUMBER

SALES REPRESENTATIVE #

DEALER NAME

SAFETY INSTRUCTIONS

ADMIRAL 86038270 05/22/07 2

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precaution

must always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE.

This machine is for commercial use.

To reduce the risk of fire, electric shock, or injury:

Connect to a properly grounded outlet.

Do not leave the machine unattended. Unplug machine from outlet when not in use and before

maintenance or service.

Use only indoors. Do not use outdoors or expose to rain.

Do not allow machine to be used as a toy. Close attention is necessary when used by or near

children.

Use only as described in this manual. Use only manufacturer’s recommended components and

attachments.

Do not use damaged electrical cord or plug. Follow all instructions in this manual concerning grounding

the machine. If the machine is not working properly, has been dropped, damaged, left outdoors, or

dropped into water, return it to an authorized service center.

Do not pull or carry machine by electrical cord, use as a handle, close a door on cord, or pull cord

around sharp edges or corners.

Do not run machine over cord. Keep cord away from heated surfaces.

Do not unplug machine by pulling on cord. To unplug, grasp the electrical plug, not the electrical cord.

Do not handle the electrical plug or machine with wet hands.

Do not operate the machine with any openings blocked. Keep openings free of debris that may reduce

airflow.

This machine is intended for cleaning carpet only.

Do not vacuum anything that is burning or smoking, such as cigarettes, matches, or hot ashes.

This machine is not suitable for picking up health endangering dust.

Turn off all controls before unplugging.

Machine can cause a fire when operating near flammable vapors or materials. Do not operate this

machine near flammable fluids, dust or vapors.

This machine is suitable for commercial use, for example in hotels, schools, hospitals,

factories, shops and offices for more than normal housekeeping purposes.

Maintenance and repairs must be done by qualified personnel.

If foam or liquid comes out of machine, switch off immediately.

SAVE THESE INSTRUCTIONS

WARNING:

CONTROLS/COMPONENT LOCATIONS

ADMIRAL 86038270 05/22/07

1. Main Handle. Used to pull and maneuver

machine.

2. Handle Adjustment. Used to adjust height of

handle.

3. Electrical Cord.

4. Solution Switch. Turns on pump. Continuous

position (bottom) activates electro-valve to

dispense solution to floor through jets.

Intermittent position (up) requires operator to

depress 1 of 3 trigger switches to dispense

solution. Center position is off.

5. Brush Motor Switch. Turns on brush motor.

6. Vacuum Motor Switch. Turns on vacuum

motor.

7. Trigger Switches. Activates electro-valve to

dispense solution to floor through jets when

solution switch is in the intermittent position.

8. Brush Motor Circuit Breaker. 4 amp.

Breaker protecting brush motor.

9. Vacuum Motor Circuit Breaker. 7 amp.

Breaker protecting vacuum motor.

10. Recovery Dump Hose. Facilitates draining

dirty cleaning solution.

11. Solution Dump Hose. Facilitates draining

excess cleaning solution from solution tank.

8 9 4 6

CONTROLS/COMPONENT LOCATIONS

ADMIRAL 86038270 05/22/07

1. Solution Accessory Tool Hookup. Used

for various auxiliary cleaning tools.

2. Vacuum Hose Door. Used to connect

various auxiliary 1 ½ inch cleaning tool

vacuum hoses.

3. Brush Height Adjustment. Used to

regulate brush height from storage position

to various carpet heights.

4. Recovery Tank. Used to collect dirty

cleaning solution.

5. Solution Tank. Used to hold cleaning

solution.

6. Recovery Tank Dome.

7. Vacuum Shoe.

8. Brush Housing.

9. Front Lifting Handle.

10. Cleaning Solution Filter.

11. Solution Tank Fill Hose.

CONTROLS/COMPONENT LOCATIONS

ADMIRAL 86038270 05/22/07

1. Solution Intake Cover.

2. Vacuum Intake Cover.

3. Float Shut-Off.

4. Clean-Out Opening.

5. Pour Spout.

6. Lift Handle.

2 1

FILLING OPERATIONS

ADMIRAL 86038270 05/22/07 6

FILLING THE ADMIRAL

NOTE: Use clean bucket of water to fill solution tank

Do not put defoamer, solvents, spotter or

prespray chemicals in the solution tank.

Do not allow water to spill into vacuum motor inlet. Dry

spillage from top of solution tank before replacing

recovery tank.

CHEMICALS

Suitable Chemicals Non-Compatible Chemicals

Alkalis Aldehydes

Detergents Aromatic Hydrocarbons

Hydroxides SP Butyls

Soaps Carbon Tetrachloride

Vinegar Clorox*

Chlorinated Bleaches

Chlorinated Hydrocarbons

Lysol*

Methyl Ethel Ketone (MEK)

Perchorethylene (perc)

Phenolics

Trichlorethylene

D-Limonene

* Product Trademark Names

STEP

RECOVERY TANK

SOLUTION

TANK

Remove recovery

tank

FILL LINE

Replace recovery

tank

dd cleaning

chemical

8 – 16oz.

(237ml – 473ml)

dd water

8 gal.

(30.3 ltr.)

140°F

(

60°C

)

OPERATIONS

ADMIRAL 86038270 05/22/07

Remove electrical cord and literature

from recovery tank. Fill solution tank

(see filling instructions page 6).

Adjust brush to proper setting. Note:

For good operation the brush must

skim the carpet. If circuit breaker

trips raise brush to prevent damage

to motor or carpet.

Plug cord into grounded outlet. Note:

Be sure dome is seated on recovery

tank, and float shut-off is installed

correctly.

Turn on brush and vacuum motor

switches (“ON”=“I”). Turn on solution

switch for continuous spray or set

switch to intermittent to allow use of

trigger switches.

STEP

CORRECT

INCORRECT

1/8in

(3mm)

SOLUTION VACUUM

CONT

INT BRUSH ONON

OPERATIONS

ADMIRAL 86038270 05/22/07 8

Select continuous setting to start

solution spray or select intermittent

setting to enable use of trigger

switches to start solution spray.

The intermittent setting requires the

operator to hold any one of the

three trigger switches in the “on”

position with the fingers, and is

typically used in small areas where

short cleaning passes are made.

The continuous setting allows the

operator to set the switch in the “on”

position with one touch, and is

typically used in large areas where

long cleaning passes are made.

Lower machine to floor.

Adjust handle to comfortable

operating position. Tip machine

back by main handle to move to

starting point.

STEP

INT

CONT

CLEANING PROCEDURE

ADMIRAL 86038270 05/22/07

Release intermittent trigger

switches or turn off continuous

setting on solution switch

approximately 1 foot before ending

cleaning pass.

Push down on handle to raise

vacuum shoe and brush before

moving to the next cleaning pass.

Overlap brush contact area a

minimum of 1inch on the right

(close cleaning) side of machine.

During operation, observe the following:

The Admiral is equipped with clear

internal covers to facilitate operator

viewing of dirty solution and vacuum air

flow.

During operation, observe the vacuum

intake cover. Large amounts of water or

foam entering the vacuum system can

damage the vacuum motor. If you

notice either condition, shut down the

machine immediately. Empty recovery

tank and/or add defoamer to recovery

tank.

STEP

Start at wall closest to power outlet.

Pull straight back without pushing

down on handle.

STEP

SOLUTION

INTAKE COVER

VACUUM

INTAKE COVER

1in.

(25mm)

OFF

1ft.

(30cm)

Andere Handbücher für ADMIRAL ADM8IA - 10080010

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Windsor Bodenreinigungsmaschine Handbücher

Windsor

Windsor CMPS2 Bedienungsanleitung

Windsor

Windsor SABER S28 Bedienungsanleitung

Windsor

Windsor DOMINATOR D250 Bedienungsanleitung

Windsor

Windsor Cadet 7 CDT7I Bedienungsanleitung

Windsor

Windsor VOYAGER E Bedienungsanleitung

Windsor

Windsor 10020430 Bedienungsanleitung

Windsor

Windsor COMMODORE CMD Bedienungsanleitung

Windsor

Windsor Chariot iGloss 20 Bedienungsanleitung

Windsor

Windsor passport Bedienungsanleitung

Windsor

Windsor SCC172 Bedienungsanleitung

Windsor

Windsor ADMIRAL Admiral 8 Bedienungsanleitung

Windsor

Windsor Voyager 2 VGR2 Bedienungsanleitung

Windsor

Windsor CB20 Bedienungsanleitung

Windsor

Windsor Chariot 2 iVac 24 AVT Bedienungsanleitung

Windsor

Windsor Commodore 20 Bedienungsanleitung

Windsor

Windsor 1.022-322.0 Technische Daten

Windsor

Windsor Dri-Matic Bedienungsanleitung

Windsor

Windsor MERiT 2000 Bedienungsanleitung

Windsor

Windsor CDT7IA/10080050 Bedienungsanleitung

Windsor

Windsor PRESTO! PRSIFB2 Bedienungsanleitung

Windsor

Windsor BDP 51/2000C Bedienungsanleitung

Windsor

Windsor Admiral ADM8 Bedienungsanleitung

Windsor

Windsor CLP Bedienungsanleitung

Windsor

Windsor Chariot iScrub Bedienungsanleitung

Beliebte Bodenreinigungsmaschine Handbücher anderer Marken

Nilfisk-Advance

Nilfisk-Advance Advance SC370 17B Bedienungsanleitung

Numatic

Numatic ET 4045 Bedienungsanleitung

HAWK ENTERPRISES

HAWK ENTERPRISES HP1513-180BRUTE Bedienungsanleitung

Mytee

Mytee 8070 Mytee-Lite Bedienungsanleitung

Kärcher

Kärcher B 140 R Bedienungsanleitung

Triple S

Triple S Ace 26T1 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SW 750 Bedienungsanleitung

Tornado

Tornado Marathon 2000 98190 Handbuch

Numatic

Numatic TTB 1117/100 Bedienungsanleitung

Tennant

Tennant 8210D Bedienungsanleitung

Nobles

Nobles Frontier Produkthandbuch

lavina

lavina 21-X Bedienungsanleitung

KENT

KENT Edge 28B Bedienungsanleitung

Tennant

Tennant 215 Produkthandbuch

CleanFreak

CleanFreak DURA-18HD Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Warrior 34RST Administratorhandbuch

BETCO

BETCO PB24 Bedienungsanleitung

IPC

IPC CT51-71 BT Bedienungsanleitung