ACME MACE Bedienungsanleitung

User Manual

www.prolight.co.uk

Contents

1. Safety Instructions .................................................................................................... 2

2. Features..................................................................................................................... 3

3. Technical Specifications ........................................................................................... 3

4. Installation ................................................................................................................ 3

5. Control Panel ............................................................................................................ 4

6. Troubleshooting ........................................................................................................ 5

7. Cleaning And Maintenance ...................................................................................... 5

1. Safety Instructions

Warning

!Please keep this User Guide for future consultation. If you sell the fixture to another user, be

sure that they also receive this instruction booklet.

Cautions:

!All fixtures are intact from the manufacturer, please operate follow up the user manual,

artificial fault are not under guarantee repair.

!Unpack and check carefully there is no transportation damage before using the fixture.

!Be sure that no ventilation slots are blocked, otherwise the fixture will be overheated.

!Before operating, ensure that the voltage and frequency of power supply match the power

requirements of the fixture.

!Use in a dry location.

!It’s important to ground the yellow/green conductor to earth in order to avoid electric shock

(Class 1)

!Maximum ambient temperature is 40°. Don’t operate it where the temperature is higher than

this.

!First run, there will be smoke or smells, and all disappearing a few minutes later.

!Make sure there are no flammable materials close to the fixture while operating, as it is fire

hazard.

!Look over power wires carefully, replace immediately if there is any damage.

!Fixture surface temperature may reach up to 65°. Don’t touch the housing bare-hand during its

operation.

!Never run on for a long time lest shortening lifespan.

!Do not operate in dirty and dusty environment, also cleaning fixtures regularly.

!Do not allow children to operate the fixture.

!Never turn on and off the fixture time after time.

!The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged.

!Do not open the fixture as there are no user serviceable parts inside. Never try to repair the

fixture by yourself. Repairs carried out by unskilled people can lead to damage or malfunction.

Please contact the nearest authorised technical assistance center.

!Disconnect the mains power if the fixture is not used for a long time.

Please read the instructions carefully which includes important

information about the installation, operation and maintenance.

2. Features

!Great built-in programs triggered by music

!3 balls rotating speed can be adjustable by a knob

!2 Operation Modes: Sound Activation, Automatic selectable via switch

!Low heat, Low power consumption, no duty cycle, runs all the night

!Colour Mix Effect

!Suitable for theaters, studios, retail stores, and other similar locations.

3. Technical Specifications

!Power supply:AC 100V~240V, 50/60Hz

!Power Consumption: 21.4W

!Coverage: 360°

!LED Sources: 6 x 3W RGB LEDs

!Dimension: 313 x 287.5 x 254mm

!Weight: 2.2Kgs

4. Installation

The fixture should be mounted via its screw holes on the bracket. Always ensure that the fixture

is firmly fixed to avoid vibration and slipping while operating. Always ensure that the structure to

which you are attaching the fixture is secure and is able to support a weight of 10 times of the

fixture’s weight. Also always use a safety cable that can hold 12 times of the weight of the fixture

when installing the fixture.

5. Control Panel

1. Potentiometer Knob: Adjust the rotation speed of the motor:

The speed at which this unit spins can be adjusted by turning the knob. When the knob is turned

all the way counter-clockwise it will spin the slowest at 21 r.p.m. By turning the knob

clockwise you can increase the rate of speed 21 r.p.m. to the fastest rate at 35 r.p.m.

2. Power Switch: Control the mains power On or Off.

3. Power Cable: Connect to the power supply.

6. Troubleshooting

If the fixture does not work, no light, please check the connection of power cable, also measure the

mains voltage on the main connector

7. Cleaning And Maintenance

The cleaning must be carried out periodically to optimize light output. Cleaning frequency depends

on the environment in which the fixture operates: moist, smoky or particularly dirty surrounding

can cause greater accumulation of dirt on the fixture.

!Clean with lint-free cloth using normal glass cleaning liquid.

!Always dry the parts carefully.

!Clean the surface at least every 30 days.

!Never use alcohol or solvents.

Declaration of Conformity

We declare that our products (lighting equipments) comply with the

following specification and bears CE mark in accordance with the

provision of the Electromagnetic Compatibility (EMC) Directive

2004/108/EC.

EN55103-1: 2009 ; EN55103-2: 2009;

EN61000-3-2: 2006 + A1:2009 + A2:2009; EN61000-3-3: 2008.

Harmonized Standard

EN 60598-1:2008 + All:2009; EN 60598-2-17:1989 + A2:1991;

EN 62471:2008; EN 62493: 2010

Safety of household and similar electrical appliances

Part 1: General requirements

Innovation, Quality, Performance

Inhaltsverzeichnis

Andere ACME DJ-Equipment Handbücher

ACME

ACME SAMBA Color Bedienungsanleitung

ACME

ACME LED-BL8 Bedienungsanleitung

ACME

ACME Dotline 360 Bedienungsanleitung

ACME

ACME Stage Blinder P4 Bedienungsanleitung

ACME

ACME E-10 WW DXX Bedienungsanleitung

ACME

ACME LED-737 Bedienungsanleitung

ACME

ACME RAYZOR HYBRID XA-100 BSW Bedienungsanleitung

ACME

ACME MP-400Z IP Bedienungsanleitung

ACME

ACME Theatre LED Colour Flood Bedienungsanleitung

ACME

ACME WHACK XP-231 BEAM Bedienungsanleitung

ACME

ACME Elf Laser Bedienungsanleitung

ACME

ACME Color Fusion CF-805 Bedienungsanleitung

ACME

ACME AE-610 BEAM Bedienungsanleitung

ACME

ACME CEILING 40 Bedienungsanleitung

ACME

ACME LED-Exercet Bedienungsanleitung

ACME

ACME E-10C WW DXX Bedienungsanleitung

ACME

ACME MINI ELLIPSOIDAL 10 Bedienungsanleitung

ACME

ACME LED-BL4B Bedienungsanleitung

ACME

ACME FURY LED RGB Bedienungsanleitung

ACME

ACME Genesis move 25R Bedienungsanleitung

ACME

ACME Dragonfly Quad Bedienungsanleitung

ACME

ACME LED-635S Bedienungsanleitung

ACME

ACME MP-90 RGBW Bedienungsanleitung

ACME

ACME XP-1000WZ Bedienungsanleitung

Beliebte DJ-Equipment Handbücher anderer Marken

ALPHA LITE

ALPHA LITE ALPHA 1500 Betriebsanleitung

Chauvet

Chauvet OVATION E-930VW Bedienungsanleitung

Zumtobel

Zumtobel APHRODITE Home Bedienungsanleitung

Snow Masters

Snow Masters Zig Oscillator Bedienungsanleitung

EuroLite

EuroLite 50530554 Bedienungsanleitung

Beamz

Beamz BUV243 Bedienungsanleitung

thomann

thomann Stairville DJ Lase 40-G MK-III Bedienungsanleitung

Eagletone

Eagletone 6 Eyes Flower Bedienungsanleitung

EuroLite

EuroLite FLD-1508 Bedienungsanleitung

Technical Pro

Technical Pro LG8xSEA Bedienungsanleitung

JB Systems

JB Systems Lounge Laser DMX Bedienungsanleitung

Lightmaxx

Lightmaxx Vega Halo 90 Bedienungsanleitung

Elation

Elation FUZE WASH Z350 Bedienungsanleitung

Maverick

Maverick MK3 WASH Bedienungsanleitung

Infinity

Infinity TF-260C7 Fresnel Bedienungsanleitung

Chauvet

Chauvet EVE E-50Z Bedienungsanleitung

Eliminator Lighting

Eliminator Lighting E 138 Bedienungsanleitung

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Bedienungsanleitung