Argo Dream IP21 Bedienungsanleitung

V 06/16

OPERATING INSTRUCTIONS

Read the instructions carefully before operating the appliance or carrying out maintenance

operations.

Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or

damage. Store these instructions in a safe place for future reference.

CERAMIC FAN HEATER for BATHROOM USE – IP21

V 06/16

GENERAL SAFETY INFORMATION

Use this fan heater only as outlined in this manual. Any other use

not recommended by the manufacturer may cause fire, electric

shock or injury to persons.

Make sure that the type of mains power complies with the electrical

requirements of the fan heater (220-240 V~/50 Hz).

This appliance can be used by children aged from 8 years and

above and people with reduced physical, sensory or mental

capabilities or lack of experience and knowledge if they have been

given supervision or instruction concerning use of the appliance in a

safe way and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children

without supervision.

This product is not a toy. Children under the age of 3 years must be

kept out of reach unless properly supervised, to ensure that they do

not play with the appliance.

Children aged between 3 and 8 years must only be able to turn the

appliance on/off, provided that the appliance has been placed in its

normal operating position, that instructions have been given on how

to use the equipment safely, and that its risks have been

understood.

Children aged between 3 and 8 years must not be able to plug in,

adjust, clean or perform any maintenance on the appliance.

WARNING: certain parts of this product may become very hot and

cause burns. Special care should be taken when children and

vulnerable people are nearby.

To avoid the risk of accidentally resetting the thermal protection, this

appliance must not be powered through an external switching

device, such as a timer, or connected to a circuit that is switched on

and off by the utility.

WARNING: do not use the fan heater with a controller or any

other device that activates the appliance automatically, as

there may be a risk of fire if the fan heater is covered or

incorrectly positioned.

Do not restrict the air inlet and outlet grilles.

The appliance heats up significantly when running and can cause

burns. Avoid unprotected contact with the hot surface.

V 06/16

Keep flammable materials, such as furniture, cushions, blankets,

paper, cloths, curtains and similar items at least 1 m away from the

front, sides and back of the appliance.

Disconnect the mains power when the appliance is not in use or

during cleaning.

Avoid using the fan heater in dusty environments or in the presence

of flammable vapours (e.g. in workshops or garages).

Do not place anything on the product; avoid placing wet garments

on the fan heater.

Use the fan heater in a well-ventilated area.

Avoid placing fingers or foreign objects in the air inlet/outlet grilles,

as this may lead to electric shock or fire and may damage the

appliance.

To prevent the risk of fire, do not block the grilles or tamper with

them in any way while the fan heater is in use.

Do not use the appliance if the power cord or plug are

damaged. Contact a service centre to replace a damaged power

cord, so as to avoid any safety risks.

Do not use the appliance if it has fallen from a certain height or if it

has been damaged in any way. Contact a service centre to check

the fan heater or make any necessary electrical or mechanical

repairs.

The most common cause of overheating is the build-up of dust in

the appliance. Remove the accumulated dust by pulling out the plug

and cleaning the grilles using a vacuum cleaner.

Do not use any abrasive products to clean the appliance. Clean it

using a damp cloth (not wet) rinsed with soapy water. Remove the

plug from the socket before performing any maintenance.

To disconnect the fan heater, turn the switch to OFF and remove

the plug from the socket. Pull on the plug only. Do not pull on the

cord when turning off the fan heater.

Do not place any objects on the cable and avoid bending the latter.

Extension cords are not advisable, as they may overheat and cause

the risk of fire. Never use a single extension cord to operate multiple

appliances.

Do not immerse the power cord, plug or any other part of the

appliance in water or other liquids.

Do not touch the plug with wet hands.

Do not place the fan heater above or near another heat source.

V 06/16

WARNING: AVOID COVERING THE FAN HEATER TO PREVENT IT

FROM OVERHEATING.

The symbol below signals this warning:

The fan heater may cause the risk of fire if, while operating, it is

covered or comes into contact with flammable material including

curtains, drapery, blankets, etc. KEEP THE FAN HEATER AWAY

FROM THESE MATERIALS.

Do not connect the fan heater to the power supply until it has been

correctly assembled or positioned.

Do not run the cord under carpets. Do not cover the cord with

blankets, carpets or similar materials. Place the cord far away from

busy areas, or in a place where it cannot be pulled out accidentally.

Do not operate the fan heater in close proximity to bathtubs,

showers, washbasins or pools.

The appliance is equipped with IP21 protection for use in private

bathrooms in Zone 3.



Do not position the fan heater beneath a power socket.

Do not operate the appliance outdoors.

Upon initial start-up, the fan heater may emit a slight, harmless

smell. This smell is a normal effect of the initial heating up of the

internal heating elements, and should not recur later on.

WARNING:

THE ON/OFF SWITCH IS NOT THE ONLY METHOD OF

DISCONNECTING THE MAINS POWER.

ALWAYS UNPLUG THE APPLIANCE DURING MAINTENANCE

OPERATIONS, WHEN MOVING IT OR WHILE IT IS NOT IN USE.

Zone 3 Zone 2 Zone 1

Zone 0

V 06/16

A fan heater contains parts that generate electrical arcs and sparks.

It must not be used in potentially dangerous areas such as those

subject to the risk of fire or explosion, or areas filled with chemical

substances or humidity.

Do not use the appliance on soft surfaces such as beds, where the

grilles may get covered. Always rest the fan heater on a flat and

stable surface when it is running, so as to prevent it from toppling

over. Arrange the cord so that the fan heater and other objects do

not rest on it.

Always unplug the appliance when it is not in use.

Turn the appliance off if unattended, in order to prevent accidents.

In the event of any anomalies (abnormal noise or a strange smell),

immediately turn off the appliance; do not attempt to repair it but

take it to your local service centre.

DESCRIPTION OF PARTS

1. Hot air outlet grille

2. Presence sensor

3. Front panel

4. Rear panel

5. ON/OFF switch

6. Power cord

7. Dust filter

8. Filter cover

HOW TO USE THE FAN HEATER

Place the fan heater in a vertical position on a flat and stable surface.

Install the filter inside the rear cover and re-close the latter.

Connect the power cord to a suitable electric socket (220-240 V~/50 Hz).

Use the handle to move the appliance.

V 06/16

CONTROL PANEL

Move the switch-on button (on the rear, beneath the air intake grille) to position ‘I’. When the appliance emits a beep, this

means that the fan heater is ready for use (stand-by). The STAND-BY LED is lit.

By pressing the STAND-BY button ‘ ’, the appliance will start functioning in NORMAL mode, at the

COMFORT heat level .

At this stage it is possible to leave the NORMAL operating mode or select the BODY-SENSOR mode (activation

of the PRESENCE SENSOR): the corresponding LED will light up.

In both the NORMAL and in the BODY-SENSOR modes, it is possible to select the COMFORT mode

(maximum heat 2000 W) or the ECO mode (minimum heat 1300 W) or cool ventilation (seq.). It is also

possible to set the timer for switch-off, after 1, 2 or 4 hours.

When the COMFORT mode is selected, the appliance will first operate for 10” at minimum power before

activating the maximum heat mode.

If the unit is operating and the STAND-BY button is pressed, the unit will continue to ventilate for a few minutes

before switching off completely, to cool the ceramic heating element.

If the unit has been in stand-by mode for quite some time, so that the heating element has already cooled

down, pressing the ON/OFF button causes the unit to switch off instantly, without ventilating.

In the BODY-SENSOR mode: every 2 minutes the unit detects the presence of people in the room, in the range

of approximately 2 metres. If is does not detect anyone and the ECO or COMFORT modes have been selected,

the heating element switches off but the fan will continue operating for 8 minutes: the unit will then enter the

stand-by mode. If the cold ventilation mode is selected, the fan will continue to operate for 10 minutes before

entering the stand-by mode.

To switch off the fan heater completely, move the on/off button to the “0” position.

STAND-BY

LED

OPERATING

MODE LED

1. STAND-BY BUTTON

2. SELECTION BUTTON

operation without PRESENCE

SENSOR (NORMAL) or with

PRESENCE SENSOR (BODY-S)

3. OPERATING MODE BUTTON

COMFORT – maximum heat (2000 W)

ECO – minimum heat (1300 W)

ventilation only

(repetition sequence)

4. TIMER BUTTON:

with the unit operating it

allows for programming the

switch-off after 1, 2 or 4

hours, by pressing it once,

twice or three times

(repetition sequence)

NORMAL or

BODY-SENSOR

MODE LED

TIMER LED

V 06/16

The appliance is equipped with an anti-tipping device which interrupts operation when the product is tilted.

Do not position the appliance on its side or upside down.

CAUTION: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE OPERATIONS.

IMPORTANT: DO NOT IMMERSE THE CERAMIC FAN HEATER IN WATER

Cleaning the outside surface of the appliance

Use a soft cloth to remove any dust from the fan heater.

If the fan heater is excessively dirty, use a soft cloth dampened with water and neutral detergent at a temperature below

50°C. Leave the fan heater to dry completely before using it again.

Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. When cleaning the

appliance, do not use oils, chemical substances or other items that may damage the surface.

Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.

Monthly cleaning the air filter, if necessary.

Remove the air filter for cleaning as shown in the diagram below.

If the appliance is cleaned with water, make sure that the air filter is dry before re-installing it onto the

appliance.

STORAGE

If the appliance is not used for prolonged periods, it must be stored together with this manual in its original packaging, in a

cool and dry place.

MAINTENANCE AND STORAGE

INFORMATION ON THE CO

RRECT DISPOSAL OF THE PRODUCT, PURSUANT TO DIRECTIVE 2012/19/EU ON WASTE

ELECTRICAL AND ELECTRONIC EQUIPMENT

At the end of its useful life, this appliance must not be disposed of together with household waste. We call your attention to the

crucial role played by the consumer in the reuse, recycling and other forms of recovery of such waste.

The appliance must be disposed of at a registered local authority collection point or returned free of charge to the retailer on

purchase of a new like-for-like product.

Sorted disposal of electric and electronic equipment prevents the negative effects on the environment and human health resulting

from improper scrapping, and also allows the materials from which it is made to be recovered and recycled, with significant savings

in terms of energy and resources.

The sorted disposal requirement is indicated by the crossed out waste bin label displayed on the appliance.

Filte

Cover

Inhaltsverzeichnis

Andere Argo Heizung Handbücher

Argo

Argo WILMA Bedienungsanleitung

Argo

Argo LOXO Bedienungsanleitung

Argo

Argo Symphony Bedienungsanleitung

Argo

Argo MARGE Bedienungsanleitung

Argo

Argo Sleek Bedienungsanleitung

Argo

Argo Soultt Bedienungsanleitung

Argo

Argo CLOE Bedienungsanleitung

Argo

Argo HIFAN Black Bedienungsanleitung

Argo

Argo ARKE TOWER Bedienungsanleitung

Argo

Argo HI FLOOR RAY Bedienungsanleitung

Argo

Argo CULT Bedienungsanleitung

Argo

Argo SPLITTO Leitfaden

Argo

Argo IP24 Bedienungsanleitung

Argo

Argo BOBO Bedienungsanleitung

Argo

Argo WHISPER 9 Bedienungsanleitung

Argo

Argo HIFAN HiFi Bedienungsanleitung

Argo

Argo HiFan Digit Bedienungsanleitung

Argo

Argo HIFAN Bedienungsanleitung

Argo

Argo SPLITTO JR Bedienungsanleitung

Argo

Argo HI FLOOR DESIGN Bedienungsanleitung

Argo

Argo DAKOTA Bedienungsanleitung

Argo

Argo BETSY Bedienungsanleitung

Argo

Argo CREOLA Q3 Bedienungsanleitung

Argo

Argo SILENCE 9 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

IRSAP

IRSAP The Radiator Company Ovali Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung