Audiovox GMRS121-2 Bedienungsanleitung
128-7005
1 of 20
General Mobile Radio Service (GMRS)
Model :GMRS121-2
Released: 1-16-04
Owner’s Manual
MODE
128-7005
2 of 20
THIS PAGE LEFT BLANK INTENTIONALLY
2
128-7005
3 of 20
3
CAUTION
SAFETY INFORMATION
Your wireless hand-held portable transceiver contains a low power
transmitter. When the PTT button is pushed (or the VOX mode is enabled)
it sends out radio frequency (RF) signals. The device is authorized to operate
at a duty factor not to exceed 50%. In August 1996, the Federal
Communications Commissions (FCC) adopted RF exposure guidelines
with safety levels for hand-held wireless devices.
Important: To maintain compliance with the FCC’ s RF exposure guidelines
hold the transmitter at least 1 inch (2.5 centimeters) from your
face and speak in a normal voice, with the antenna pointed up
and away. If you wear the handset on your body while using the
headset accessory, use only the Audiovox supplied carry clip
for this product and ensure that the antenna is at least 1 inch
(2.5 centimeters) from your body when transmitting. Use only
the supplied antenna. Do not use your transceiver with a
damaged antenna. Unauthorized antennas, modifications, or
attachments could damage the transmitter and may violate
FCC regulations.
Performance:
Your transceiver will only achieve its maximum operating range when
communicating with other transceivers across open and flat areas or
between elevated points. Normally occurring environmental factors such
as buildings, trees, terrain and weather, or interference from other radio or
electrical equipment, may have adverse effects on the transceiver’s effective
range. These are not indicative of a fault condition.
Avoid placing the GMRS121-2 radio transceiver for prolonged periods of
time in direct sunlight or temperatures below -4°F(-20°C) or above
140°F (60°C).
128-7005
4 of 20
WARNINGS:
Battery Care
Never attempt to charge alkaline or dry cell batteries, as batteries may
burst causing personal injury and damage to the product.
Battery Disposal
In general, if handled improperly, batteries pose a risk of fire or burns. Do
not disassemble, crush, puncture, short external contacts, or dispose of
the batteries in fire or water. Dispose of the batteries in a environmentally
safe manner and recycle whenever possible.
FCC WARNING
Replacement or substitution of transistors, diodes or other parts of a unique
nature, with parts other than those recommended by the manufacturer,
may cause a violation of the technical regulations of Part 15 of FCC Rules.
GMRS LICENSE:
USE OF THIS RADIO WITHIN THE UNITED STATES REQUIRES AN FCC
GMRS LICENSE. AN INDIVIDUAL 18 YEARS OF AGE OR OLDER, WHO IS
NOT A REPRESENTATAIVE OF A FOREIGN GOVERNMENT, IS ELIGIBLE
TOAPPLY FOR A GMRS SYSTEM LICENSE. YOU WILL NEED TWO FORMS
FROM THE FCC: FCC FORM 159, AND FCC FORM 605 (MAIN FORM AND
SCHEDULE F). YOU CAN FIND THE FORMS ONLINE AT:
HTTP://WWW.FCC.GOV/FORMPAGE.HTML, OR CALL 1-800-418-3676.
4
128-7005
5 of 20
5
1. Battery Cover
2. Push-To-Talk (PTT) and Func-
tion Confirmation Button
3. Detachable Carry Clip
4. Antenna
5. Liquid Crystal Display (LCD)
6. Up Channel/Volume Button
Model GMRS121-2 (FCC License Required)
7. Down Channel/Volume
Button
8. MODE Button
9. Built-in Microphone
10. Power On/Off and SCAN
Button
11. Built-in Speaker
3
5
4
1
2
11
3
(REF)
7
1
(REF)
10
6
8
9
MODE
PTT
128-7005
6 of 20
6
Model GMRS120 DISPLAY
1. Busy Indicator: This icon appears when the unit is receiving a
transmission.
2. Transmit Indicator: Icon appears when the unit is in the transmit
mode (PTT button activated or VOX mode active).
3. Large Segment Display: Indicates the channel number in use between
1 and 22.
4. Scan Indicator: This function allows the user to scan a channel every
0.5 second to search for a valid signal.
5. Battery Level Indicator: Icon indicates the battery charge level.
6. Roger Beep Tone Indicator: This icon appears when the Roger Beep
tone is on, and disapppears when the tone is not in use.
7. Voice Activated Transmission (VOX) Indicator: This function allows
hands-free conversation. The icon appears when the VOX mode is
activated.
Equipment and Accessories Supplied
1. Radio (2) GMRS121-2
2. Owner’s Manual (1) 128-7005
Powering the transceiver:
Your GMRS121-2 radio transceiver operates on three AAA Alkaline batteries.
7
1
2
4
3
5
6
128-7005
7 of 20
7
Installing the batteries:
Battery installation is made more convenient when the carry clip is rotated
either left or right to the upside-down position, or is removed completely.
Simply rotate the clip in either direction to the vertical position. Be careful
not to use excessive force. To remove the clip, press down on the the
release tab and pull the clip straight out from the radio body. Next, press
down with the thumb at the embossed arrow, slide the battery cover down
and lift it away from the compartment. Insert three AAA batteries (alternate
positive ends (+) toward the top of the transceiver, starting left-to-right).
2. Then lift cover at
bottom to open.
Remove cover.
3. Insert three AAA batteries
(positive (+) end toward
the top begining at left
side and alternating
positive terminals as
shown).
1. Using thumb,
press down on
battery cover at
arrow and slide
cover down.
+ +
+
CLIP RELEASE
TAB
BATTERY
COVER
CARRY
CLIP
COVER
ARROW
POSITIVE
TERMINAL
POSITIVE
TERMINALS
128-7005
8 of 20
8
The following guidelines will improve performance and provide longer
operating times for the GMRS121-2:
1. Do not mix old and new batteries.
2. The use of alkaline-type batteries is recommended to provide the
longest operating time.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
4. If the unit is not to be used for an extended period of time, remove the
batteries. Old or leaking batteries can cause damage to the unit and
will void the warranty.
GMRS121-2 OPERATIONAL MODES
GMRS/FRS
(MODE)
CHANNEL
SELECT
ROGER
BEEP
(1-22)
(on or oF)
NOTE: Refer to the appropriate section of this manual for detailed op-
erating instructions for each mode. Channels 1 through 7 are
shared GMRS/FRS. Channels 8 through 14 are FRS only,
and channels 15 through 22 are GMRS only.
128-7005
9 of 20
9
Controls:
Power On-Off/SCAN Button (10)
Press and hold the PWR on/off button for at least 2 seconds. You will hear
a confirming melody to indicate the unit is on. To turn the unit off, press and
hold the button for at least 2 seconds.
Adjusting the Volume (6, 7)
With the unit powered on, press the Up Channel/Volume button ( ) to
increase volume and the Down Channel/Volume button ( ) to decrease
volume. The display will indicate the current volume level ( V )followed by
the number (1-7). As volume is increased upward, the unit will beep at
each step, and vice-versa. When the minimum and maximum volume
settings are reached, a unique tone will sound.
Monitoring a Call
Whenever an incoming call occurs, the icon will apppear on the display
and you will hear static if frequency is clear.
Do not transmit if you hear
conversation.
The monitor function will temporarily bypass the squelch
setting and play all signals on a given channel. This feature is useful
when communicating with other parties at extreme range.
Push To Talk (PTT) Button (2)
Pressing and holding this button will allow you to speak to any transceiver
that is set to the same channel as yours. Hold the transceiver approximately
1 to 2 inches from your face as you speak into the built in microphone (9).
After you have finished speaking, release the PTT Button to allow reception
of incoming signals. It is not possible to transmit and receive at the same
time. Whenever the button is pressed, the transmit signal icon ( ) will
appear in the upper left corner of the display. Releasing the button allows
the unit to revert to standby mode. When receiving an incoming signal, the
icon will appear.
The PTT Button can also be used as a two-way call ringer. Pressing the
button twice quickly will call another party on the same channel. The transmit
icon ( ) will be displayed for 3 seconds and then disappear.
128-7005
10 of 20
10
Up Channel/Volume Button (6)
In the standby mode, pressing this button will increment the listening
volume. When in function edit mode this button will be used to adjust the
unit’s settings.
Down Channel/Volume Button (7)
In the standby mode, pressing this button will decrement the listening
volume. When in function edit mode this button will be used to adjust the
unit’s settings.
MODE Button (8)
This button is used to select various feature settings in the GMRS and FRS
modes.
Scan Button (10)
With the unit in standby mode, press the Power On/Off Button momentarily
to enable or disable the scan function; SCAN will appear on the display.
Operating Modes and Features
GRMS/FRS Operation:
- Press and hold the Power On/Off button for 2 seconds to turn on
power.
- Press the MODE button so the Channel number flashes.
- Select the desired channel with the Up (6) and Down (7) Buttons.
When receiving a call, the icon appears to indicate an incoming
call.
- Press and hold the PTT button (2) to transmit, then speak into the
microphone clearly and slowly. The Transmit icon ( ) appears
on the display while the button is pressed.
- Release PTT Button (2) to receive.
- Communication can only be accomplished when the channel of at
least two parties are the same.
Inhaltsverzeichnis
Andere Audiovox Radio Handbücher
Audiovox
Audiovox GMRS-1545 Bedienungsanleitung
Audiovox
Audiovox GMRS600SLK Bedienungsanleitung
Audiovox
Audiovox GMRS1262CH Bedienungsanleitung
Audiovox
Audiovox XpressR Bedienungsanleitung
Audiovox
Audiovox GMRS6000-2PK Bedienungsanleitung
Audiovox
Audiovox GMRS100 Bedienungsanleitung
Audiovox
Audiovox GMRS600SCH Bedienungsanleitung
Audiovox
Audiovox GMRS2572CH Bedienungsanleitung
Audiovox
Audiovox GMRS-7000 Bedienungsanleitung
Audiovox
Audiovox GMRS602CH Bedienungsanleitung
Audiovox
Audiovox GMRS762CH Bedienungsanleitung
Audiovox
Audiovox SIR-CK3 Bedienungsanleitung
Audiovox
Audiovox XAPH1 Bedienungsanleitung
Audiovox
Audiovox GMRS1100-2CH Bedienungsanleitung
Audiovox
Audiovox SIR-PNP1 Montage- und Bedienungsanleitung
Audiovox
Audiovox GMRS-1535 Bedienungsanleitung
Audiovox
Audiovox XM CNP-1000C Bedienungsanleitung
Audiovox
Audiovox Sirius SIR-PNP3 Bedienungsanleitung
Audiovox
Audiovox ACD-30 Programmierhandbuch
Audiovox
Audiovox GMRS200W Bedienungsanleitung
