Canon EF 70-300mm f/4.5-5.6 IS USM Bedienungsanleitung

Instructions

ENG

EF70-300mm f/4-5.6 IS II USM

ENG-1

Thank you for purchasing a Canon product.

The Canon EF70-300mm f/4-5.6 IS II USM

is a telephoto zoom lens, for use with EOS

cameras.

 “IS” stands for Image Stabilizer.

 “USM” stands for Ultrasonic Motor.

Camera Firmware

 When using this lens, please check the Canon website

for the latest camera rmware. If the camera’s rmware

is not the latest version, be sure to update to the latest

rmware.

 For details on updating rmware, please check the

Canon website.

Conventions used in this instruction

Warning to prevent lens or camera malfunction

or damage.

Supplementary notes on using the lens and

taking pictures.

ENG-2

Precautions to ensure that the camera is used

safely. Read these precautions thoroughly. Make

sure all details are observed in order to prevent

risks and injury to the user and other people.

Warning Details pertaining to risks that may

result in death or serious injury.

 Do not look at the sun or a bright light source

through the lens or single-lens reflex camera.

Doing so could result in loss of vision. Looking at the

sun directly through the lens is especially hazardous.

 Do not point the lens or camera at the sun or

photograph it. This is because the lens concentrates

the sun’s rays even when the sun is outside the image

area or when shooting with backlight, which could

cause malfunction or fire.

 Whether it is attached to the camera or not, do

not leave the lens under the sun without the

lens cap attached. This is to prevent the lens from

concentrating the sun’s rays, which could cause a re.

Caution Details pertaining to risks that may

result in injury.

 Do not leave the camera in locations subject to

high or low temperatures. This may result in the

camera becoming excessively hot or cold, which may

cause burns or other injuries when touched.

Caution Details pertaining to risks that may

result in damage to property.

 Do not leave the lens in excessive heat such as in a

car in direct sunlight. High temperatures can cause the

lens to malfunction.

Safety Precautions

ENG-3

Handling Precautions

 If the lens is taken from a cold environment into a

warm one, condensation may develop on the lens

surface and internal parts. To prevent condensation in

this case, rst put the lens into an airtight plastic bag

before taking it from a cold to warm environment. Then

take out the lens after it has warmed gradually. Do the

same when taking the lens from a warm environment

into a cold one.

 Please also read any lens related handling precautions

listed in your camera’s instruction manual.

General Precautions

ENG-4

Shooting Precautions

This lens uses Nano USM as the drive unit for the focus lens (the lens that aligns the focus).

The motor also controls the focus lens during zooming.

1. When the camera is OFF

The motor does not operate while the camera is OFF or when the camera is OFF due to the use of the auto

power off function. Therefore, users must be aware of the following points.

 Manual focus adjustments are not possible.

 During zooming, delayed focus will occur.

2. When the lens is in sleep mode

If not operated for a certain period of time, this lens will enter sleep mode in order to save power. Sleep mode

differs from when the camera is OFF due to the use of the auto power off function.

In this state, the motor will not operate even if the camera is ON. Therefore, users must be aware of the

following points.

 Manual focus adjustments are not possible.

 During zooming, delayed focus will occur.

 To exit sleep mode, press the shutter button halfway.

General Precautions

ENG-5

When using the lens with lm single-lens reex camera

 The drive speed of the focus lens will be slower than when the lens is used with a digital camera.

 Images will appear out of focus while the camera’s internal ash is charging or when zooming during

exposure for still images.

 Even when the camera in <ON>, images may appear out of focus when zooming. If this occurs, press the

shutter button halfway while zooming.

 After focusing in AF mode or AF operation in the ONE SHOT AF mode and zooming by holding the shutter

button halfway, the camera may indicate that the AF mode has been changed to manual focus (MF) mode.

 During continuous shooting, zooming may slow down shooting speed.

 There are some cases when users must wait a few seconds after zooming before the autofocus (AF) will

function.

 When using the lens with lm single-lens reex camera other than the EOS-1V/HS, information may not be

displayed on the lens information display (p.13-17) even when pressing the shutter button down halfway or all

the way, or when pressing the display mode select button.

 When using the lens with certain lm single-lens reex cameras, displaying information on the lens

information display may cause the autofocus (AF) to stop working. In this case, please shoot after rst setting

lens information display to OFF (p.13).

General Precautions

ENG-6

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

Do not make any changes or modications to the equipment

unless otherwise specied in the instructions. If such

changes or modications should be made, you could be

required to stop operation of the equipment.

This equipment has been tested and found to comply with

the limits for a class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

CAN ICES-3 (B) / NMB-3 (B)

ENG-7

Hood mount (→ 19)

Filter mounting

thread (→ 20)

Focusing ring (→ 9)

Zoom ring lock lever

(→ 10)

Lens mount index (→ 8)

Focus mode switch (→ 9)

Image stabilizer switch (→ 11)

Zoom ring (→ 8) Zoom position index (→ 8)

Display mode select

button (→ 13)

Lens information

display (→ 13)

Contacts (→ 8)

 For detailed information, reference page numbers are provided in parentheses (→ **).

Nomenclature

ENG-8

See your camera’s instructions for details on

mounting and detaching the lens.

 After detaching the lens, place the lens with

the rear end up to prevent the lens surface and

contacts from getting scratched.

 If the contacts get soiled, scratched, or have

ngerprints on them, corrosion or faulty

connections can result. The camera and lens

may not operate properly.

 If the contacts get soiled or have ngerprints on

them, clean them with a soft cloth.

 Attach the lens cap and dust cap when

disconnecting the lens. When attaching the

dust cap, align the lens mount index with the 

index of the dust cap and rotate in a clockwise

direction as shown in the illustration. Follow the

reverse procedure to detach it.

To zoom, turn the lens’ zoom ring.

 Be sure to nish zooming before focusing.

Zooming after focusing can affect the focus.

 Blurring may temporarily occur if the zoom ring is

quickly rotated.

 Zooming when the camera is OFF will result in

delayed focus.

 Zooming during still image exposure will result in

delayed focus. This causes any streaks of light

that are captured during exposure to be blurred.

1. Mounting and

Detaching the Lens

2. Zooming

ENG-9

After autofocusing in the AF mode or AF operation

in the ONE SHOT AF mode, focus manually by

pressing the shutter button halfway and turning the

focusing ring (Full-time manual focus).

To shoot in autofocus (AF) mode, set the focus

mode switch to AF.

To use only manual focusing (MF), set the focus

mode switch to MF, and focus by turning the

focusing ring.

 Quickly rotating the focusing ring may result in

delayed focus.

 Manual focus adjustments are not possible when

the camera is OFF.

3. Setting the Focus Mode

Andere Handbücher für EF 70-300mm f/4.5-5.6 IS USM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Canon Kameraobjektiv Handbücher

Canon

Canon EF 28-80mm 1:2.8-4.0L USM Bedienungsanleitung

Canon

Canon EF500mm f/4L IS II USM Bedienungsanleitung

Canon

Canon EF14mm f/2.8L II USM Bedienungsanleitung

Canon

Canon HJ40x10B IASD-V Bedienungsanleitung

Canon

Canon EF 20mm 1:2.8 USM Bedienungsanleitung

Canon

Canon IMAGE STABILIZER ULTRASONIC EF300MM f/4L IS... Bedienungsanleitung

Canon

Canon EOS 5D Mark IV + 70-200mm Bedienungsanleitung

Canon

Canon EF-S 10-22mm f/3.5-4.5 USM Bedienungsanleitung

Canon

Canon CN-E30-300mm T2.95-3.7L SP Bedienungsanleitung

Canon

Canon EF 70-200mm f/2.8L IS II USM Bedienungsanleitung

Canon

Canon CN-E31.5-95mm T1.7 L S Bedienungsanleitung

Canon

Canon EF 70-200mm Bedienungsanleitung

Canon

Canon HJ17ex7.6B IRSE A Bedienungsanleitung

Canon

Canon EF-S18-200mm f/3.5-5.6 IS Bedienungsanleitung

Canon

Canon RF 35mm F1.8 MACRO IS STM Bedienungsanleitung

Canon

Canon EF28 Bedienungsanleitung

Canon

Canon MP-E 65 mm 1:2.8 1-5x Bedienungsanleitung

Canon

Canon EF-S60mm f/2.8 MACRO USM Bedienungsanleitung

Canon

Canon EF 400mm f/2.8L IS II USM Bedienungsanleitung

Canon

Canon EF300mm f/2.8L IS II USM Bedienungsanleitung

Canon

Canon EF 70-200mm 1:2.8 L USM Bedienungsanleitung

Canon

Canon EF-S 55-250mm f/4-5.6 IS Bedienungsanleitung

Canon

Canon EF16-35mm f/4l IS USM Bedienungsanleitung

Canon

Canon EF 20-35mm 1:3.5-4.5 USM Bedienungsanleitung

Beliebte Kameraobjektiv Handbücher anderer Marken

THORLABS

THORLABS ELL15 Bedienungsanleitung

FUJICA

FUJICA ZC1000 Bedienungsanleitung

Tamron

Tamron A09 Handbuch

Sony

Sony SEL-55210 Bedienungsanleitung

Sony

Sony VCL-HG2037 Bedienungsanleitung

Honeywell

Honeywell HLM25V6F12 Bedienungsanleitung

Sony

Sony VCL-ST30 Bedienungsanleitung

Sony

Sony SAL-85F14Z - 85mm f1.4 Carl Zeiss Planar T Coated Telephoto... Bedienungsanleitung

ARRI

ARRI Lenses Bedienungsanleitung

Olympus

Olympus M.Zuiko Digital ES 300mm f4.0 IS PRO Bedienungsanleitung

Sony

Sony VCL-DE07T Bedienungsanleitung

Tamron

Tamron A036 Bedienungsanleitung

Samsung

Samsung 20-50mm F3.5-5.6 ED II Bedienungsanleitung

Tamron

Tamron 272E Bedienungsanleitung

Sinar

Sinar Rolleiflex 6008 AF Bedienungsanleitung

Rokinon

Rokinon SP 85mm F1.2 Bedienungsanleitung

Nikon

Nikon AF-S Zoom-Nikkor 17-35mm f/2.8D IF-ED Bedienungsanleitung

Samsung

Samsung Samsung 18-55mm Bedienungsanleitung