CommScope AMP NETCONNECT SL Series Bedienungsanleitung

Instruction Sheet

1of 2

LOC B

408-8398

AMP NETCONNECT* SL Series Faceplate Kits

1339118-[ ], 1339119-[ ], and 1479486-[ ] 21 DEC 16Rev D

Figure 1

1. INTRODUCTION

This instruction sheet provides installation and

removal procedures for the SL Series faceplate kits

shown in Figure 1.

Each faceplate accepts SL Series jacks, MT-RJ optical

fiber jacks, an assortment of SL Series jacks and

inserts, 110Connect modular jacks and inserts, and

blank modules (1.5 and 1 unit high).

The 3-port angled module accepts all unshielded

SL Series jacks and SL Series inserts. The 2-port

straight and angled modules accept all SL Series

jacks and inserts plus all 110Connect modular

jacks and inserts.

Reasons for reissue of this instruction sheet are

provided in Section 5, REVISION SUMMARY.

2. DESCRIPTION

Each kit consists ofa faceplate, mounting screws

(one per mounting hole), label, and label cover. Refer

to Figure 1. Each port of the faceplate accepts two

(1.5 units high) or three (1 unit high) front-loaded

modules.

3. INSTALLATION

3.1. Faceplate

1. Route the wires through the port of the

faceplate.

2. Align the faceplate mounting holes with the

screw holes of electrical box. Install and hand

tighten the mounting screws to secure the

faceplate to the box.

3.2. Jack

1. Terminate the jack according to instructions

packaged with the jack.

2. Align the terminated jack with the back of the

selected module. Insert the jack at a slight angle

with the stationary latch on the rail of the module.

Gently pivot the jack until the movable latch

engages onto the opposed rail and snaps into

place. See Figure 2.

Figure 2

Single-Gang Faceplate Kit

1339118-[ ]

Double-Gang Faceplate Kit

1339119-[ ]

Double-Gang Faceplate Kit

149486-[ ]

Label

Label Cover

Mounting Screw

Port

Note: Dash number indicates color of faceplate.

-1 Light Almond 0- -4 Gray

-2 Black 1- -1 Electrical Ivory

-3 White

NOTE

Movable Latch

of Jack

Rail

Back of Module

Movable Latch

of Insert

To obtaininformationon CommScope®products, contact

your local CommScope®account representative,

PartnerPRO®Network Partner or visit our website at

www.commscope.com

This product is covered by one or more U.S.

patents or their foreign equivalents. For patents, see

www.commscope.com/ProductPatent/ProductPatent.aspx

408-8398

2of 2

Rev D

3.3. Insert (See Figure 2)

1. Install the proper connection to the rear of the

insert.

2. Align the insert with the back of the selected

module.

3. Install the insert at a slight angle with the

stationary latch on the rail of the module. Gently

pivot the insert until the movable latch engages

onto the opposed rail and snaps into place.

4. Install blank inserts into the ports that are not

used.

3.4. Module (See Figure 3)

1. From the front of the faceplate, position the

loaded module in the port and snap it into place.

Repeat this step as needed.

2. Install blank modules (1.5 or 1 unit high) into

the faceplate where loaded modules are not

used.

3. Secure the faceplate to the box by installing

and tightening the mounting screws.

4. Install the label and label cover into the label

holder. If applicable, install standard icons into

the flashed-over icon slots (not included).

Figure 3

4. REMOVAL

4.1. Module

To remove a module from the faceplate:

1. Insert a screwdriver tip into the module

removal access hole (upper latch on 1.5 unit high

and lower latch on 1 unit high, refer to Figure 3)

and gently release the latch.

2. Using the screwdriver tip in the remaining

access holes, gently remove the module from the

faceplate.

4.2. Jack and Insert

To remove a jack or insert from the module:

1. Insert a screwdriver tip over the moveable

latch and pry down slightly to release the latch.

2. Pull the jack or insert out of the module.

5. REVISION SUMMARY

Revisions to this instruction sheet include:

•Changed company logo

•Updated instruction sheet to corporate

requirements

•Added AMP NETCONNECT logo and website

•Rebranded to CommScope

Module

(Ref)

Mounting Screw

Hole (Ref)

Front of

Faceplate

Icon Slot Label

Holder

Module

(Ref) Module Removal

Access Hole (Ref)

Note: For clarity, cables are not shown.

Dieses Handbuch passt für folgende Modelle

Andere CommScope Kabel und Steckverbinder Handbücher

CommScope

CommScope HELIAX FiberFeed FDH1206-12M50 Series Merkblatt

CommScope

CommScope ION-M7P Bedienungsanleitung

CommScope

CommScope HELIAX FiberFeed FDH1210-24SE2 Series Merkblatt

CommScope

CommScope AMP NETCONNECT MRJ21 1479452-1 Bedienungsanleitung

CommScope

CommScope TDUX-35 Bedienungsanleitung

CommScope

CommScope NOVUX Bedienungsanleitung

CommScope

CommScope OmniReach FTTX Bedienungsanleitung

CommScope

CommScope LightCrimp Plus SC Simplex Bedienungsanleitung

CommScope

CommScope PICABOND 60944-6 Bedienungsanleitung

CommScope

CommScope SYSTIMAX 360 iPatch... Bedienungsanleitung

CommScope

CommScope HELIAX FiberFeed HFA208 Series Merkblatt

CommScope

CommScope FOSC-400BG Bedienungsanleitung

CommScope

CommScope LightCrimp Plus ST Bedienungsanleitung

CommScope

CommScope SCIL-B Bedienungsanleitung

CommScope

CommScope NOVUX SXT Bedienungsanleitung

CommScope

CommScope FIBER INDEXING TERMINAL Bedienungsanleitung

CommScope

CommScope SYSTIMAX VisiPatch CPC5562 Bedienungsanleitung

CommScope

CommScope FOSC-350C Bedienungsanleitung

CommScope

CommScope FIST-RSKG-16 Bedienungsanleitung

CommScope

CommScope LC Bedienungsanleitung

CommScope

CommScope SYSTIMAX 360 iPatch 360-iP-G2-1U-LC-FX Bedienungsanleitung

CommScope

CommScope OFDC-A4 SPLICE/PATCH Bedienungsanleitung

CommScope

CommScope AMP NETCONNECT 1933352 Series Bedienungsanleitung

CommScope

CommScope FIST-RSKG-1 Bedienungsanleitung

Beliebte Kabel und Steckverbinder Handbücher anderer Marken

Philips

Philips SWA6310 Bedienungsanleitung

StarTech.com

StarTech.com CRJ4550PK Bedienungsanleitung

Nohau

Nohau EMUL-IP2K-PC Bedienungsanleitung

Foxun

Foxun SX-SP144E-HD4K2K Bedienungsanleitung

Philips

Philips SWA3305W Bedienungsanleitung

opticis

opticis Stretch DVIM1-1P0x Bedienungsanleitung

Volkswagen

Volkswagen VAS 6558A Bedienungsanleitung

NEXIBO

NEXIBO N-13 Bedienungsanleitung

CYP

CYP PU-1H3HBTL Bedienungsanleitung

Allen-Bradley

Allen-Bradley 1784-u2dhp Bedienungsanleitung

Global Caché

Global Caché Flex Link Blaster Bedienungsanleitung

Hauppauge

Hauppauge USB-Live2 Bedienungsanleitung

Fenix

Fenix MPSV 15 Bedienungsanleitung

BEGA

BEGA 71 085 Bedienungsanleitung

Tesla

Tesla HPWC Bedienungsanleitung

GAMERON

GAMERON LUXURY TV CABLE Bedienungsanleitung

molex

molex Milli-Grid Dual row 87568 Series Bedienungsanleitung

Burndy

Burndy Continental Industries thermOweld CRE-7 Bedienungsanleitung