Dyson Humdinger 387402 Bedienungsanleitung

User manual

SV12 JN.00000 PN.000000-00-00

00.00.00 VERSION NO.01

In the box

Getting started

Charging your machine

Emptying your bin

Cleaning your bin

Washing your filter

Cleaning your tools

Clearing blockages

Looking after your machine

Dyson Humdinger

In the box

Vacuum cleaner Charger

Combi-crevice tool

Charges your vacuum with

or without a dock.

Worktop tool

Engineered for cleaning kitchen

worktops, tables and hard surfaces.

Two tools in one – narrow nozzle and

brush, for quick switching between

cleaning and dusting tasks.

Mini motorised tool

Motorised brush bar, concentrated in a

smaller head to remove stubborn dirt

from mattresses, upholstery and stairs.

Some tools may not be included.

Your Dyson vacuum

drops into the wall-

mounted charging

dock, ready for your

next clean.

Wall dock

Main body

showing the

handle and

bin attached.

The charger is a one

piece unit with the

plug, connector end

and cable.

This tool has a combina-

tion of brush head and

crevice tool together in

one unit. The brush head

slides down the crevice

tool when needed.

A small cleaner head

with a body housing the

motor and an electrical

connector to attach to

the wand or directly to

the machine.

This tool is angled and

has a nozzle end.

Power button

Press the Power button

once for comfortable,

continuous cleaning.

Getting started

Press the button to change

power modes.

Power modes

Eco mode

Max mode

The optimum balance of

power and run time

Delivers maximum power.

For intensive cleaning of

ground-in dirt.

Location of the

power button

on the top of

the machine.

The main body with the

power button and mode

button at the base of the

handle and bin with the

bin base closed.

Charging your machine

For the best experience, we recommend fully charging your machine, and

any additional batteries, as soon as you open the box and after every clean.

The LED light on the end of the handle will flash when the power is running

low and you need to put your battery on to charge.

Connect the charger directly to the charging point on the base of the

handle of your machine. You can also connect to your dock as shown in the

installation instructions supplied with your dock.

The LED light on the end of the handle will pulse with a blue LED light when

charging, and the light will go out when fully charged.

It can take up to 3.5 hours to fully charge your battery. Your battery has been

designed to be left on charge.

Your machine won’t operate or charge if the ambient temperature is below

5°C (41°F). This is designed to protect both the motor and battery.

You can help prolong the battery life by leaving your machine to cool down

before recharging.

The charger connected from

the power supply directly into

the front of the battery.

Emptying your bin

Empty your bin as soon as the dirt reaches the MAX mark.

You may need to clean the filter more often if you use your machine with a full bin.

Cleaning your bin

Release the dirt

To remove the bin for emptying:

Minimise dust contact

Reassemble your machine

Don’t put any part of your machine in a dishwasher or use detergents,

polishes or air fresheners.

Hold your vacuum over a bin.

Push the red bin release button, taking care not to press the power button.

The bottom of the bin will open and the shroud will slide down inside the bin,

wiping away any dirt.

If the bin doesn’t open, check the bin release button is pushed down fully.

If the bin doesn't empty fully, remove the bin and empty the dirt.

Press the red button located on the bin runner to release the bin and slide

your bin off the runner.

Cover your bin tightly in a dust proof bag while you empty. Remove the bin

carefully, seal the bag tightly and dispose.

If you have removed your bin, slide it back on to the runner. Make sure that

the bin and lid are both securely in position.

Push the bin base upwards until the bin and lid both click into place.

Reconnect the wand.

clik

Replace your bin

Clean your bin

If it is necessary to clean your bin, empty it as shown in the ‘Emptying your

bin’ section.

Press the red button located on the bin runner to release the bin and slide

your bin off the runner.

Only clean your bin with a damp cloth.

Make sure that the bin and seals are completely dry before replacing.

Insert the spine on to the bin runner.

Close your bin by pushing the bin base upwards until the bin and bin base

click into place.

The MAX mark on the bin of the

machine, showing that the dirt

should not be filled over the Max

mark when the machine is at the

angle of normal use.

Illustration of

the bin being

emptied into

a bag.

Two images of the bin with arrows

showing the bin lid closing and

a click symbol and the bin being

pushed upwards with another

click symbol.

The bin lid

closing with an

audible click and

the bin being

pushed upwards

with another

click once it is

fully in place.

The bin being

removed and the

location of the bin

release lever on the

underside of the

bin runner.

The bin being pushed

back into position on

the bin runner.

Washing your filter

Wash your filter at least once a month to maintain the best performance.

Make sure the filter is completely dry before refitting.

Twist off your filter

Wash your filter

Shake and dry

Refit your filter

Don’t put any part of your machine in a dishwasher or use detergents,

polishes or air fresheners.

Turn your filter anti-clockwise and pull it away from your machine.

Before washing your filter, tap it gently over a bin to remove any loose dust

and debris.

Wash the outside of the filter, rubbing with your fingers to remove the dirt.

Carefully rinse the inside filter, without allowing water to fill the filter.

Repeat these steps until the water runs clear.

Empty the filter and shake firmly to remove excess water.

Keep shaking until there’s no water coming from the filter.

Place your filter end up, as shown.

Leave your filter to dry for at least 24 hours in a well-ventilated, warm place.

Don’t dry your filter in a tumble dryer, microwave or near a naked flame.

Important: your filter must be completely dry before you put it back into the

machine. Your machine could be damaged if used with a damp filter.

To refit your filter, slide it onto the handle and turn it clockwise until it clicks

into place.

Your filter may need more frequent washing if you vacuum fine dust,

use Max mode frequently or use with the bin full.

A hand holding the filter with the

narrow end pointing downwards with

droplets of water being shaken from the

filter and again, with the end pointing

downwards shaking water out.

The filter is left to dry

with the pleated filter

end facing upwards.

Filter with hand over

the open end with

arrows showing a

shaking motion.

Filter held in upright

position, with the wider

end in the palm of a

hand. Water running

from a tap into the

narrower end.

The filter is located at the

rear of your machine.

Holding the filter

by the hard, plastic

end, tap the other

end over the bin.

Cleaning your tools

Don’t put any part of your machine in a dishwasher or use detergents,

polishes or air fresheners.

Wipe with a damp, lint-free cloth, without touching the connector end.

Make sure your tools are completely dry before using.

Combi-crevice tool Worktop tool Mini motorised tool

Clearing blockages

If your machine detects a blockage, the motor will pulse six times. You won’t

be able to use your machine until the blockage has been cleared.

If you try to use your machine when the motor is pulsing, it will automatically

cut out.

Leave your machine to cool down before looking for blockages and,

for your safety, take care not to touch the power button.

Check for blockages in

the filter end and bin

ends of the machine.

The bin being removed

and the location of the

bin release lever on the

underside of the bin

runner.

Looking after your machine

To always get the best performance from your machine, it’s important to

clean it regularly and check for blockages.

Look after your machine

Look after your battery

Your serial numbers

You can register your machine using the serial number found on the bottom

of your machine.

If your machine is dusty, wipe with a damp lint-free cloth.

Check for blockages in the cleaner head and tools of your machine.

Wash your filter regularly and leave to dry completely.

Don’t use detergents or polishes to clean your machine.

To get the best performance and life from your battery, use Eco mode.

Your machine won’t operate or charge if the ambient temperature is below

5°C (41°F). This is designed to protect both the motor and battery.

You can find your serial numbers on your machine, battery and charger.

Use your serial number to register.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Dyson Staubsauger Handbücher

Dyson

Dyson DC21 Motorhead Bedienungsanleitung

Dyson

Dyson DC05 Bedienungsanleitung

Dyson

Dyson DC39 multi floor Bedienungsanleitung

Dyson

Dyson DC02 Bedienungsanleitung

Dyson

Dyson DC44 Bedienungsanleitung

Dyson

Dyson DC26 Bedienungsanleitung

Dyson

Dyson Ball Bedienungsanleitung

Dyson

Dyson DCo7 Bedienungsanleitung

Dyson

Dyson DC15 Bedienungsanleitung

Dyson

Dyson DC29 Bedienungsanleitung

Dyson

Dyson Omni-glide Bedienungsanleitung

Dyson

Dyson DC19T2I Bedienungsanleitung

Dyson

Dyson Dc45 Bedienungsanleitung

Dyson

Dyson DC31 Bedienungsanleitung

Dyson

Dyson DCo7 Bedienungsanleitung

Dyson

Dyson CINETIC BIG BALL ABSOLUTE Bedienungsanleitung

Dyson

Dyson DC59 Animal Bedienungsanleitung

Dyson

Dyson DC31 Bedienungsanleitung

Dyson

Dyson DC14 All Floor Bedienungsanleitung

Dyson

Dyson DC15 The Ball Bedienungsanleitung

Dyson

Dyson DC05 Bedienungsanleitung

Dyson

Dyson DC 23 Bedienungsanleitung

Dyson

Dyson DC 37C Bedienungsanleitung

Dyson

Dyson CINETIC BIG BALL ABSOLUTE Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung

Dyson humdinger 387402 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken