Edelbrock 5274 5274 Bedienungsanleitung

Page

1 of 2

Brochure No. 63-0337

Catalog #5274

Rev. 5/06 - DA/mc

EDELBROCK LOWER TRAILING ARMS

for 1982-2002 Camaro / Firebird

Catalog #5274

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Trailing Arms. If you have any questions, please

contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time

or e-mail us at [email protected]. Please fill out and mail your warranty card.

Application: Designed for 1982-2002 Camaro/Firebird vehicles. These trailing arms are designed to stabilize the rear

suspension, while improving suspension articulation.

Suggested Tools for Installation:

❑Jack and proper load rated jackstands ❑Blue Locktite

❑Tire chocks ❑Torque wrench

❑Lug wrench ❑Grease gun

❑18mm socket and combination wrench

1. Place vehicle on level surface and place tire

chocks in front of and behind front tires.

2. Support rear of the vehicle on the jackstands

and remove the rear wheels

(See Figure. 1)

3. Place a floorjack under the differential and lift up

slightly to remove tension from the trailing arm

bolts. Make sure not to lift the vehicle off the

jackstands

(See Figure 1).

NOTE: Keep floorjack under vehicle during

the complete removal and installation

procedure.

CAUTION: Do not remove both trailing arms

at the same time or the axle will rotate and

the trailing arm installation will be much

more difficult.

4. Remove trailing arm bolts and trailing arms

(See Figure 2).

REMOVAL OF STOCK TRAILING ARMS

Fig. 1

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Fig. 2

Brochure No. 63-0337

Catalog #5274

Rev. 5/06 - DA/mc

Page

2 of 2

Edelbrock Corporation, 2700 California Street, Torrance, CA 90503

Toll-Free Tech Line: 1-800-416-8628

Tech E-Mail: [email protected]

NOTE: Edelbrock trailing arms are fully assembled,

greased, and ready to install. Install new

trailing arms with the grease fittings facing

down. New high strength metric bolts washers

and nuts are included. We have also included

(2) 1/2” Grade 8 bolts and nuts (for use on the

front trailing arm mount in case the frame holes

have been enlarged).

1. Install the new trailing arm by locating the front

bolt first. NOTE: Spherical ball assembly goes

toward the front of the vehicle.

2. Place one drop of blue Loctite on clean threads

and torque the nut to 70 ft./lbs.

3. The trailing arm should then pivot smoothly on

the chassis.

4. Install the supplied 12mm rear bolt at the rear of

the arm.

5. Place one drop of blue Loctite on clean threads

and torque the nut to 70 ft./lbs.

(See Figure 2).

INSTALLATION OF EDELBROCK TRAILING ARMS

6. Although Edelbrock Trailing Arms are pre-lubed,

you may want to finish your installation by

lubing the front and rear bushings with a grease

gun. Be sure to replace the dust caps on the

zerk fittings to prevent dirt and corrosion from

damaging the fitting. Teflon grease is

recommended to lube polyurethane bushings

and a high pressure rated chassis lube works

good for the special ball end of the arm.

Re-check all nut and bolt tightness after first

10 miles.

NOTE: To further upgrade your suspension,

use other Edelbrock suspension

products such as springs, shocks,

torque arm, panhard rod, sub-frame

connectors, strut tower brace, trailing

arm relocation brackets.

Kit Contents

Qty.Description

❑2 Trailing Arm Assembly (#25-4069)

❑2 1/2” - 13 Grade 8 Hex Bolts

❑ 2 1/2” - 13 Grade C Lock Nuts

❑8 1/2” Thick Hardened Washers

❑4 12mm Hex Bolts

❑4 12mm Grade C Lock Nuts

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Edelbrock Automobilteil Handbücher

Edelbrock

Edelbrock 68752 Bedienungsanleitung

Edelbrock

Edelbrock 97383 Bedienungsanleitung

Edelbrock

Edelbrock 5276 Bedienungsanleitung

Edelbrock

Edelbrock Honda TRX450R Betriebsanleitung

Edelbrock

Edelbrock 5253 Bedienungsanleitung

Edelbrock

Edelbrock 65012 Bedienungsanleitung

Edelbrock

Edelbrock 5758 Bedienungsanleitung

Edelbrock

Edelbrock 47522 Bedienungsanleitung

Edelbrock

Edelbrock 77509 Bedienungsanleitung

Edelbrock

Edelbrock 15015 Bedienungsanleitung

Edelbrock

Edelbrock 3811 Bedienungsanleitung

Edelbrock

Edelbrock 4250 Bedienungsanleitung

Edelbrock

Edelbrock Performer 2261 Bedienungsanleitung

Edelbrock

Edelbrock 72552 Bedienungsanleitung

Edelbrock

Edelbrock Camaro 5290 Bedienungsanleitung

Edelbrock

Edelbrock 8873 Bedienungsanleitung

Edelbrock

Edelbrock 3881 Bedienungsanleitung

Edelbrock

Edelbrock 29565 Bedienungsanleitung

Edelbrock

Edelbrock 4100 Series Bedienungsanleitung

Edelbrock

Edelbrock 60469 Bedienungsanleitung

Edelbrock

Edelbrock Victor Glidden 18 2858 Bedienungs- und Wartungshandbuch

Edelbrock

Edelbrock 541583 Bedienungsanleitung

Edelbrock

Edelbrock Russell 641530 Bedienungsanleitung

Edelbrock

Edelbrock 8135 Bedienungsanleitung

Beliebte Automobilteil Handbücher anderer Marken

Dakota Digital

Dakota Digital 650277 Bedienungsanleitung

bosal

bosal 037031 Bedienungsanleitung

Vintage Air

Vintage Air 571063 Bedienungsanleitung

GFB

GFB EX38 Bedienungsanleitung

bosal

bosal 028091 Bedienungsanleitung

Dodge

Dodge 8W-43 Kurzanleitung

ICI

ICI Magnum FBM10DGN Bedienungsanleitung

Volant Perfomance

Volant Perfomance 19435 Bedienungsanleitung

BENDIX

BENDIX GEN 4 GEN 5 ABS Bedienungsanleitung

Vintage Air

Vintage Air 571065 Bedienungsanleitung

Rugged Ridge

Rugged Ridge 11503.13 Bedienungsanleitung

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Bedienungsanleitung

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Leitfaden

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Bedienungsanleitung

Toshiba

Toshiba 48-1250 A Bedienungsanleitung

aldes

aldes EHT2 Bedienungsanleitung

Go Rhino

Go Rhino 24371T Bedienungsanleitung

BBK

BBK 18950 Bedienungsanleitung