Edelbrock 5670 Bedienungsanleitung

Brochure #63-0489 Page 1 of 2

Catalog #5670

Rev. 1/06 - DA/mc

EDELBROCK CAT-BACK EXHAUST SYSTEM

for 1994-1996 Impala SS with 5.7L V8 Engine

Catalog #5670

INSTALLATION INSTRUCTIONS

Application: Designed for 1994-1996 Impala SS with 5.7L V8 Engine.

Suggested Tools for Installation:

❑3/8” rachet set and metric sockets ❑15mm wrench

❑Jackstands and jack ❑Liquid penetrant and rubber lubricant

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Disassembly

1. Raise vehicle and support with the proper jackstands,

leaving the rear suspension hanging.

2. Use caution around hot exhaust systems to avoid

burns.

3. Use penetrating oil on all nuts, bolts and rubber

hangers.

4. If you are using a lift or jackstands, the old system can

be removed in one piece. Remove the nuts to the

catalytic converter pipes and remove the old muffler

assembly.

5. Remove the stock hangers behind the stock mufflers.

Assembly

1. Install supplied rear muffler hangers using stock

muffler hanger holes.

2. Install the left and right I-pipes to catalytic converter

and snug bolts (do not tighten at this time). Slip

mufflers onto I-pipe. Slip 2-1/2” band clamps on and

snug bolts.

Please study these instructions carefully before installing your new Cat-Back Exhaust System. If you have any questions,

please contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific

Standard Time or e-mail us at [email protected]. Please fill out and mail your warranty card.

WARNING: Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any leaks before driving!

3. Install I-pipe bracket in factory location (on left side

transmission mount). The two mounting bolts are

slotted to help you align exhaust system. Do not

tighten at this time.

4. Slip a 2-1/2” U-clamp onto left I-pipe and snug pipe to

bracket installed in Step 2.

5. Slip the 2-1/2” U-clamps over the muffler outlets.

Install the overaxle pipe into the mufflers, slip on 2-

1/2” U-clamps and let hang on hangers.

6. Slip band clamps onto tailpie inlet end, then slip

tailpipes onto overaxle pipes. Engage hangers on

tailpipes into stock isolators.

7. Using band clamps, install tailpipe tips onto outlet of

tailpipe and snug clamps.

8. Align system to clear frame, heat shields, suspension,

etc., and tighten working from front to rear of vehicle.

NOTE: Bumper height may vary by as much as 1/2” on

different vehicles, so you may need to bend the rear

hanger to adjust for your vehicle.

9. Check for leaks and correct as needed.

KIT CONTENTS

Catalog #5670

Qty. Part # Description

1 25-3100 I-Pipe Assembly (left)

1 25-3101 I-Pipe Assembly (right)

1 25-3102 Overaxle Pipe Assembly (left)

1 25-3103 Overaxle Pipe Assembly (right)

1 25-3104 Tailpipe Assembly (left)

1 25-3105 Tailpipe Assembly (right)

2 25-3236 Tailpipe Tips (SS)

2 25-5510 SDT Muffler

2 33-8001 Hangers

2 46-1076 Flange

1 23-1726 I-Pipe Bracket

3 46-5185 2-1/2” U-Clamps

6 46-6611 2-1/2” Band Clamps

Band Clamp

U-Clamp

Band Clamp

Right I-Pipe Assembly

Left I-Pipe Assembly

Band Clamp

Left I-Pipe Bracket

Hanger

SDT Muffler

Assembly

(Left)

SDT Muffler

Assembly

(Right)

Hanger

Flange

Hanger

Left Tailpipe Assembly

Right Tailpipe Assembly

Hanger

WARNING: Support your vehicle with

proper jackstands rated for the total

vehicle weight. Place stands so that

the rear axle is allowed to hang free

for easy system removal.

WARNING: These cat-back systems are

engineered to fit stock catalytic

converters or equivalent replacements.

If you original system has been modified,

Edelbrock will not warranty fit or

performance.

Brochure #63-0489

Catalog #5670

Rev. 1/06 - DA/mc

Page 2 of 2

Andere Edelbrock Automobilteil Handbücher

Edelbrock

Edelbrock 5222 Bedienungsanleitung

Edelbrock

Edelbrock Quiet-Flo 1791 Bedienungsanleitung

Edelbrock

Edelbrock 305 Gebrauchsanweisung

Edelbrock

Edelbrock 70402 Bedienungsanleitung

Edelbrock

Edelbrock 70404 Bedienungsanleitung

Edelbrock

Edelbrock 7577 Bedienungsanleitung

Edelbrock

Edelbrock 1799 Bedienungsanleitung

Edelbrock

Edelbrock EFI Fuel Pressure Regulators 1728 Bedienungsanleitung

Edelbrock

Edelbrock 5694 (Stainless Steel) Bedienungsanleitung

Edelbrock

Edelbrock 5734 Bedienungsanleitung

Edelbrock

Edelbrock 4789 Bedienungsanleitung

Edelbrock

Edelbrock 5056 Bedienungsanleitung

Edelbrock

Edelbrock 6700 Bedienungsanleitung

Edelbrock

Edelbrock 7122 Bedienungsanleitung

Edelbrock

Edelbrock 2162 Gebrauchsanweisung

Edelbrock

Edelbrock 5253 Bedienungsanleitung

Edelbrock

Edelbrock 5724 Bedienungsanleitung

Edelbrock

Edelbrock 68712 Bedienungsanleitung

Edelbrock

Edelbrock 67362 Bedienungsanleitung

Edelbrock

Edelbrock 6607 Bedienungsanleitung

Edelbrock

Edelbrock 66042 Bedienungsanleitung

Edelbrock

Edelbrock Torker II 5021 Bedienungsanleitung

Edelbrock

Edelbrock 4462 Handbuch

Edelbrock

Edelbrock 71850 Bedienungsanleitung

Beliebte Automobilteil Handbücher anderer Marken

Dakota Digital

Dakota Digital 650277 Bedienungsanleitung

bosal

bosal 037031 Bedienungsanleitung

Vintage Air

Vintage Air 571063 Bedienungsanleitung

GFB

GFB EX38 Bedienungsanleitung

bosal

bosal 028091 Bedienungsanleitung

Dodge

Dodge 8W-43 Kurzanleitung

ICI

ICI Magnum FBM10DGN Bedienungsanleitung

Volant Perfomance

Volant Perfomance 19435 Bedienungsanleitung

BENDIX

BENDIX GEN 4 GEN 5 ABS Bedienungsanleitung

Vintage Air

Vintage Air 571065 Bedienungsanleitung

Rugged Ridge

Rugged Ridge 11503.13 Bedienungsanleitung

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Bedienungsanleitung

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Leitfaden

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Bedienungsanleitung

Toshiba

Toshiba 48-1250 A Bedienungsanleitung

aldes

aldes EHT2 Bedienungsanleitung

Go Rhino

Go Rhino 24371T Bedienungsanleitung

BBK

BBK 18950 Bedienungsanleitung