Edelbrock 5747 Bedienungsanleitung

Catalog #5747

Brochure No. 63-0504

Rev. 8/07 - DA/mc

Page 1 of 2

EDELBROCK CAT-BACK EXHAUST SYSTEM

For 2007-2008 Tahoe, Yukon XL, Suburban, & Avalanche

5.3L V8, 2WD & 4WD

Catalog #5747

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Edelbrock Cat-Back Exhaust System. If you have any

questions, please contact our Technical Hotline at: 1-800-416-8628 , 7am - 5pm, Monday-Friday, Pacific Standard

Time or e-mail us at [email protected].

Suggested Tools for Installation:

❑3/8" ratchet set and metric sockets ❑9/16” and 15mm wrench

❑Jack and jackstands ❑Liquid penetrant and rubber lubricant

DISASSEMBLY

1. Raise vehicle and support with proper jackstands for

the weight, leaving the suspension hanging.

2. Use caution around hot exhaust systems to avoid

burns.

3. Use penetrating oil on all nuts and bolts.

4. Remove the bolts, nuts, and clamps from the system

and lubricate the rubber hangers.

5. Use a long pry bar to pull the rubber hangers off of

the pipe hangers.

6. Remove the old system. In some cases, you will find

it easier to cut the overaxle pipe to remove it.

ASSEMBLY

1. Install I-pipe to factory outlet flange (behind catalytic

converters). NOTE: Do not tighten flange bolts

at this time (snug only).

2. Suburban, Yukon XL, & Avalance Only:

Install I-pipe extension onto outlet of I-pipe using

supplied 3” band clamp.

3. Install the muffler onto the intermediate pipe with a

3” band clamp on the front. NOTE: Inlet end of

muffler is marked. Snug the clamp so you can adjust

the system later.

4. Place a 3” band clamp on the outlet of the muffler.

5. Install the overaxle pipe and engage it into the stock

rubber hanger isolators in front of the axle. Snug the

clamps.

6. Install hanger clamp #23-4077 onto the outlet end of

the overaxle pipe. Arc of U-bolt will face toward

center of vehicle. (This hanger clamp can be used to

adjust the exhaust system).

7. Install tailpipe onto overaxle pipe, install 3” band

clamp and snug clamp.

8. Install hanger clamp #23-4076 onto I-pipe and

engage into factory isolator and snug the clamp.

9. Install hanger clamp assembly #23-4094 onto front

of overaxle pipe, engage into O.E. isolator, align

clamp and snug U-bolt nuts.

10. Check for clearance to body, frame, and driveline as

you tighten the system from front to rear.

11. Check for leaks and correct, if necessary.

WARNING!!!

Exhaust gas contains carbon monoxide, a deadly invisible gas.

Correct any leaks before driving!

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Catalog #5747

Brochure No. 63-0504

Rev. 8/07 - DA/mc

Page 2 of 2

KIT CONTENTS

Catalog #5747

Qty.Part # Description

❑1 25-3239 I-pipe Front

❑1 25-3268 I-pipe Extension

❑1 25-3240 Overaxle Pipe

❑1 25-3223 Tail pipe

❑1 25-5572 Muffler

❑1 22-5747 Installation Kit

WARNING: Support your vehicle with proper

jackstands or ramps rated for the total vehicle weight.

Place stands so that the rear axle is allowed to hang

free for easy system removal.

WARNING: These cat-back systems are engineered

to fit stock catalytic converters or equivalent

replacements. If you original system has been

modified, Edelbrock will not warranty fit or

performance.

Edelbrock Corporation, 2700 California St., Torrance, CA 90503

Tech Line: (800) 416-8628

Office: (310) 781-2222

E-Mail: [email protected]

Inhaltsverzeichnis

Andere Edelbrock Automobilteil Handbücher

Edelbrock

Edelbrock 28385 Bedienungsanleitung

Edelbrock

Edelbrock 6692 Bedienungsanleitung

Edelbrock

Edelbrock 15004 Bedienungsanleitung

Edelbrock

Edelbrock 8192 Bedienungsanleitung

Edelbrock

Edelbrock 47522 Bedienungsanleitung

Edelbrock

Edelbrock Russell 207-2 Handbuch

Edelbrock

Edelbrock 5782 Bedienungsanleitung

Edelbrock

Edelbrock 15015 Bedienungsanleitung

Edelbrock

Edelbrock 3881 Bedienungsanleitung

Edelbrock

Edelbrock 71836 Bedienungsanleitung

Edelbrock

Edelbrock SBC Vortec 283-400 c.i.d. Chevy V8 Bedienungsanleitung

Edelbrock

Edelbrock 66722 Bedienungsanleitung

Edelbrock

Edelbrock 5056 Bedienungsanleitung

Edelbrock

Edelbrock Edelbrock Header 6525 Bedienungsanleitung

Edelbrock

Edelbrock 5210 Bedienungsanleitung

Edelbrock

Edelbrock Russell R08364 Bedienungsanleitung

Edelbrock

Edelbrock Nitrous Systems 71831 Bedienungsanleitung

Edelbrock

Edelbrock 97383 Bedienungsanleitung

Edelbrock

Edelbrock 72552 Bedienungsanleitung

Edelbrock

Edelbrock 6893 Bedienungsanleitung

Edelbrock

Edelbrock 5726 Bedienungsanleitung

Edelbrock

Edelbrock 3562 Bedienungsanleitung

Edelbrock

Edelbrock 66662 Bedienungsanleitung

Edelbrock

Edelbrock 2760 Bedienungsanleitung

Beliebte Automobilteil Handbücher anderer Marken

Dakota Digital

Dakota Digital 650277 Bedienungsanleitung

bosal

bosal 037031 Bedienungsanleitung

Vintage Air

Vintage Air 571063 Bedienungsanleitung

GFB

GFB EX38 Bedienungsanleitung

bosal

bosal 028091 Bedienungsanleitung

Dodge

Dodge 8W-43 Kurzanleitung

ICI

ICI Magnum FBM10DGN Bedienungsanleitung

Volant Perfomance

Volant Perfomance 19435 Bedienungsanleitung

BENDIX

BENDIX GEN 4 GEN 5 ABS Bedienungsanleitung

Vintage Air

Vintage Air 571065 Bedienungsanleitung

Rugged Ridge

Rugged Ridge 11503.13 Bedienungsanleitung

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Bedienungsanleitung

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Leitfaden

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Bedienungsanleitung

Toshiba

Toshiba 48-1250 A Bedienungsanleitung

aldes

aldes EHT2 Bedienungsanleitung

Go Rhino

Go Rhino 24371T Bedienungsanleitung

BBK

BBK 18950 Bedienungsanleitung