Emerson Sensi Predict Bedienungsanleitung

This guide describes installation and activation of the Sensi Predict™Condensate Switch

Monitor accessory. The accessory provides indication of system shutdown by condensate level

switches responding to excessive water levels. One or more switches may be monitored.

To install, connect the free wires of the condensate switch monitor to either end of the

condensate switch chain as shown below. Plug the connector into one of the accessory ports

of the Sensi Predict Data Hub and ensure that the red stripe on the 3-pin connector side of the

wire is facing up, as illustrated below. See back for validation procedure.

CONDENSATE SWITCH MONITOR CONNECTIONS

BEFORE INSTALL

0037-7658001

NOTE: Please verify that the condensate switch is rated

to control the connected load.

NOTE: The condensate switch monitor MUST be wired

in parallel

Ensure that the red stripe on the 3-pin connector side

of the wire is facing up, as shown above

CONDENSATE

SWITCH WIRES

R,C, OR Y

CONTROL WIRE INDOOR DEVICE

R,C, OR Y

CONTROL WIRE

CONDENSATE

SWITCH MONITOR

TO CONDENSATE SWITCH(S)

CONDENSATE

SWITCH WIRES

R,C, OR Y

CONTROL WIRE

R,C, OR Y

CONTROL WIRE

TO CONDENSATE SWITCH(S)

CONDENSATE SWITCH MONITOR INSTALLATION GUIDE

WARNING

ELECTRICAL SHOCK/FIRE HAZARD

• Installer must be qualied technician

• Connect only to a 24 volt class 2 circuit

• Follow all local and national codes and ordinances

• Ensure proper operation of HVAC system, following manufacturer’s instructions

The Sensi Predict PRO Portal can be accessed at sensipredictpro.com

For login support, contact your ofﬁce administrator.

For support within the PRO Portal, call 1-877-424-1715.

When the Condensate Switch Monitor is connected to the Data Hub the green light will be on, as

shown in Figure A. If the monitor’s green LED does not illuminate and the Data Hub is powered

on, unplug the 3-pin connector, ﬂip over and reinsert.

Proper connection to the condensate switch may be conﬁrmed by momentarily opening the

switch and observing that the red light comes on, as seen in Figure B. (24 volt system power

must be on and the control wire being interrupted must be active for this step.) If the red light

does not indicate when the switch is open, please verify that the switch is operating correctly.

In the event of a condensate switch opening the red light will illuminate and the Sensi Predict

system will detect an open status. Sensi Predict technicians will not trigger a homeowner alert

unless an actual condensate event is diagnosed. When the condensate switch closes (after

removing the clog and draining the water) the red light will go out.

SENSOR LED LIGHTS

ﬁg.a ﬁg.b

SENSOR LED LIGHT INDICATORS

0037-7658001

The Sensi Predict PRO Portal can be accessed at sensipredictpro.com

For login support, contact your ofﬁce administrator.

For support within the PRO Portal, call 1-877-424-1715.

Inhaltsverzeichnis

Andere Emerson Messgerät Handbücher

Emerson

Emerson Rosemount 585 Annubar Bedienungsanleitung

Emerson

Emerson Rosemount MCL-220 Bedienungsanleitung

Emerson

Emerson Rosemount 5900 Kurzanleitung

Emerson

Emerson 404B Bedienungsanleitung

Emerson

Emerson Machinery Health Expert CSI 2600 Bedienungsanleitung

Emerson

Emerson Dixell XRi30T Bedienungsanleitung

Emerson

Emerson 56WM WirelessHART SensEnable Bedienungsanleitung

Emerson

Emerson Rosemount WPG Bedienungsanleitung

Emerson

Emerson Rosemount 2051CF series Bedienungsanleitung

Emerson

Emerson Rosemount 3814 Programmierhandbuch

Emerson

Emerson Micro Motion Kurzanleitung

Emerson

Emerson A6312 Bedienungsanleitung

Emerson

Emerson LMS1000 Bedienungsanleitung

Emerson

Emerson 7003M Bedienungsanleitung

Emerson

Emerson TopWorx 4310 Bedienungsanleitung

Emerson

Emerson Rosemount 3812 Bedienungsanleitung

Emerson

Emerson ROSEMOUNT NGA2000 HFID Bedienungsanleitung

Emerson

Emerson CSI 2140 Bedienungsanleitung

Emerson

Emerson Micro Motion 7827 Bedienungsanleitung

Emerson

Emerson ROSEMOUNT OCX8800C Bedienungsanleitung

Emerson

Emerson AMS AM 5820-IM Bedienungsanleitung

Emerson

Emerson Energy Meter Bedienungsanleitung

Emerson

Emerson Rosemount 8782 Bedienungsanleitung

Emerson

Emerson Rosemount 3051 Series Bedienungsanleitung

Beliebte Messgerät Handbücher anderer Marken

Suaoki

Suaoki D40 Bedienungsanleitung

Elster

Elster BK-G1.6 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Deltabar FMD71 Handbuch

Duratool

Duratool D03128 Bedienungsanleitung

Vega

Vega VEGAPULS 65 Bedienungsanleitung

Tonghui

Tonghui TH2618B Bedienungsanleitung

Tenmars

Tenmars TM-801 Bedienungsanleitung

MSR

MSR 145 Bedienungsanleitung

TPS

TPS WP-82 Bedienungsanleitung

ELMETRON

ELMETRON CP-511 Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 003C30 Bedienungsanleitung

Tenma

Tenma 72-10465 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Proline Promag 50 Technische Daten

Siemens

Siemens SITRANS F Coriolis FCT030 Stücklistenhandbuch

KLINGER

KLINGER CMF V Series Bedienungsanleitung

EXFO

EXFO FTB-2 Bedienungs- und Wartungshandbuch

Keysight

Keysight M8290A Bedienungsanleitung

ADTEK

ADTEK MW-5 Bedienungsanleitung