Ergotron StyleView Bedienungsanleitung

1 of 8

888-97-319-W-02 rev. F • 04/19

www.ergotron.com | USA: 1-800-888-8458 | Europe: +31 (0)33-45 45 600 | China: 400-120-3051 | Japan: [email protected]

English, Español, Français, Deutsch, Nederlands, Italiano, Svenska, 日本語, 汉语

StyleView®Scanner Shelf

Max weight: 2 lbs (1 kg)

SV Cart & Head Unit

• Option 1 - LCD Carts

• Option 2 - Laptop Carts • Option 3 - Wall Track

• Option 4 - Back of SV Cart

User's Guide

English

For the latest User Installation Guide please visit: www.ergotron.com

2 of 8

888-97-319-W-02 rev. F • 04/19

ABC

1/4”

14mm

1x 1x 1x

M4 x 16mm

M5 x 12mm 2x #8/32x5/16”

Components

Tools Needed

These symbols alert users of a safety condition that

demands attention. All users should be able to

recognize and understand the signicance of the fol-

lowing Safety Hazards if encountered on the product

or within the documentation. Children who are not

able to recognize and respond appropriately to Safety

Alerts should not use this product without adult

supervision!

Hazard Symbols Review Symbol Signal Word Level of Hazard

NOTE A NOTE indicates important information that helps you

make better use of this product.

CAUTION

A CAUTION indicates either potential damage to

hardware or loss of data and tells you how to avoid the

problem.

WARNING A WARNING indicates either potential for property dam-

age, personal injury, or death.

ELECTRICAL

An Electrical indicates an impending electrical hazard

which, if not avoided, may result in personal injury, re

and/or death.

For Laptop Carts

For LCD Carts

3 of 8

888-97-319-W-02 rev. F • 04/19

2x M4 x 16mm

2x M5 x 12mm

Open Worksurface with key.

a. Attach the shelf bracket to the bottom of the head unit using two M4x16mm Phillips

screws.

b. Loosely attach the scanner shelf to the bracket using two M5x12mm Phillips screws.

Adjust the shelf to the desired height; ensure that the shelf is level, then tighten the

screws.

c. Close and lock worksurface.

d. Go to page 8 for options on how to secure scanner to shelf.

Option 1 - Mounting to right or left side of LCD head unit

exterior

view

interior

view

CAUTION: Do Not Exceed Maximum SV LCD Cart Weight Capacity 35 lbs. (16 kg). This is the sum of LCD monitor, CPU, key-

board/mouse, scanner and any worksurface load, including drawers, if present. Failure to heed this caution may cause serious Injury or

property damage to occur.

4 of 8

888-97-319-W-02 rev. F • 04/19

M4 x 16mm

Note: the screws pass into the head unit ﬂoor from above, as illustrated. Laptop

support bar may need to be removed temporarily to allow installation of scanner

bracket.

CAUTION: Do Not Exceed Maximum SV Laptop Cart Weight Capacity 22 lbs. (10 kg). This is the sum of laptop, keyboard/mouse,

scanner and any worksurface load, including drawers, if present. Failure to heed this caution may result in personal Injury or property damage.

a. Unlock both sides of worksurface.

b. Remove worksurface.

a. Attach the shelf bracket to the right or left side of the head unit using two M4x16mm

Phillips screws.

Option 2 - Mounting to right or left side of laptop head unit

right

exterior

view

left

exterior

view

ﬂoor view ﬂoor view

5 of 8

888-97-319-W-02 rev. F • 04/19

M5 x 12mm

14mm (9/16")

3a. Loosely attach the scanner shelf to the bracket using two M5x12mm Phillips screws.

b. Adjust the shelf to the desired height; ensure that the shelf is level, then tighten the

screws. Close and lock worksurface.

c Go to page 8 for options on how to secure scanner to shelf.

d. After the scanner has been secured to shelf, follow Step 4 Adjustment, below.

Option 2 - Mounting to right or left side of laptop head unit (cont.)

Once the scanner has been mounted to the shelf, it is important that

you adjust the lift tension for the additional weight. Test the lift tension

by moving the head unit up and down. If it travels smoothly and easily

through the full range of motion, and does not drift up or sag down from

the place you set it, the tension is good. If not, adjust as directed below:

To change lift tension:

Lift – Up and down

NOTE: Adjustment

may require 40 - 60

revolutions.

Adjustment Step

a. Remove cap and turn adjustment nut with a 14mm (9/16”) socket

head.

b. Test lift tension by lifting head unit up and down. When desired lift

tension has been achieved, replace cap.

6 of 8

888-97-319-W-02 rev. F • 04/19

2x 8/32x5/16”

Option 3 - Mounting to wall track

a. Attach the scanner shelf to the walltrack bracket using two 8/32x5/16” Phillips screws.

Adjust the shelf to the desired height; ensure that the shelf is level, then tighten the

screws.

b. Go to page 8 for options on how to secure scanner to shelf.

Note: several pair of

mounting holes are available.

7 of 8

888-97-319-W-02 rev. F • 04/19

M5 x 12mm

1a. Remove cap.

b. If present, remove existing accessory by sliding it up off the slot in the riser.

NOTE: loosen screws only, do not remove them.

c. Attach t-nut to scanner shelf with M5x12 screws as illustrated.

d. Slide shelf/nut assembly into slot, adjust shelf to the desired height and tighten the

screws.

Option 4 - Mounting to rear of cart

8 of 8

888-97-319-W-02 rev. F • 04/19

www.ergotron.com |

USA: 1-800-888-8458

Europe: +31 (0)33-45 45 600

China: 400-120-3051

Japan: [email protected]

3 Mounting Options

For local customer care phone numbers visit: http://contact.ergotron.com

For Service visit: www.ergotron.com

For Warranty visit: www.ergotron.com/warranty

Andere Handbücher für StyleView

Inhaltsverzeichnis

Andere Ergotron Inneneinrichtung Handbücher

Ergotron

Ergotron WorkFit-TLE Bedienungsanleitung

Ergotron

Ergotron 97-540-053 Bedienungsanleitung

Ergotron

Ergotron Elevate II Bedienungsanleitung

Ergotron

Ergotron Zido Handle Bedienungsanleitung

Ergotron

Ergotron WORKFIT Bedienungsanleitung

Ergotron

Ergotron TeachWell LCD Bedienungsanleitung

Ergotron

Ergotron Glide Upgrade Bedienungsanleitung

Ergotron

Ergotron JUV Bedienungsanleitung

Ergotron

Ergotron Neo-Flex Bedienungsanleitung

Ergotron

Ergotron LX Sit-Stand Bedienungsanleitung

Ergotron

Ergotron Bench II Bedienungsanleitung

Ergotron

Ergotron 48" Bench II Bedienungsanleitung

Ergotron

Ergotron 97-540-053 Bedienungsanleitung

Ergotron

Ergotron Projector Shelf for TeachWell Bedienungsanleitung

Ergotron

Ergotron Zido ZGBCG Bedienungsanleitung

Ergotron

Ergotron WorkFit-T Bedienungsanleitung

Ergotron

Ergotron WORKFIT Standing Desk Converter Bedienungsanleitung

Ergotron

Ergotron 72” AnthroBench II Bedienungsanleitung

Ergotron

Ergotron WorkFit B Bedienungsanleitung

Ergotron

Ergotron SV10 Bedienungsanleitung

Ergotron

Ergotron Neo-Flex Notebook Lift Stand Bedienungsanleitung

Ergotron

Ergotron WorkFit-C Dual Bedienungsanleitung

Ergotron

Ergotron Neo-Flex Notebook PC Stand Bedienungsanleitung

Ergotron

Ergotron LearnFit 24-756-003 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung