Federal Signal Corporation 400HMK-AC Bedienungsanleitung

256A434

REV. B 608

Printed in U.S.A.

INSTRUCTION SHEET FOR MODEL 400HMK-AC

FOR

INSTALLATION OF FEDERAL MODEL 350 VIBRATONE HORNS

FEDERAL MODEL 400 SERIES LIGHTS

A. GENERAL

This sheet contains instructions for the installa-

tion of a Federal Model 350 Vibratone Horn in Fed-

eral Model 400 Series Warning Lights, enabling the

user to assemble an integrated light/sound warning

device. The instructions in this sheet are intended to

be used in conjunction with the Installation Instruc-

tions for Model 400 Series Lights. It is usually most

convenient to install the horn in the light before

attaching the light to the mounting surface. However,

the horn can be installed later, if required.

B. INSTALLATION

1. Check the parts received against the Kit Con-

tents List, at the end of this sheet, to make sure that

the installation kit is complete.

2. Insert ﬁrst a grommet and then a bushing

into each of the two holes, in both mounting brackets,

as shown in ﬁgure 1.

3. Install the supplied gasket in the mounting

box groove, as indicated in ﬁgure 1.

4. See ﬁgure 1. Connect the horn supply wires

to the wires in the mounting box assembly, using the

wire nuts supplied with the horn.

5. Attach the horn to the mounting box as-

sembly, using the two 8-32 x 1-5/8" oval head screws

supplied with the horn. Tighten the screws securely.

6. Remove and discard the two Phillips head

screws from the front of the horn, as indicated in

ﬁgure 2.

7. Apply the two adhesive foam seals to the

holes from which the screws were removed in step

6. Ensure that there is a clear passage through the

seals to the interior of the mounting box. These seals

form a closed passage to minimize the accumulation

of dust in the light assembly.

8. If the light has already been installed and in

use, disconnect the power to the unit.

9. Detach the lower, metal, housing from the

light assembly by removing the four slotted fastening

nuts.

10. Attach the mounting brackets with the grom-

mets and bushings that were installed in step 2, to

the four exposed 8-32 x 5/8" studs, using the four

elastic stop nuts supplied.

Figure 1. Figure 2.

11. Connect the receptacle from the horn assem-

bly to the plug leading from the terminal block, on

the light assembly.

12. Attach the horn to the mounting brackets,

that were installed in step 10, using two 1/4"-20 x 1/2

hex head machine screws and lockwashers, as indi-

cated in ﬁgure 1.

13. Remove the grille cover from the bottom of

the lower housing by removing the four 6-32 KEPS

nuts and washers at the bottom of the housing.

14. If the light/horn assembly is to be ceiling

mounted, attach the light mounting bracket to the

lower housing and reassemble the light before con-

tinuing with the procedure in the light installation

sheet.

15. If the light/horn assembly is to be wall

mounted, replace the lower housing on the assembly

and install the unit following the installation instruc-

tions included with the light.

KIT CONTENTS LIST

Qty. Description

1 Mounting Box Assy.

1 Gasket

2 Mounting Bracket

4 Grommet

4 Bushing

2 Foam Seal

2 Screw mach., hex hd., 1/4"-20

4 Elastic stop nut, 8-32

2 Lockwasher, 1/4"

-2-

Inhaltsverzeichnis

Andere Federal Signal Corporation Sicherheitssystem Handbücher

Federal Signal Corporation

Federal Signal Corporation CommCenter D1 Series Handbuch

Federal Signal Corporation

Federal Signal Corporation Fireball FB2LEDX Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation CP-PB Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation e-Q2B Handbuch

Federal Signal Corporation

Federal Signal Corporation e-Q2B Handbuch

Federal Signal Corporation

Federal Signal Corporation Premium Vision Kurzanleitung

Federal Signal Corporation

Federal Signal Corporation SelecTone 300SCW-1 Handbuch

Federal Signal Corporation

Federal Signal Corporation 400 Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation SMART VECTOR SL Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation SelecTone Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation 2001SRNB Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation PA4000 Handbuch

Federal Signal Corporation

Federal Signal Corporation SST-MV Handbuch

Federal Signal Corporation

Federal Signal Corporation VISION Kurzanleitung

Federal Signal Corporation

Federal Signal Corporation PA4000 Handbuch

Federal Signal Corporation

Federal Signal Corporation PA300 Series 690009 Handbuch

Federal Signal Corporation

Federal Signal Corporation PA300 Series 690009 Betriebsanleitung

Federal Signal Corporation

Federal Signal Corporation Solaris LP800 Handbuch

Federal Signal Corporation

Federal Signal Corporation SmartSiren Platinum SSP3000B Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Vision SLR Series Handbuch

Federal Signal Corporation

Federal Signal Corporation 2-120 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation SSTX3-MV Handbuch

Federal Signal Corporation

Federal Signal Corporation 27XL-024-4 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation 2-240 Handbuch

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung

DSC

DSC PC 4010 Betriebsanleitung

UniPOS

UniPOS 6202L Bedienungsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Rondish

Rondish Nexus Bedienungsanleitung