Fujitsu M3091DC Bedienungsanleitung
ÿ
M3091DC
Image Scanner User' Guide
Notice to American
Users Federal Communications Commission
Radio Frequency Interference Statement
Notice: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
FCC warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Notes
•The use of a non-shielded interface cable with the referenced device is
prohibited. The length of the parallel interface cable must be 3 meters (10 feet)
or less. The length of the serial interface cable must be 15 meters (50 feet) or
less.
•The length of the power cord must be 3 meters (10 feet) or less.
Notice to Canadian
Users This digital apparatus does not exceed the class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the
Canadian Department of Communications.
Le présent appareil numériqué n'émet pas de bruits radioélectnques dépassant les
limites applicables aux appareils numériques de la classe B prescrites dans le
Règlement sur le brouillage radioélectrique édicté par le ministère des
Comunications du Canada.
Notice to German
Users
Bescheinigung des Herstellers/Importeurs
Hiermit wird bescheinigt, daß der/dieldas
•M3091DC in Übereinsstimmung mit den Bestimmungen der
•AmtsblVfg 243/1991 funk-entstört ist. Der Deutschen Bundesport wurde das
inverkehrbringen dieses Gerätes angezeigt und die Berechtigung zur
Überprüfung der Serie auf Einhaltung der Bestimmungen eingeräumt.
•Maschinenlärminformationsverordnung 3. GS GV, 18.01.1991:
Der höchste Schalldruckpegel beträgt 70 dB (A) order weniger gemäß ISO
/7779.
The contents of this manual may be revised without prior notice and without
obligation to incorporate changes and improvements into units already shipped.
Every effort has been made to ensure that the information included here is
complete and accurate at the time of publication, but Fujitsu cannot be held
responsible for errors and omissions.
Copyright © 1995,1996,1997 Fujitsu Limited
Printed in Japan. All rights reserved. No part of this manual may be reproduced or
translated, stored in a database or retrieval system, or transmitted, in any form or
by any means, electronic, mechanical, photocopying, recording, or otherwise,
without the prior written permission of the Fujitsu Limited.
C150-E???-??EN, ??? 1998
Trademark Acknowledgment
Fujitsu are registered trademarks of Fujitsu Limited.
Safe Operation
About this user's guide
This user's guide contains important information about using the M3091DC safely. Read this guide
thoroughly before using the M3091DC. Do not use the M3091DC until you have read and thoroughly
understood the section "Precautions for Safety." Keep this manual in a safe place as long as you use the
M3091DC.
Preface
Thank you for purchasing the M3091DC image scanner. The M3091DC image scanner reads high-color
images. This user's guide explains the basic methods for using the scanner. Read the guide carefully so
that you will use the scanner correctly.
In this manual, we abbreviate "Microsoft® Windows NT® operating system" to "Windows NT®" and
"Microsoft ® Windows ® 95 operating system" to "Windows ® 95."
Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation in the United
States and other countries.
Other company names and product names are trademarks or registered trademarks of their respective
owners.
FUJITSU's Liability and Other Important
Information
The user assumes all responsibility for the use of the scanner unit, software used by the scanner, and this
manual, all of which are provided as the M3091DC product.
FUJITSU takes no responsibility for any damage or data loss caused by the use of the M3091DC.
Any compensation for damage caused by the M3091DC will in no event exceed the price paid by the
user for the M3091DC.
Software contained in the M3091DC and update software provided by FUJITSU for the M3091DC must
only be used in the M3091DC. Modification or disassembly of the software is not allowed.
Message Conventions
Alert Messages Conventions
This manual uses alert messages to protect users and other persons in the vicinity of the scanner from
personal injury and property damage. An alert message consists of an alert signal and alert text. The
alert signal consists either of an alert symbol and a signal word or of simply a signal word.
Indicates a hazardous situation that could result in personal injury if the user
does not perform the procedure correctly.
Indicates a hazardous situation could result in minor or moderate personal injury
if the user does not perform the procedure correctly. This alert signal also
indicates potential damage to the product or other property if the user does not
perform the procedure correctly.
The following alert indications are used in this manual together with those
above to indicate a specific hazard.
indicates a warning or an action requiring caution. The symbol in the
triangle indicates the type of hazard (in the example, electric shock).
indicates actions that are prohibited. An image inside the symbol or text
above it provides more concrete information in the example, disassembly is
prohibited).
indicates an action that must be complied with. An image inside the circle or
text above it provides more concrete information (in the example, the
information is to always remove the power plug from the outlet).
Safety Precautions
The following provides important information about the M3091DC. Be sure to comply with this
information to ensure that you use the M3091DC in a safe manner.
Precautions regarding power
- Insert the AC adapter only in a 110 VAC outlet rated at 15 A. Do not use a
multiple receptacle plug. Disregarding these precautions may cause a fire or
electric shock.
- Do not scratch, damage, or otherwise alter the power cord. Do not put
heavy objects on the power cord, and do not pull or bend it. Disregarding
these precautions may damage the power cord, causing fire or electric
shock.
- Be sure to use the power cord (AC adapter) attached to the scanner. Do not
use an extension cord. Disregarding this precaution may result in abnormal
heat or a fire.
- Do not use a power cord or AC adapter that is damaged, or an outlet with a
loose socket. Disregarding this precaution may result in a fire or electric
shock. Return the damaged item to the store where you purchased it, or
contact FUJITSU.
- Disconnect the AC adapter before connecting an interface cable or optional
product. Disregarding this precaution may result in electric shock.
- Do not insert or remove the AC adapter with wet hands. Disregarding this
precaution may result in electric shock.
ÿ
- Clean a dusty AC adapter or outlet with a dry cloth. Using a dusty adapter
or outlet can cause a fire.
- In the following cases, stop using the scanner, remove the AC adapter from
the outlet, and contact the store where you purchased the scanner or contact
FUJITSU.
You see smoke coming from the scanner, or the outside of the scanner is hot
to the touch.
You hear any unusual sounds.
Water gets into the scanner
Continuing to use the scanner in any of these conditions may cause a fire.
- If you hear thunder nearby, remove the AC adapter from the outlet. Failure
to do so may result in damage to the scanner and any connected devices.
- Insert the AC adapter fully and securely into the outlet. Failure to do so
may cause a fire or a failure.
- Be sure to disconnect the AC adapter from the outlet before cleaning,
maintaining, or repairing the scanner.
If you clean or maintain the scanner without disconnecting the AC adapter
from the outlet, you may receive an electric shock.
- If you will not be using the scanner for a long time, be sure to disconnect the
AC adapter from the outlet for safety reasons. Failure to do so may cause a
fire or a failure.
Andere Handbücher für M3091DC
1
Inhaltsverzeichnis
Andere Fujitsu Scanner Handbücher
Fujitsu
Fujitsu fi-680PRB Handbuch
Fujitsu
Fujitsu ScanZen EK6 Konfigurationshandbuch
Fujitsu
Fujitsu FI-6670A Bedienungsanleitung
Fujitsu
Fujitsu fi-6800 Handbuch
Fujitsu
Fujitsu S500M - ScanSnap - Document Scanner Handbuch
Fujitsu
Fujitsu M3096EX Handbuch
Fujitsu
Fujitsu SV600 Bedienungsanleitung
Fujitsu
Fujitsu fi-4530C Konfigurationshandbuch
Fujitsu
Fujitsu fi 5750C - Document Scanner Konfigurationshandbuch
Fujitsu
Fujitsu ScanSnap S1100i Montageanleitung
Fujitsu
Fujitsu FI-4010CU Bedienungsanleitung
Fujitsu
Fujitsu ScanSnap iScanner fi-6010N Bedienungsanleitung
Fujitsu
Fujitsu FI-5530C2 Konfigurationshandbuch
Fujitsu
Fujitsu fi-5650C Konfigurationshandbuch
Fujitsu
Fujitsu M3093E Handbuch
Fujitsu
Fujitsu fi-565PR Handbuch
Fujitsu
Fujitsu ScanSnap iScanner fi-6010N Handbuch
Fujitsu
Fujitsu fi-4860C Referenzhandbuch
Fujitsu
Fujitsu ScanSnap iScanner fi-6010N Bedienungsanleitung
Fujitsu
Fujitsu S510M - ScanSnap - Document Scanner Handbuch
Beliebte Scanner Handbücher anderer Marken
Infinite Peripherals
Infinite Peripherals INFINEA TAB M Bedienungsanleitung
Mustek
Mustek PageExpress 4800 Pro Bedienungsanleitung
Optex
Optex 750830 Bedienungsanleitung
Innova
Innova 5210 Bedienungsanleitung
Visioneer
Visioneer CardReader 100 Kurzanleitung
Rohde & Schwarz
Rohde & Schwarz TSME6 Bedienungsanleitung