Hoover Performance Floors & All HU86-FAL-S Bedienungsanleitung

Version 1.0

Performance

Floors & All

User Guide

HU86-FAL-S

Contents

Machine Overview

General Safety Information

Operation

Maintenance

FAQs

Other Information

CONTENTS

Unit

Filters & Accessories

NOTE: Some parts may vary according to model. Please check inside ﬂap of box for more details.

Handle

Air Bleed Hole

Extension Tube

Main Body

Release Button

Dirt Container

Release Button

Power ON/OFF Switch

Separator

Dirt Container

Post Motor Filter

Hose to Machine

Connector

Hose to Handle

Connector

Hose

Extension Tube

Release Button

Quick Release

Cord Hook

Power Cord

TurboTool

2-in-1 Tool

Pre-Motor Filter

Post-Motor Filter

MACHINE OVERVIEW 2

16 17 18 19

FOR HOUSEHOLD USE ONLY.

When using the vacuum cleaner, basic safety precautions should always be observed,

including the following:

1. Only use the vacuum cleaner indoors on dry surfaces and keep the area your cleaning well lit

2. Keep ﬁngers, hair and loose clothing from moving parts and openings whilst using the

vacuum cleaner

3. This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by a person responsible for their safety

4. Only Hoover recommended tools should be used with this vacuum cleaner

5. Don’t use this vacuum cleaner if it has been dropped, damaged or left outdoors

6. Don’t run over the power cord or use the vacuum cleaner if the power cord or plug is damaged.

7. Don’t handle the plug or use the vacuum cleaner with wet hands

8. Don’t use the power cord as a handle, pull the power cord around corners, sharp edges,

close a door over the power cord or unplug the vacuum cleaner by pulling on the power cord.

9. Don’t vacuum up sharp or hard objects or any ﬂammable or combustible materials (lighter ﬂuid,

petrol, kerosene etc.) or use the vacuum cleaner in an area with explosive vapours or liquid

10. Don’t vacuum up hot coals, cigarette butts, matches or smoking hot burning items or use in

an area where there may be harmful ﬂuids (chlorine, bleach, and ammonia drain cleaner)

11. Don’t attempt to remove blockages with sharp objects

12. Don’t use the vacuum cleaner with incorrect voltage as this may result in damage or injury

to the user. The correct voltage is listed on the ratings label

13. Turn off all controls on the vacuum cleaner before disconnecting or connecting the power cord,

hose or accessories

14. Always make sure both the pre-motor/post motor ﬁlters are in place before use.

15. Always take extra care when positioning the vacuum cleaner on the stairs.

16. Keep all openings clear and free from debris as this may affect the airﬂow/suction.

17. Always replace the fuse in the plug with a 13amp fuse. Always protect the power cable from

heated surfaces and open ﬂames.

18. Use only CE approved 13amp extension cords, non-approved extension cords may overheat.

Care should be taken to arrange the extension cord as it could be a trip hazard.

19. Store your vacuum cleaner in a cool, dry area. If ﬁlters have been cleaned as per user guide

instructions make sure they are thoroughly dry before storing away.

20. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or

similarly qualiﬁed persons in order to avoid a hazard

PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.

GENERAL SAFETY INFORMATION

Place the dirt

container onto the

main body and click

into position.

Align the main body

with the ﬂoor head

and push into place.

Push the hose into

the hose clips on

the machine.

Wrap the power

cord around the

quick release cord

hook and the lower

cord hook, continue

wrapping the

power cord until it

is secure.

Assembling your upright

Please read General Safety Information at the beginning before use.

OPERATION 4

Push the hose into

the hose to handle

connector and twist

to lock into position.

Insert the extension

tube into the top of

the main body and

click into place.

Using as a detachable canister ﬂoorhead without the main body

Before you begin cleaning

• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/

attachments, or removing and emptying the dirt container

• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does

overheat the thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum

cleaner off and unplug from electrical socket. Remove and empty the dirt container also check the vacuum

cleaner for blockages. Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned

the ﬁlters please wait 24 hours for the ﬁlters to fully dry before putting back into the vacuum)

• For best cleaning results ﬁlters require cleaning at least every 3 months

• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage

• When using the accessories always make sure the brushbar is switched to the off position

Twist the quick

release cord

hook to release

the power cord.

Place your foot

gently onto the

ﬂoorhead and pull

the handle back to

recline the machine.

To release the

handle with

extension tube

press the extension

tube release button

and lift the handle

to remove.

To remove the main

body: Hold the dirt

container handle,

press the main body

release button and lift

to remove.

Put the main body

to one side, use

ﬂoorhead for difﬁcult

to reach places.

Press extension tube

release button and lift

the handle to remove.

Press handle release

button, pull extension

tube to remove.

TIP: The brush bar will

not rotate when the

vacuum cleaner is in

the upright position.

Plug in the

machine.

Press the

power on/off

switch to turn

on.

OPERATION

Attaching accessories to telescopic tube or handle

Press extension tube

release button and

lift handle to remove

extension tube.

Choose an accessory.

a) 2 in 1 tool/crevice

& dusting brush

b) TurboTool

c) Microﬁbre dust pad

Attach accessories to

the end of extension

tube

or handle.

Always hold the

vacuum cleaner when

using the hose or

extension tube.

a b c

OPERATION 6

Emptying and cleaning the dirt container

Cleaning the pre motor ﬁlter

TIP: Filters require cleaning at least every three months.

TIP: Don’t overﬁll the dirt container to avoid clogging the ﬁlter.

Press the dirt container

release button and

pull to remove the dirt

container.

Hold dirt container

over a bin and press

the dirt container

release button to open,

allowing dirt to fall out.

When re-attaching the dirt

container, align the base ﬁrst

then push until you hear an

audible click. The dirt container

is now locked in place.

Tap the ﬁlter over a bin to

release any dirt.

Wash the ﬁlter under

running water (40°C

max).

tap

24hr

Leave to fully dry for at least 24 hours before

putting back into the vacuum cleaner.

Grasp tab on ﬁlter and

pull to remove.

Turn the dirt container

lid anti-clockwise and lift

to remove.

24hr

MAINTENANCE

Cleaning the shroud

Cleaning the post motor ﬁlter

Removing Debris from the Brushbar

TIP: Always make

sure the shroud

is fully dry and

correctly ﬁtted

before using the

machine.

Grasp tab on ﬁlter

and pull to remove.

Turn the dirt container

lid anti-clockwise and

lift to remove.

Press button on post motor

ﬁlter cover and remove.

Lift the shroud from the dirt

container and tap over a bin to

remove dirt and debris.

Tap the post motor ﬁlter over a bin to remove

any dirt and debris and replace it into the machine.

Pull the post motor

ﬁlter from the machine.

Wash the shroud under running water (Max

40°C) and leave to fully dry for at least 24 hours

before replacing back into the dirt container.

tap

24hr

40oC max

Grasp the centre

of the shroud and

pull to remove.

Switch off your vacuum cleaner at

the main socket. Using a pair of

scissors, cut any hair or debris free

from around the brushbar.

MAINTENANCE 8

Removing blockages from the TurboTool

Changing the belt

Remove the

rubber ring.

Using a pair of scissors,

cut any hair or debris free

from around the brushes.

Push both buttons to

open the turbo tool.

Tabs

Switch off and unplug

your vacuum cleaner.

Recline the vacuum and

lie it on its front, remove

5 screws to release

brushbar cover.

Lift the brushbar out

of the ﬂoor head and

remove the dry belt.

Remove the brushbar

cover and push the

ﬂoor head into

reclined position.

Remove the drive belt

and any debris from the

spindle. Loop new drive

belt around the spindle

ﬁrst and then onto the

brushbar. Insert the

brushbar back into the

ﬂoor head and replace

the brushbar cover, insert

5 screws to secure.

MAINTENANCE

Warning: Always switch off and unplug the vacuum cleaner before performing maintenance/

troubleshooting checks.

Inhaltsverzeichnis

Andere Hoover Staubsauger Handbücher

Hoover

Hoover Curve Bedienungsanleitung

Hoover

Hoover POWER SCRUB Bedienungsanleitung

Hoover

Hoover TurboPower WindTunnel Series Bedienungsanleitung

Hoover

Hoover REACT UH73100CDI Bedienungsanleitung

Hoover

Hoover HPS700 Bedienungsanleitung

Hoover

Hoover Commercial WindTunnel Bedienungsanleitung

Hoover

Hoover SmartWash Pet Complete Bedienungsanleitung

Hoover

Hoover 5221 ULTRA LIGHT Bedienungsanleitung

Hoover

Hoover ONEPWR EMERGE BH53600V Bedienungsanleitung

Hoover

Hoover TP71 Range Turbopower Bedienungsanleitung

Hoover

Hoover 53425 Bedienungsanleitung

Hoover

Hoover Telios Bedienungsanleitung

Hoover

Hoover Stick Cleaner S2535 Bedienungsanleitung

Hoover

Hoover FLOORMATE DELUXE FH40170 Series Bedienungsanleitung

Hoover

Hoover air cordless 2 in 1 Bedienungsanleitung

Hoover

Hoover XP81OP25 Bedienungsanleitung

Hoover

Hoover Breeze Bedienungsanleitung

Hoover

Hoover WindTunnel Dual V Bedienungsanleitung

Hoover

Hoover FREESPACE Bedienungsanleitung

Hoover

Hoover ONEFI VR81OF01 Bedienungsanleitung

Hoover

Hoover Velocity Evo Bedienungsanleitung

Hoover

Hoover FREEJET EVO Bedienungsanleitung

Hoover

Hoover Quickie Bedienungsanleitung

Hoover

Hoover Portapower C2089 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung

Nobles

Nobles 608669 Produkthandbuch