Kohler Englefield Valencia Elite Bedienungsanleitung

1278274-A02-D September 2023 engleﬁeld.co.nz

Page1

VALENCIA / VALENCIA ELITE

SINGLE DRAWER VANITY

FURNITURE | ® ®

BEFORE YOU BEGIN:

ROUGH-IN:

Please read these instructions carefully to familiarise yourself with the required tools, materials, and

installation sequences. Follow the sections that pertain to your particular installation. This will help you

avoid costly mistakes. In addition to proper installation, read all operating and safety instructions.

Prior to installation, inspect the cabinet and vanity top (either Durastone top, ceramic top or stone

quartz top) to ensure that no damage has occurred in transit. If damage has occurred, or a visible defect

exists, do not proceed with installation, and advise your supplier immediately.

Instructions, drawings, and diagrams contained in this manual present information available at the time

of printing.

Although every attempt has been made to keep them up-to-date, Engleﬁeld reserves the right to implement

product changes without further notice.

engleﬁeld.co.nz

Page2

1278274-A02-D September 2023

Please leave these instructions for the consumer. They contain important information.

INSTALLATION INSTRUCTIONS

750 900

455

405

Drain cut

out centered

1200

Drain cut outs

in each drawer

VALENCIA Single Drawer Vanity

VALENCIA ELITE

®®

1. Drawer removal

CONSTRUCTION REQUIREMENTS:

INSTALLATION:

TOOLS AND MATERIALS REQUIRED - (Not Supplied)

To suit pipework To suit screws

TOOLS MATERIALS - Not supplied & must be purchased separately

Fixing washers

20mm

Screws (Refer step 3)

10g x 75mm

www.engleﬁeld.co.nz

Page3

1278274-A02-D September 2023

INSTALLATION INSTRUCTIONS

850

A height of 850mm from the

ﬂoor to the top of the vanity

top is recommended.

50mm from top of cabinet

to centre of nog.

Stud finder

( a) Open the drawer and carefully lift up on

the end of the drawer to release it from

the runner locator pins. It may be necessary

to gently pry the runner away from the

drawer.

( b) The drawer is now only held by the runner

hooks at the back and can be pulled out in

the direction shown.

Locator pin Runner hook

Cabinets must be ﬁxed to a nog and at least one stud in the wall. The nog size should be 5 0 x 7 5 mm.

Use a stud ﬁnder to locate studs & nogs in ﬁnished walls.

VALENCIA Single Drawer Vanity

VALENCIA ELITE

®®

2 Changing drawer trims (Optional)

3. Water supply and waste pipe holes

engleﬁeld.co.nz

Page4

1278274-A02-D September 2023

INSTALLATION INSTRUCTIONS

( c) For 7 7 29 6 A - * :

To make the installation easier remove the

cabinet door. To release the door hinges press

the buttons at the rear of the hinges. ( a) Measure and mark the centres for water

supply and waste pipes on the back of the

cabinet.

NOTE : Ensure that plumbing holes are

positioned to allow for a maximum height of

260 mm between the bottom of the basin to

the base of the trap.

( b) With a suitably sized hole saw, drill the

holes for the water supply and waste.

( c) Having drilled the required holes ﬁt the

cabinet into position over the pipework.

NOTE: Before fastening the cabinet make

sure that it is sitting level and square.

NOTE : This section is only applicable if you

have purchased alternate trim for your vanity

cabinet.

( a) After the drawer has been removed (refer

to section 1 ) , unscrew the trim ﬁxing screws

from each angle bracket located behind either

side of the trim.

( b) Unscrew the 3 - 4 screws from underneath

the trim and remove the trim from the cabinet.

NOTE : Keep the screws for use later on.

that were removed from the original trim.

Button

Hook

Trim

Angle

brackets Angle

brackets

Maximum

height

260mm

VALENCIA Single Drawer Vanity

VALENCIA ELITE

®®

4 Fixing the vanity to the wall

5 Vanity top

6 Waste and tapware

engleﬁeld.co.nz

Page5

INSTALLATION INSTRUCTIONS

1278274-A02-D September 2023

NOTE: Screws should be positioned evenly

and ﬁxed into nogs or studs.

ensuring that the back is ﬂush against the

wall and there is an even overhang on either

side of the cabinet.

(d) Wipe off any excess silicone sealant.

(a) Fit the waste and tapware. Connect the

water supply to the taps and waste pipe to

the waste outlet.

(b) Run hot and cold water and check for

leaks.

When satisﬁed with the results move on to

the next section.

(e) Fix the cabinet to the wall using at least

6 screws for the 750mm & 900 mm cabinets

and 8 screws for the 1200 cabinets (min 10g

x 75 mm) and * 20 mm washers.

Screw through the back wall so that they

screw into the nog and stud(s) in the wall

behind.

* Washers must be used to spread the load.

(a) Unpack the top and check for any damage

that might have occurred in transit.

Check and conﬁrm the ﬁt of your selected

tapware.

(b) Apply a continuous bead of silicone (not

supplied) to the top edge of the cabinet sides

and back. Ensure there are no gaps in the

sealant bead. This will ensure the top stays

securely ﬁtted to the cabinet and no water

spillage will ﬁnd its way into the cabinet.

50mm

200mm

50mm

100mm

50mm

No silicone on

front edge

Mounting brackets screw positioning

Mounting

bracket

VALENCIA Double Drawer Vanity

VALENCIA ELITE

®®

8. Drawer Height Adjustment

Runner hook

engleﬁeld.co.nz

5 Vanity top

(a) Unpack the top and check for any damage that

might have occured in transit. Check and

confirm the fit of your selected tapware.

(b) Apply a continuous bead of silicone (not

supplied) to the top edge of the cabinet sides

and back. Ensure there are no gaps in the

sealant bead. This will ensure the top stays

securely fitted to the cabinet and no water

spillage will find its way into the cabinet.

No silicone on

front edge

(a) To re-install the drawers, extend the runners.

Place a drawer onto the runners and slide back

so that the runner hooks insert into the rear of

the drawer.

(b) Make sure the locator pins line up with the

holes in the bottom of the drawer and press the

drawer down so that the pins slot into place.

= =

7 Drawer re-installation

(a) All edges MUST be sealed with an approved

Silicone Sealant.

- Between cabinet and floor

- Bewteen cabinet and wall

- Between upstand and wall

8 Sealing

VALENCIA

Vanity

6 Waste and tapware

that the back is flush against the wall and

there is an even overhang on either side of the

cabinet.

(d) Wipe off any excess sealant.

(a) Fit the waste and tapware. Connect the water

supply to the taps and waste pipe to the waste

outlet.

(b) Run hot and cold water and check for leaks.

When satisfied with the results move on to the

next section.

(a) Remove the drawer. To tilt the drawer front

forward before adjusting the height of drawer.

(b) Turn anticlockwise on the locator pin spacer

to raise the height of the drawer and turn clock-

wise to raise down. Repeat on the other runner.

Note: All drawers are aligned during assembly. However

further adjustment is often required after installation.

Please ensure the cabinet has not been twisted

and installed correctly before adjusting.

Page6

INSTALLATION INSTRUCTIONS

7 Drawer re-installation

Height Adjustment Front Sectional View

DOWN

1278274-A02-D September 2023

a) To re-install the drawer, extend the runners.

Place the drawer onto the runners and slide it

back so that the runner hooks insert into the

rear of the drawer.

(b) Make sure the locator pins line up with the

holes in the bottom of the drawer and press

the drawer down so that the pins slot into place.

Hook the hinges onto the base plates and press

down as shown.

(a) All edges MUST be sealed with an approved

Silicone Sealant.

Locator pin

Hook

9 Sealing

INSTALLATION COMPLETE

Runner hook

*Mount Screws will

need to unscrewed

before removing the

drawer for latest

runners setup.

VALENCIA Double Drawer Vanity

VALENCIA ELITE

®®

Page7

1278274-A02-D September 2023

INSTALLATION INSTRUCTIONS

engleﬁeld.co.nz

(a) To re-install the drawers, extend the runners.

Place a drawer onto the runners and slide back

so that the runner hooks insert into the rear of

the drawer.

(b) Make sure the locator pins line up with the

holes in the bottom of the drawer and press the

drawer down so that the pins slot into place.

7 Drawer re-installation

(a) All edges MUST be sealed with an approved

Silicone Sealant.

- Between cabinet and floor

- Bewteen cabinet and wall

- Between upstand and wall

8 Sealing

INSTALLATION COMPLETE

Runner hook

Locator pin

INSTALLATION INSTRUCTIONS

ENGLEFIELD

CONTACT AND WARRANTY INFORMATION

NEW ZEALAND

Kohler New Zealand

0800 100 382

AUSTRALIA

engleﬁeld.com

info@engleﬁeld.co.nz

engleﬁeld.co.nz

For cleaning instructions, please refer to the Owner’s Information Leaﬂet.

Compression moulded vanity top:

To clean use non abrasive soap and water. It is recommended that the product surface is

wiped dry after each use to prevent the build up of soap and scum.

Vanity cabinet:

The materials used in the vanity cabinet are water resistant only, not water proof.

Care must be taken to clean up all water spillage onto the vanity cabinet surfaces.

To maintain the ﬁnish on your vanity cabinet clean with mild soapy water and dry with a soft

cloth.

WARNING

FOR YOUR PERSONAL SAFETY AND PRODUCT DURABILITY,

ENSURE THAT HOT WATER SUPPLY IS REGULATED TO 55°C MAXIMUM

CAUTION

Material used in cabinet is water resistant only, not waterproof.

Care must be taken to clean up all water spillage.

CLEANING AND MAINTENANCE INSTRUCTIONS

VALENCIA Double Drawer Vanity

VALENCIA ELITE

®®

Andere Handbücher für Englefield Valencia Elite

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Kohler Inneneinrichtung Handbücher

Kohler

Kohler 5900SP Montageanleitung

Kohler

Kohler K-2412 Montageanleitung

Kohler

Kohler K-26773-C05 Bedienungsanleitung

Kohler

Kohler M MODULAR Bedienungsanleitung

Kohler

Kohler TOOBI II Series Bedienungsanleitung

Kohler

Kohler AMERISSIC K-99073T Bedienungsanleitung

Kohler

Kohler Top Art K-14041 Montageanleitung

Kohler

Kohler CL Series Bedienungsanleitung

Kohler

Kohler K-2607 Montageanleitung

Kohler

Kohler K-45764T Bedienungsanleitung

Kohler

Kohler Verdera Bedienungsanleitung

Kohler

Kohler K-96106X-L Montageanleitung

Kohler

Kohler Kathryn K-2317-SN Bedienungsanleitung

Kohler

Kohler K-2461 Bedienungsanleitung

Kohler

Kohler K-2732 Montageanleitung

Kohler

Kohler K-11750 Montageanleitung

Kohler

Kohler Kathryn K-2318 Bedienungsanleitung

Kohler

Kohler K-CB-CLW2030DAW Bedienungsanleitung

Kohler

Kohler K-6138 Bedienungsanleitung

Kohler

Kohler Jacob Delafon Idol Bedienungsanleitung

Kohler

Kohler Natura 15457T Bedienungsanleitung

Kohler

Kohler M MODULAR Bedienungsanleitung

Kohler

Kohler PASTORIFE K-99074T Bedienungsanleitung

Kohler

Kohler Englefield Valencia Elite Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung