Kohler Verdera K-99007-TL-NA Montageanleitung

Installation and Care Guide

Lighted Medicine Cabinet

Français, page ″Français-1″

Español, página ″Español-1″

1267931-2-H

SAFETY INSTRUCTIONS

Read all instructions before using or installing this product.

WARNING: When using electrical products, basic precautions should always be followed,

including the following:

WARNING: Risk of electric shock. Grounding is required for the outlets within the power bar.

Connect only to a circuit protected by a Class A Ground-Fault Circuit-Interrupter (GFCI)*, which

protects against line-to-ground shock hazard. Use a 120 V, 15 A service.

WARNING: Risk of electric shock. A qualiﬁed electrician must route all electrical wiring for the

product. Improper installation will create an electrical hazard and may not comply with local

building and electrical codes.

WARNING: Risk of electric shock. Turn the electricity off at the circuit breaker or fuse box before

moving, testing, cleaning, or repairing this product. When unplugged, the electric supply will no

longer be electrically live, which will eliminate the risk of electric shock.

CAUTION: Risk of electric shock. Risk of electric shock. Electrical wiring may need to be

relocated.

NOTICE: Follow all local building, electrical, and plumbing codes.

IMPORTANT! A dimmer switch is required. This product is compatible with most residential dimmer

switches intended for incandescent and dimmable LED bulbs. For optimal dimming performance, a

programmable digital fade dimmer switch intended for LED lighting with a minimum rating of 150 W is

recommended.

*Outside North America, this device may be known as a Residual Current Device (RCD).

Speciﬁcations

Electrical Service

Power Bar 120 V, 60 Hz, 15 A Max

Light 120 V, 60 Hz, 0.8 A

Tools and Materials

Stud

Finder

GFCI/RCD

Receptacle

Dimmer

Switch

2x4 Lumber

(Recess-Mount Only)

Plus:

• Wire Cutter/Stripper

• Assorted Drill Bits

• Framing and Drywall Tools

• Framing and Drywall Fasteners

1267931-2-H 2 Kohler Co.

Before You Begin

CAUTION: Risk of personal injury. Medicine cabinets are very heavy. Get assistance lifting the

cabinet.

CAUTION: Risk of electric shock. For surface-mount installation, side mirror kit K-99012 or wood

kit K-99675 is required to enclose exposed electrical wiring.

NOTICE: Risk of property or product damage. The location of the cabinet is critical. Make sure that the

door will clear all obstacles (such as a faucet or light ﬁxture). Ensure that any obstacles behind the ﬁnished

wall will not be damaged during the cutting and/or drilling process.

IMPORTANT! The model K-99011-TL does not feature a reversible door.

IMPORTANT! Reroute any electrical wires or water supply piping from the wall cavity. If you encounter

drain or vent piping or if your wall is load-bearing, consult a professional before proceeding.

NOTE: Recessed-Mount Installation: The wall cavity must be framed. The cabinet must be secured to the

framing studs.

Observe all local building codes.

This medicine cabinet is for recessed- or surface-mount installations. Follow the instructions that

apply to your chosen installation.

The appearance of your medicine cabinet may differ from the medicine cabinet illustrated. The

installation steps still apply.

This installation is easiest when performed by two people.

When determining the height of the product, verify that the doors will clear all obstacles (such as a

faucet or light ﬁxture). A minimum distance of 3″(76 mm) is required.

Kohler Co. 3 1267931-2-H

Roughing-In Information

When determining the height of the product, verify that the door will clear all obstacles (such as a

faucet or light ﬁxture). Provide a minimum distance of 3″(76 mm).

Plan for the location of the dimmer switch and the GFCI/RCD receptacle. The electrical wires

should enter the power bar 5-1/2″(127 mm) from the bottom of the mirror.

3" (76 mm) Min

3" (76 mm)

5-1/2"

(127 mm)

Dimmer

Switch

GFCI/RCD

Receptacle

1267931-2-H 4 Kohler Co.

1. Preparation

IMPORTANT! The cabinet is designed for either right or left door swing (except K-99011-TL).

Recess-Mount Installation

Measure and mark the cutout for your model.

Surface-Mount Installation

Mark the mounting bar position and stud locations.

Determine the electrical wire hole locations according to the dimensions shown above for your

product.

4-5/8"

(117 mm)

Ø 3/4"

(19 mm)

28-1/4"

(718 mm)

K-99003-TLC

K-99007-TLC

K-99009-TLC

K-99011-TLC

Recess-Mount Installation Surface-Mount Installation

19-1/8"

(486 mm)

23-1/8"

(587 mm)

33-1/8"

(841 mm)

39-1/8"

(994 mm)

19-1/2"

(495 mm)

23-1/2"

(597 mm)

33-1/2"

(851 mm)

39-1/2"

(1003 mm)

Kohler Co. 5 1267931-2-H

2. Recess-Mount – Construct the Framing

NOTE: The following instructions are for recess-mount only. For surface-mount installation, refer to the

″Surface-Mount″sections.

Using a jigsaw or keyhole saw, carefully remove the ﬁnished wall material from the marked cutout.

Frame out the wall cavity. If needed, install a header.

IMPORTANT! Hole location in the framing is critical for electrical wire alignment with the cabinet. If you

plan to install an optional decorative surround, use the dimension speciﬁed for the cabinet plus surround.

For cabinet only installation: Mark the center of the hole 4-5/8″(117 mm) from the bottom of the

cavity, and 2-5/16″(59 mm) from the ﬁnished wall.

For cabinet plus surround: Mark the center of the hole 4-5/8″(117 mm) from the bottom of the

cavity, and 1-7/8″(48 mm) from the ﬁnished wall.

Drill a 3/4″(19 mm) hole into each side of the framed cavity at the marked locations.

Cabinet Only:

2-5/16" (59 mm)

Cabinet + Surround:

1-7/8" (48 mm)

4-5/8"

(117 mm)

Ø 3/4"

(19 mm)

1267931-2-H 6 Kohler Co.

3. Route the Wiring

Recess-Mount Installation

Drill a 3/4″(19 mm) hole into each side of the framed cavity, located 4-5/8″(117 mm) from the

bottom of the cavity.

Route the GFCI/RCD receptacle and dimmer switch wires through the holes in the framing.

The wiring should extend at least 20″(508 mm) from each hole.

Surface-Mount Installation

Drill two 3/4″(19 mm) holes for the electrical wire locations.

Route the GFCI/RCD receptacle and the dimmer switch wires through the holes in the ﬁnished

wall.

The wires should extend at least 20″(508 mm) from each hole.

20"

(508 mm)

20"

(508 mm)

Ø 3/4"

(19 mm)

Recess-Mount Installation Surface-Mount Installation

Ø 3/4"

(19 mm)

4-5/8"

(117 mm)

Kohler Co. 7 1267931-2-H

4. Recess-Mount – Install the Cabinet

NOTE: The following instructions are for recess-mount only. For surface-mount installation, refer to the

″Surface-Mount″sections.

If purchased, install the decorative surround before installing the medicine cabinet. Follow the

instructions packed with the surround.

IMPORTANT! Never leave the door supported with only one hinge attached. Get assistance supporting

the door.

Open and remove the door(s). While supporting the door, remove the screws from the bottom hinge

ﬁrst.

With assistance, position the cabinet into the cutout, and hold in place.

Use the screws provided to mount the cabinet to the framing studs using each of the four mounting

holes.

Decorative

Surround

(Optional)

K-99011-TLC Only

All Other Models

1267931-2-H 8 Kohler Co.

5. Surface-Mount – Install the Mounting Bar

NOTE: The following instructions are for surface-mount only. For recess-mount installation, refer to the

″Recess-Mount″sections.

Using a 3/16″drill bit, drill three holes on the groove of the mounting bracket. Position one hole at

a stud location.

Mark hole locations on the wall.

Drill holes at the marked locations on the wall.

Insert anchors (not provided) where needed.

Secure the mounting bar with three 2″hex head screws or screws provided with the anchors.

3/16"

(25 mm)

3/32"

Kohler Co. 9 1267931-2-H

6. Surface-Mount – Hang the Cabinet

NOTE: The following instructions are for surface-mount only. For recess-mount installation, refer to the

″Recess-Mount″sections.

IMPORTANT! Never leave the door supported with only one hinge attached. Get assistance supporting

the door.

Open and remove the door(s). While supporting the doors, remove the screws from the bottom

hinge ﬁrst.

Slide the hanger hooks onto the top T-slot.

Position each hook 2″(51 mm) from the ends of the cabinet.

Lift the cabinet onto the mounting bar. Make sure that the hanger hooks engage the bar.

All Other Models

K-99011-TLC Only

2" (51 mm)

1267931-2-H 10 Kohler Co.

Inhaltsverzeichnis

Sprachen:

Andere Kohler Inneneinrichtung Handbücher

Kohler

Kohler MAXISPACE 2.0 K-24374T Bedienungsanleitung

Kohler

Kohler Stillness 14388T Bedienungsanleitung

Kohler

Kohler Verdera Bedienungsanleitung

Kohler

Kohler Purist K-3080 Bedienungsanleitung

Kohler

Kohler K-1082 Montageanleitung

Kohler

Kohler K-20195 Montageanleitung

Kohler

Kohler 97631-G9 Montageanleitung

Kohler

Kohler Vanity K-2604 Montageanleitung

Kohler

Kohler Conceal K-2970 Montageanleitung

Kohler

Kohler K-CB-CLW2030DAW Montageanleitung

Kohler

Kohler SEQUOIA Bedienungsanleitung

Kohler

Kohler Top Art K-14041 Montageanleitung

Kohler

Kohler MING Bedienungsanleitung

Kohler

Kohler Natura 15457T Bedienungsanleitung

Kohler

Kohler K-23111T Bedienungsanleitung

Kohler

Kohler Verdera K-99003-TL Bedienungsanleitung

Kohler

Kohler Paradox K-15050T-UP Bedienungsanleitung

Kohler

Kohler K-2526 Montageanleitung

Kohler

Kohler Englefield 1141301 Bedienungsanleitung

Kohler

Kohler K-2967 Montageanleitung

Kohler

Kohler K-45775T Bedienungsanleitung

Kohler

Kohler K-2684 Montageanleitung

Kohler

Kohler Top Art K-14041 Bedienungsanleitung

Kohler

Kohler K-2962 Montageanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung