Kohler K-6536 Bedienungsanleitung

Installation

Guide

Barrier-Free Cast Iron Sink

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-6536

1019951-2-A

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and website are listed on

the back cover. Thanks again for choosing Kohler Company.

Before You Begin

CAUTION: Risk of personal injury or product damage. Cast

iron sinks are very heavy. Get help lifting the sink into place.

Read these instructions carefully before you begin this

installation.

Observe all local plumbing and building codes.

Prior to installation, unpack the new sink and inspect it for

damage. Return the sink to its protective carton until you are

ready to install it.

This sink is not intended for undercounter installation.

Inspect the drain and supply tubing. Replace if necessary.

The cabinet and frame shown in these instructions are generic

and may not represent the actual design or structure.

Due to the special nature of this installation, Kohler Co.

recommends that an experienced cabinet maker build the new

cabinet or modify an existing cabinet for this sink.

To ensure a safe and damage-free installation, two people should

install the sink.

Pencil

Drill

Safety

Glasses Tape

Measure Blade

Screwdriver Keyhole/Compass

Saw

Sealant

Plus:

1/2" or larger drill bit

Support frame members

1019951-2-A 2 Kohler Co.

Before You Begin (cont.)

Due to the variety of installations possible with this sink, you

may need to use procedures other than those described.

Kohler Co. 3 1019951-2-A

1. Wheelchair Accessibility Requirements

Provide clear ﬂoor space as shown per ANSI A117.1 (also

complies with ADA requirements).

2. Preparation

Install the water supplies and drain piping according to the

roughing-in information.

Tile-In Installations

Tile backer board installed over plywood is the recommended

underlayment for installing this sink. Tile should be bonded to

the backer board with dry set or latex Portland mortar.

Acceptable underlayments include:

•Tile backer board over 3/4″(1.9cm) exterior grade plywood

•3/4″(1.9cm) exterior grade plywood

IMPORTANT! Do not use:

•Flakeboard

•Interior grade plywood

•Gypsum wallboard

Consult with a tile contractor to determine the material to be

used.

6" (15.2cm) Max. Toe Clearance

Finished Wall

30"

(76.2cm) 48"

(121.9cm)

FRONT APPROACH SIDE APPROACH

30"

(76.2cm)

30"

(76.2cm)

9" (22.9cm) Min.

Toe Clearance

34"

(86.4cm)

Max.

Required Clear Floor

Space Per Front or

Side Approach Kitchen

Design

8" (20.3cm)

Min. Knee

Clearance

1019951-2-A 4 Kohler Co.

3. Cabinet/Support Frame Construction

CAUTION: Risk of personal injury or product damage. The

wood support and frame for the sink must sufficiently support

300 lbs. (136 kg) (approximate weight of the cast iron sink when

full and with a garbage disposal installed).

Construct a wood support frame to ﬁt inside a cabinet opening of

36” (91.4cm). Allow adequate clearance for the faucet assemblies

and sink basin.

For a barrier-free installation, the front frame member must be cut

from 2x4 (rough stock) to the size shown.

Front Frame

Member 2x4 Use

for barrier-free

installations when

installing the

K-6543 shroud

Back Frame Member 1"

(2.5cm) x 3" (7.6cm) Min. 23"

(58.4cm)36"

(91.4cm)

2-7/8"

(7.3cm)

Side Frame

Member 1"

(2.5cm) x 3"

(7.6cm) Min.

Support Frame

33-5/8" (85.4cm) Max.

33-3/8" (84.8cm) Min.

Front Support

Frame Member

36"

(91.4cm)

Opening

Kohler Co. 5 1019951-2-A

4. Support Frame Installation

Tile-In Installations

This sink is designed to be installed ﬂush with or slightly lower

than the surrounding tile. Measure and compare the thickness of

the sink rim and tile. The rim thickness on this sink is plus or

minus 1/32” (1mm). Take these measurements into consideration

when determining the support frame placement. Because of the

varying thickness of the tile and sink, or if adhesive or mortar

bed installation is used, you may need to make allowances to

shim the sink, or route the underlayment as required.

Undercounter and Solid Surface Installations

Position the support frame in the cabinet opening so when

installed, the top of the sink will be level and ﬂush with the top

of the cabinet.

All Installations

NOTE: Ensure that the securing hardware will not penetrate

through the cabinet walls.

Secure the support frame to the cabinet. Position the securing

hardware to allow for easy removal should the sink need to be

removed or replaced.

Support Frame

33-5/8" (85.4cm) Max.

33-3/8" (84.8cm) Min.

Front Support

Frame Member

36"

(91.4cm)

Opening

1019951-2-A 6 Kohler Co.

5. Install Mounting Bracket for Optional Shroud (K-6543)

Install Wall Bracket: Install the wall bracket on the back wall

with the bottom of the bracket 14-1/4″(36.2 cm) above the ﬂoor

using four #8 x 1″wood screws and wall plugs (included) if

needed.

Install Mounting Bracket: Snap the clip-on receptacle over the

large holes in the mounting bracket as shown. Install the

mounting bracket onto the bottom of the front support frame

member using two #8 x 1″wood screws (included). The edge of

the mounting bracket should be aligned with the edge of the

front support frame member.

Wall Bracket

Back Wall

Install the front

edge of the bracket

flush with the front

frame member

Wood Screw

#8 x 1" (2.5cm) Clip-On

Receptacle

Front Support

Frame Member

14-1/4"

(36.2cm)

Kohler Co. 7 1019951-2-A

6. Tile-In Installation

CAUTION: Risk of personal injury or product damage. Cast

iron sinks are very heavy. Get help lifting the sink into place.

Verify that the sink will ﬁt in the cabinet opening. If necessary,

sand the opening or add wood ﬁller strips.

Install the strainer or garbage disposal to the sink according to

the manufacturer’s instruction.

Install the faucet to the sink according to the manufacturer’s

instructions.

Apply a 1” (2.5cm) spot of sealant at each corner of the frame

where it will contact the sink.

NOTE: If using shims, additional sealant will be needed.

Carefully position the sink within the frame, making sure to

center the sink in the cabinet.

Verify that the sink is level. Adjust or shim between the sink and

support if needed.

Apply sealant in the spaces between the sink and the cabinet and

along the sides and back of the sink.

Install the tile. To absorb vibration from a garbage disposal, apply

sealant between the sink and tile directly next to the sink rim.

This will prevent the grout around the sink from cracking.

Sink

Sealant Tile

Cabinet

Mortar or

Adhesive

Water

Resistant

Underlayment

Support

Frame

3/4" (2cm)

Rim

Thickness Sealant

Sealant

Front Support

Frame Member

1019951-2-A 8 Kohler Co.

Tile-In Installation (cont.)

Connect and tighten the trap to the strainer, and complete the

water supply connections to the faucet according to the

instructions packed with the faucet.

Run water into the sink and check for leaks.

Clean up with a non-abrasive cleaner.

Kohler Co. 9 1019951-2-A

7. Undercounter Installation

CAUTION: Risk of personal injury or product damage. Cast

iron sinks are very heavy. Get help lifting the sink into place.

Verify that the sink will ﬁt in the cabinet opening. If necessary,

sand the opening or add wood ﬁller strips.

Install the faucet to the sink according to the manufacturer’s

instructions.

Install the strainer or garbage disposal to the sink according to

the manufacturer’s instructions.

Apply a 1” (2.5cm) spot of sealant at each corner of the frame

where it will contact the sink.

NOTE: If using shims, additional sealant will be needed.

Carefully position the sink within the frame, making sure to

center the sink in the cabinet.

Verify that the sink is level. The top of the sink should be ﬂush

with the top of the cabinet to allow proper countertop

installation. Adjust or shim between the sink and support if

needed.

Apply sealant in the spaces between the sink and the cabinet and

along the sides and back of the sink.

Determine the countertop cut-out shape and size.

Cabinet

Mortar or Adhesive

Sealant Countertop

Cabinet

Sealant

Support Frame

1/8" (3mm)

Laminate Installation

Solid Surface/Tile-In Installation

2" (5cm) Min. Sealant

Sealant

1/8" (3mm)

Support Frame

Front Support

Frame Member

Water Resistant

Underlayment

Sink

Backsplash

Sink

Backsplash

Countertop - Laminate

Three sides

1019951-2-A 10 Kohler Co.

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Loure T97330-4-CP Bedienungsanleitung

Kohler

Kohler K-T9493 Bedienungsanleitung

Kohler

Kohler K-2804 Bedienungsanleitung

Kohler

Kohler MINIMA K-45803T-L-SHP Bedienungsanleitung

Kohler

Kohler Reve K-5036BR Bedienungsanleitung

Kohler

Kohler K-7776 Montageanleitung

Kohler

Kohler Elate 13963X-4 Bedienungsanleitung

Kohler

Kohler K-7179 Montageanleitung

Kohler

Kohler K-14533 Bedienungsanleitung

Kohler

Kohler Glenbury Quiet-Close K-4733 Bedienungsanleitung

Kohler

Kohler K-T16236 Bedienungsanleitung

Kohler

Kohler STRAYT 37331-4 Bedienungsanleitung

Kohler

Kohler K-3900 Bedienungsanleitung

Kohler

Kohler K-8801 Montageanleitung

Kohler

Kohler URBANITY 23748T-9 Bedienungsanleitung

Kohler

Kohler K-22066-BL Bedienungsanleitung

Kohler

Kohler K-T16106 Bedienungsanleitung

Kohler

Kohler K-12286-4 Montageanleitung

Kohler

Kohler KARAT K-2960X Montageanleitung

Kohler

Kohler 8022A Bedienungsanleitung

Kohler

Kohler Margaux K-16230-4 Bedienungsanleitung

Kohler

Kohler NEW MEMOIRS K-76555T Bedienungsanleitung

Kohler

Kohler Cantata K-2199 Bedienungsanleitung

Kohler

Kohler K-R99252X-4CD Montageanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung