Kohler Mira Platinum Rear Fed Bedienungsanleitung

For SPARES,

ADVICE or REPAIRS

please call us free

on 0800 001 4040

(UK only)

Installation and User Guide

These instructions must be left with the user

Mira Platinum Rear Fed Shower Fittings

11559389-W2-A

Introduction

Thank you for choosing a Mira showers. To enjoy the full potential

of your new shower ttings, please take time to read this guide

thoroughly, and keep it handy for future reference.

Guarantee

Recommended Usage

Mira Showers guarantee this product against any defect in materials

or workmanship for a period of one year for the shower ttings.

This is e󰀨ective from the date of purchase.

Failure to follow the instructions provided with the shower

ttings will invalidate the guarantee.

For Terms and Conditions refer to the 'Customer Service'.

These ttings are designed for use with Mira showers only.

Domestic 

Light Commercial 

Heavy Commercial 

Healthcare 

Patents and Design Registration

Design Registration

6233204, 6233205, 6233206, 6233207, 6233208,

6233209, 6233210, 6233211, 6233200, 6233201,

6233202, 6233203, 6233197, 6233198, 6233199

Patents GB: 2 612 395, 2 466 504

Patent Application 2213874.7

21559389-W2-A

Pack Contents

1 x Slide Bar

Assembly

1 x Installation Template

1 x Hex Key

2 x 45 mm Screws

2 x Wall Plugs

2 x Hex Screws

1 x Showerhead

2 x End Plugs

2 x Brackets

1 x Right Angled

Connector (RAC) Kit

1 x Concealing Shroud

1 x Backplate

Assembly

1 x Signature Overhead

For Dual Outlet Product Only

1 x Shower Arm

1 x Fittings Pack

1 x Hose

2 x Rubber

Washers

31559389-W2-A

Please read the important safety information and the operation

section of this guide before using the shower ttings. Failure to follow

the instructions provided with this shower ttings will invalidate the

guarantee.

1. Installation of the shower ttings must be carried out in accordance

with these instructions by qualied, competent personnel. Read

all instructions for products being used in conjunction with these

ttings.

2. The plumbing installation must comply with all national or local

water regulations and all relevant building regulations, or any

particular regulation or practice specied by the local water supply

company.

3. A water treatment device should be installed where the water

hardness may exceed 200 ppm. Malfunctions caused by excessive

limescale formation are not covered by this shower’s guarantee

(see back page for details).

4. The showerhead should be positioned so that it discharges down

the centre line of the bath or across the opening of a shower

cubicle. The nished position of the overhead shower should also

be considered to prevent water spraying directly on to the shower

unit. The showerhead must be directed away from the shower unit,

during normal use the showerhead must not spray directly on to

the shower unit.

5. DO NOT t any form of ow control in the outlet pipe work if the

shower ttings are installed in conjunction with a product that

requires the ttings to act as a vent (e.g. an electric shower).

6. DO NOT use excessive force when making connections.

7. Avoid layouts where the shower hose will be sharply kinked. This

may reduce the life of the hose.

8. Special consideration should be given to the xing arrangements

when installing onto a dry lined, stud partition, shower cubicle

or laminated panel wall structures. Installers may wish to obtain

alternative proprietary cavity xings, or choose other options,

however, these methods of xing are beyond the scope of this

guide.

General

41559389-W2-A

9. DO NOT install the shower or ttings where they may be exposed

to freezing conditions.

10.The position of the shower ttings must provide a minimum air gap

of 25 mm between the showerhead and the spill over level of any

bath, shower tray or basin. There must be a minimum distance of

30 mm between the showerhead and the spill over lever of any

toilet, bidet or other appliance with a Fluid Category 5 backow

risk.

Hose retaining ring tted and shower ttings xed at a suitable height

preventing dirty water backow

Note: There will be occasions when the hose retaining ring will not provide

a suitable solution for Fluid Category 3 installations, in these instances

an outlet double check valve must be tted, this will increase the required

supply pressure typically by 10kPa (0.1 bar). Double check valves tted in

the inlet supply to the appliance cause a pressure build up, which a󰀨ect

the maximum static inlet pressure for the appliance and must not be tted.

For Fluid category 5 double check valves are not suitable.

Zone of

Backflow Risk

30 mm

Minimum

Toilet or Bidet

FC5

Hand Basin

FC3

Bath or Shower

Tray FC3

25 mm

Minimum

25 mm Minimum

51559389-W2-A

Important Safety Information

1. These ttings can be used by all children and persons with reduced

physical, sensory, or mental capabilities or lack of experience

and knowledge if they have been given supervision or instruction

concerning use of them in a safe way and understand the hazards

involved.

2. Children shall not be allowed to play with the shower.

3. Cleaning and user maintenance shall not be made by children

without supervision.

4. The showerheads must be descaled regularly. Any blockage of the

showerheads or hose can cause damage to the shower.

5. DO NOT change the handset and overhead model. Fit only shower

heads recommended by Mira and do no t any additional device

to restrict the water outlet ow.

6. Caution! Always check the water temperature is safe before

entering the shower.

7. Ensure all instructions on correct hose and their connections are

followed.

8. DO NOT hang anything on the hoses as this can cause premature

failure due to kinking.

9. DO NOT connect the outlet of the shower to any tap, control valve,

trigger operated handset or showerhead other than those specied

for use with this shower as the outlet acts as a vent for the tank

body. Only Kohler Mira recommended accessories should be used.

10. When adjusting the handset mode, point the handset away from

body and make sure that the water temperature has stabilised

before continuing to shower.

61559389-W2-A

Installation Schematic

71559389-W2-A

Installation: Shower Fittings

Note: To be trimmed after completion

of nished wall surface when installing

right angled connector.

Important! Ensure arrow on backplate

is oriented vertical as shown.

Disassemble the right angled connector

assembly and mark the locations of the

screw xings.

Drill the xing holes and t the wall plugs.

DO NOT drill through the backplate into

the wall.

Caution! Be aware of hidden pipes or

cables.

81559389-W2-A

Fit an isolating valve (not supplied) close

to the digital mixing valve for ease of

maintenance.

Make sure that the outlet pipe work

protrudes approx. 60 mm through a

Dia 20 mm hole square to the nish wall

surface.

29-33 mm

90°

Note: 15mm copper pipe

must be used here.

60mm

Finish the surface of the wall as required.

Trim the pipework back to the required

depth from the nished wall surface.

Remove all burrs and sharp edges.

8 mm

Important! Ensure arrow on

backplate is oriented vertical as

shown.

Secure the backplate to the wall so the

foam seal is fully compressed.

Fit the collet and seal retainer.

Re-check the pipe length.

Flush pipework to clear all debris.

Fit the o seal and elbow.

91559389-W2-A

1 min

O seal

Foam Seal

29-33 mm

Collet

Seal Retainer

O-ring

Seal

Retainer

600 mm

Clamp bracket

to be positioned

with the buttons

on left side.

Check for leaks.

Fit the cover. Carefully lift the cover to

locate the screw. Unscrew fully to lock

using the 2.5 mm hex key supplied.

The slide bar should be xed to the wall at a

convenient height for all the users. It should

be positioned so that water sprays down the

centre of the bath, or away from the opening

of a shower cubicle. Water should spray

away from the Bluetooth®controller when

the showerhead is held on the slide bar.

Decide on suitable position for slide bar

avoiding buried cables and pipes in wall.

Using template as guide, mark positions of

the xing holes for wall brackets (600 mm).

Important! Ensure arrow on backplate

is oriented vertical as shown.

101559389-W2-A

Cover

Wall Bracket

Slide Bar

Assembly

Inhaltsverzeichnis

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Parigi K-2175 Montageanleitung

Kohler

Kohler 84625 Handbuch

Kohler

Kohler 13EOZD Bedienungsanleitung

Kohler

Kohler K-T16225 Bedienungsanleitung

Kohler

Kohler K-T6808 Bedienungsanleitung

Kohler

Kohler K-5414 Betriebsanleitung

Kohler

Kohler K-7166-AF Montageanleitung

Kohler

Kohler K-10086 Montageanleitung

Kohler

Kohler VINTAGE K-7158 Bedienungsanleitung

Kohler

Kohler K-13700 Bedienungsanleitung

Kohler

Kohler K-616 Montageanleitung

Kohler

Kohler Memoirs Stately 3 Hole Basin Mixer Bedienungsanleitung

Kohler

Kohler K-1491 Bedienungsanleitung

Kohler

Kohler K-10577 Montageanleitung

Kohler

Kohler K-476, K-477 Montageanleitung

Kohler

Kohler Reve K-5148-8 Bedienungsanleitung

Kohler

Kohler SKYLINE Series Bedienungsanleitung

Kohler

Kohler K-812-H2 Montageanleitung

Kohler

Kohler K-5024-T Bedienungsanleitung

Kohler

Kohler Corbelle Comfort Height Revolution 360 ContinuousClean... Bedienungsanleitung

Kohler

Kohler K-8855 Bedienungsanleitung

Kohler

Kohler K-10268 Bedienungsanleitung

Kohler

Kohler AIRFOIL 37273T Bedienungsanleitung

Kohler

Kohler K-15251 Montageanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung