Kohler STEWARD ECO Bedienungsanleitung

1145740-T01-B

STEWARD ECO

INSTALLATION INSTRUCTIONS

0.5

0.5L TOUCHLESS URINAL (REAR INLET)

K-4888T( )

-1-

Observe all local plumbing and building codes.

Carefully inspect the new urinal for damage.

Site preparation may require additional tools and

hardware.

Handle with care. Vitreous china can break

or chip if the product is handled carelessly.

CAUTION: Risk of personal injury or product

damage.

Please read these instructions carefully to familiarize

yourself with the required tools, materials, and installation

sequences. Follow the sections that pertain to your

particular installation. This will help you avoid costly

mistakes. In addition to proper installation, read all

operating and safety instructions.

All information in these instructions is based upon the

latest product information available at the time of

publication. Kohler China reserves the right to make

changes in product characteristics, packaging, or

availability at any time without notice.

These instructions contain important care, cleaning, and

warranty information -

please leave instructions for the

consumer

Open end/adjustable wrenches

Tape measure

Basin wrench

Pipe wrench

Square

Level

Pliers

Socket wrench with sockets

Screw driver

Seal tape

Connection wire

Wire cutter

Insulation tape

Bushing

Drill

Sealant

RECOMMENDED TOOLS AND MATERIALS (NOT SUPPLIED)RECOMMENDED TOOLS AND MATERIALS (NOT SUPPLIED)

()

BEFORE YOU BEGIN

, 2010

528137

1145740-T01-B

0.18~0.55MPa. 0.5L

0.1MPa. 0.5L

1~ 55 C

0.07Mpa( )~0.86MPa( )

4888T

2 5 (AA 2)

SPECIFICATIONS

-2-

Model

Power

Liter per flushing

Temperature

Starting pressure

Testing time

Detecting method

4888T

2 AA size alkaline batteries""

Water pressure at 0.18~0.55 MPa:no more than 0.5L

Water pressure at 0.1 MPa:no more than 0.5L

Environmental temperature: 1 to 55 C

0.07Mpa (Dynamic pressure)~0.86MPa (Static pressure)

About 4 seconds

Detecting the urine and human movement

ROUGHING-IN

Unit:mm

Reference Value

Kohler reserves the right to change marked dimensions without prior notice.

Fig.1

[

552

2" NPT Tap

1/2"

402

Floor

Wall

600

356

198

415

180

Wall Hangers 166

750

2" NPT Tap

6262

Spud Detail

381

440

Center of

Hanger Slots

Roughing-in dimensions are identical if using an optional

3"outlet spud.

The urinal complies with ADA requirements when the rim

is mounted no higher than 432mm from the finished floor.

432mm

ADA

1145740-T01-B -3-

(

)

NOTE:

For Retrofit Installations

For New Installations

If a pre-existing waste pipe will be used and will result

in an acceptable rim height (refer to the rough-in dimensions),

follow the retrofit installation instructions.

Turn the water supply line off, remove the existing urinal,

then cap off the water supply line inside the wall.

Install waste pipe as necessary to conform to the

roughing-in dimensions.

Install adequate support framing for the hangers as

needed.

Wall Hangers

Wall

Hangers

Fig.2

PREPARE THE SITEPREPARE THE SITE

Panel, Nozzle

Cap

Gasket

Collar

Washer

Bolt

Waste Pipe

Apply Sealant Tape

Notice: To ensure an effective flush performance,

strongly recommended inner diameter of

water supply (including water meter, valve,

etc.) is no less than 25mm, and supplied

water pressure (sensor inlet dynamic

pressure) is 0.18MPa ~0.55MPa.

(

) 25mm (

) 0.18MPa ~0.55MPa

A. Install hook

Drill 2 mounting holes on the wall and install hook. Fix hook

on the wall by tightening screws.

INSTALLATION

Fig.3

Wall Hangers

Wall

1145740-T01-B -4-

f. Screw on the drain lid.

Fig.8

B. Install urinal

1. Install the sprayer and the adapter

a. Insert the sprayer into the hole, with the guide hole in the

middle.

b. Install the gasket and screw the nut tight.

c. Install the adapter and make the inlet at a 90 degree

angle to the left, as shown in Fig. 5.

c. 90 5

Fig.4

Fig.5

2. Install the drain and the plastic trap

a. Put the washer onto the drain and insert it into the hole.

b. Put the gasket and nut on the bottom.

Do not over screw the nut in this step, because it

is to be screwed tight in the next step after the

pipe is installed.

NOTE:

Fig.6

Fig.7

c. Connect the hose with the trap.

d. Screw the trap onto the drain and screw tight.

e. Screw tight the nut of the drain mentioned in step.

e. 2

Fig.9

3. Install the manual button and magnetic valve

a. Install the magnetic valve.

1145740-T01-B -5-

4. Install the sensor controller

a. Install the sensor controller box.

b. Install the spring.

c. Connect the sensor wire.

Fig.10

Fig.11

Fig.12

b. Install the manual button. Insert the button into the hole,

then put on the washer and the nut.

c. Connect with the hose.

Spring

Sensor Controller

Sensor Wire

C. Install and uninstall the Fixture, Valve Battery Box

Assembly

Unscrew the screws on the Fixture, Valve, Battery Box

Assembly and withdraw the clamp. Remove the Fixture,

Valve Battery Box Assembly from the urinal by moving it

rightwards and then downwards. Fix the Fixture, Valve

Battery Box Assembly back to the urinal by doing the above

steps inversely.

Screw

Clamp

Fixture, Valve,

Battery Box Assy.

Fixture, Valve,

Battery Box Assy. Fig.13

1145740-T01-B -6-

USER S GUIDEUSER S GUIDE

Illustrations

The urinal will automatically flush after using.

Fig.14

Deodorizing Flushing

The urinal will take a flush automatically when it's used 3 or 4

times in 2 minutes.

2 3-4

Replacement of Batteries

When the batteries run out, please remove the Battery Box

Assembly by following the instructions in step C and then

replace the batteries.

Battery Box Assy.

Screw M3 22

M3 22

Cover of Battery Box

Battery Box

Fig.15

1145740-T01-B

Manual Flushing

Sensorless Cleaning Mode

Press the manual button for about 2 seconds and the urinal

will automatically flush once.

Enter or exit the sensorless cleaning mode by pressing the

manual button for over 5 seconds.

Under this mode, press the manual button for about 2

seconds to control the urinal to flush or stop flushing. The

longest continuous flushing time is about 15 seconds.

This function will automatically exit after it is started for about

8 minutes.

This function can be used after the power is

turned on for ten minutes.

Notice:

Manual Button

Fig.16

-7-

MAINTENANCE

Fig.17

Clean the Filter Screen

If the flushing volume reclines sharply after installation or

used for a long time with no cause from water pressure, the

filter may need a wash. Please operate as following steps:

Remove the

a. Turn off the water supply and power

supply before cleaning the filter.

b. Avoid damaging or losing the filter during

cleaning.

Caution:

Fixture, Valve, Battery Box Assembly and take

out the filter, clean the filter and then reinstall it.

Filter Valve Cap Kit

Fixture, Valve,

Battery Box Assy.

1145740-T01-B -8-

TROUBLESHOOTING

No flushing 1. No power or mistake connected.

2. Not able to detect the urine.

3. Out of electricity.

1. Check the power connect.

2. See user's guide.

3. Replace batteries.

Please make following checks before repair:

Symptoms Probable causes Corrective actions

No flashing

1. The small hole of valve core is blocked.

2. The filter of valve core is blocked.

1. Clean the small hole of valve core with

thin steel wire.

2. Wash the filter of valve core with a brush.

If the trouble remains after above-mentioned actions are taken, please contact with us via distributor.

No flushing or poor

flushing

1. Adjusting bolt not fully open

2. Low water pressure.

3. Filter is obstructed.

1. Open the adjusting bolt.

2. Improve water supply.

3. Clean the filter.

IMPORTANT CONSUMER INFORMATION

Consumer Responsibilities

1. Do not directly flush the sensor with water. The sensor is

an electronic instrument.

2. Keep away from strong electromagnetic field.

3. Clean the urinal with soft rag and neutral liquid detergent.

Do not use eradicator, abrasive powder or oil, acid or

alkali liquid detergent.

4. Urinal is designed for use with potable water. Avoid water

that includes a lot of contaminants or acid/alkali water and

impure water.

5. All electrical connection must be compliance with related

regulation and codes.

6. All installation staff should be well familiar with installation

instruction.

WARNING

WARNING: Risk of product damage.

Never spit phlegm and throw stub or

something else into the urinal.

Please avoid using articles either dissolvable or with

the diameter smaller than 5mm, such as moth ball.

Do not throw into the urinal what is easy to block it,

such as newspaper, paper pilch.

Do not bump the vitreous china with great force to

prevent it from damaging and leaking.

Do not use the product in the water below 0 C.

5mm

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler 1152813-A2-A Bedienungsanleitung

Kohler

Kohler K-205 Montageanleitung

Kohler

Kohler 18492-CP Montageanleitung

Kohler

Kohler K-8801 Montageanleitung

Kohler

Kohler rada Thermotap-3 Bedienungsanleitung

Kohler

Kohler K-29221T Series Bedienungsanleitung

Kohler

Kohler K-11496X Montageanleitung

Kohler

Kohler K-193-4-CP Bedienungsanleitung

Kohler

Kohler K-1517 Bedienungsanleitung

Kohler

Kohler WELLWORTH WATERGUARD K-3520 Bedienungsanleitung

Kohler

Kohler STANCE Series Bedienungsanleitung

Kohler

Kohler K-6340 Montageanleitung

Kohler

Kohler Cyan K-705788 Bedienungsanleitung

Kohler

Kohler Purist 7505D Bedienungsanleitung

Kohler

Kohler K-T72771 Montageanleitung

Kohler

Kohler K-35025-DWG Bedienungsanleitung

Kohler

Kohler K-6354 Bedienungsanleitung

Kohler

Kohler K-7702 Bedienungsanleitung

Kohler

Kohler Mira Honesty Bedienungsanleitung

Kohler

Kohler RiverBath Quadrangle K-1365-F2 Bedienungsanleitung

Kohler

Kohler Stillness K-14450 Bedienungsanleitung

Kohler

Kohler 10-Jet K-1000-H2 Bedienungsanleitung

Kohler

Kohler K-307 Montageanleitung

Kohler

Kohler K-3363 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung