Kohler Torsion Bedienungsanleitung

These instructions must be left with the user

Installation Guide

Torsion Round Sliding Shower

July 2019 1281734-A02-C

1G006-02

Safety Information

Ensure the door is undamaged and no parts are missing.

Ensure the panel size is suitable for the installation. Tempered glass cannot be cut.

The wall retainers must be installed onto a waterproof, vertical and flat wall surface.

Failure to do so will result in an unsatisfactory seal, which may cause property damage.

The wall inclination (out-of-squareness) is should be out by no more than ±4mm/m.

It is the responsibility of the INSTALLER to ensure that the installation complies with

council and/or local authority bylaws.

Instructions, drawings and diagrams contained in this manual present information

available at the time of printing. Although every attempt has been made to keep them

up-to-date, KOHLER reserves the right to implement product changes without

futher notice.

Attention

GENERAL INFORMATION

INTRODUCTION

future reference.

General

Care should be taken to avoid hidden pipes or wires when drilling into walls and floors.

We recommend that the unit is installed by a qualified shower installer or plumber.

TOOLS REQUIRED

3.0 mm

#1 sqr

drive 6.0 mm

CONSTRUCTION REQUIREMENTS

Due to the weight of the glass panels, KOHLER strongly recommends fixing the

wall retainers to double studs in the wall framing.

Attention

Double

studs

Double

studs

1000 x 1000 1000 1000

1200 x 1000 LH 1200 1000

1200 x 1000 RH 1000 1200

Dim “A”Nominal Size Dim “B”

4.0 mm 2.0 mm

PACK CONTENTS

Component Pack

x 8

8 x 50 mm

x 2 x 2

1 x 3 mm

x 8 x 8

8 x 19 mm

x 1 x 2

x 1

x 3

Handle Pack Twisted Glass Aftercare Pack

x 1

Info Booklet

Applicator

X 1

flat

panel curved

panel

X 1

X 2

Pack 1

X 1 X 4

X 2

X 1

Pack 2

INSTALLATION OPTIONS

This shower enclosure is designed to be installed onto tiled floor and walls.

However, an acrylic wall & tray installation may also be possible. Please refer to

all applicable documentation before proceeding.

The door frame is to be assembled before placing it in its designated location.

This task will require two people.

Note

Tray: For tray installation refer to the instructions supplied with the tray.

Wall: The vertical wall retainers MUST be installed onto the waterproof membrane

PRIOR TO WALL TILING. If possible, the complete door/return system should

be installed onto the waterproof membrane prior to wall tiling.

CAUTION: Failure to install the wall retainers first may mean the door system

may not fit on the shower tray due to the tile thickness.

The design of the wall retainer allows for tiling even if not installing the complete

door system first. The installer can still tile up to the wall retainer as the cover

extrusion fits in from the front.

Proceed to page 8, Installation.

OPTION 2 - Tiled Wall & Acrylic Tray

The door and return can be installed directly onto the wall and floor tiles.

OPTION 1 - Tiled Wall & Floor

For tiled base option:

- Mark from the medium of installation to

the outer edge of the retainer channel.

i.e: If installing onto waterproof membrane,

(pre-tiling), mark from the face of the

membrane to the outer edge of retainer.

If installing onto tiled wall, mark from

the finished face of tiled wall to the

outer edge of retainer.

Please disregard the acrylic base pictured

within these instructions.

Proceed to page 8, Installation.

1000 x 1000

1200 x 1000 LH

1200 x 1000 RH

975 975

1175 975

975 1175

ASize B

(a) Separate the wall channels from the glass panels.

INSTALLATION

10 mm

± 0 mm

(a)

(b)

(c)

(d)

(e)

(f)

(g)

Position the side panel wall channel on wall. Use a level to ensure it is upright.

Ensure that the tiled floor or tray is level, and walls are vertical and square.

Drill the holes and insert the wall plugs if required.

Position wall channel on the wall and partially install fixing screws .

Apply silicone sealant according to the manufacturer’s instructions along the

length of the wall and at the bottom of wall channel. Remove excess sealant.

± 0 mm

10 mm

(a)

(b)

(c)

(d)

(e)

(f)

Position the second channel on the wall. Use a level to ensure it is upright.

Drill the holes and insert the wall plugs if required.

Position wall channel on the wall and partially install fixing screws .

Apply silicone sealant according to the manufacturer’s instructions along the

length of the wall and at the bottom of wall channel. Remove excess sealant.

Andere Handbücher für Torsion

Inhaltsverzeichnis

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler ARTIFACTS 72798T Bedienungsanleitung

Kohler

Kohler ODEON K-8766 Bedienungsanleitung

Kohler

Kohler K-9018 Montageanleitung

Kohler

Kohler MINIMA K-45805T Bedienungsanleitung

Kohler

Kohler K-9142 Bedienungsanleitung

Kohler

Kohler LOURE 98452T-CP Bedienungsanleitung

Kohler

Kohler K-7179 Montageanleitung

Kohler

Kohler Soleo 8690 Bedienungsanleitung

Kohler

Kohler Rada 215 Series Bedienungsanleitung

Kohler

Kohler Mira Response Handset L19A Bedienungsanleitung

Kohler

Kohler Rada T1 Bedienungsanleitung

Kohler

Kohler Mira Logic L19B Bedienungsanleitung

Kohler

Kohler TAUT 73194T-4E2 Bedienungsanleitung

Kohler

Kohler K-2268 Bedienungsanleitung

Kohler

Kohler 114753-2-CD Bedienungsanleitung

Kohler

Kohler K-2958 Montageanleitung

Kohler

Kohler K-1107 Bedienungsanleitung

Kohler

Kohler K-2098 Montageanleitung

Kohler

Kohler K-20257T-CP Bedienungsanleitung

Kohler

Kohler K-T945 Bedienungsanleitung

Kohler

Kohler Singulier 7787T-4 Bedienungsanleitung

Kohler

Kohler 10089W-CP Bedienungsanleitung

Kohler

Kohler K-6814 Montageanleitung

Kohler

Kohler K-14431 Montageanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung