Kramer VM-218DT Bedienungsanleitung

VM-218DT Quick Start

P/N:

2900- 300931QS

Rev:

Scan for full manual

VM-218DT Quick Start Guide

This guidehelps you install and useyour VM-218DT for the first time.

Go to www.kramerav.com/downloads/VM-218DT todownload the latest user manual andcheck if firmware

upgrades are available.

Step 1: Check what’s in the box

VM-218DT HDMI/HDBT Switcher/DA

1 Quick start guide

1 Set of rack ears

1 Power cord

4 Rubber feet

Step 2: Get to know your VM-218DT

Feature

Function

IR LED

Lights orange when the unit accepts IR remote commands.

IR Sensor

Use to control a peripheral device connected to OUT 2 HDBT with that device’s remote

controller.

POWER LED

Lights when the unit is powered.

VOLUME ()

Press to decrease the volume of the analog audio output.

VOLUME ()

Press to increase the volume of the analog audio output.

INPUT Selector Button

Press to select input 1 HDMI or input 2 HDBT.

INPUT LEDs

Lights green to indicate the selected input: 1 HDMI or 2 HDBT.

EDID READ Button

Press to read the selected EDID and write it to both inputs.

EDID SELECT Button

Press to cycle through the sources from which to read the EDID: Default, External, or Output.

When Output is selected, cycles through outputs 1 to 9. The relevant EDID TYPE and OUTPUT

LEDs light green.

EDID TYPE LEDs

Lights green to indicate the selected EDID type: DEFAULT, EXT. (external) or OUTPUT.

OUTPUT LEDs (1 to 9)

In normal operation mode: lights green when an acceptor is connected to the output.

In EDID mode: when EDID TYPE OUTPUT LED lights green, press the EDID SELECT button

briefly to cycle through output 1 to 9 to select the output from which to read EDID. The relevant

LED lights during EDID setup and remains lit after completing the EDID setup.

Feature

Function

IN 2 IR on a 3.5 Mini Jack

Connect to an IR emitter/sensor cable for IR link extension via IN 2 HDBT.

IN 2 RS-232 (G, Rx, Tx) Terminal Block

Connector

Connect to a serial controller for RS-232 link extension via IN 2 HDBT.

IN 1 HDMI™Connector

Connect to an HDMI source.

IN 2 HDBT on RJ-45 Connectors

Connect to an HDBT transmitter (for example, TP-580Txr).

IR OUT on 3.5 Mini Jacks (2 to 9)

Connect to remote IR emitter/sensor cables to IR control the devices that

are connected to the HDBT acceptors.

RS-232 OUT (G, Rx, Tx) Terminal Block

Connectors (2 to 9)

Connect to serially control the devices connected to the HDBT acceptors.

OUT 1 HDMI Connector

Connect to a local HDMI acceptor.

OUT HDBT RJ-45 Connectors (2 to 9)

Connect to HDBT receivers (for example, TP-580Rxr).

AUDIO OUT 3.5mm Mini Jack

Connect to an analog audio acceptor.

RS-232 CONTROL 3-pin Terminal Block

Connect to the serial controller to control the VM-218DT.

REMOTE 3-pin Terminal Block

For future use.

SETUP DIP-switches

Use to set the device behavior.

ETHERNET RJ-45 Connector

Connect to LAN for remote IP control of the VM-218DT.

RESET Button

Press and hold while powering on the device to reset to factory default

parameters.

PROG Mini USB Connector

Connect to a PC to perform firmware upgrades.

Mains Power Connector, Fuse, and Switch

Connect to the mains supply.

Step 3: Install VM-218DT

Install VM-218DT using one of the following methods:

Remove the three screws from each side of the unit, reinsert those screws through the rack ears

and mount on a 19" rack.

Attach the rubber feet and place the unit on a flat surface.

Step 4: Connect the inputs and outputs

Always switch OFF the power on each device before connecting it to your VM-218DT. For best results, we recommend that

you always use Kramer high-performance cables to connect AV equipment to the VM-218DT.

RJ-45 Pinout:

DIP-Switch Settings

For the Ethernet connector, see the wiring diagram

below:

Changes to the DIP-switches only take effect on power-up. After

changing a switch, reboot the device. All DIP-switches are set to Off

(up) by default.

PIN EIA /TIA 568B

Wire Color

Feature

Dip-switch Settings

Orange / White

Reserved

Orange

Reserved

Green / White

Audio de-

embedding

On (down) –Disable audio de-embedding. Note

that the audio output port is muted.

Off (up) –Enable audio de-embedding to the

analog audio output port (default).

Blue

Green

Brown / White

Force RGB

On (down) –Force RGB mode.

Off (up) –Normal mode (default)

Brown

For optimum range and performance use the recommended Kramer cables available at www.kramerav.com/product/VM-218DT.

Step 5: Connect the power

Connect the power cord to VM-218DT and plug it into the mains electricity.

Safety Instructions

Caution:

There are no operator serviceable parts inside the unit.

Warning:

Use only the power cord that is supplied with the unit.

Warning:

Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.

Warning:

Disconnect the power and unplug the unit from the wall before installing.

See www.KramerAV.com for updated safety information.

Step 6: Operate the VM-218DT

Web pages:

RS-232 and Ethernet:

RS-232/Ethernet

Baud Rate:

115,200

Parity:

None

Data Bits:

Command Format:

ASCII Protocol 3000

Stop Bits:

Example (Route input 1 to output 1):

#ROUTE 1,1,1 <cr>

Ethernet Parameters

IP Address:

192.168.1.39

Subnet Mask:

255.255.0.0

Default UDP Port #:

50000

Default Gateway:

192.168.0.1

Full Factory Reset

Front Panel

Buttons:

Front panel buttons: power off the device, press and hold the

RESET button for 3 seconds while powering the device, and

then release.

Protocol 3000:

“#factory” command.

Web Pages:

In the Device Settings page, click Reset.

Technical Specifications

Inputs

1 HDMI

On a female HDMI connector

1 HDBT

On an RJ-45 connector

Outputs

1 HDMI

On a female HDMI connector

8 HDBT

On RJ-45 connector

1 Unbalanced Stereo Audio

On a 3.5mm mini jack

Ports

1 IR IN

On a 3.5mm mini jack for IR link extension via IN 2 HDBT

8 IR OUT

On 3.5mm mini jacks for IR link extension via OUT HDBT (2 to 9)

1 RS-232 IN

On a 3-pin terminal block for serial link extension via IN 2 HDBT

8 RS-232 OUT

On 3-pin terminal blocks for serial link extension via OUT HDBT (2 to 9)

1 Mini USB

On a female USB connector for firmware upgrade

1 RS-232

On a 3-pin terminal block for device control

1 10/100BaseT Ethernet

On an RJ-45 female connector for device control via LAN and Ethernet link

extension via IN HDBT and OUT HDBT (2 to 9)

Extension Reach

4K @60Hz (4:2:0)

Up to 40m (130ft)

Full HD (1080p @60Hz 36bpp)

Up to 70m (230ft)

Compliance

HDBaseT 1.0

Video

Max. Resolution

4K@60Hz (4:2:0) and 4K@30Hz (4:4:4)

Compliance

Supports HDMI 2.0 and HDCP 1.4

RS-232 Extension

Baud Rate

300 to 115,200

Analog Audio

Max Level

1 Vrms

THD + Noise

0.03% @1kHz at nominal level

Controls

Front Panel

Front panel buttons: input select, volume, EDID, IR

Indication LEDs: input select, EDID type, outputs

Rear Panel

RS-232 device control

RS-232 remote control via HDBT ports

IR remote control via HDBT ports

Ethernet device control

DIP-switches

Supported PC Web

Browsers

Windows 7 and Higher

Internet Explorer (32/64 bit) version 10

Firefox version 30

Chrome version 35

MAC

Chrome version 35

Chrome version 63.0.3239.84

Firefox version 30

Firefox version 57.0.2

Safari version 7

Minimum Browser Window Size

1024 x 768 when in full screen mode

Power

Consumption

65VA

Source

100-240V AC, 50/60Hz

Environmental

Conditions

Operating Temperature

0° to +40°C (32° to 104°F)

Storage Temperature

-40° to +70°C (-40° to 158°F)

Humidity

10% to 90%, RHL non-condensing

Regulatory

Compliance

Safety

CE, FCC

Environmental

RoHs, WEEE

Enclosure

Size

19” 1U

Type

Aluminum

Cooling

Fan ventilation

General

Net Dimensions (W, D, H)

43.6cm x 23.7cm x 4.4cm

(17.2” x 9.3” x 1.7”)

Shipping Dimensions (W, D, H)

52.5cm x 33cm x 10.7cm

(20.7” x 13” x 4.2”)

Net Weight

2,47kg (5.5lbs) approx.

Shipping Weight

3.23kg (7.1lbs) approx.

Accessories

Included

Power cord, rack ears

Optional

For optimum range and performance use the recommended USB, Ethernet, serial

and IR Kramer cables available at

www.kramerav.com/product/VM-218DT

Specifications are subject to change without notice at www.kramerav.com

The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Andere Kramer Medienkonverter Handbücher

Kramer

Kramer 482 Bedienungsanleitung

Kramer

Kramer VM-3A Bedienungsanleitung

Kramer

Kramer VP-480 Bedienungsanleitung

Kramer

Kramer PC-49 Bedienungsanleitung

Kramer

Kramer KDS-EN5 Bedienungsanleitung

Kramer

Kramer VM-4DH Bedienungsanleitung

Kramer

Kramer VP-410 Bedienungsanleitung

Kramer

Kramer VP-420 Bedienungsanleitung

Kramer

Kramer KDS-EN7 Bedienungsanleitung

Kramer

Kramer VM-16HDMI Bedienungsanleitung

Kramer

Kramer VP-451 Bedienungsanleitung

Kramer

Kramer 575 Bedienungsanleitung

Kramer

Kramer KIT-500 Bedienungsanleitung

Kramer

Kramer VP-472 Bedienungsanleitung

Kramer

Kramer FC-31xl Bedienungsanleitung

Kramer

Kramer VM-1110xl Bedienungsanleitung

Kramer

Kramer FC-331 Bedienungsanleitung

Kramer

Kramer TOOLS VP-100 Bedienungsanleitung

Kramer

Kramer VP-439 Bedienungsanleitung

Kramer

Kramer VP1 Bedienungsanleitung

Kramer

Kramer VP-475UX Bedienungsanleitung

Kramer

Kramer OC-1N Bedienungsanleitung

Kramer

Kramer DigiTOOLS 6410N Bedienungsanleitung

Kramer

Kramer TP-583Txr Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung