Life Gear STEP MAKER PRO 97340 Bedienungsanleitung
Owner’s Manual
MODEL # 97340
2008, Sept.
STEP MAKER PRO
1
PAGE OF CONTENTS
ONE YEAR LIMTED WARRANTY
LifeGear Inc. warrants to the original purchaser that this product is free from defects in material and workmanship when used for the purpose
intended, under the conditions that it has been installed and operated in accordance with LifeGear's Owner's Manual. LifeGear's obligation under
this warranty is limited to replacing or repairing, free of charge, any parts which may prove to be defective under normal home use. This warranty
does not include any damage caused by improper operation, misuse or commercial application.
From the date of purchase, the frame is warranted to be free from defects for 1 (one) year. This warranty is extended only to the original owner
and is not transferable. When ordering replacement parts please have the following information ready:
WARRANTY 1
SAFETY INSTRUCTIONS 2
OVERVIEWDRAWING 4
PARTS LIST 5
HARDWARE PACKING LIST 6
ASSEMBLY INSTRUCTIONS 7
FOLDINGUPTHETREADMILLANDINCLINEADJUSTMENT 10
COMPUTER OPERATION 11
TROUBLE SHOOTINGGUIDE 14
RUNNINGBELTADJUSTMENTANDLUBRICATION 15
WARM UP AND COOLDOWN ROUTINE 16
1. Owner's Manual
2. Model Number
3.Description of Parts
4.Part Number
5.Date of Purchase
2
Basic precautions should always be followed, including the following safety instructions when using this treadmill: Read all
instructions before using this treadmill.
DANGER: To reduce the risk of electric shock, please read the following:
zAlways unplug the treadmill from the electrical outlet immediately after using and before cleaning, assembling, or servicing.
NOTE: Failure to follow these instructions may lead to personal injury and cause damage to the treadmill.
WARNING: To reduce the risk of burns, fire, electric shock or injury to any persons, please read the following:
zNever leave the treadmill unattended when plugged in. Disconnect by turning off the master power switch, and unplugging from
outlet when not in use and before putting on or taking off parts.
zUse this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the
manufacturer.
zNever operate this treadmill if it has a damaged cord or plug, or if it is not working properly. If it has been dropped or damaged, or
been exposed to water, return the appliance to a service center for examination and repair.
zDo not attempt any maintenance or adjustments other than those described in this manual. Should any problems arise, discontinue
use and consult an Authorized Service Representative.
zNever operate the appliance with the air openings blocked. Keep the air openings free of lint, hair, and the like.
zDo not use the treadmill outdoors.
zDo not pull the treadmill by its power cord or use the cord as a handle.
zKeep children and pets away from the equipment while in use. This machine is designed for adults only.
zDo not operate where aerosol (spray) products are being used or where oxygen is being administered.
zKeep Dry - do not operate in a wet or moist condition. Save these instructions.
zDo not operate the treadmill near a blanket. Excessive heating can occur and cause fire, electrical shock, or injury to user.
zKeep electrical cord away from heated surfaces.
zNever insert any object into any opening.
zKeep the treadmill on a solid, level surface with the minimum safety area clearance of 2000mm x 1000mm of the treadmill. Be sure
the area around the treadmill remains clear during use and has adequate clearance.
zThis treadmill is for household use only.
zWear comfortable and suitable clothing when using the treadmill. Do not use the treadmill barefoot, in only socks or in sandals,
always wear athletic shoes. Never wear loose clothing because it could run the risk of getting caught in the treadmill.
zOnly one person should be on the treadmill while in use.
zAlways hold on to the handrails while using the treadmill.
SAFETY INSTRUCTIONS
3
zAlways make sure the storage latch is in place when folding and moving the treadmill.
zDo not leave children who are under 12 year-old unsupervised near or on the treadmill.
zThis appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
zIf the supply cord is damaged, it must be replaced by the manufacture, its service agent or similarly qualified persons in order to avoid a hazard.
zPull out the Safety Tether Key for emergency stop. Reinstall the Safety Tether Key onto the Computer Console. Press the ON button to begin
exercise again.
Note: It is the obligation of the owner to review and explain these safety precautions to all users of this treadmill.
WARNING: Connect the treadmill to a properly grounded outlet only.
SAVE THESE INSTRUCTIONS
This product must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current
reducing the risk of electric shock. * This treadmill is equipped with a cord having equipment grounding connector and a
grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with
all local codes and ordinances.
DANGER: Improper connection of the treadmill grounding connector can result in the risk of electric shock. Check with a qualified
electrician, if you are in doubt as to whether the product is properly grounded. Do not modify the plug provided with the treadmill. If it will
not fit your outlet, have a properly grounded outlet installed by a qualified electrician.
This product is for use on a nominal 220 volt circuit and has a grounding plug. Make sure that the product is connected to an outlet
having the same configuration as the plug.
zThis unit must be plugged into a nominal 220 volt 50/60 hz, which has a grounding.
zKeep hands clear of all moving parts. Never place hands, feet under the treadmill.
zDo not use the treadmill on a carpet that is greater than 1/2 inch in height.
zBefore using the treadmill, check that the running belt is aligned and centered on the treadmill bed and all visible fasteners on the
treadmill are sufficiently tightened and secure.
WARNING: Before beginning any exercise program consult your physician. This is especially important for the
persons who are over 35 years old or who have pre-existing health problems. Read all instructions before using any fitness equipment.
We assume no responsibility for personal injury or property damage sustained by or through the use of this product. Do not operate this
exercise equipment without properly fitted guards, as the moving parts can present a risk of serious injury to young children.
CAUTION: Read all instructions carefully before operating this product. Retain this Owner's Manual for future reference.
4
OVERVIEWDRAWING
5
Part # Description Quantity Part # Description Quantity
1 Main Frame 1
2 Base Frame 1
3 Adjustable Pad 2
4 End Cap for Base Frame 2
5 Transportation Wheel Cap 2
6 Transportation Wheel 2
7 Rod for Transportation Wheel 2
8 Screw (M4x10) 4
9 Running Deck 1
10 Front Roller, Drive 1
11 Rear Roller, Tension 1
12 Running Belt 1
13 Motor Base 1
14 Bushing 2
15 Axis 1
16 Drive Motor 1
17 Bracket forDrive Motor 1
18 PCB Motor Controller 1
19 Drive Belt 1
20 Sensor 1
21 Bracket for Sensor 2
22 Switch, AC Power 1
23 Rubber Bumper 8
24 Side Rail 2
25 Bolt (M8x60) 2
26 Screw (M4x16) 13
27 Screw (M6x35) 8
28 Nut (M6) 8
29 Nut (M8) 4
30 End Cap (25x50) 2
31 Upper Dust Cover 1
32 Lower Dust Cover 1
33 Screw (M4x60) 4
34 Left Handrail 1
35 Right Handrail 1
36 Handlebar 1
37 End Cap for Handlebar 2
38 Computer 1
39 Computer Bracket Cover 1
40 Bolt (M5x10) 4
41 Safety Tether Key 1
42 Handlebar Adorner 2
43 Bolt (M8x50) 4
44 End Cap (30x60) 2
45 Foam Grip 2
46 Spacer 2
47 Cap Nut 2
48 Bolt (M10x60) 2
49 Nut (M10) 4
50 Bolt (M8x16) 6
51 Nut 1
52 Safety Tube A 1
53 Safety Tube B 1
54 Bolt (M8x40) 1
55 Spring Washer (M8) 11
56 Nylon Washer 2
57 Spring Knob 1
58 Foot Pad 2
PARTS LIST
6
59 Left Rear Cap 1
60 Right Rear Cap 1
61 Incline Beam 1
62 Cover for Incline Beam 2
63 Bolt (M10x40) 2
64 Bushing 2
65 Tapping Screw (ST4x10) 4
66 Upper Hand Pulse Sensor w/Wire 2
67 Lower Hand Pulse Cover 2
68 Screw (M3x20) 4
69 Bolt (M8x35) 1
70 Screw (M8x12) 2
71 Bolt (M8x45) 2
72 Screw (M4x12) 3
73 Sensor Cable I (850 mm.) 1
74 Sensor Cable II (1100 mm.) 1
75 Sensor Cable III (600 mm.) 1
76 Speed Button w/Wire 1
77 End Cap ( 25) 1
78 End Cap ( 20) 1
79 Fuse Box 1
80 Cable, Power Plug 1
81 Nylon Nut (M4) 3
82
83 Cable Switch/PCB 1
84 Wire for Fuse Box 1
85
86
87
88 Gas Spring 1
89 Mode Button w/Wire 1
90 Wire Cap 1
Part # Description Quantity Part # Description Quantity
HARDWARE PACKING LIST
43 Bolt (M8X50) ------------------------------------------------------------------------------------------4
50 Bolt (M8X16) ----------------------------------------------------------------------------------6
55 Spring Washer (M8)--------------------------------------------------------------------------6
Allen Wrench/Phillips Screwdriver
1 PC Allen Wrench
1 PC
7
ASSEMBLY INSTRUCTIONS
Install Handrails
1. Connect the Sensor Cable I (73) and Sensor Cable II (74).
2. Fasten the Right Handrail (35) to the Base Frame (2) with three M8x16 Bolts (50) and M8
Spring Washers (55).
Repeat this step to assemble the Left Handrail (34). Careful not to crimp, pinch or otherwise
damage the cable and cable connections.
Install Handlebar
3. Attach the Handlebar (36) onto the top of the Left and Right Handrails (34, 35) with two
Handlebar Adorners (42) and four M8x50 Bolts (43).
1
2
2-1
3-1
3
73
74
35
2
34
36
43
35
42
55 & 50
8
4. Connect the Sensor Cable II (74) and Sensor Cable III (75). Place the connection inside of
Right Handrail (35). Careful not to crimp, pinch or otherwise damage the cable and cable
connections.
5. Insert the End Caps (44) into the Left and Right Handrails (34, 35).
Install Computer
6. Remove the Computer Bracket Cover (39).
ASSEMBLY INSTRUCTIONS
4
4-1
75
74
35
5
6
5-1 34 44
35
39
36
9
7. Connect the Hand Pulse Wires (66), Speed Button Wire (76), Mode Button Wire (89), and
Sensor Cable III (75) to the wire that come from the Computer (38).
8. Assemble the Computer (38) onto the bracket of the Handlebar (36) with four M5x10 Bolts
(40). Place the wire connections inside the room of the Handlebar (36) bracket and cover up
the Computer Bracket Cover (39).
ASSEMBLY INSTRUCTIONS
8
7-1
8-1
7
38
38
75
66
40
36
39
Inhaltsverzeichnis
Andere Life Gear Tretmühle Handbücher
Life Gear
Life Gear MARK X 97582H Bedienungsanleitung
Life Gear
Life Gear 97288HP Bedienungsanleitung
Life Gear
Life Gear 97988T Bedienungsanleitung
Life Gear
Life Gear 97010 Bedienungsanleitung
Life Gear
Life Gear 97930 Bedienungsanleitung
Life Gear
Life Gear CAMINADORA 97001 Bedienungsanleitung
Life Gear
Life Gear 97018 Bedienungsanleitung
Life Gear
Life Gear 97355 Bedienungsanleitung
Life Gear
Life Gear 97990 Bedienungsanleitung
Life Gear
Life Gear 98850 Bedienungsanleitung
Life Gear
Life Gear 97400 Bedienungsanleitung
Life Gear
Life Gear ACACIA PRO Bedienungsanleitung
Life Gear
Life Gear 97630 Bedienungsanleitung
Life Gear
Life Gear 97430 Bedienungsanleitung
Life Gear
Life Gear PACE MAKER PRO 97320 Bedienungsanleitung
Life Gear
Life Gear 97114 Bedienungsanleitung
Life Gear
Life Gear 40215 Bedienungsanleitung
Life Gear
Life Gear 97960 Bedienungsanleitung
Life Gear
Life Gear 40120 Bedienungsanleitung
Life Gear
Life Gear 98105 Bedienungsanleitung
Beliebte Tretmühle Handbücher anderer Marken
Smooth Fitness
Smooth Fitness EVO 3i Bedienungsanleitung
NordicTrack
NordicTrack NETL81810.0 Bedienungsanleitung
Schwinn
Schwinn 830/Journey 8.0 Bedienungsanleitung
Keys Fitness
Keys Fitness HealthTrainer HT-740T Bedienungsanleitung
Spirit
Spirit XT8 Bedienungsanleitung
NordicTrack
NordicTrack T 14.0 Treadmill Bedienungsanleitung