Mazda 0000-8G-K05 Bedienungsanleitung

Page 1 of 4

AS 090-M11406cma0708

Genuine Accessories

Installation Instructions

Part Numbers:

0000-8G-K05, 0000-8G-K03 (R3 Model)

Applicable Models:

2009 > RX8

Package Contents

Front Mask

Tools Required

Stubby Phillips

Screwdriver

Fiber Stick

(Optional)

Snap Head Screw (Qty. 2)

Front End Cover (Qty. 1)

0Before Installation

A. Area to be covered by mask must be clean. It is recommended that you wash and wax vehicle prior to installation.

B. Both vehicle and mask must be completely dry prior to installation. If moisture under mask is allowed to dry on

vehicle, paint may cloud.

C. Any repainted surfaces in contact with mask must be allowed to cure completely. Consult paint manufacturer or

repair facility if you are not sure.

D. The use of a fiber stick may be required while inserting pads.

1Install Hood Cover

A. With hood open, stretch hood cover (A)

onto hood, pulling each side one or two

inches at a time, until corners fit snugly.

Install hooks on ends of straps (B)

into corresponding holes on underside

of hood. Pull evenly on ends of

adjustable straps (B) until tight. Secure

loose ends in elastic loops.

Hood Cover (Qty. 1)

Washer (Qty. 10)

Wellnut (Qty. 8)

Index Screw (Qty. 8)

Page 2 of 4

AS 090-M11406cma0708

2Remove wheel well fasteners

A. Using stubby phillips screwdriver, remove plastic

fasteners and screws along front edge of both front

wheel wells that correspond to snaps on mask. A. In both front wheel wells, using a stubby phillips

screwdriver, install wellnuts (C), washers (D) and index

snap head screws (E) into 4 holes as shown.

B. In both front wheel wells, using a stubby phillips

screwdriver, install washer (D) and #8 snap head screw

(F) into hole at fender seam.

3Install wheel well hardware

Install Upper Headlight Pads

A. Lay mask (G) over front of vehicle, Starting on the drivers

side, slide upper headlight pad (H) under fender tip.

4Install Fender Tip Pockets

A. Continue sliding upper headlight pad (H) between fender

and headlight. Install pocket (I) under fender tip.

B. Repeats steps 4 and 5 on the passengers side.

Page 3 of 4

AS 090-M11406cma0708

8Install grill attachments

A. Insert 3 pads (N) between grill and

bumper..

B. Feed velcro loops (P) through small

openings in grill. With velcro loops

fed down behind bumper, attach to

velcro hook (Q) located at underside

edge of bumper facia.

Install headlight attachments

A. On driver’s side of vehicle, Attach clip (K) to metal edge

of fender rail.

B. Attach clip (L) to edge of upper radiator support.

C. Insert 3 pads (M) into slots in between headlights and

bumper.

D. Repeat step 7 on the passenger’s side.

Install wheel well attachments

A. Press snaps (J) onto snap head screws (E) and (F) in both

front wheel wells.

QQQQ

Page 4 of 4

AS 090-M11406cma0708

12 Care and Cleaning

A. Always remove mask before washing vehicle.

B. Hand clean mask using mild soap, rinse thoroughly with

clean water and line dry completely. Do not machine dry!

C. Use Mazda Vinyl/Leather Protectant (or equivalent) to

preserve color and finish.

D. WARNING: Running up on curb will damage this product.

Manufacturer will not be responsible for damage to product

due to accident or misuse.

11 Post Installation Inspection

A. Close hood and check alignment between hood cover

and front end cover along seam (between fender and

hood). If adjustment is necessary, adjust the hood cover

by adjusting the hood cover straps. Refer to step 1.

B. If mask should flap due to high speed or wind conditions,

adjust or remove mask completely.

C. Provide installation instructions to final customer.

9Install vent attachments

A. On both sides of vehicle, insert pad (R) between fog

light mounting bracket and bumper.

B. Attach plastic clips (S) to rear edge of fog light vents.

10 Install lower clips

A. On both sides of the vehicle attach plastic clips (T) to

bottom edge of bumper.

Dieses Handbuch passt für folgende Modelle

Andere Mazda Autozubehör Handbücher

Mazda

Mazda 0000-8L-R02 Bedienungsanleitung

Mazda

Mazda CX-3 Bedienungsanleitung

Mazda

Mazda BDEL-V7-410 Bedienungsanleitung

Mazda

Mazda 0000-8E-N31 Bedienungsanleitung

Mazda

Mazda 0000 8C Z01 Bedienungsanleitung

Mazda

Mazda 0000 81 L25 Bedienungsanleitung

Mazda

Mazda C830-V7-050A Bedienungsanleitung

Mazda

Mazda Bluetooth Handsfree System Bedienungsanleitung

Mazda

Mazda PROTEGE 5 Bedienungsanleitung

Mazda

Mazda DN4J-V7-110 Bedienungsanleitung

Mazda

Mazda 0000-8G-L12 Bedienungsanleitung

Mazda

Mazda CT-L1005 Installationsanleitung

Mazda

Mazda Auto-Dimming Mirror Bedienungsanleitung

Mazda

Mazda A2DP Bedienungsanleitung

Mazda

Mazda 6 GJ 2.2 D 2012 Bedienungsanleitung

Mazda

Mazda TD11 V3 460F Leitfaden

Mazda

Mazda CX-9 Bedienungsanleitung

Mazda

Mazda KPF1 V3 460 Leitfaden

Mazda

Mazda GENUINE SIDE UNDER SPOILER Bedienungsanleitung

Mazda

Mazda CX-9 Bedienungsanleitung

Mazda

Mazda KMV6V7210 Bedienungsanleitung

Mazda

Mazda 0000-8G-N03 Bedienungsanleitung

Mazda

Mazda 0000-8L-G03A Bedienungsanleitung

Mazda

Mazda Highbay BY007P Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung