Metra Electronics 99-3410 Bedienungsanleitung

5 6

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

Re-connect the battery terminal and test the unit

for proper operation. Slide (4) Speed Clips over

the holes in the sub-dash mounting brackets and

mount the head unit/kit assembly with (4) Phillips

Pan-Head Screws supplied.

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

PAGE

APPLICATIONS

CAR

CHEVROLET

Tracker 1998-04..........................................................1

GEO

Metro 1992-94............................................................1

Tracker 1992-97..........................................................1

SUZUKI

Aerio 2003.................................................................. 2

Esteem 1995-03..........................................................2

Sidekick 1992-98........................................................1

Swift 1992-94............................................................. 1

Vitara series 1999-04.................................................1

KIT COMPONENTS

TOOLS REQUIRED

Equalizer

Dummy Plate

(4) #8 x 1" Phillips

Pan-Head Screws

(4) Speed Clips

Cutting tool

Wrench

Phillips screwdriver

Radio Housing

KIT FEATURES

Shaft and

DIN unit

provisions

Equalizer

provisions

99-3410

AW -341GO

DW -3410

INSTALLATION

INSTRUCTIONS

REV. 07-29-09

1-800-221-0932 www.metraonline.com

2-SHAFT HEAD UNITS: Slide the

aftermarket head unit into the kit and

secure with shaft nuts. (see Fig. A)

DIN HEAD UNITS: Cut and remove the

shaft supports. Slide the DIN cage into the

Radio Housing and secure by bending the

metal locking tabs down. Slide the

aftermarket head unit into the cage until

secure. (see Fig. B)

ALL VEHICLES

Fig. A Fig. A

Fig. B Fig. B

IF AN EQUALIZER WILL BE INCLUDED :

Slide the aftermarket equalizer into the back of

the Radio Housing. Using the hardware

included with the equalizer, mount the unit to

the kit. (see Fig. A)

IF AN EQUALIZER WILL NOT BE

INCLUDED: Snap the Equalizer Dummy

Plate into the Radio Housing. (see Fig. B)

KOWER

NOWLEDGE IS

nhance your installation and fabrication skills

by enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com

or call 800-354-6782 for more information

and take steps toward a better tomorrow.

Harness:

Antenna Adapter:

WIRING AND ANTENNA CONNECTIONS (Sold Separately)

• Please visit www.metraonline.com for specific interface

applications

• 40-GM10 - GM antenna adapter 88-up

Disconnect the negative battery terminal to

prevent an accidental short circuit. Remove

the climate control knobs. Remove (1)

Phillips screw located above the radio

opening. Unclip the radio trim bezel.

Remove (4) screws from the factory head

unit, slide the unit out and disconnect the

wiring.

Disconnect the negative battery terminal to

prevent an accidental short circuit. Unclip

the dash trim bezel and remove. Remove

(4) Phillips screws securing the factory head

unit and disconnect the wiring.

Cut and remove all mounting tabs on the

Radio Housing EXCEPT tabs "A". The

mounting tabs can be identified by the

stamped letter on the back of each tab. Skip

to the Installation Instructions for ALL

VEHICLES on Page #3.

Cut and remove all mounting tabs on the

Radio Housing EXCEPT tabs "B". The

mounting tabs cab be identified by the

stamped letter on the back of each tab. Skip

to the Installation Instructions for ALL

VEHICLES on Page #3.

Cut and remove all mounting tabs on the

Radio Housing EXCEPT tabs "B". The

mounting tabs cab be identified by the

stamped letter on the back of each tab. Skip

to the Installation Instructions for ALL

VEHICLES on Page #3.

Disconnect the negative battery terminal to

prevent an accidental short circuit. Remove

the climate control knobs. Remove (1)

Phillips screw above and (2) Phillips screws

below the climate controls. Unclip the radio

trim bezel. Remove (4) screws from the

factory head unit, slide the unit out and

disconnect the wiring.

SUZUKI Esteem 1995-03

SUZUKI Aerio 2003

GEO Metro / SUZUKI Swift 1992-94

1 2

Cut and remove all mounting tabs on the Radio Housing

EXCEPT tabs "B". (The mounting tabs can be identified by

the stamped letter on the back of each tab). (see Fig. A). Cut

and remove the (2) side clips on the back side of the radio trim

bezel. (This will provide proper clearance when re-attaching

the bezel after the aftermarket head unit has been installed).

(see Fig. B). Skip to the Installation Instructions for ALL

VEHICLES on Page #3.

CHEVROLET Tracker 1998-04 • GEO Tracker 1992-97

SUZUKI Sidekick 1992-98 / Vitara series 1999-04

Disconnect the negative

battery terminal to prevent an

accidental short circuit.

Remove the cigarette lighter

and climate control knobs.

Remove the ashtray and (1)

screw exposed. Pull out on the

climate control cluster and

remove (2) screws exposed.

Unclip the radio trim bezel.

Remove (4) screws from the

factory head unit, slide the unit

out and disconnect the wiring.

Fig. A

Fig. B

Dieses Handbuch passt für folgende Modelle

Andere Metra Electronics Autozubehör Handbücher

Metra Electronics

Metra Electronics 95-8166G Bedienungsanleitung

Metra Electronics

Metra Electronics Chrysler 300 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-7365B Bedienungsanleitung

Metra Electronics

Metra Electronics 70-1722 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-8712 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-6511 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-7424 Bedienungsanleitung

Metra Electronics

Metra Electronics GMOS-06 Bedienungsanleitung

Metra Electronics

Metra Electronics 95-2009 Bedienungsanleitung

Metra Electronics

Metra Electronics 95-7863 Bedienungsanleitung

Metra Electronics

Metra Electronics 95-5817 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-2005 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-3107S Bedienungsanleitung

Metra Electronics

Metra Electronics 70-5701 Service-Handbuch

Metra Electronics

Metra Electronics 95-3023HG Bedienungsanleitung

Metra Electronics

Metra Electronics 99-6507 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-9100 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-7343 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-5803 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-1005 Bedienungsanleitung

Metra Electronics

Metra Electronics GMOS-11 Bedienungsanleitung

Metra Electronics

Metra Electronics 95-7393B Bedienungsanleitung

Metra Electronics

Metra Electronics 99-8206 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-7400 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Renault

Renault 77 11 423 180 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung