Milwaukee PRO Lux MW700 Bedienungsanleitung

USER MANUAL

MW700

PRO Lux Meter

milwaukeeinstruments.com (USA & CAN)

milwaukeeinst.com

CERTIFICATION

Milwaukee Instruments conform to the

CEEuropean Directives.

Disposal of Electrical & Electronic

Equipment. Do not treat this product as

household waste. Hand it over to the

appropriate collection point for the recycling of

electrical and electronic equipment.

Disposal of waste batteries. This product

contains batteries. Do not dispose of them

with other household waste. Hand them

over to the appropriate collection point for recycling.

Please note: proper product and battery disposal

prevents potential negative consequences for human

health and the environment. For detailed information,

contact your local household waste disposal service or

go to www.milwaukeeinstruments.com (USA & CAN)

or www.milwaukeeinst.com.

RECOMMENDATION

Before using this product, make sure it is entirely

suitable for your specific application and for the

environment in which it is used. Any modification

introduced by the user to the supplied equipment

may compromise the meter’s performance. For your

and the meter’s safety do not use or store the meter in

hazardous environment. To avoid damage or burn, do

not perform any measurement in microwave ovens.

WARRANTY

This instrument is warranted against defects in

materials and manufacturing for a period of 2 years

from the date of purchase.

Probe is warranted for

6 months.

This warranty is limited to repair or free

of charge replacement if the instrument cannot be

repaired. Damage due to accidents, misuse, tampering

or lack of prescribed maintenance is not covered by

warranty. If service is required, contact your local

Milwaukee Instruments Technical Service. If the repair

is not covered by the warranty, you will be notified of the

charges incurred. When shipping any meter, make sure

it is properly packaged for complete protection.

Milwaukee Instruments reserves the right to make

improvements in design, construction and appearance

of its products without advance notice.

SATISFACTION

GUARANTEED

ISTMW700 07/20

OPERATION

yThe meter is supplied complete with a 9V battery.

Remove the battery compartment cover on the back

of the meter and install the battery into the battery

clip connector while observing polarity.

yPut the light sensor on a stable surface and the meter

at a proper distance to avoid any interference or

disturb to the sensor illumination.

yTurn the meter on by pressing the ON/OFF key.

yPress one of the three “Range keys” to select the

proper scale according to the intensity of the light.

y“1“ on the LCD indicates that it is necessary to increase

the measure scale. Press the next range key. The

decimal point moves through the display and finally

the correct value is shown.

Range

keys

yWait for about 1 second for the reading to stabilize.

yAfter about 5 minutes of non-use, the meter shuts o.

Note: Verify the sensor is clean before taking any

measurement.

BATTERY REPLACEMENT

When the battery becomes weak the meter will

display a blinking “ “ low battery indicator.

When it appears, the battery has only about 50

hours of working time left. A low battery will result

in unreliable measurements. Prompt battery

replacement is required.

Battery replacement must only take place in a non-

hazardous area using an alkaline 9 V battery.

Turn the meter o, slide the battery compartment

cover located at the rear of the meter o and replace

the 9V battery with a new one.

Make sure the battery contacts are fully engaged in

the connector, seat the battery in its compartment

and replace the cover.

SPECIFICATIONS

RANGE

0.000 - 1999 Lux

2000 - 19999 Lux

20000 - 50000 Lux

RANGE SETTING Manual

through key buttons

RESOLUTION

0.000 - 1999 Lux ±1 Lux

2000 - 19999 Lux ±10 Lux

20000 - 50000 Lux ±100 Lux

ACCURACY ±6% of reading ±1 digits

PEAK WAVE LENGTH 560 (nm)

SENSOR TYPE Silicon Photodiode

(connected to meter)

SENSOR SENSITIVITY 100 scotopic Lux

SENSOR STABILITY ±2% change per year

(in first two years)

POWER SUPPLY 1 x 9 V alkaline battery

AUTO-OFF after about 5 minutes

of non-use

BATTERY LIFE approximately 150hours

of continuous use

ENVIRONMENT 0 to 50ºC; RH95%

DIMENSIONS 143 x 80 x 32 mm

WEIGHT

(METER WITH SENSOR) approximately 270 g

Andere Milwaukee Messgerät Handbücher

Milwaukee

Milwaukee C65 Bedienungsanleitung

Milwaukee

Milwaukee MAX MW160 Bedienungsanleitung

Milwaukee

Milwaukee ORP 57 Bedienungsanleitung

Milwaukee

Milwaukee MI 413 Bedienungsanleitung

Milwaukee

Milwaukee MW605 MAX Bedienungsanleitung

Milwaukee

Milwaukee REDLITHIUM Bedienungsanleitung

Milwaukee

Milwaukee MI455 Bedienungsanleitung

Milwaukee

Milwaukee SM700 Bedienungsanleitung

Milwaukee

Milwaukee MI 413 Bedienungsanleitung

Milwaukee

Milwaukee MW500 Bedienungsanleitung

Milwaukee

Milwaukee SMS510 Bedienungsanleitung

Milwaukee

Milwaukee 2217-40 Bedienungsanleitung

Milwaukee

Milwaukee M12 3632-20 Bedienungsanleitung

Milwaukee

Milwaukee 2235-40 Bedienungsanleitung

Milwaukee

Milwaukee MC730 Bedienungsanleitung

Milwaukee

Milwaukee MW11 Bedienungsanleitung

Milwaukee

Milwaukee MW301 Bedienungsanleitung

Milwaukee

Milwaukee MW100 Bedienungsanleitung

Milwaukee

Milwaukee MW10 Bedienungsanleitung

Milwaukee

Milwaukee LDM 45 Bedienungsanleitung

Milwaukee

Milwaukee MC110 Bedienungsanleitung

Milwaukee

Milwaukee pH 58 Bedienungsanleitung

Milwaukee

Milwaukee MW802 Bedienungsanleitung

Milwaukee

Milwaukee 48-22-9801 Bedienungsanleitung

Beliebte Messgerät Handbücher anderer Marken

Suaoki

Suaoki D40 Bedienungsanleitung

Elster

Elster BK-G1.6 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Deltabar FMD71 Handbuch

Duratool

Duratool D03128 Bedienungsanleitung

Vega

Vega VEGAPULS 65 Bedienungsanleitung

Tonghui

Tonghui TH2618B Bedienungsanleitung

Tenmars

Tenmars TM-801 Bedienungsanleitung

MSR

MSR 145 Bedienungsanleitung

TPS

TPS WP-82 Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 003C30 Bedienungsanleitung

Tenma

Tenma 72-10465 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Proline Promag 50 Technische Daten

Siemens

Siemens SITRANS F Coriolis FCT030 Stücklistenhandbuch

KLINGER

KLINGER CMF V Series Bedienungsanleitung

Keysight

Keysight M8290A Bedienungsanleitung

Acterna

Acterna MS1400 Bedienungsanleitung

R&S

R&S ZPH Bedienungsanleitung

Datacolor

Datacolor ColorReader DC10-2 Bedienungsanleitung