Oase ProMax MudDrain 7000 Bedienungsanleitung

ProMax MudDrain 7000 |11000 |14000

2 ProMax MudDrain 7000/11000/14000

POX0008

POX0013

C D

POX0010 POX0011



POX0009

10 ProMax MudDrain 7000/11000/14000

Translation of the original Operating

Instructions

INFORMATION ABOUT THIS

OPERATING MANUAL

Welcome to OASE Living Water. You

made a good choice with the purchase of

this product ProMax MudDrain

7000/11000/14000.

Prior to commissioning the unit, please

read the instructions of use carefully and

fully familiarise yourself with the unit. En-

sure that all work on and with this unit is

only carried out in accordance with these

instructions.

Adhere to the safety information for the

correct and safe use of the unit.

Keep these instructions in a safe place!

Please also hand over the instructions

when passing the unit on to a new owner.

Symbols used in these instructions

Warnings

The warning information is categorised by

signal words, which indicate the extent of

the hazard.

WARNING

Indicates a possibly hazardous situa-

tion.

Non-observance may lead to death or

serious injuries.

NOTE

Indicates information intended to give the

user a better understanding.

Additional information

A Reference to a figure, e.g. Fig. A.

Reference to another section.

PRODUCT DESCRIPTION

Overview



ProMax Mud Drain

7000/11000/14000

1 Handle, adjustable

2 Pump base

3 Float switch

4 Connection, pressure side, G1½

5 Power connection cable

6 Stepped hose adapter

Intended use

ProMax MudDrain 7000/11000/14000, re-

ferred to in the following as "unit", may

only be used as specified in the following:

For pumping clear water or rain water.

For pumping dirty water and max.

30 mm large particles.

For irrigating and watering.

For transferring water from and draining

basins such as swimming pools.

Extraction of water from a well.

– Only for irrigation and watering pur-

poses!

For pumping the water out of water

butts/rain barrels or cisterns.

Operation under observance of the

technical data.

Possible incorrect use

The following restrictions apply to the unit:

Not suitable for salt water.

Not suitable for drinking water.

Do not use for long-term operation (e.g.

continuous recirculation of the water in

a pond).

Do not use for commercial or industrial

purposes.

Do not use in conjunction with chemi-

cals, foodstuff, easily flammable or ex-

plosive substances.

Do not connect to the drinking water

supply.

SAFETY INFORMATION

This unit can be used by chil-

dren aged 8 and above and by

persons with reduced physical,

sensory or mental capabilities

or lack of experience and

knowledge if they are super-

vised or have been instructed

on how to use the unit in a safe

way and they understand the

hazards involved.

Do not allow children to play

with the unit.

Only allow children to carry out

cleaning and user maintenance

under supervision.

Electrical connection

Only connect the unit if the electrical

data of the unit and the power supply

coincide. The unit data is to be found on

the unit type plate, on the packaging or

in this manual.

Ensure that the unit is fused for a rated

fault current of max. 30 mA by means of

a fault current protection device.

Extension cables and power distributors

(e.g. outlet strips) must be suitable for

outdoor use (splash-proof).

Protect the plug connections from mois-

ture.

Only plug the unit into a correctly fitted

socket.

Safe operation

Dangerous electrical voltage. Possible

death or severe injury from electrocu-

tion! Before reaching into the water, al-

ways switch off and disconnect (isolate)

all units located in the water with a volt-

age of >12 V AC or >30 V DC and se-

cure them from being switched on

again.

Only operate the unit if no persons are

in the water.

Never operate the unit if either the elec-

trical cables or the housing are defec-

tive!

Do not carry or pull the unit by its elec-

trical cable.

Route cables/hoses such that they are

protected from damage and do not pre-

sent a tripping hazard.

Only open the unit housing or its at-

tendant components, when this is ex-

plicitly required in the operating instruc-

tions.

Only carry out work on the unit that is

described in this manual. If problems

cannot be overcome, please contact an

authorised customer service point or,

when in doubt, the manufacturer.

Only use original spare parts and acces-

sories for the unit.

Never carry out technical modifications

to the unit.

Power connection cables cannot be re-

placed. If a cable is damaged, dispose

of the respective unit or components.

12 ProMax MudDrain 7000/11000/14000

INSTALLATION AND CONNECTION

Connecting the pressure hose

An optimum flow rate is achieved with a

hose inside diameter of 38 mm (1½").

How to proceed:

B

1.Adapt the stepped hose adapter to the

hose diameter

2.Screw the stepped hose adapter onto

the connection on the pressure side.

3.Connect the pressure hose to the

stepped hose adapter.

– Secure the pressure hose with a

hose clip.

Automatic mode

When the water level rises, it lifts the float

switch until the switch-on point is reached

and the pump switches on.

When the water level drops, the float

switch lowers until the switch-off point is

reached and the pump switches off.

C

Push the float switch cable into the ca-

ble clip.

– The shorter the cable between the

float switch and the cable clip, the

lower the switch-on point and the

higher the switch-off point.

NOTE

To ensure faultless function, ensure that

the length of cable between the float

switch and the cable clip measures at

least 10 cm.

NOTE

The minimum residual water height is

only reached in manual mode.

Manual mode

The pump remains permanently switched

on if the float switch is set vertically and

the cable points downward.

NOTE

The pump can run dry in manual mode.

Switch off the pump when the minimum

water level is reached.

Running the pump dry increases wear.

D

Move the handle into the horizontal po-

sition and push the cable directly at the

transition to the float switch into the ca-

ble clip such that the float switch is in a

vertical position.

Installing the pump

H

Install the pump in a horizontal and sta-

ble position in the water.

If it needs to be lowered into a well or a

shaft, fasten a rope to the handle. Do

not carry the pump by its power connec-

tion cable.

Install the pump such that it does not

take in dirt particles with a size >30 mm,

which would block the intake. Install the

pump in a raised position if necessary.

Ensure that the float switch can always

move freely.

OPERATION

WARNING

Dangerous electrical voltage!

Death or severe injury from electrocu-

tion.

Only connect the pump to the power

supply when there are no persons in or

reaching into the water.

Before stepping into or reaching into

the water, switch off all units located in

the water.

Switching on the unit

Insert the power plug into the socket.

– The pump is ready for operation.

– The pump will start up as soon as

the level of the water reaches the

switch-on height.

Switching off the unit

Disconnect the power plug.

– When the pump is switched off, re-

sidual water in the hose may flow

back and out of the pump intake.

NOTE

Do not use the unit for long-term opera-

tion. Otherwise this will impair the operat-

ing life of the unit accordingly.

NOTE

Rinse the pump with clean water after

use.

REMEDY OF FAULTS

Malfunction Cause Remedy

Pump does not start. Power supply interrupted Check the fuse and electri-

cal plug connections.

Pump switches off after a

short running period.

Overload protection has

switched the pump off due

to overheating.

Clean the intake and

pressure hose.

Allow the pump to cool

down.

The pump is running but is

not delivering, or the deliv-

ered quantity is insufficient

Pressure hose kinked Route the pressure hose

without kinks

Check the outlet and

clean if necessary

Intake blocked Clean the intake

Air in the pressure hose Expel the air from the

pressure hose.

If applicable:

Non-return valve incorrectly

fitted in the pressure hose

or clogged

Correctly fit the non-re-

turn valve.

Clean the non-return

valve.

Impeller defective or worn Contact OASE

The impeller may only be

replaced by the OASE

Service.

14 ProMax MudDrain 7000/11000/14000

MAINTENANCE AND CLEANING

WARNING

Dangerous electrical voltage!

Death or severe injury from electrocu-

tion.

Before reaching into the water, switch

off the mains voltage of all units in the

water.

Isolate the unit (disconnect from the

power supply) before carrying out any

work on it.

NOTE

Recommendation on regular cleaning:

Clean the unit as required but at least

twice per year.

Do not use aggressive cleaning agents

or chemical solutions as they could at-

tack the housing or impair the function

of the unit.

Recommended cleaning agent for re-

moving stubborn limescale deposits:

– Pump cleaning agent PumpClean

from OASE.

– Vinegar- and chlorine-free household

cleaning agent.

After cleaning, thoroughly rinse all parts

in clean water.

WEAR PARTS

Wear parts are excluded from the war-

ranty.

The following components are wear parts

and may only be replaced by the OASE

Service.

Impeller

STORAGE/OVER-WINTERING

The unit is not frost-proof and has to be

removed and put into storage if minus

temperatures are expected.

How to correctly store the unit:

Drain the unit as far as possible, clean

thoroughly and check for damage.

Empty all hoses, pipes and connections

as far as possible.

Thoroughly clean the unit, check it for

damage and replace any damaged

parts.

Store the unit in a dry and frost-free

place.

Do not immerse plugs in water.

DISPOSAL

Do not dispose of this unit with domestic

waste! For disposal purposes, please use

the return system provided. Render the

unit unusable beforehand by cutting the

cables.

TECHNICAL DATA

ProMax MudDrain 7000 11000 14000

Rated voltage V AC 230 230 230

Rated frequency Hz 50 50 50

Rated power W 325 625 950

Protection type IP68 IP68 IP68

Connection, pressure side – G1½ G1½ G1½

Minimum switch-on height / maximum

switch-off height

mm 500/250 530/270 530/270

Maximum switch-on height / minimum

switch-off height

mm 670/120 700/100 700/100

Flow rate max. l/h 7500 11500 14500

Head height max. m 5 7 11

Immersion depth max. m 7 7 7

Particle size max. mm 30 30 30

Power connection

cable

Length m 10 10 10

Dimensions Length mm 193 193 193

Width mm 247 247 247

Height mm 395 422 422

Weight kg 4.8 6.4 7.7

POX0039

Andere Handbücher für ProMax MudDrain 7000

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Oase Wasserpumpe Handbücher

Oase

Oase AquaOxy 250 Bedienungsanleitung

Oase

Oase ProMax MudDrain 7000 Bedienungsanleitung

Oase

Oase OptiMax 2000 Produktinformationsblatt

Oase

Oase ProMax Garden Classic 3000 Bedienungsanleitung

Oase

Oase AQUARIUS UNIVERSAL 180 Bedienungsanleitung

Oase

Oase ProMax Series Bedienungsanleitung

Oase

Oase Aquarius 1500 Bedienungsanleitung

Oase

Oase ProMax MudDrain 20000 Bedienungsanleitung

Oase

Oase AquaMax Eco Premium 6000/12 V Bedienungsanleitung

Oase

Oase Varionaut 1 Wartungs- und Serviceanleitung

Oase

Oase AquaMax Eco Classic 1200 Bedienungsanleitung

Oase

Oase AquaMax Eco 5000 Bedienungsanleitung

Oase

Oase Varionaut 270 DMX/02 Bedienungsanleitung

Oase

Oase AquaMax Eco Twin 20000 Bedienungsanleitung

Oase

Oase AquaMax Eco Classic Series Bedienungsanleitung

Oase

Oase Profinaut 21 Bedienungsanleitung

Oase

Oase promax cleardrain 7000 Bedienungsanleitung

Oase

Oase Aquarius Universal Classic 600 Bedienungsanleitung

Oase

Oase Aquamax Dry 6000 Bedienungsanleitung

Oase

Oase Nautilus Solar 70 Bedienungsanleitung

Oase

Oase biOrb AIR 30 Bedienungsanleitung

Oase

Oase 6600 Bedienungsanleitung

Oase

Oase AquaOxy 2500 Leitfaden

Oase

Oase Nautilus 50 Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Xylem

Xylem e-1532 Series Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung

STA-RITE

STA-RITE ST33APP Bedienungsanleitung